• Economic and Environmental Geology
• /
• v.39 no.5 s.180
• /
• pp.525-535
• /
• 2006

A study on stream-groundwater exchange was performed using head and temperature data of stream water, streambed, and groundwater. Groundwater level and temperature were obtained from multi-depth monitoring wells in small-scale watershed. During the summer and winter season, time series of temperature data at streambed and groundwater were monitored for six months. In the winter time, we measured the temperature gradient between stream water and streambed. The observed data showed three typical types of temperature characteristics. First, the temperature of streambed was lower than that of stream water; second, the temperature of streambed and stream water was similar; and the last, the temperature of streambed was higher than that of stream water. The interconnections between the stream and the streambed were not homogeneously distributed due to weakly developed sediments and heterogeneous bedrock exposed as bed of the stream. The temperature data may be used in formal solutions of the inverse problems to estimate groundwater flow and hydraulic conductivity.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.9 no.5
• /
• pp.49-58
• /
• 2010

The traffic signal controllers being used in the domestic currently are being manufactured based on the korean national police standard which was developed for controlling the quad-light traffic signal having the red, yellow, left-turn arrow, and green lights. But according to the national policy for the traffic operation, they have to be changed to be able to switch the tri-light signal having red, yellow and green lights. In this study, a new tri-light traffic signal controller was designed and developed by the way improving the Signal Control Unit of the existing quad-light standard traffic controller. The Load Signal Unit(LSU) was improved to output 6 signals which are the two assemblies of three signal indications having the red, yellow, and green lights. To enough traffic signals output to control each directional movements and the various transport modes which are car, bus, bike, and pedestrian etc., the connector bus system was designed to be able to accommodate maximum 96 signals outputs being constructed by 16 LSUs. Flasher device was developed to be able to support maximum 32 red signals. In the software, the communication protocol between traffic control center and the traffic signal controller was improved and new signal map code values were defined for the developed LSU controlling the quad-light traffic signal. A model of the quad-light traffic signal controller developed and was tested three operations, protocol-operation, remote-command and control-mode. The test result operated all of them successfully.

• Asian Pacific Journal of Cancer Prevention
• /
• v.16 no.10
• /
• pp.4335-4338
• /
• 2015

Background: Oral cancer is the third most common malignancy in Saudi Arabia, the highest incidence of which is reported from Jazan province. The objective of this study was to evaluate the association of various locally used substances, especially shamma, with oral cancer in the Jazan region of Saudi Arabia. Materials and Methods: A hospital-based case-control study was designed and patient records were scanned for histologically confirmed oral cancer cases. Forty eight patients who were recently diagnosed with oral cancer were selected as cases. Two healthy controls were selected for each observed case and they were matched with age (+/- 5 years) gender and location. Use of different forms of tobacco such as cigarettes, pipe-smoking and shamma (smokeless-tobacco) was assessed. Khat, a commonly used chewing substance in the community was also included. Descriptive analysis was first performed followed by multiple logistic regression (with and without interaction) to derive odds ratios (ORs) and 95% confidence interval (CIs). Results: Mean age of the study sample (56% males and 44% females) was 65.3 years. Multinomial regression analysis revealed that shamma use increased the odds of developing oral cancer by 29 times (OR=29.3; 10.3-83.1). Cigarette (OR=6.74; 2.18-20.8) was also seen to have an effect. With the interaction model the odds ratio increased significantly for shamma users (OR=37.2; 12.3-113.2) and cigarette smokers (OR=10.5; 2.88-3.11). Khat was observed to have negative effect on the disease occurrence when used along with shamma (OR=0.01; 0.00 - 0.65). Conclusions: We conclude that shamma, a moist form of smokeless tobacco is a major threat for oral cancer occurrence in the Jazan region of Saudi Arabia. This study gives a direction to conduct further longitudinal studies in the region with increased sample size representing the population in order to provide more substantial evidence.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.34 no.1
• /
• pp.17-25
• /
• 2012

Purpose: Recently, a three dimensional approach to hard and soft tissues of the maxillofacial area has been widely used. This study was to evaluate the reproducibility and accuracy of a stereocamera compared to actual measurement methods using a digital caliper and digitizer. Methods: The stereoscopies of 7 head dummies with different sizes and shapes were obtained using a Di3D system (Dimensional Imaging, Glasgow, UK) after marking reference points on facial areas. From the obtained stereoscopy, 10 measurements representing the width, height and depth of each of the facial sections of the dummy were measured twice using a three dimensional reverse engineering software program (RapidForm$^{TM}$ 2006, Inus, Seoul, Korea). The x, y, and z coordinates of each of the three dimensional measurements were obtained and distances between two points were calculated. All procedures were repeated twice. The actual measurement method was performed twice, directly on dummies, using a digital caliper and values were compared with the previously determined values. Results: The results were as follows. In the ANOVA analysis, there were no significant statistical differences among the three measurement methods. In the Bonferroni analysis, with adjustments applied for multiple comparisons, there was no difference between actual measurement methods using a digitizer and a digital caliper. However, there was some difference between using a stereocamera and actual measurement methods using a digitizer and a digital caliper in values of $Ex_{Rt}-Ex_{Lt}$, $En_{Rt}-En_{Lt}$, $Ala_{Rt}-Ala_{Lt}$, $Ch_{Rt}-Ch_{Lt}$, G-Pg', $Ala_{Rt}$-Prn, $Ala_{Rt}$-Prn. The mean value for technical error in measurement (TEM) in Di3D (0.98 mm) was slightly higher than for a digital caliper (0.17 mm) and a digitizer (0.30 mm). In an intraclass correlation coefficient (ICC) there were no significant differences among the three measurement methods, but the Di3D system with the stereocamera showed relatively lower reproducibility compared to actual measurement methods using a digitizer and a digital caliper. Conclusion: These results indicate that some complementary measures may be needed to improve accuracy and reproducibility in the Di3D system with stereocamera.

• Biomedical Science Letters
• /
• v.6 no.2
• /
• pp.119-129
• /
• 2000

The skin is an organ that has many important roles, including protection against infection, regulation of temperature and fluid loss, and sensory function. Injury to the skin, wound repair normally involves: (1) balanced activity of inflammation, (2) the re-epithelial phase and (3) the matrix formation of remodeling phase. Thus, skin wound healing is a finely controlled biological process involving a series of complex cellular interactions. Laser therapy is being implemented with increasing frequency in medicine. Low intensity laser is one that is capable of producing an energy density so low that any biologic alterations are the result of direct irradiation effect, not thermal events. This study was designed to evaluate the efficacy of low intensity laser therapy on skin wound healing in rabbits. A total of 10 male rabbits (New Zealand White Rabbit), age 8 weeks were used. Skin wound were surgically created dorso-lateral on the flank of 10 rabbits (2$\times$2 cm/damage areas). The experimental animals were treated with 5Hz (830 nm wave length) low-intensity laser (MILTA-01 Model) daily for 10 min (1.6 J/$cm^2$) for 12 days. Control animals were sham treated with the laser head. Laser irradiation animals showed a complete remodeling of the epithelial layer, a positive repair of connective tissues, and enhanced the wound closure rate over time as compared to the control animals. Especially, laser irradiation groups improved fibroblast activity, cellular content, granulation tissue formation, and collagen deposition which is resulted in improving the tensile strength of the wound. These findings suggest that laser photostimulation could accelerate healing of open wound in rabbits, and may be benefit in the treatment of open wound, including decubitis ulcers.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.12
• /
• pp.629-635
• /
• 2019

In this study, we analyzed the effect of FAN and oil cooler application on APU. MIL-STD-810 was applied to the atmospheric environment and radiation dose in order to perform thermal flow analysis. The heat flow was analyzed for the case in which the inlet / outlet fan was applied (Case 1), the case in which the inlet fan and the oil cooler were applied (Case 2), and the case in which the inlet / outlet fan and the oil cooler were applied (Case 3). As a result, it was confirmed that the cylinder head temperature of Case 3 was 21.4 times lower than that of Case 1 and 8.0 times lower than that of Case 2. Experiments were conducted under the same ambient conditions in order to examine the validity of the results. The numerical values and experimental results showed a difference of less than 7%. Through this, we were able to confirm that the APU heat flow optimization model satisfies the design conditions. The results of this study are expected to be used as basic data for optimizing heat flow of APU.

• Journal of Labour Economics
• /
• v.24 no.2
• /
• pp.1-34
• /
• 2001

This study analyzes the male-female difference in self-employment rates in Korea using panel data constructed from the Economically Active Population Survey in 1999. Given that most studies on self-employment have focused on male self-employment and have not examined why self-employment rate is usually higher among males than females, this study certainly extends the existing literature on this subject This study consists of two parts. The first part deals with estimating self-employment rates for males and female within a Markov framework. The second part presents decomposition results of the male-female differential in self-employment rates. Major findings of the study are (1) self-employment rate is higher for males than females because entry into self-employment is larger but exit from self-employment is smaller for males than female, (2) higher entry probability for males is due to differences in coefficients of transition probability functions while lower exit probability for males is due to differences in characteristics, (3) a large part of male-female gap in self-employment rates results from differences in being a head of family, marital status and age between males and females.

• Journal of Biomedical Engineering Research
• /
• v.25 no.2
• /
• pp.89-95
• /
• 2004

Intensity-modulated radiation therapy (IMRT) often uses small beam segments. The heterogeneity effect is well known for relatively large field sizes used in the conventional radiation treatments. However, this effect is not known in small fields such as the beamlets used in IMRT. There are many factors that can cause errors in the small field i.e. electronic disequilibrium and multiple electron scattering. This study prepared geometrically regular heterogeneous phantoms, and compared the measurements with the calculations using the Convolution/Superposition algorithm and Monte Carlo method for small beams. This study used the BEAM00/EGS4 code to simulate the head of a Varian 2300C/D. The commissioning of a 6MV photon beam were performed from two points of view, the beam profiles and depth doses. The calculated voxel size was 1${\times}$1${\times}$2$\textrm{cm}^2$ with field sizes of 1${\times}$1$\textrm{cm}^2$, 2${\times}$2$\textrm{cm}^2$, and 5${\times}$5$\textrm{cm}^2$. The XiOTM TPS (Treatment Planning System) was used for the calculation using the Convolution/Superposition algorithm. The 6MV photon beam was irradiated to homogeneous (water equivalent) and heterogeneous phantoms (water equivalent ＋ air cavity, water equivalent ＋ bone equivalent). The beam profiles were well matched within :t1 mm and the depth doses were within ${\pm}$2%. In conclusion, the dose calculations of the Convolution/Superposition and Monte Carlo simulations showed good agreement with the film measurements in the small field.

• Journal of radiological science and technology
• /
• v.34 no.1
• /
• pp.43-50
• /
• 2011

In this study we modeled the varian 2100C/D linear accelerator head and multi-leaf collimator by simulation with the GEANT4 Monte Carlo toolkit. Then central axis percentage depth dose profiles and lateral dose profiles within homogeneous water phantom($50{\times}50{\times}50\;cm^3$) were evaluated with 6 MV photon beam. The simulations were performed in two stages. In the first stage, photon energy spectrum at the target were computed were computed. Then spectra data was directly irradiated in the water phantom using sampling techniques. The simulation data were compared with experimental data to evaluate the accuracy of the model. Results showed that two data were matched within 2% error boundary. The proposed method will be applied for simulation of dose calculation and dose distribution study.

• The Journal of Engineering Geology
• /
• v.30 no.2
• /
• pp.147-160
• /
• 2020

Unsaturated hydraulic conductivity of near-surface unconsolidated layers depends on the physical properties and water content of the unconsolidated layers. So far, many studies have been conducted on the unsaturated hydraulic conductivity of near-surface unconsolidated layers. However, researches on hydraulic conductivity of unsaturated fractured rocks have been relatively rare. In relation to the construction of a low/intermediate level radioactive waste surface-disposal facility, this study compared and analyzed van Genuchten parameters (α, n) in the laboratory and the hydraulic conductivity obtained in field tests for fractured hornfels at a radioactive-waste disposal site of Korea. The relationship between the field hydraulic conductivity and van Genuchten parameters using data from the ten depth intervals of three boreholes resulted in that the correlation coefficient (R) between the hydraulic conductivity and the van Genuchten parameter α was 0.7607, showing positive correlation whereas the R between the hydraulic conductivity and the van Genuchten shape-defining parameter n was -0.8720, showing negative correlation. Hence, this study confirmed the relationship between the field hydraulic conductivity and the van Genuchten unsaturated functions for the unsaturated fractured hornfels.