• Korean Management Science Review
• /
• v.30 no.2
• /
• pp.97-106
• /
• 2013

Of the new and renewable energies currently being pursued domestically, wind energy, together with solar photovoltaic energy, is a new core growth driver industry of Korea. As of May 2012, 33 wind farms at a capacity of 347.8MW are in operation domestically. The purpose of this study was to compare and analyze how efficiently each operational wind farm is utilizing its power generation capacity and the weather resource of wind. For this purpose, the study proceeded in 3 phases. In phase 1, ANOVA analysis was performed for each wind farm, thereby categorizing farms according to capacity, region, generator manufacturer, and quantity of weather resources available and comparing and analyzing the differences among their operating efficiency. In phase 2, for comparative analysis of the operating efficiency of each farm, Data Envelopment Analysis (DEA) was used to calculate the efficiency index of individual farms. In the final phase, phase 3, regression analysis was used to analyze the effects of weather resources and the operating efficiency of the wind farm on the power generation per unit equipment. Results shows that for wind power generation, only a few farms had relatively high levels of operating efficiency, with most having low efficiency. Regression analysis showed that for wind farms, a 1 hour increase in wind speeds of at least 3m/s resulted in an average increase of 0.0000045MWh in power generation per 1MW generator equipment capacity, and a unit increase in the efficiency scale was found to result in approximately 0.20MWh power generation improvement per unit equipment.

• Korean Journal of Food Science and Technology
• /
• v.30 no.3
• /
• pp.650-654
• /
• 1998

Three distinct phases were observed in acidity change during the Kakdugi fermentation; the first increasing phase, a stable phase, and the second increase phase. Enterobacter strains were the dominant bacteria (more than 90%) just after preparation of Kakdugi. Lactobacillus and Leuconostoc sp. were the mainly isolated from properly-ripened (53 and 43%, respectively) as well as from over-ripened Kakdugi (63 and 37%, respectively). Leuconostoc mesenteroides subsp. paramesenteroides was the dominant one among the lactic cocci from Kakdugi. The isolates from properly-ripened Kakdugi required more amino acids for growth compared to those from over-ripened one while no difference was observed with vitamins. Their physiological characteristics such as amino acid and vitamin requirement were different from those of 9 type strains of various Leuconostoc species.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.29 no.6
• /
• pp.494-498
• /
• 2007

Pleiotrophin or osteoblast-specific factor 1(HOSF-1) is a growth-associated protein present in bone matrix. This study was designed to study pleiotrophin expression in osteoblastic cells. Pleiotrophin was expressed by osteoblast-like cell line. Pleiotrophin expression increased following the proliferative phase and was minimal at the terminal phases of the induced differentiation of cultured MC3T3-E1 cells. Pleiotrophin expression represents another autocrine factor that may contribute to the physiologic control of induced bone formation. In this study, induced osteogenesis will be examined in the context of the osteoblast expression of and regulation by PTN. I hypothesized that PDGF-BB stimulation of PTN expression represents an important paracrine signal during the induced osteogenesis associated with periodontal and implant surgeries. The possible mediation by PTN of anabolic effects attributed to PDGF-BB stimulation was examined in cell culture models of osteoblast differentiation. These studies will contribute fundamental insights to osteoblast biology and insights regarding the potential use of factors such as PTN in the clinical environment.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.9
• /
• pp.766-771
• /
• 2009

Lead-free $0.94(Na_{0.5}K_{0.5})NbO_3$-0.06Ba$(Ti_{0.9}Sn_{0.1})O_3$ [0.94NKN-0.06BTS] ceramics doped with 1 mol% $MnO_2$ were synthesized by a conventional solid state method. The phase transitional behavior and piezoelectric properties of the ceramics sintered at various temperatures were investigated. The 0.94NKN-0.06BTS ceramics sintered at $1050^{\circ}C$, having morphotropic phase boundary of orthorhombic and tetragonal phases, exhibited a microstructure with abnormal grain growth. A diffused phase transition behavior for all the specimens was verified as high degree of diffuseness (${\gamma}$) values from 1.45 to 1.79. A high piezoelectric constant of $d_{33}=256$ pC/N and a satisfactory electromechanical coupling factor of $k_p=42%$ were obtained for the relatively dense 0.94NKN-0.06BTS ceramics sintered at $1050^{\circ}C$.

• KSBB Journal
• /
• v.9 no.2
• /
• pp.140-146
• /
• 1994

Aureobasidium pullulans produced high concentration of polyols extracellularly in the media of sucrose, glucose and mannose as sole carbon source. Mannitol was the main polyol produced during the late exponential and stationary phases of growth together with small quantities of glycerol. Sucrose and glucose were rather rapidly metabolized to mannitol among carbon sources examined where the initial glucose concentration showed no difference in the amount of mannitol. In contrast 20%(w/v) of sucrose was the most appropriate concentration tested. However, the yield of mannitol based on substrate used($Y_{p/s}$) was independent on the initial concentration, and the mean value of mannitol yield in 10% glucose and sucrose media was 0.144 and 0.188, respectively. Mannitol production was reduced in response to an elevated water stress imposed by salts within the range from 0.25 to IM of NaCl or KCl as stress solutes. However, glycerol contents and its ratio to mannitol were increased at the conditions of high salinity. Based on the results, extracellular mannitol produced by A. pullulans probably resulted partly from osmoregulation(in case of glycerol) and mainly from, as known to occur in most of fungi, enzymatic reduction of the corresponding hexoses through phosphate pathway.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.10
• /
• pp.1089-1095
• /
• 2011

Numerical simulation is performed for nucleate boiling on a micro-finned surface, which has been widely used to enhance heat transfer, by solving the equations governing the conservation of mass, momentum, and energy in the liquid and vapor phases. The bubble motion is determined by a sharp-interface level-set method, which is modified to include the effect of phase change and to treat the no-slip and contact-angle conditions, as well as the evaporative heat flux from the liquid microlayer on immersed solid surfaces such as micro fins and cavities. The numerical results for bubble formation, growth, and departure on a microstructured surface including fins and cavities show that the bubble behavior during nucleate boiling is significantly influenced by the fin-cavity arrangement and the fin-fin spacing.

• Journal of Magnetics
• /
• v.8 no.4
• /
• pp.138-141
• /
• 2003

$Ni_{0.65}Zn_{0.35}Fe_2O_4$thin films were prepared by using a sol-gel method. Their crystallographic, dielectric and magnetic properties were investigated as a function of Cu contents by means of an X-ray diffractometer (XRD), X-ray reflectivity, LCZ meter (NF2232), a vibrating sample magnetometer (VSM), and an atomic force microscope (AFM). From typical C-V measurements for $Ni_{0.65}Zn_{0.35}Fe_2O_4$ thin films on p-type silicon substrate, the surface charge density was calculated as 1.4 ${\mu}$C/$m^2$. The dielectric constant evaluated from the capacitance at the accumulation state was 28. The high $H_{c}$ and low $M_{sat}$ at x=0.0 and 0.1 were due to the growth of the ${\alpha}$-$Fe_2O_3$ phase having antiferromagnetic properties. The rapidly decreased $H_{c}$ and increased $M_{sat}$ at x=0.2 and 0.3 can be explained that the ${\alpha}$-$Fe_2O_3$ phases have completely disappeared at x=0.3 and so, non-magnetic defects are minimized. The $M_{sat}$ was slightly decreased and the $H_{c}$ was increased above at x=0.3 because the increase of grain boundary due to smaller grain size acts as defects during magnetization process.

• Journal of the Korean Ceramic Society
• /
• v.51 no.6
• /
• pp.623-628
• /
• 2014

Orthorhombic $Ba(Ti_{0.94}Zr_{0.06})O_3$ single crystals are fabricated using the cost-effective solid-state single crystal growth (SSCG) method; their dielectric and piezoelectric properties are also characterized. Measurements show that (001) $Ba(Ti_{0.94}Zr_{0.06})O_3$ single crystals have an electromechanical coupling factor ($k_{33}$) higher than 0.83, piezoelectric charge constant ($d_{33}$) of about 400 [pC/N], and piezoelectric voltage constant ($g_{33}$) higher than 50 [${\times}10^{-3}Vm/N$]. The transition temperature ($T_{OT}$) of the (001) $Ba(Ti_{0.94}Zr_{0.06})O_3$ single crystals between orthorhombic and tetragonal phases is also observed to be about $61^{\circ}C$. Because their electromechanical coupling factor ($k_{33}$) and piezoelectric voltage constant ($g_{33}$) are higher than those of soft PZT ceramics, it is expected that (001) $Ba(Ti_{0.94}Zr_{0.06})O_3$ single crystals can be used as "lead-free" piezoelectric materials in many piezoelectric applications.

• Journal of Microbiology and Biotechnology
• /
• v.13 no.4
• /
• pp.598-606
• /
• 2003

Salmonella encodes an enterotoxin (Stn) which possesses biological activity similar to the cholera toxin. Stn contributes significantly to the overall virulence of S. typhimurium in a murine model. The production of Stn is enhanced in a high-osmolarity medium and by contact with epithelial cells. In the present study, the in vitro and in vivo transcriptional regulations of the sin promoter revealed two promoters, P1 and P2. The P1 promoter identified by a primer extension analysis of stn mRNA exhibited a switching mechanism in vivo. Depending on the growth stage, transcription was initiated from different start sites termed $P1_S\;and\;P1_E$. $P1_S$, recognized by RNA polymerase containing ${\sigma}^S(E{\sigma}^S),\;and\;P1_E$, recognized by $E{\sigma}^70$, were activated during the stationary and exponential phases, respectively, while $P1_S\;and\;P1_E$ were both negatively regulated by CRPㆍcAMP and H-NS. Results revealed that $P1_S$ was the responsible promoter activated under a high osmolarity and low pH. The P2 promoter was identified 45 nucleotides downstream from $P1_E$ and negatively controlled by CRPㆍcAMP in vitro. No P2 activity was detected in vivo. The regulation of stn expression monitored using a Pstn::egfp fusion indicated that $E{\sigma}^S$ was required for the induction of stn and various factors were involved in stn regulation inside animal cells.

• Journal of the Microelectronics and Packaging Society
• /
• v.17 no.1
• /
• pp.1-7
• /
• 2010

Interfacial reaction characteristics of a Bi-10Cu-20Sb-0.3Ni Pb-free alloy on Cu pad was investigated by reflow soldering at $430^{\circ}C$. The thickness of interfacial reaction layers with respect to the soldering time was also measured. After the reflow soldering, it was observed that a $(Cu,Ni)_2Sb$, a $Cu_4Sb$ intermetallic layer, and a haze layer, which is consisted of Bi and $Cu_4Sb$ phases, were successively formed at the Bi-10Cu-20Sb-0.3Ni/Cu interface. The total thickness of the reaction layers was found to be linearly increased with increasing of the reflow soldering time up to 120 s. As the added Ni element did not participate in the formation of the thickest $Cu_4Sb$ interfacial layer, suppression of the interfacial growth was not observed.