• Journal of Energy Engineering
• /
• v.25 no.1
• /
• pp.29-42
• /
• 2016

This study analyzes the economic efficiency of utilizing hot waste water at a thermoelectric power plant, which is part of recent projects supported by the Korean government to foster new energy industry. The author proposes an institution that provides economic incentives to promote the project. Based on a method of calculating Levelized cost of energy (LCOE), this study finds that the LCOE of using hot waste water at power plants is higher than that of oil boiler, biomass and a power plant's auxiliary steam but similar to that of the geothermal system. Also, according to sensitivity analysis on the LCOE of each element in the system of using hot waste water, a distance of heat supply is most sensitive. Therefore, this study shows that when the government devises an incentive-based institution to expand the project of utilizing hot waste water, it is necessary to establish Renewable Energy Certificate (REC) weights that are differentiated by a distance of heat supply.

• Advances in environmental research
• /
• v.8 no.1
• /
• pp.23-38
• /
• 2019

In this study, Malachite Green (MG) dye removal from synthetic wastewaters by adsorption process using raw boron enrichment waste (BEW) and it's modifications (with acid and ultrasound) were aimed. 81% MG removal was obtained by BEW at optimum equilibrium conditions (time: 40 min., dosage: 500 mg/dm³, pH: 5-6, speed: 200 rpm, 298 K). MG removal from wastewaters using acid modified boron enrichment waste (HBEW) was determined as 82% at optimum conditions (time: 20 min., dosage: 200 mg/dm³, pH: 10, speed: 200 rpm, 298 K). For ultrasound modified BEW (UBEW), the highest MG removal percent was achieved as 84% at optimum conditions (time: 30 min, dosage: 375 mg/ dm³, pH: 8, speed: 200 rpm, 298 K). The equilibrium data of Malachite Green was evaluated for BEW, HBEW and UBEW adsorbents by using sorption isotherms such as Langmuir, Freundlich and Temkin models, out of which Langmuir model (R² = 0.971, 0.987 and 0.984) gave better correlation and maximum adsorption capacity was found to be 147.05, 434.78 and 192.30 mg/g, respectively. The adsorption kinetics followed the pseudo-second-order kinetic equation for sorption of MG onto wastes. A look at thermodynamic data reveals that natural sorption is spontaneous and endothermic because of free negative energy exchange and positive change in enthalpy, respectively. The results indicated that boron enrichment waste, and HCl and ultrasound-modified boron enrichment waste served as good alternative adsorbents in dye removal from wastewater.

• Journal of Energy Engineering
• /
• v.21 no.3
• /
• pp.315-324
• /
• 2012

Waste reduce, recycle, energy recovery technology is one of 27 key green technology by 2012, the government should increase R&D investment, despite the period 2008 to 2010 average annual growth rate was decreased. Accordingly, this area of government investment in R&D status analyzed in detail and as a result, total government investment in R&D decreased, but in these fields to define strategic product services investment in technology is increasing centralization trend that appears to be investment in the quality of determined that the good is. In particular, in 2010, strategic product service of the technologies 3 technology groups ((1) waste energy equipment (2) waste resource recycling facilities (3) waste based materials production facilities) the proportion of 24-28% relatively evenly invested, government R&D is judged that adequate investment in quality.

• Journal of Nuclear Fuel Cycle and Waste Technology
• /
• v.1 no.1
• /
• pp.57-63
• /
• 2013

Natural green rust (GR) can retard the migration of anions through geological media because it has a Layer Double Hydroxyl (LDH) structure with a positive charge. In this study, the sorption behaviors of anions such as selenite ($Se(IV)O{_3}^{2-}$), selenate ($Se(VI)O{_4}^{2-}$), and iodide ($I^-$) onto green rusts with different structures, i.e., GR($Cl^-$) and GR($CO{_3}^{2-}$), were investigated by conducting batch sorption experiments in an anoxic condition. Experimental results showed that selenite was mostly sorbed onto GR($CO{_3}^{2-}$) and then partly reduced to metal selenium, Se(0). However, little selenate and iodide was sorbed onto GR($CO{_3}^{2-}$) while some iodide was sorbed onto GR($Cl^-$). It is presumed from the experimental results that the major sorption mechanism of $SeO{_3}^{2-}$ and $I^-$ onto green rusts is the anion exchange reaction with the anions existing in the interlayer of the rusts. Green rust, therefore, can play an important role in the retardation of anions migrating through deep geological environments owing to its LDH structure with a high anion exchange capacity.

• Resources Recycling
• /
• v.18 no.3
• /
• pp.3-10
• /
• 2009

This paper will introduce the study which is the solidification and reduction of $CO_2$ green house gas, by using inorganic industrial wastes such like waste cement, steel making slag, incineration ash and so on. These inorganic wastes contain a large quantity of CaO content in common, which is easily reacted with CaO resulting in formation of $CaCO_3$. It will be suggested in this study that the necessary of the reduction and solidification of $CO_2$ gas with using industrial inorganic wastes is for building the Korea carbon storage model in this study.

• Journal of the Korean Chemical Society
• /
• v.57 no.2
• /
• pp.272-278
• /
• 2013

Extract of ginger has been evaluated as a green inhibitor for the corrosion of steel in sulfide polluted NaCl solution using potentiodynamic polarization, electrochemical impedance spectroscopy (EIS) and electrochemical frequency modulation (EFM) techniques. Potentiodynamic polarization measurements showed that this extract acts as a mixed type inhibitor but mainly inhibits the cathodic reaction. The inhibition efficiency was found to increase with inhibitor concentration reaching to approximately 83.9% using 250 ppm of ginger. Nyquist plots show a single capacitive loop in uninhibited and inhibited solutions. From EFM the causality factors are very close to theoretical values which indicate that the measured data are of good quality. The adsorption process of the studied extract on steel surface obeys Temkin adsorption isotherm. The results obtained from the different electrochemical techniques were in good agreement which prove the validity of these tools in measurement of corrosion rate. Ginger extract has no effect on Escherichia Coli and can be applied safely on waste water treatment plants.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.1
• /
• pp.234-241
• /
• 2010

Industrial combustible waste is very valuable source for refuse derived solid fuel since its heating value is usually over 3,000kcal/kg. Especially, synthetic high molecular compound which is high of productivity and heating value is used as raw material in many cases. Film type plastic has been widely used for producing RPF because their shaping is easy and they has high heating value. On the other hand, the possibility of various type of waste as a source for RPF in this study. It has been found that resin compound drived and tire derived solid fuel showed more than 6,000kcal/kg of heating value. But the heating value decreased by adding paper and wood waste.

• Journal of Fashion Business
• /
• v.16 no.4
• /
• pp.29-45
• /
• 2012

The purpose of this study is for providing not only the latest design technique trend for zero waste fashion, but information about creative fashion design education through eco-fashion industry trend in globally and domestic which is focusing on eco-fashion labelling. The research were processed with literature related eco, sustainable, green fashion books, former articles, newspapers, and web sites. The results as follows; The certification about eco-fashion product is moving to 'Life Cycle Assessment' from focused on primary process like material, finishing, dyeing. Especially simplicity of process means reducing the wastes. And fabric wastage for adult outwear was estimated 15% percent of total fabric used in general design studios. Three cases for Zero waste fashion were as follows; First, Jigsaw puzzle by Timo Rissane and Mark Liu were different zero waste methods, but the result was same. Rissene's method was based on traditional cutting like 'cut and sew' but traditional cutting can lead to design that have an abundance of fabric and drape. Jigsaw of Rissene was approached with description a pattern-cutting technique in which all piece interlock with each other generating no waste from design production. Another Jigsaw by Liu was related with innovative textile design. DTP makes the possibilities for zero waste garment production almost endless. The dress intricately cut from 10 pieces, wastes none of the fabric required to make it. Second, Subtraction Cutting by Julian Roberts provides unexpected fluid, organic forms and zero waste fabric. Utilizing Roberts plug(tunnel) technique enables any part of the garment that is removed for fit or aesthetics to be reincorporated into the design of garment. Third was 'Bio Couture' by Suzanne Lee. She has created garments from cellulose bacteria which grow in a bathtub using only green methods addressing in such as way ecological issues and exploring the future of fashion design in conjunction with technology.

• Resources Recycling
• /
• v.22 no.2
• /
• pp.11-17
• /
• 2013

The recycling technology of carbon residue produced from the process of oil recovery in waste tire pyrolysis is significant in environmental and economical aspects. This study was done to figure out the recycling possibility of carbon residue to activated carbon. For this, the characteristics of the carbon residue obtained from the commercial pyrolysis process of waste tire were studied. Also, the variation of pore structure of carbon residue was studied after 1 hour of carbonization at $600^{\circ}C$ and $800^{\circ}C$ and 3 hours of activation at $950^{\circ}C$. The specific surface area of the carbon residue was $8.0m^2/g$ and it increased to $548.3m^2/g$ after carbonization and activation.

• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.664-667
• /
• 2001

Segregation of binary particle systems in a horizontally gyrated bed has been experimentally studied to recover the heavy metals from municipal waste incineration (MWI) ash. Differences in density and size had less effect on segregation. Effective segregation took place under the centrifugal effect of 1 or less for any particle size ratio. Zn, Cu and Pb were concentrated in the upper side of bed by the horizontal vibration. However, there was less change in concentration for other metals such as Mg, Al and Fe etc. The separation system with the horizontal gyrating separator proved to be an effective method for the pretreatment of recovering Zn, Cu and Pb from incineration residues.