• Journal of the Korean Geotechnical Society
• /
• v.21 no.8
• /
• pp.37-43
• /
• 2005

Hoek-Brown model, which was developed in order to predict the behavior of rock mass, has widely been utilized and revised by many researchers to solve various problems encountered in tunnelling and slope stability analysis. However, there is no schematic investigation on the application of the Hoek-Brown model to numerical analysis including finite element simulations. In this paper the Hoek-Brown model was formulated as a constitutive model according to the procedure of generalized plasticity theory, and a Rounded Hoek-Brown model, which could overcome the numerical difficulties by modifying the edge part of the yield surface as a curve shape, was newly proposed. The new model could satisfy the requirements as an elasto-plastic constitutive soil model and follow the yield surface of the original Hoek-Brown model in the compression mode. The constitutive equation for the proposed model herein was established and presented to be applicable to the generalized nonlinear finite element analysis.

• Journal of the Korean Geotechnical Society
• /
• v.21 no.8
• /
• pp.45-53
• /
• 2005

Shallow slope failures in residual soil during periods of prolonged infiltration are common over the world. Therefore, this study examines an approximate method to estimate the influence of infiltration on surficial stability of slopes by one-dimensional infiltration model. Modified GAML model based on the Green-Ampt model was extended to predict the infiltration behavior of two-layered slope. Then, the model has been considered to evaluate the likelihood of shallow slope failure which is induced by a particular rainfall event that accounts for the rainfall intensity and duration for various return periods in two-layered soil profile. The results obtained from the approximate method were compared with those obtained from numerical analyses. According to the results, with the use of properly estimated input parameters, the proposed method was found to give good results that agree reasonably well to those of the more rigorous finite element analyses.

• Journal of the Korean Geotechnical Society
• /
• v.15 no.2
• /
• pp.17-27
• /
• 1999

It comes to be an important point to judge precisely the effects of excavation on adjacent ground and structures. It is incorrect to evaluate the ground settlement by excavation without considering the adjacent structure. In this study, laboratory scale tests were carried out by varying the position of structure under the condition of different system stiffness and wall friction to evaluate the behavior of adjacent structures and ground by excavation. When the distance between the structures and the wall was less than 0.3 times of the excavation depth, the ground settlement increased by 181%. No additional effect was observed when the distance was more than 1.0H. As the embedded depth was deeper, the influence zone was smaller, and few additional settlements and angular displacement were observed when the embedded depth was more than 0.75H.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.7
• /
• pp.5-15
• /
• 2013

Clogging phenomenon is one of the important problems in deteriorated tunnels, and it caused inhibition of drainage system by long-term behavior. Clogging phenomenon is mainly composed of $CaCO_3$ in the form calcite. Calcite is generally created by the reaction of $Ca(OH)_2$ with $CO_2$ emitted from vehicles. The structure of deteriorated tunnels was simulated and the setting of outflow from drainage pipe was observed in this study. The test was experienced by changing the slope of drainage system because existing drainage system was pracitced almost below $5^{\circ}$. As a result, in case of drainage system's slope is $2^{\circ}$, Quantum Stick has an effect for prohibiting scale in drainage system, but magnetic treatment was not effective. As a result, in case of drainage system's slope is $5^{\circ}$, both technologies were effective for prohibiting scale in drainage system, but Quantum Stick was especially more effective than magnetic treatment.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.11
• /
• pp.129-138
• /
• 2013

In this study, Anchor Pile Precast Retaining Wall (APC) with screw shape flange was investigated and the results were arranged for designing APC specifications. Since precast materials require special care when they are manufactured, carried or treated, more accurate design and analysis of optimized dimension are needed : thus moment distribution of front foot was checked. Through full-scale field test, form and optimal stiffening shape were obtained and through fracture test with real load, applicable load was reasonably calculated. Research result in this thesis could be used as guideline or standard of designing and constructing Anchor Pile Precast Retaining Wall with screw shape flange.

• Journal of the Korean Geotechnical Society
• /
• v.33 no.6
• /
• pp.37-48
• /
• 2017

Soil-water characteristic curve (SWCC) has been widely used to estimate the shear strength and coefficient of permeability for unsaturated soils. In general, it is divided into the drying path in which the water is discharged and the wetting path in which the water is permeated, and it has a hysteresis indicating different suctions at the same volumetric water content. In reality the field behavior of unsaturated soils is much closer to the wetting path during the infiltration. The drying path has been practically used for various analyses because obtaining the wetting path takes longer than the drying path. Although many approaches for estimating wetting path have been studied till now, these are complex and do not fit well. Therefore, a simple method for estimating wetting path based on empirical approach in this study is proposed in unsaturated soils, and a feasibility study is conducted as well.

• Geotechnical Engineering
• /
• v.9 no.4
• /
• pp.55-64
• /
• 1993

The Undrained creep tests on the normally consolidated clays with four different consolication ratios(c3c'/clc': 1.0, 0.7, 0.5, 0.4) were performed to investigate the effects of avisotropic consolidation on the undrained creep rupture behavior. The elapsed time to a certain minimum strain rate is decreased with decreasing the value of the consolidation pressure ratio, and the elapsed time to rupture for a certain minimum strain rate is also decreased with decreasing the ratio. The upper yield strength obtained from the equation suggested by Finn and Shead(1.) is coincided well with the creep strength irrespective of the magnitude of the consolidation pressure ratio, and the normallised upper yielding strength by mean confining pressure is decreased with increasing the consolidation pressure ratio. The critical strain for creep rupture, the strain at min. strain rate, is constant irrespective of the magnitude of creep stress, but it increased exponentially with increasing the ratio, It accordingly is dangerous that the potential of in-situ creep rupture is estimated only by the creep rupture test on the isotropically consolidated clay in case of K0-value below 1.0.

• Geotechnical Engineering
• /
• v.11 no.4
• /
• pp.13-24
• /
• 1995

Laboratory testings, consisting of soil properties testing and vacuum consolidation testing with and without vertical wick drain, were carried out on five different types of soil to determine soil properties and relationship between settlement and time. One dimensional consolidation teat was performed to determine if this test could be used for predicting the behavior of soils during vacuum consolidation. From the results of this study, the one dimensional consolidation test does not appear to be suitable for predicting the rate of vacuum consolidation without wick drain. However, one dimensional consolidation test reasonably predicts the total settlement of vacuum consolidation without wick drain. In vacuum consolidation, the amount of the settlement for silty soils were more or less the same for both cases, with wick drain and without wick drain, even if the time required for consolidation was considerably different. And, strategic placement of wick drain ensures moisture content and the value of the density are similar throughout the soil sample. However, the presence of wick drain for clay Boils increased the amount of settlement and also shortened the time required for consolidation.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.2
• /
• pp.247-254
• /
• 2003

While the interests in the environmental problem during the construction are increasing, the use of low noise-vibration auger-drilled pilling is increasing to solve noise and vibration problem in pilling. Therefore, in Korea, SIP (Soil-Cement Injected Precast Pile) method is mainly used as auger-drilled pilling. However, there is no proper design criteria compatible with the ground condition of Korea, so which is most wanted. To improve and supplement this situation, direct shear tests for the friction between SIP pile skin interface and soil were executed on various conditions. Through the analysis of test results, skin friction characteristics of SIP were investigated thoroughly Also, hyperbolic model parameter fomulas which describe the friction behavior and the new non-linear unit skin friction capacity model with SM, SC soil were suggested.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.2
• /
• pp.279-289
• /
• 2003

Geosynthetic reinforced earth wall was introduced about 20 years ago and many structures have been constructed. Especially, segmental concrete panel facing and friction tie system are the most popular system in Korea, and this friction tie was composed of high tenacity PET filament and LDPE(Low Density Polyethylene) sheath. Due to the lack of direct-test results, design coefficients of friction tie (creep reduction factor) had been determined by quoting the previous and the foreign reference data. This is an unreasonable fact for the use of friction ties. In this study, the creep tests were performed to evaluate the creep behavior of friction tie, and the reduction factor of creep was calculated for the correct design of geosynthetic reinforced earth retaining walls. From the test results, finally it was found that the allowable creep strength of friction tie is 60% of Tult during service life, and creep reduction factor is 1.67 for each grade of friction ties.