• Proceedings of the KSME Conference
• /
• 2002.08a
• /
• pp.427-430
• /
• 2002

The present parer outlines the system identification and vibration control performance of air traffic control tower of Yangyang international airport with tuned mass damper(TMD). From the free vibration test, natural frequency, damping ratio and mode shape of tower are obtained and these values are compared with the values from numerical analysis. In the vibration control test to evaluate the vibration control performance, equivalent damping ratio increased by tuned mass damper are obtained in case the TMD is operated as passive mode. Damping ratio of tower evaluated from free vibration test is about $1.0{\%}$. It is very low value than damping ratio recommended in general code. Damping ratio of passive mode is about $5{\%}$. These equivalent damping ratio increased by TMD is enough to enhance the serviceability of tower structure under wind load.

• Journal of Advanced Marine Engineering and Technology
• /
• v.7 no.2
• /
• pp.29-35
• /
• 1983

In general, for measuring residual stresses in plane stress state, two principal stresses {\sigma}_1 , {\sigma}_2$ and their directions .theta., should be determined. Naturally, for deciding three unknowns ${\sigma}_1, {\sigma}_2, ${\theta}$-three informations are necessary and therefore three strain gages are required for determining residual stresses at one point. In this paper, we tried to measure the residual stresses of one point with only two strain gages by drilling twice the hole of different diameters at the point and by detecting relaxation strains for each hole-drilling. We present also the formulas for determining the residual stresses from relaxation strains detected by strain gages in each hole-drilling. We carried out experiment, determining principal stresses and their directions of specimens applied specified uniform stress, and compared experimental results with the values calculated by formulas presented in this paper. The values calculated by formulas presented in this paper are always a little greater than the experimental results.

• Structural Engineering and Mechanics
• /
• v.9 no.1
• /
• pp.1-16
• /
• 2000

To study the dynamic response of a rigid block standing unrestrained on a rigid foundation which shakes horizontally, four modes of motion can be identified, i.e., rest, slide, rock, and slide and rock. The occurrence of each of these four modes and the transition between any two modes depend on the parametric values specified, the initial conditions, and the magnitude of ground acceleration. In this paper, a general two-dimensional theory is presented for dealing with the various modes of a free-standing rigid block, considering in particular the impact occurring during the rocking motion. Through selection of proper values for the system parameters, the occurrence of each of the four modes and the transition between different modes are demonstrated in the numerical examples.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.8
• /
• pp.2415-2418
• /
• 2014

In this report, the contact resistance between "electrode" and "lead" is investigated for reasonable measurements of samples' resistance in a polypyrrole (PPy) nanowire device. The sample's resistance, including "electrode-lead" contact resistance, shows a decrease as force applied to the interface increases. Moreover, the sample's resistance becomes reasonably similar to, or lower than, values calculated by resistivity of PPy reported in previous studies. The decrease of electrode-lead contact resistance by increasing the applying force was analyzed by using Holm theory: the general equation of relation between contact resistance ($R_H$) of two-metal thin films and contact force ($R_H{\propto}1/\sqrt{F}$). The present investigation can guide a reliable way to minimize electrode-lead contact resistance for reasonable characterization of nanomaterials in a microelectrode device; 80% of the maximum applying force to the junction without deformation of the apparatus shows reasonable values without experimental error.

• Journal of the Chungcheong Mathematical Society
• /
• v.26 no.3
• /
• pp.441-451
• /
• 2013

In this paper, we derive recurrence relations for moments of lower generalized order statistics within a class of doubly truncated distributions. Inverse Weibull, exponentiated Weibull, power function, exponentiated Pareto, exponentiated gamma, generalized exponential, exponentiated log-logistic, generalized inverse Weibull, extended type I generalized logistic, logistic and Gumble distributions are given as illustrative examples. Further, recurrence relations for moments of order statistics and lower record values are obtained as special cases of the lower generalized order statistics, also two theorems for characterizing the general form of distribution based on single moments of lower generalized order statistics are given.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.3 no.4
• /
• pp.95-100
• /
• 1999

Dynamic measurements are used rather sparingly to determine the elastic modull of rock cores and modulus values are not much utilized in design practice. The reason seems to result from the general perception that values obtained by dynamic measurement are much higher (about 10 times) than those determined statically. This paper presents results from dynamic and static tests on rock cores. The findings are: 1) elastic modull can be consistently determined by laboratory seismic testing. 2) nonlinear deformation characteristics of rock cores was tentatively proposed with variation in elastic modulus with strain.

• Journal of the Korean Society of Food Culture
• /
• v.10 no.5
• /
• pp.405-417
• /
• 1995

This research was designed to see the relationship among nutrient intake, food intake frequency and psychosocial stress in ordinary life. The subjects were 190 males and 263 females of university students in urban areas. There were significant correlations between nutrient intake and stress value, and between food intake frequency and stress value. In male, the more they consumed energy, protein and carbohydrate, the higher they had stress in several categories. But in female the results were reversed. Their stress values were lower when they have consumed protein source food frequently. And in general, stress values of female were higher than those of male. From these results, we conclude that nutrient intake tends to be decresed with increase stress in less stressful condition, but to be increased in more stressful condition.

• Journal of Mechanical Science and Technology
• /
• v.18 no.5
• /
• pp.857-864
• /
• 2004

The change in the NO emission indices (EINO) in a two-dimensional plane has been investigated, which is due to the interaction between a vortex and methane-air flames established at different equivalence ratios, by solving the field equation. After solving the field equation, the spatial distribution of G-values is obtained. The NO emission index is calculated after applying the appropriate relation between the G-values and the NO production rate or the mass fraction of methane obtained from the library of freely propagating flames created from detailed simulations. When a vortex exists in a reacting flow field, in general EINO slightly increases, whereas ElNO is lowered in the vicinity of the vortex regardless of flow direction. A change in vortex size has negligible impact on EINO$\_$T/ but increasing the vortex strength slightly increases EINO$\_$T/ in the domain of this study.

• Journal of Advanced Marine Engineering and Technology
• /
• v.40 no.2
• /
• pp.120-130
• /
• 2016

In general, a series of ship steering motions is composed of a combination of translational motions and rotational motions of the ship. In particular, a series of rotational motions frequently occurs in narrow areas such as ports and canal zones. In this paper, a method was suggested for composing an integrated control algorithm based on the jog dial as a command instrument for rotational motion control. In order to realize the rotational motions, several algorithms were suggested for generating rotational commands, for selecting motion variables, for choosing reference input values for the motion variables, for computing required accelerations and thrusts, and for allocating thrusts to actuators. A simulation program was compiled to execute simulations for three rotational motions. Finally, the effectiveness of the suggested method was verified by analyzing the simulation results.

• Journal of the Korean Society of Costume
• /
• v.52 no.3
• /
• pp.111-122
• /
• 2002

The study of traditional costume is significant in terms of figuring out of the reality of its originality and enrich the costume culture of today. The purpose of this study is to analyze the aesthetic characteristics and to contemplate the aesthetic values of the Kokuryo costume. Kokuryo costume were characterized with the simpleness in its clothing constructions. The spaces found on the dresses were emphasized giving a geometric characteristics and abstract images. Many different colors were used for tops, bottoms, and border elements showing value contrast in each parts of dress. Patterns were simplified in a dot or stripe shapes impling a certain symbols. Dot patterns were varied in its shapes. In general. the decorative elements were simple and eliminated. Through the process of investigating these aesthetic characteristics, aesthetic values were found. The aesthetics of nature were favoured and tradition were respected. Religious mind were favoured and progressive spirit were endowed by the Kokuryo people. They have pursued the diversities and many changes in visual forms of dresses which were the manifestations of their esprit.