• E2M - 전기 전자와 첨단 소재
• /
• 제10권1호
• /
• pp.26-32
• /
• 1997

The gate induced drain leakage(GIDL) current under the stress of worse case in -MOSFET's with ultrathin gate oxides has been measured and characterized. The GIDL current was shown that P-MOSFET's of the thicker gate oxide is smaller than that of the thinner gate oxide. It was the results that the this cur-rent is decreased with the increamental stress time at the same devices.It is analyzed that the formation components of GIDL current are both energy band to band tunneling at high gate-drain voltage and energy band to defect tunneling at low drain-gate voltage. The degradations of GIDL current was analyzed the mechanism of major role in the hot carriers trapping in gate oxide by on-state stress.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2012년도 제42회 동계 정기 학술대회 초록집
• /
• pp.344-345
• /
• 2012

The Gate-Induced-Drain-Leakage (GIDL) current with channel doping and width dependence are characterized. The GIDL currents are found to increase in MOSFETs with higher channel doping levels and the observed GIDL current is generated by the band-to-band-tunneling (BTBT) of electron through the reverse-biased channel-to-drain p-n junction. A BTBT model is used to fit the measured GIDL currents under different channel-doping levels. Good agreement is obtained between the modeled results and experimental data. The increase of the GIDL current at narrower widths in mainly caused by the stronger gate field at the edge of the shallow trench isolation (STI). As channel width decreases, a larger portion of the GIDL current is generated at the channel-isolation edge. Therefore, the stronger gate field at the channel-isolation edge causes the total unit-width GIDL current to increases for narrow-width devices.

• 대한전자공학회논문지SD
• /
• 제38권6호
• /
• pp.390-397
• /
• 2001

GIDL(Gate-Induced Drain-Leakage)을 줄일 수 있는 새로운 구조의 ESD(Elevated Source Drain) MOSFET을 제안하고 분석하였다. 제안된 구조는 SDE(Source Drain Extension) 영역이 들려진 형태를 갖고 있어서 SDE 임플란트시 매우 낮은 에너지 이온주입으로 인한 저활성화(low-activation) 효과를 방지 할 수 있다. 제안된 구조는 건식 식각 및 LAT(Large-Angle-Tilted) 이온주입 방법을 사용하여 소오스/드레인 구조를 결정한다. 기존의 LDD MOSFET과의 비교 시뮬레이션 결과, 제안된 ESD MOSFET은 전류 구동능력은 가장 크면서 GIDL 및 DIBL(Drain Induced Barrier Lowering) 값은 효과적으로 감소시킬 수 있음을 확인하였다. GIDL 전류가 감소되는 원인으로는 최대 전계의 위치가 드레인 쪽으로 이동함에 따라 최대 밴드간 터널링이 일어나는 곳에서의 최대 전계값이 감소되기 때문이다.

• 전자공학회논문지A
• /
• 제30A권12호
• /
• pp.77-87
• /
• 1993

PMOSFETs were studied on the effect of Hot-Carrier induced drain leakage current (Gate-Induced-Drain-Leakage). The result turned out that change in Vgl(drain voltage where 1pA/$\mu$m of drain leadage current flows) was largest in the Channel-Hot-Hole(CHH) injection condition and next was in dynamic stress and was smallest in electron trapping (Igmax) condition under various stress conditions. It was analyzed that if electron trapping occurrs in the overlap region of gate and drain(G/D), it reduces GIDL current due to increment of flat-band voltage(Vfb) and if CHH is injected, interface states(Nit) were generated and it increases GIDL current due to band-to-defect-tunneling(BTDT). Especially, under dynamic stress it was confirmed that increase in GIDL current will be high when electron injection was small and CHH injection was large. Therefore as applying to real circuit, low drain voltage GIDL(BTDT) was enhaced as large as CHH Region under various operating voltage, and it will affect the reliablity of the circuit.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1996년도 추계학술대회 논문집
• /
• pp.113-116
• /
• 1996

The drain current of the MOSFET in the off state(i.e., Id when Vgs=0V) is undesired but nevertheless important leakage current device parameter in many digital CMOS IC applications (including DRAMs, SRAMs, dynamic logic circuits, and portable systems). The standby power consumed by devices in the off state have added to the total power consumed by the IC, increasing heat dissipation problems in the chip. In this paper, hot-carrier-induced degra- dation and gate-induced-drain-leakage curr- ent under worse case in P-MOSFET\`s have been studied. First of all, the degradation of gate-induced- drain-leakage current due to electron/hole trapping and surface electric field in off state MOSFET\`s which has appeared as an additional constraint in scaling down p-MOSFET\`s. The GIDL current in p-MOSFET\`s was decreased by hot-electron stressing, because the trapped charge were decreased surface-electric-field. But the GIDL current in n-MOS77T\`s under worse case was increased.

• 전기학회논문지
• /
• 제57권2호
• /
• pp.235-238
• /
• 2008

This paper explores 28 nm MOSFET design for LSTP(Low Standby Power) applications using TCAD(Technology Computer Aided Design) simulation. Simulated results show that the leakage current of the MOSFET is increasingly dominated by GIDL(Gate Induced Drain Leakage) instead of a subthreshold leakage as the Source/Drain extension doping increases. The GIDL current can be reduced by grading lateral abruptness of the drain at the expense of a higher Source/Drain series resistance. For 28 nm MOSFET suggested in ITRS, we have shown Source/Drain design becomes even more critical to meet both leakage current and performance requirement.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 하계학술대회 논문집
• /
• pp.346-346
• /
• 2010

A capacitorless one transistor dynamic random access memory (1T-DRAM) on silicon-germanium-on-insulator substrate was investigated. SGOI technology can make high effective mobility because of lattice mismatch between the Si channel and the SiGe buffer layer. To evaluate memory characteristics of 1T-DRAM, the floating body effect is generated by impact ionization (II) and gate induced drain leakage (GIDL) current. Compared with use of impact ionization current, the use of GIDL current leads to low power consumption and larger sense margin.

• 한국전기전자재료학회논문지
• /
• 제25권2호
• /
• pp.96-99
• /
• 2012

We fabricated fully depleted (FD) SOI-based 1T-DRAM cells with planar channel or recessed channel and the electrical characteristics were investigated. In particular, the dependence of memory operating mode on the channel structure of 1T-DRAM cells was evaluated. As a result, the gate induced drain leakage current (GIDL) mode showed a better memory property for planar type 1T-DRAM. On the other hand, the impact ionization (II) mode is more effective for recessed type.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2006년도 하계종합학술대회
• /
• pp.579-580
• /
• 2006

Simple nonoverlapped source/drain-to-gate MOSFETs to suppress GIDL (gate-induced drain leakage) is simulated with SILVACO simulation tool. Changing spacer thickness for adjusting length of Drain to Gate nonoverlapped region, this simulation observes on/off characteristic of nonoverlapped source/drain-to-gate MOSFETs. Off current is dramatically decreased with S/D to gate nonoverlapped length increasing. The result shows that maximum on/off current ratio is achieved by adjusting nonoverlapped length.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2011년도 제41회 하계 정기 학술대회 초록집
• /
• pp.285-285
• /
• 2011

최근 반도체 소자의 미세화에 따라, 단채널 효과에 의한 누설전류 및 소비전력의 증가 등이 문제되고 있다. 대표적인 휘발성 메모리인 dynammic random access memory (DRAM)의 경우, 소자의 집적화가 진행됨에 따라 저장되는 정보의 양을 유지하기 위해 캐패시터영역의 복잡한 공정을 요구하게 된다. 하나의 캐패시터와 하나의 트랜지스터로 이루어진 기존의 DRAM과 달리, single transistor (1T) DRAM은 silicon-on-insulator (SOI) 기술을 기반으로 하여, 하나의 트랜지스터로 DRAM 동작을 구현한다. 이러한 구조적인 이점 이외에도, 우수한 전기적 절연 특성과 기생 정전용량 및 소비 전력의 감소 등의 장점을 가지고 있다. 또한 strained-Si 층을 적용한 strained-Silicon-On-Insulator (sSOI) 기술을 이용하여, 전기적 특성 및 메모리 특성의 향상을 기대 할 수 있다. 본 연구에서는 sSOI 기판위에 1T-DRAM을 구현하였으며, impact ionization과 gate induced-drain-leakage (GIDL) 전류에 의한 메모리 구동 방법을 통해 sSOI 1T-DRAM의 메모리 특성을 평가하였다. 그 결과 strain 효과에 의한 전기적 특성의 향상을 확인하였으며, GIDL 전류를 이용한 메모리 구동 방법을 사용했을 경우 낮은 소비 전력과 개선된 메모리 윈도우를 확인하였다.