• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.288-288
• /
• 2011

최근 Charge Trap Flash (CTF) Non-Volatile Memory (NVM) 소자가 30 nm node 이하로 보고 되면서, 고집적화 플래시 메모리 소자로 각광 받고 있다. 기존의 CTF NVM 소자의 tunnel layer로 쓰이는 SiO2는 성장의 용이성과 Si 기판과의 계면특성, 낮은 누설전류와 같은 장점을 지니고 있다. 하지만 단일층의 SiO2를 tunnel layer로 사용하는 기존의 Non-Valatile Memory (NVM)는 두께가 5 nm 이하에서 direct tunneling과 Stress Induced Leakage Current (SILC) 등의 효과로 인해 게이트 누설 전류가 증가하여 메모리 보존특성의 감소와 같은 신뢰성 저하에 문제점을 지니고 있다. 이를 극복하기 위한 방안으로, 최근 CTF NVM 소자의 Tunnel Barrier Engineered (TBE) 기술이 많이 접목되고 있는 상황이다. TBE 기술은 SiO2 단일층 대신에 서로 다른 유전율을 가지는 절연막을 적층시킴으로서 전계에 대한 민감도를 높여 메모리 소자의 쓰기/지우기 동작 특성과 보존특성을 동시에 개선하는 방법이다. 또한 터널링 절연막으로 유전률이 큰 High-K 물질을 이용하면 물리적인 두께를 증가시킴으로서 누설 전류를 줄이고, 단위 면적당 gate capacitance값을 늘릴 수 있어 메모리 소자의 동작 특성을 개선할 수 있다. 본 연구에서는 CTF NVM 소자의 trap layer로 쓰이는 HfO2의 두께를 5 nm, blocking layer의 역할을 하는 Al2O3의 두께를 12 nm로 하고, tunnel layer로 Si3N4막 위에 유전율과 Energy BandGap이 유사한 HfAlO와 ZrO2를 적층하여 Program/Erase Speed, Retention, Endurance를 측정을 통해 메모리 소자로서의 특성을 비교 분석하였다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.2 no.3
• /
• pp.431-437
• /
• 1998

In this paper, we have investigated the electrical properties of ultra-thin nitrided oxide(NO) and re-oxidized nitrided oxide(ONO) films that are considered to be promising candidates for replacing conventional silicon dioxide film in ULSI level integration. Especially, we have studied a variation of I-V characteristics, gate voltage shift, and time-dependent dielectric breakdown(TDDB) of thin layer NO and ONO film depending on nitridation and reoxidation time, respectively, and measured a variation of leakage current and charge-to-breakdown(Q$\_bd$) of optimized NO and ONO film depending on ambient temperature, and then compared with the properties of conventional SIO$\_2$. From the results, we find that these NO and ONO thin films are strongly influenced by process time and the optimized ONO film shows superior dielectric characteristics, and (Q$\_bd$) performance over the NO film and SIO$\_2$, while maintaining a similar electric field dependence compared with NO layer.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.31 no.6
• /
• pp.372-376
• /
• 2018

The effects of off-state bias stress on the characteristics of p-type poly-Si TFT were investigated. To reduce the gate-induced drain leakage (GIDL) current, the off-state bias stress was changed by varying Vgs and Vds. After application of the off-state bias stress, the Vgs causing GIDL current was dramatically increased from 1 to 10 V, and thus, the Vgs margin to turn off the TFT was improved. The on-current and subthreshold swing in the aged TFT was maintained. We performed a technology computer-aided design (TCAD) simulation to describe the aged characteristics. The aged-transfer characteristics were well described by the local charge trapping. The activation energy of the GIDL current was measured for the pristine and aged characteristics. The reduced GIDL current was mainly a thermionic field-emission current.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.9
• /
• pp.1717-1723
• /
• 2007

In this study , quasi-MFISFET (Metal-Ferroelectric-Insulator-Semiconductor FET) devices are fabricated using PLZT(10/30/70), PLT(10), PZT(30/70) thin film and their drain current properties are investigated. It is found that the drain current of quasi-MFISFET is directly influenced by the polarization strength of ferroelectric thin fan. Also, when the gate voltages are ${\pm}5\;and\;{\pm}10V$, the memory windows are 0.5 and 1.3V, respectively. It means that the memory window is changed with the variation of coercive voltage generated by the voltage applied on ferroelectric thin film. The electric field and the leakage current with time delay of PLZT(10/30/70) thin lam are measured to investigate the retention property of MFISFET device. Some material parameters such as current density constant, $J_{ETO}$, electric field dependent factor K and time dependent factor m are obtained. The variation of charge density with time is quantitatively analyzed by using the material parameters.

• Progress in Superconductivity
• /
• v.4 no.1
• /
• pp.1-9
• /
• 2002

Transferring single flux quanta across a Josephson junction at an exactly determined rate has made highly precise voltage measurements possible. Making use of self-shunted Nb-based SINIS junctions, programmable fast-switching DC voltage standards with output voltages of up to 10 V were produced. This development is now extended from fundamental DC measurements to the precise determination of AC voltages with arbitrary waveforms. Integrated RSFQ circuits will help to replace expensive semiconductor devices for frequency control and signal coding. Easy-to-handle AC and inexpensive quantum voltmeters of fundamental accuracy would be of interest to industry. In analogy to the development in the flux regime, metallic nanocircuits comprising small-area tunnel junctions and providing the coherent transport of single electrons might play an important role in quantum current metrology. By precise counting of single charges these circuits allow prototypes of quantum standards for electric current and capacitance to be realised. Replacing single electron devices by single Cooper pair circuits, the charge transfer rates and thus the quantum currents could be significantly increased. Recently, the principles of the gate-controlled transfer of individual Cooper pairs in superconducting A1 devices in different electromagnetic environments were demonstrated. The characteristics of these quantum coherent circuits can be improved by replacing the small aluminum tunnel Junctions by niobium junctions. Due to the higher value of the superconducting energy gap ($\Delta_{Nb}$ ＝ $7\Delta_{Al}$), the characteristic energy and the frequency scales for Nb devices are substantially extended as compared to A1 devices. Although the fabrication of small Nb junctions presents a real challenge, the Nb-based metrological devices will be faster and more accurate in operation. Moreover, the Nb-based Cooper pair electrometer could be coupled to an Nb single Cooper pair qubit which can be beneficial for both, the stability of the qubit and its readout with a large signal-to-noise ratio..

• KEPCO Journal on Electric Power and Energy
• /
• v.1 no.1
• /
• pp.169-174
• /
• 2015

In this research, pristine graphene was synthesized using methane ($CH_4$) gas, and N-doped graphene was synthesized using pyridine ($C_5H_5N$) liquid source by chemical vapor deposition (CVD) method. Basic optical properties of both pristine and N-doped graphene were investigated by Raman spectroscopy and XPS (X-ray photoemission spectroscopy), and electrical transport characteristics were estimated by current-voltage response of graphene channel as a function of gate voltages. Results for CVD grown pristine graphene from methane gas show that G-peak, 2D-peak and C1s-peak in Raman spectra and XPS. Charge neutral point (CNP; Dirac-point) appeared at about +4 V gate bias in electrical characterization. In the case of pyridine based CVD grown N-doped graphene, D-peak, G-peak, weak 2D-peak were observed in Raman spectra and C1s-peak and slight N1s-peak in XPS. CNP appeared at -96 V gate bias in electrical characterization. These result show successful control of the property of graphene artificially synthesized by CVD method.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.207-207
• /
• 2016

plasma group velocities of neon with oxygen admixture (ug) are obtained by intensified charge coupled device (ICCD) camera images at fixed gate width time of 5 ns. The propagation velocities outside interelectrode region are in the order of 104 m/s.The plasma ambipolar diffusion velocities are calculated to be in the order of 102 m/s. Plasma jet is generated by all fixed sinusoidal power supply, total gas flow and repetition frequency at 3 kV, 800 sccm and 40 kHz, respectively. The amount of oxygen admixture is varied from 0 to 2.75 %. By employing one dimensional convective wave packet model, the electron temperatures in non-thermal atmospheric-pressure plasma jet are estimated to be in a range from 1.65 to 1.95 eV.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.156.1-156.1
• /
• 2015

Neon and argon plasma group velocities (ug) are obtained by intensified charge coupled device (ICCD) camera images at fixed gate width time of 5 ns. The propagation velocities in upstream and downstream region are in the order of 104-105 m/s. The plasma ambipolar diffusion velocities are calculated to be in the order of 101-102 m/s. Plasma jet is generated by sinusoidal power supply in varying voltages from 1 to 4 kV at repetition frequency of 40 kHz. By employing one dimensional convective wave packet model, the neon and argon electron temperatures in non-thermal atmospheric-pressure plasma jet are estimated to be 1.95 and 1.18 eV, respectively.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.11a
• /
• pp.200-200
• /
• 2003

Polycrystalline Si(polysilicon) TFTs have opened a way for the next generation of display devices, due to their higher mobility of charge carriers relative to a-Si TFTs. The polysilicon W applications extend from the current Liquid Crystal Displays to the next generation Organic Light Emitting Diodes (OLED) displays. In particular, the OLED devices require a stricter control of properties of gate oxide layer, polysilicon layer, and their interface. The polysilicon layer is generally obtained by annealing thin film a-Si layer using techniques such as solid phase crystallization and excimer laser annealing. Typically laser-crystallized Si films have grain sizes of less than 1 micron, and their electrical/dielectric properties are strongly affected by the presence of grain boundaries. Impedance spectroscopy allows the frequency-dependent measurement of impedance and can be applied to inteface-controlled materials, resolving the respective contributions of grain boundaries, interfaces, and/or surface. Impedance spectroscopy was applied to laser-annealed Si thin films, using the electrodes which are designed specially for thin films. In order to understand the effect of grain size on physical properties, the amorphous Si was exposed to different laser energy densities, thereby varying the grain size of the resulting films. The microstructural characterization was carried out to accompany the electrical/dielectric properties obtained using the impedance spectroscopy, The correlation will be made between Si grain size and the corresponding electrical/dielectric properties. The ramifications will be discussed in conjunction with active-matrix thin film transistors for Active Matrix OLED.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.4
• /
• pp.284-288
• /
• 2013

Power MOSFETs(Metal Oxide Semiconductor Field Effect Transistor) operate as energy control semiconductor switches. In order to reduce energy loss of the device during switch-on state, it is essential to increase its conductance. We have experimental results and explanations on the doping profile dependence of the electrical behavior of the vertical MOSFET. The device is fabricated as $8.25{\mu}m$ cell pitch and $4.25{\mu}m$ gate width. The performances of device with various p base doping concentration are compared at Vth from 1.77 V to 4.13 V. Also the effect of the cell structure on the on-resistance and breakdown voltage of the device are analyzed. The simulation results suggest that the device optimized for various applications can be further optimized at power device.