• 한국소음진동공학회논문집
• /
• 제19권3호
• /
• pp.301-312
• /
• 2009

This paper presents a theoretical approach to calculate the resonant frequency of a thickness vibration mode in the radial direction for a 1-3 piezoelectric composite transducer of circular arch shape. For the composite transducer composed of a piezoelectric ceramic and a polymer, vibration parameters were derived according to the volume ratio of a ceramic, and a vibration characteristic equation was derived from the piezoelectric governing equations with adequate boundary conditions. The fundamental resonant frequencies were calculated numerically and verified by comparing them with those obtained from the finite element analysis and the experiment. The volume ratio and the thickness are more substantial than the curvature radius to determine the fundamental resonant characteristics, and the fundamental resonant frequency becomes higher for the larger volume ratio of the piezoelectric ceramic and for the smaller thickness.

• Journal of Power Electronics
• /
• 제15권2호
• /
• pp.518-529
• /
• 2015

Repetitive and proportional-resonant controllers can effectively reject grid harmonics in grid-connected inverters because of their high gains at the fundamental frequency and the corresponding harmonics. However, the performances of these controllers can seriously deteriorate if the grid frequency deviates from its nominal value. Non-ideal proportional-resonant controllers provide better immunity to variations in grid frequency by widening resonant peaks at the expense of reducing the gains of the peaks, which reduces the effectiveness of the controller. This paper proposes a repetitive control scheme for grid-connected inverters that can track changes in grid frequencies and keep resonant peaks lined up with grid frequency harmonics. The proposed controller is implemented using a digital signal processor. Simulation and practical results are presented to demonstrate the controller capabilities. Results show that the performance of the proposed controller is superior to that of a proportional-resonant controller.

• Journal of Magnetics
• /
• 제16권4호
• /
• pp.461-465
• /
• 2011

Traditional magnetostrictive/piezoelectric laminate composites are generally in the regular geometries such as rectangles or disks. To explore properties of the irregular geometry magnetostrictive/piezoelectric transducer in the fundamental resonant frequency, a step dumb-bell shaped Magnetoelectric (ME) transducer is presented in this study. Both analytical and experimental investigations are carried out for the dumb-bell shaped transducer in the fundamental frequency. Comparing with the traditional rectangular transducer, the theory shows the resonant frequency of dumb-bell shaped transducer is reduced 31%, and the experiment gives the result of that is 37% which is independent of dc magnetic fields. The ratio of magnetoelectric voltage coefficient (MEVC) between the dumb-bell shaped and rectangular shaped transducers in theory is 66% comparing with that of in experiment is varying from 140% to 33% when the dc field is increased from 0 Oe to 118 Oe.

• Journal of Power Electronics
• /
• 제7권1호
• /
• pp.13-20
• /
• 2007

LLC resonant converters display many advantages over the conventional LC series resonant converter such as narrow frequency variation over wide range of load and input variation and zero voltage switching even under no load conditions. This paper presents analysis and design consideration for the half bridge LLC resonant converter. Using the fundamental approximation, the gain equation is obtained, where the leakage inductance in the transformer secondary side is also considered. Based on the gain equation, the practical design procedure is investigated to optimize the resonant network for a given input/output specifications. The design procedure is verified through an experimental prototype of the 115W half-bridge LLC resonant converter.

• Journal of Power Electronics
• /
• 제16권3호
• /
• pp.1176-1189
• /
• 2016

In this paper, a novel quasi-direct power control (Q-DPC) scheme based on a resonant frequency adaptive proportional-resonant (PR) current controller with a variable frequency resonant phase locked loop (RPLL) is proposed, which can achieve a fast power response with a unity power factor. It can also adapt to variations of the generator frequency in T-type Three-level shaft synchronous generator (SSG) converters. The PR controller under the static α-β frame is designed to track ac signals and to avert the strong cross coupling under the rotating d-q frame. The fundamental frequency can be precisely acquired by a RPLL from the generator terminal voltage which is distorted by harmonics. Thus, the resonant frequency of the PR controller can be confirmed exactly with optimized performance. Based on an instantaneous power balance, the load power feed-forward is added to the power command to improve the anti-disturbance performance of the dc-link. Simulations based on MATLAB/Simulink and experimental results obtained from a 75kW prototype validate the correctness and effectiveness of the proposed control scheme.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 하계학술대회 논문집 C
• /
• pp.1283-1285
• /
• 1994

A three-layered piezoelectric ceramic transducer is fabricated with three piezoelectric ceramic disk transducers and two sheets of thin insulator. Its equvalent circuit is derived from the Mason's model of a thickness-driven piezoelectric transducer. We applied the electric input near its fundamental resonant frequency to the center transducer and connect the output voltages across the left and right transducers in series to the resistor load. Then we investigate the load characteristics at resonant frequencies under various resistor loads and the frequency characteristics near the resonant frequency under no load. Moreover, symbolic expressions for input impedances, voltage ratios, resonant frequencies, and bandwidths have been derived. The values calculated from those symbolic expressions are shown to agree well with the measurement values.

• Journal of Electrical Engineering and Technology
• /
• 제6권6호
• /
• pp.842-848
• /
• 2011

The current study proposes the design of a hybrid series-parallel resonant converter (SPRC) and a three-stage Cockcroft-Walton voltage multiplier for precisely adjusting the power generated by a continuous wave (CW) $CO_2$ laser. The design of a hybrid SPRC, called LCC resonant converter, is described, and the fundamental approximation of a high-voltage and high-frequency (HVHF) transformer with a resonant tank is discussed. The results of the current study show that the voltage drop and ripple of a three-stage Cockcroft-Walton voltage multiplier depend on frequency. The power generated by a CW $CO_2$ laser can be precisely adjusted by a variable-frequency controller using a DSP (TMS320F2812) microprocessor. The proposed LCC converter could be used to obtain a maximum laser output power of 23 W. Moreover, it could precisely adjust the laser output power within 4.3 to 23 W at an operating frequency range of 187.5 to 370 kHz. The maximum efficiency of the $CO_2$ laser system is approximately 16.5%, and the minimum ripple of output voltage is about 1.62%.

• International Journal of Fluid Machinery and Systems
• /
• 제7권4호
• /
• pp.160-173
• /
• 2014

Surge phenomena in multi-stage axial flow compressors were studied with attention to the frequency behaviors. A new parameter "volume-modified reduced surge frequency" was introduced, which took into consideration the essential surge process, i.e., emptying and filling of the working gas in the delivery plenum. The behaviors of the relative surge frequencies at the stall stagnation boundaries, compared with the corresponding duct resonance frequencies, have demonstrated the existence of two types of surges; i.e., a near-resonant surge and a subharmonic surge. The former, which has fundamentally a near-resonance frequency, occurs predominantly at the stall stagnation boundary for the short -and-fat plenum delivery flow-path and the long-and-narrow delivery duct flow-path, and possibly in the intermediate conditions. The latter, which has a subharmonic frequency of the fundamental near-resonant one and occurs mainly in the intermediate zone, is considered to be caused by the reduced frequency restricted to a limited range. In relation with those dimensionless frequencies at the stall stagnation boundary, the surge frequency behaviors in more general situations away from the boundaries could be estimated, though very roughly.

• Current Optics and Photonics
• /
• 제1권4호
• /
• pp.278-283
• /
• 2017

We theoretically study the dynamics of water tetramer in intense femtosecond laser pulses with different frequencies. The simulations are carried out by incorporating the molecular dynamics method non-adiabatically into the time-dependent local-density approximation (TDLDA-MD). Three typical scenarios of water tetramer including the normal vibration with enlarged OH bonds, free OH bonds breaking and the pure Coulomb explosion are presented by investigating the electronic and ionic dynamics. The result indicates that the ionization is enhanced and the corresponding fragmentation effect as well as the damping of the dipole moment are found more notably when increasing the laser frequency especially when the frequency falls in the resonant region of the absorption spectra. The study of the level depletion reveals that the ratio of the emission amount from different levels can be controlled by changing the laser frequency referring to the Keldysh parameter.

• 전기전자학회논문지
• /
• 제25권1호
• /
• pp.218-228
• /
• 2021

본 논문에서는 다중공진회로를 이용한 고효율 DC-DC 컨버터를 제안한다. 제안한 컨버터는 하프브리지 전력구조이며 컨버터의 고효율화를 위해 2개의 인덕터(LL)와 1개의 커패시터(C)로 구성된 다중공진회로를 이용한다. 이 다중공진회로는 동작모드에 따라, 각각의 공진주파수를 가진 직렬회로 형태의 공진회로를 각각 형성한다. 본 논문에서는 먼저, 동작모드와 정상상태 기본파 근사 모델링에 의해 제안한 컨버터의 동작원리를 설명한다. 그다음 이에 근거하여 제안한 컨버터의 설계예시를 보인다. 그리고 설계된 회로 파라미터에 의해 제작된 프로토타입 컨버터의 실험결과를 통하여 제안한 컨버터의 고효율 DC-DC 전력변환 동작특성을 입증한다.