• Geomechanics and Engineering
• /
• v.15 no.4
• /
• pp.997-1004
• /
• 2018

The brine leakage is a tough problem in artificial freezing engineering. This paper takes the common soft clay in Wujiang District as the study object, and calcium chloride solutions with six salinity levels were considered. The 'classic' cooling curve method was employed to measure the freezing point of specimens after freeze-thaw. Results indicate that four characteristic stages can be observed including supercooling, abrupt transition, equilibrium and continual freezing, strongly dependent on the variation of unfrozen water content. Two characteristic points were found from the cooling curves, i.e., freezing point and initial crystallization temperature. A critical value for the former exists at which the increment lowers. The higher the saline content approximately linearly, lower the freezing point. In the initial five cycles, the freezing point increases and then stabilizes. Besides, the degree of supercooling was calculated and its correlations with water, salt and freeze-thaw cycles were noted. Finally, an empirical equation was proposed for the relationship of freezing point and three main factors, i.e., water content, saline content and freeze-thaw cycles. Comparison of calculated and measured data proves that it is reliable and may provide guidance for the design and numerical analysis in frozen soil engineering.

• Proceedings of the Korean Society of Embryo Transfer Conference
• /
• 2002.11a
• /
• pp.103-103
• /
• 2002

This study was conducted to investigate cryopreservation of pearl oyster, Pinctada fucata martensii larvae. Four cooling rates (-0.25, -0.5, -0.75 and -1.0$^{\circ}C$/min.) were used to examine a proper cooling rate during cryopreservation of trochophores before seeding temperature (-12$^{\circ}C$). Seven developmental stages (early and late trochophores, early and late D-shaped larvae and early, middle and late umbo stage larvae) and different sugars (fructose, glucose and sucrose) were used to investigate optimal larval stage and effective sugar in cryopreservation of larvae. The survival rates of frozen-thawed trochophores increased at cooling rate of -1.0$^{\circ}C$/min. As larval developing, survival rate of frozen-thawed larvae increased, except umbo stage larvae, and especially late D-shaped larvae highly survived as 91%. Addition of sugar revealed positive effect on cryopreservation in this experiment and 0.2 M glucose and sucrose mixed with 2.0 M dimethyl sulfoxide significantly enhanced survival rate of larvae (P<0.05). The results of our study indicate that desirable cooling rate, developmental stages of larvae and effective sugar far cryopreservation of pearl oyster, P. fucata martensii larvae are -1$^{\circ}C$/min, late D-shaped larvae and 0.2 M glucose and sucrose, respectively.

• Proceedings of the Korean Society of Embryo Transfer Conference
• /
• 2002.11a
• /
• pp.104-104
• /
• 2002

This study was performed to find out the optimal larval stage among trochophore, D-shaped and umbo stage larvae and the desirable protective additive such as fructose, glucose, sucrose and trehalose with cryoprotectant for cryopreservation of surf clam, Spisula sachalinensis larvae. Dimethyl sulfoxide and ethylene glycol were used as cryoprotectant and each cryoprotectant was made to 2.0 M with previous protective additives. The larvae were immersed in the preparations waited for 15 minutes to reach equilibration, and then frozen in a program freezer (-35$^{\circ}C$) and liquid nitrogen (-196$^{\circ}C$). The freezing rate of 1.0$^{\circ}C$ /min. was used for cryopreservation of trochophores before seeding temperature (-12$^{\circ}C$). The survival rate of frozen-thawed larvae increased as larval developing and that of umbo stage larvae was the highest as 96.1 ${\pm}$ 1.0%. The presence of lower concentration of disaccharides as sucrose or trehalose significantly enhanced survival rate when mixed with cryoprotectants (P<0.05). The results of our study indicate that desirable developmental stages of larvae and protective additive for cryopreservation are the umbo stage larvae and 0.2 M sucrose, respectively.

• Food Science of Animal Resources
• /
• v.18 no.3
• /
• pp.240-247
• /
• 1998

This experiment was carried out investigate changes in proximate composition, pH, volatile basic nitrogen (VBN), thiobarbituric acid value (TBA) and mineral contents of pure Kaesojoo (PK) and Kaesojoo added medicinal herbs (KMH) during storage period (30 days) at 4$^{\circ}C$ and -18$^{\circ}C$. Two dogs with 12kg live weight were slaughtered to obtain samples from extracts. The results obtained were as follows: Crude fat and ash of KMH were higher than those of the PK, but the moisture and crude protein was higher in the PK (p＜0.001). Proximate composition did not affect cold and frozen storage and storage period. the pH of the PK through all periods. The VBN value of all treatment gradually increased during storage period. That of KMH tend to be lower than PK, all treatment was maintained freshness. The TBA value of all treatment gradually increased during storage period (p＜0.05). Cold storage and PK tend to be higher frozen storage and KMH. Among minerals Ca, K, Mg, Na, P contents of the KMH were higher than those of the PK and the Ca, Mg, Zn contents were significantly changes (p＜0.05) according to the storage period and temperature.

• Journal of Embryo Transfer
• /
• v.10 no.3
• /
• pp.203-208
• /
• 1995

This study was carried out to efficiently use the ultrarapid freezing method in the cryopreservation of mouse ova. For this, the effects of dehydration method, oval vigour and $0^{\circ}C$ controlling method on post-thawing viability were investigated. Fresh mouse ova were dehydrated in mPBS with 3.5M DMSO and /or 0.25M sucrose, and directly immersed in L$N_2$ for ultrarapidly freezing. The frozen ova were thawed at 37$^{\circ}C$, rehydrated in mPBS with 0.25M sucrose, and then repeatedly washed in HAM's Fl0 before evaluating the morphological normality of frozen-thawed ova. The results obtained showed that there was difference between treatments in a experiment. 1) The post-thawing viability of ova dehydrated in multi-step (48.4$\pm$13.8%) was higher than that of ova in two-step (40.9$\pm$14.0%). 2) The post-thawing viability of fertilized ova (87$\pm$14.0%) was significantly(p<0.0l) higher than that of unfertilized ova (5.4$\pm$5.4%). 3) The post-thawing viability of ova dehydrated and rehydrated using a cooling machine (95.8$\pm$4.2%) was significantly(p<0.05) higher than that on ice(84.1$\pm$9.9). In conclusion, in order to efficiently cryopreserve ova in vitro with ultrarapidly freezing method, highly viable embryos should be selected, heavy osmotic shock to the dehydrating ova should be avoided, and embryos in high osmotic condition were dehydrated and rehydrated in a constantly low temperature.

• Journal of Embryo Transfer
• /
• v.11 no.1
• /
• pp.27-33
• /
• 1996

The efficient cryopreservation of embryos requires optimal times of dehydration and rehydration This study was carried out to investigate the effect of various times of dehydration and rehydration The effects were evaluated through testing morphological normality and developmental ability of 1 cell mouse embryos which were ultrarapidly frozen and thawed. The 1 cell embryos were dehydrated for 1.5, 3, 5, and 10 minutes using mPBS-BSA containing 3.SM DMSO and 0.25M sucrose on cooling chamber or on ice. After ultrarapidly frozen and thawed, they were rehydrated for 0, 0.5 and 5 minutes with mPBS-BSA containing 0.25M sucrose at room temperature. The results obtained were as follows: The embryos that were rehydrated for 0.5 minutes showed higher normality than the embryos for 0 and 5 minutes did. The embryos that were dehydrated for 10 minutes showed higher normality than the embryos for 1.5, 3, and 5 minutes did. The developmental ability of normal thawed-embryos was high in 10 minute dehydration treatment compared to other treatments. However, it was not affected by cooling methods (on ice and on cooling chamber) for embryo dehydration.

• Geomechanics and Engineering
• /
• v.34 no.5
• /
• pp.507-527
• /
• 2023

Accurately estimation of the geo-mechanical parameters in Artificial Ground Freezing (AGF) is a most important scientific topic in soil improvement and geotechnical engineering. In order for this, one way is using classical and conventional constitutive models based on different theories like critical state theory, Hooke's law, and so on, which are time-consuming, costly, and troublous. The others are the application of artificial intelligence (AI) techniques to predict considered parameters and behaviors accurately. This study presents a comprehensive data-mining-based model for predicting the Young's Modulus of frozen sand under the triaxial test. For this aim, several single and hybrid models were considered including additive regression, bagging, M5-Rules, M5P, random forests (RF), support vector regression (SVR), locally weighted linear (LWL), gaussian process regression (GPR), and multi-layered perceptron neural network (MLP). In the present study, cell pressure, strain rate, temperature, time, and strain were considered as the input variables, where the Young's Modulus was recognized as target. The results showed that all selected single and hybrid predicting models have acceptable agreement with measured experimental results. Especially, hybrid Additive Regression-Gaussian Process Regression and Bagging-Gaussian Process Regression have the best accuracy based on Model performance assessment criteria.

• Journal of the Korean GEO-environmental Society
• /
• v.10 no.2
• /
• pp.5-12
• /
• 2009

Soil samples from the King Sejong Station in Antarctic and Vladivostok were tested in the laboratory and specific gravity, compaction curve, grain size distribution were determined. The effect of temperature change on the thermal conductivity, unfrozen water content, compressive strength were investigated. In addition, the change of tensile strength with temperature of the soil from Vladivostok was measured. Samples for the compressive strength test and tensional strength test were prepared in a mould with a fixed volume to prevent swelling. Also the effects of temperature and water content change on those strength were compared. Results from the thermal conductivity test showed that thermal conductivity values for both soils was larger at temperatures below freezing than those above freezing. The unfrozen water content dropped rapidly within a temperature range of $0{\sim}-5^{\circ}C$ and then gradually decreased further $-20^{\circ}C$. Compressive strength test results showed various stress/deformation curves with a change in water content. Sandy soil of the King Sejong Station had a much larger strength than ice at an identical temperature, while clayey soil of Vladivostok had a smaller strength than ice in the initial stage, but showed a larger strength at temperatures belows $-15^{\circ}C$. Tensile strength tests revealed an increase in the strength with a decreasing temperature.

• Journal of Advanced Marine Engineering and Technology
• /
• v.32 no.5
• /
• pp.724-729
• /
• 2008

Umbilical cord blood has been recently considered an attractive potential alternative as a source of stem cell transplantation to curing diseases such as leukemia, cancers, immune disorders. Normally the stored system of the umbilical cord blood specimen is equipped with a computer-controlled robotic arm that enables the samples to locate the identification places in liquid nitrogen tank at regulated temperature as about $-196^{\circ}C$. As the half of robotic arm is in the air and the rest part is submerged in liquid nitrogen, the temperature of robotic arm varies from ambient to liquid nitrogen temperature. In this study the temperature variation of upper part of arm above tank lid was thermally analysed by using the commercial code of Ansys. The result of analysis was that the upper part of robotic arm was seriously frozen due to heat transfer from liquid nitrogen as low as -$120^{\circ}C$. In order to solve the frost problem of robotic arm, small PTFE tube block as resistance material was introduced into the lower part of tank lid instead of the whole stainless steel(SUS) robotic arm. The results showed that the temperature of robotic arm above the lid was higher enough, and this method would be one of the very effective measure to solve the problem.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2016.10a
• /
• pp.13-14
• /
• 2016

In the modern construction industry, since numerous skyscrapers have been built, there have been sought for developing various kinds of methods for shortening a construction period. Therefore, many kinds of studies on some kinds of cold-weather concrete have been conducted actively for the purpose of a year-round construction. Accordingly, this research team once developed a double-layered bubble sheet as a surface-coated curing material for winter. And there have been raised some worries that some initial damages to frozen concrete caused by low temperature of reinforcing bars which are exposed out of the wall areas of a wall-type apartment during winter. Therefore, in this study, it is intended to find out clearly whether it is possible for concrete to be damaged initially or not by analyzing the temperature characteristics of the exposed reinforcing bars of the wall areas under the temperature conditions during winter.