• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.1 no.2
• /
• pp.70-73
• /
• 1987

This paper itltroduces a simple stair-case PWM using the pseudo-sinusoidal method. In a configuration of controller, the value of sine as a fundamental factor divided into stair-case level and the three-phase PWM inverter is composed by digital compound for each value of stair-case level. The three-phase output pulse at a fixed carrier frequency and a variable reference frequency is obtained under the effect of reduced harmonics. In this experiment, using the power FET as the switching device, 0.5 H.P. induction motor operation is performed when the switching frequency is 20KHz.

• Proceedings of the KIEE Conference
• /
• 2002.07a
• /
• pp.313-315
• /
• 2002

Frequency and phasor are the most important quantities in power system operation because they can reflect the whole power system situation. This paper proposes a design and implementation using phase angle difference calculation for frequency measuring in power system. The process is considered to be complicated as compared to the present proposed method. Performance test results, using signals from Excel program, indicate that the proposed technique can provide accurate estimates within 16ms.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.62 no.12
• /
• pp.1700-1705
• /
• 2013

A second harmonic millimeter wave oscillator utilizing sub-harmonic injection-synchronization is presented. A 8.7GHz oscillator with MES-FET is designed, and is driven as a harmonic output oscillator at 17.4GHz by means of sub-harmonic injection-synchronization. The oscillator operates as a multiplier as well as a oscillator in this scheme. Adopting this method, a high sable, high frequency millimeter wave source is obtainable even though self-oscillating frequency of an oscillator is relatively low. The range of injection-synchronization is about 26MHz, and is proportional to the input sub-harmonic power. The spectrum analysis of the 2nd harmonic output frequency shows remarkably decreased the phase noise level.

• Proceedings of the KIPE Conference
• /
• 1998.07a
• /
• pp.423-427
• /
• 1998

A new single-switch, three-phase, high power factor, multi-resonant, ZCS buck rectifier that operates in the continuous conduction mode has been reported. Basically, pulse frequency modulation method should be adopted to suitably control the system. This paper puts main focus on the methods how the pulse frequency modulation can be implemented and a comprehensive investigation on the corresponding control loops is coducted.

• ETRI Journal
• /
• v.36 no.4
• /
• pp.537-544
• /
• 2014

In this paper, we present a new inter-carrier interference (ICI) self-cancellation scheme - namely, ISC scheme - for orthogonal frequency-division multiplexing systems to reduce the ICI generated from phase noise (PHN) and residual frequency offset (RFO). The proposed scheme comprises a new ICI cancellation mapping (ICM) scheme at the transmitter and an appropriate method of combining the received signals at the receiver. In the proposed scheme, the transmitted signal is transformed into a real signal through the new ICM using the real property of the transmitted signal; the fast-varying PHN and RFO are estimated and compensated. Therefore, the ICI caused by fast-varying PHN and RFO is significantly suppressed. We also derive the carrier-to-interference power ratio (CIR) of the proposed scheme by using the symmetric conjugate property of the ICI weighting function and then compare it with those of conventional schemes. Through simulation results, we show that the proposed ISC scheme has a higher CIR and better bit error rate performance than the conventional schemes.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.8
• /
• pp.97-103
• /
• 2014

Signal processing technique of linear frequency modulation-frequency shift keying (LFM-FSK) waveform has been introduced for rear view radars of an automobile. LFM-FSK waveform consists of two sequential stepped frequency waveforms with some frequency offset, and thus, can be used to generate inverse synthetic aperture radar (ISAR) images of rear view target of an automobile. However, ISAR images can often be blurred due to inter-pulse phase errors. To resolve this problem, one-dimensional (1-D) entropies of high resolution range profiles (HRRP) are minimized with the help of particle swarm optimization (PSO). The searching space used in PSO is adaptively adjusted by the use of information on the target's velocity obtained from LFM-FSK waveforms. Simulation results show that the proposed method can generate well-focused ISAR images.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.4
• /
• pp.1626-1634
• /
• 2015

LCL filters are widely used in three-phase PWM converter for its advantages of small volume, low cost and inhibition of high frequency current harmonic. However, it is difficult to optimize its design because its parameters are mutually influenced while the value of each parameter for LCL filter has impacts on the converter's cost and size. In this paper, the target of optimization is to minimize the parameter values of LCL filter, and an optimization method for parameters of LCL filter of three-phase PWM converter based on least square method is proposed. With this method, a quantitative calculation of the harmonic component of the converter’s side phase voltage is performed first, and then the quantitative relationship between phase voltage harmonics and grid phase current harmonics is analyzed. After that, the attenuation requirement of each harmonic is obtained by taking into account the requirements for each harmonic component of grid current. Then according to the optimization objective, the objective function with minimum harmonic attenuation deviation is established, and least squares method is adopted for three-dimensional global searching of parameters for LCL filter. Thus, the designed harmonic attenuation curve approximates the minimum attenuation requirements, and the optimized LCL filter parameters are obtained. Finally, the effectiveness of the method is verified by the experiments.

• Korean Journal of Optics and Photonics
• /
• v.22 no.5
• /
• pp.207-213
• /
• 2011

We propose a new method to measure the phase errors of an AWG(arrayed waveguide grating) through Monte-Carlo analysis. In the frequency domain method, we used the Monte-Carlo method to fit the theory to the experimental results. The phase and amplitude values are obtained from the fitted theory. To verify our method, we carried out a simulation. Some phase errors were included to make a virtual interferogram and we measured the actual AWG phase errors from it by our method. The results show that our method gives good results if the laser tuning range is larger than 1.7 times of the AWG FSR(free spectral range) and if the phase errors are within ${\pm}50^{\circ}$.

• Journal of Power Electronics
• /
• v.17 no.1
• /
• pp.262-271
• /
• 2017

This paper studies the performances of five typical Phase-locked Loops (PLLs) for distorted and unbalanced grid, which are the Decoupled Double Synchronous Reference Frame PLL (DDSRF-PLL), Double Second-Order Generalized Integrator PLL (DSOGI-PLL), Double Second-Order Generalized Integrator Frequency-Lock Loop (DSOGI-FLL), Double Inverse Park Transformation PLL (DIPT-PLL) and Complex Coefficient Filter based PLL (CCF-PLL). Firstly, the principles of each method are meticulously analyzed and their unified small-signal models are proposed to reveal their interior relations and design control parameters. Then the performances are compared by simulations and experiments to investigate their dynamic and steady-state performances under the conditions of a grid voltage with a negative sequence component, a voltage drop and a frequency step. Finally, the merits and drawbacks of each PLL are given. The compared results provide a guide for the application of current control, low voltage ride through (LVRT), and unintentional islanding detection.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.33 no.1
• /
• pp.46-53
• /
• 2013

Impedance spectroscopy is a non-destructive evaluation (NDE) method first proposed and developed for evaluating TGO layers with compressive stress inside thermally degraded plasma-sprayed thermal barrier coatings (PS TBCs). A bode plot (phase angle (h) vs. frequency (f)) was used to investigate the TGO layer on electrical responses. In our experimental study, the phase angle of Bode plots is sensitive for detecting TGO layers while applying compressive stress on thermal barrier coatings. It is difficult to detect TGO layers in samples isothermally aged for 100 hrs and 200 hrs without compressive stress, and substantial change of phase was observed these samples with compressive stress. Also, the frequency shift of the phase angle and change of the phase angle are observed in samples isothermally aged for more than 400 hrs.