• Journal of Astronomy and Space Sciences
• /
• 제23권3호
• /
• pp.199-208
• /
• 2006

The terrestrial impact cratering record recently has been examined in the time domain by Chang & Moon (2005). It was found that the ${\sim}26$ Myr periodicity in the impact cratering rate exists over the last ${\sim}250$ Myrs. Such a periodicity can be found regardless of the lower limit of the diameter up to D ${\sim}35km$. It immediately called pros and cons. The aim of this paper is two-fold: (1) to test if reported periodicities can be obtained with an independent method, (2) to see, as attempted earlier, if the phase is modulated. To achieve these goals we employ the time/frequency analysis and for the first time apply this method to the terrestrial impact cratering records. We have confirmed that without exceptions noticeable peaks appear around ${\sim}25$ Myr, corresponding to a frequency of ${\sim}0.04(Myr)^{-1}$. We also find periodicities in the data base including small impact craters, which are longer. Though the time/frequency analysis allows us to observe directly phase variations, we cannot find any indications of such changes. Instead, modes display slow variations of power in time. The time/frequency analysis shows a nonstationary behavior of the modes. The power can grow from just above the noise level and then decrease back to its initial level in a time of order of 10 Myrs.

• Journal of Power Electronics
• /
• 제16권5호
• /
• pp.1939-1949
• /
• 2016

This paper presents an alternative frequency adaptive grid synchronization technique named HDN-FLL, which can accurately extract the fundamental positive- and negative-sequence components and interested harmonics in adverse three-phase grid voltage. The HDN-FLL is based on the harmonic decoupling network (HDN) consisting of multiple first order complex vector filters (FOCVF) with a frequency-locked loop (FLL), which makes the system frequency adaptive. The stability of the proposed FLL is strictly verified to be global asymptotically stable. In addition, the linearization and parameters tuning of the FLL is also discussed. The structure of the HDN has been widely used as a prefilter in grid synchronization techniques. However, the stability of the general HDN is seldom discussed. In this paper, the transfer function expression of the general HDN is deduced and its stability is verified by the root locus method. To show the advantages of the HDN-FLL, a simulation comparison with other gird synchronization methods is carried out. Experimental results verify the excellent performance of the proposed synchronization method.

• Journal of electromagnetic engineering and science
• /
• 제15권1호
• /
• pp.53-58
• /
• 2015

For the testing of nonlinear power amplifiers, this paper suggests an approach to design optimized multisine signals that could be substituted for the original modulated signal. In the design of multisines, complex coefficients should be determined to mimic the target signal as much as possible, but very few methods have been adopted as general solutions to the coefficients. Furthermore, no solid method for the phase of coefficients has been proven to show the best resemblance to the original. Therefore, in order to determine the phase of multisine coefficients, a time-domain nonlinear optimization method is suggested. A frequency-domain-method based on the spectral response of the target signal is also suggested for the magnitude of the coefficients. For the verification, multisine signals are designed to emulate the LTE downlink signal of 10 MHz bandwidth and are used to test a nonlinear amplifier at 1.9 GHz. The suggested phase-optimized multisine had a lower normalized error by 0.163 dB when N = 100, and the measurement results showed that the suggested multisine achieved more accurate adjacent-channel leakage ratio (ACLR) estimation by as much as 12 dB compared to that of the conventional iterative method.

• Journal of Power Electronics
• /
• 제13권5호
• /
• pp.884-895
• /
• 2013

In this paper, the Fourier-based PLL (Phase-locked Loop) is introduced with a new structure, capable of selective harmonic detection in single and three-phase systems. The application of the FB-PLL to harmonic detection is discussed and a new model applicable to three-phase systems is introduced. An analysis of the convergence of the FB-PLL based on a linear model is presented. Simulation and experimental results are included for performance analysis and to support the theoretical development. The decomposition of an input signal in its harmonic components using the Fourier theory is based on previous knowledge of the signal fundamental frequency, which cannot be easily implemented with input signals with varying frequencies or subjected to phase-angle jumps. In this scenario, the main contribution of this paper is the association of a phase-locked loop system, with a harmonic decomposition and reconstruction method, based on the well-established Fourier theory, to allow for the tracking of the fundamental component and desired harmonics from distorted input signals with a varying frequency, amplitude and phase-angle. The application of the proposed technique in three-phase systems is supported by results obtained under unbalanced and voltage sag conditions.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2003년도 학술대회논문집
• /
• pp.373-376
• /
• 2003

A new method measuring soil resistivity in frequency range of 5-500[KHz] using variable frequency inverter was presented, and soil resistivity was analysed by resistive and reactive components on the basis of magnitude and phase of measured ground impedance. The test lead arrangement was proposed to reduce the inductive coupling in test circuit for measuring the soil resistivity. The frequency dependence of soil resistivity was mainly caused by the inductive current flowing through grounding conductors over the frequency of 70[KHz].

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2006년도 International Symposium on GPS/GNSS Vol.2
• /
• pp.185-190
• /
• 2006

The correct estimation of the ionospheric delays is very important for the precise kinematic positioning especially in case of the long baseline. In case of triple frequency system, the ionospheric delays can be estimated from the measurements, but, in case of dual frequency system, the situation is not so simple. The precision of those supplied by the external information source such as IONEX is not sufficient. The high frequency component is neglected, and the precision of the low frequency component is not sufficient for the long baseline positioning. On the other hand, the high frequency component can be estimated from the phase range measurements. If the low frequency components are estimated by using the external information source or pseudo range measurements, a more reasonable estimation of the ionospheric delays may be possible. It has already been discussed by the author that the estimation of the low frequency components by using the external information source is not sufficient but fairly effective. The estimation using the pseudo range measurements is discussed in the present paper. The accuracy is not sufficient at present because of the errors in the pseudo range measurements. It is clarified that the bias errors in the pseudo range measurements are responsible for the poor accuracy of the ionospheric delays. However, if the accuracy of the pseudo range measurements is improved in future, the method would become very promising.

• 대한전자공학회논문지
• /
• 제27권6호
• /
• pp.879-885
• /
• 1990

The geometrical algorithm for generating a 3-phase SPWM signal for VVVF (Variable Voltage, Variable Frequency) inverter drives is proposed. In this techniques, it is suitable for micro-processor based implementation since the pulsewiths are computable in real time from simple analytic expressions. System hardware consists of the inverter circuit and the 3-phase SPWM signal generating circuit. The inverter circuit is a 3-phase SPWM signal generating circuit is single board micro-processor consisting of Z-80A CPU, EPROMXI, CTC, PIO. The method of controlling VVVF at the inverter output is discussed here.

• 전자공학회논문지
• /
• 제50권6호
• /
• pp.246-253
• /
• 2013

위상 펼침 (phase unwrapping)과 최소자승(least-squares) 기법들을 이용한 기존 디지털 주파수 변별기 (Digital Frequency Discriminator: DFD) 설계를 바탕으로, 본 논문에서는 주파수 판별 대역이 4배 확장한 새로운 DFD 설계를 제안한다. 구체적으로, 주파수 판별 대역을 기존 2-6GHz에서 2-18GHz로 4배 확장함에 따라 주파수 판별 정확도를 높이기 위해 DFD 내의 지연선 수가 증가되고, 이에 따른 주파수 추정 연산량이 증가되는데, 본 논문에서는 이러한 2-18GHz 대역 주파수 판별을 위해 보다 효율적인 주파수 추정 알고리즘을 제안한다. 특히, 제안하는 주파수 추정 방법에서는 기존 방법인 위상 펼침 기법을 기반으로 펼친 위상의 후보군을 만들되, 각 지연선에서 발생할 수 있는 위상 잡음을 미리 추정하여, 적절한 펼친 위상 후보군을 선택하는 새로운 주파수 후보군 선택 방법을 제안한다. 이렇게 선택된 위상 후보군만을 최소자승 기법에 적용하여 주파수를 추정함으로써, 결과적으로 기존 DFD의 주파수 추정에 비해 연산량을 줄일 수 있다. 끝으로, 제안한 DFD에 대한 주파수 변별 방법을 비교 분석하고, 시뮬레이션을 통해 제안된 방법의 주파수 판별 성능을 검증한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1999년도 전력전자학술대회 논문집
• /
• pp.147-150
• /
• 1999

SRM drives generate large vibration and acoustic noise because it is commutated individually by step pulse m.m.f on each phase pole. The frequency or motor speed of peak vibrations and acoustic noises is coincided with the natural resonant frequency of the magnetic structure and frame material. And this radial vibration force is induced on the phase commutation region. This paper suggest the new electromagnetic structure of SRM with auxiliary commutation winding excited d.c e.m.f.. This phase- commutating winding is coupled magnetically between one phase winding and the vibrating force is falled down. As a result, SRM with d.c exciting commutation winding is very useful to reduce vibration and acoustic noise of SRM drive.

• 제어로봇시스템학회논문지
• /
• 제5권7호
• /
• pp.800-807
• /
• 1999

A Periodic disturbance canceller is proposed to compensate for the periodic disturbance due to cutting process in a CNC machining center. The periodic disturbance canceller estimates the Periodic disturbance without phase delay. This is achieved by using linear phase low-pass filter and frequency response reciprocal filter of plant at the frequency of the periodic disturbance. This method is implemented in the position control system of the CNC machining center with general disturbance compensators in order to compensate for both the frictional force and the periodic disturbance. The experimental results are described to show its effectiveness.