• Archives of design research
• /
• v.21
• /
• pp.77-86
• /
• 1997

Modern society has created the age of mass media image. Advertising media strongly stimulate and influence the image contact and the frequency of receivers by visual communication media in everyday life. Until today no consciousness concerning the necessity of typographic visual image and it's selection for newspaper advertising has been developed. The necessity of headline typography visual image in newspaper advertising and it's selection should be considered a problem that must be solved by a more reasonable and logical approach, like it is done in the case of advertising copy, in order to increase the efficiency of advertising for the consumer.

• Asian Journal of Atmospheric Environment
• /
• v.8 no.2
• /
• pp.89-95
• /
• 2014

There have been a lot of efforts to keep permissible emission standards and to reduce the amount of emitted air pollutants. There are several air pollution control equipments, however, wet scrubber is used to remove particulate matters and gaseous pollutants simultaneously, even if it has low collection efficiency in the particle size less than $5.0{\mu}m$. To overcome this problem, we introduced a spray tower scrubber with an electrospray system which a high voltage was indirectly applied. We found that collection efficiency of fine particles in the electrospray system was improved by increasing electrical field strength and the ratio of liquid-gas flow rate (from 41% to 84% for $0.3{\mu}m$ particles). In addition, a number of small droplets generated from an electrospray system led high collection efficiency, resulting from electrostatic attraction between droplets and particles and higher collision frequency. Therefore, we can conclude that the introduction of an electrospray system is quite effective to increase the particle removal efficiency of a spray tower scrubber.

• Journal of Satellite, Information and Communications
• /
• v.3 no.2
• /
• pp.48-53
• /
• 2008

In the future, satellite communication systems, such as ISDB in Japan and DVB in Europe, are required to support higher transmission date rate for providing multimedia services including HDTV, high rate data communication etc. Considering the effectiveness of OFDM technique in efficient usage of frequency bandwidth and its robustness to the multi-path fading, several OFDM based standards have been proposed for satellite communication. However, the problem of high Peak to Average Power Ratio is one of the main obstacles for the implementation of OFDM based system. Many PAPR reduction schemes have been proposed for OFDM systems. Among these, the partial transmit sequences (PTS) is attractive as they obtain better PAPR property by modifying OFDM signals without distortion. In this paper, considering the complexity issue, we present a simplified minimum maximum (minimax) criterion and Sub-Optimal PTS algorithm to optimize the phase factor. This algorithm can be dynamically made tradeoff`f between performance and complexity on demand. In addition, we integrate guided scrambling (GS) with this method. Simulation in multiple antenna based OFDM system proves that the proposed Hybrid schemes can get much more PAPR reduction and do not require transmission of side information (SI). Thus it is helpful when implementing OFDM technique in satellite communication system.

• Journal of Power System Engineering
• /
• v.9 no.4
• /
• pp.71-76
• /
• 2005

Marine structures are often in contact with inner or outer fluid as stern, ballast and oil tanks. The effect of interaction between fluid and structure has to be taken into consideration when we estimate the dynamic response of the structure appropriately. Fatigue damages can also be sometimes observed in these tanks which seem to be caused by resonance. Thin walled tank structures in ships which are in contact with water and located near engine or propeller where vibration characteristics are strongly affected by the added mass of containing water. Therefore it is essentially important to estimate the added mass effect to predict vibration characteristics of tank structures. But it is difficult to estimate exactly the magnitude of the added mass because this is a fluid-structure interaction problem and is affected by the free surface, vibration modes of structural panels and the depth of water. I have developed a numerical tool of vibration analysis of 3-dimensional tank structure using finite elements for plates and boundary elements for fluid region. In the present study, the effect of added mass of containing water, the effect of structural constraint between panels on the vibration characteristics are investigated numerically and discussed. Especially a natural frequencies by the fluid interaction between 2 panels and a breath mode of the water tank are focused on.

• Journal of Power System Engineering
• /
• v.9 no.4
• /
• pp.162-167
• /
• 2005

The purpose of this paper is to improve the hysteresis characteristics of a stack type piezoelectric actuator using system identification and tracking control. Recently, several printing methods that are cost less and faster than previous semiconductor processes have been developed for the production of electric paper and RFID(Radio Frequency IDentification). The system proposed in this study prints by spraying the molten metal. And this system consist of a nozzle, heating furnace, operating actuator and an XYZ 3-axis stage. As an operating system, the piezoelectric(PZT) actuator is a very useful tool for position control of the metal printing system. However, the PZT actuator has a hysteresis nonlinearity due to the ferroelectric characteristics of the PZT element. This hysteresis causes problem position control characteristics in the system and deteriorates the performance of the system. In this study, an investigation was conducted to improve the hysteresis characteristics of the PZT actuator that has an output displacement for the input voltage. In order to reduce the hysteresis nonlinearity of the PZT actuator, this proposed a inverse hysteresis model and a mathematic modeling method that can express the geometric relationship between voltage and displacement. In addition, system identification and PID control methods were examined. Also, it was confirmed that the proposed control strategy gives good tracking performance.

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.442-444
• /
• 2007

How to observe the atmosphere is a subject of atmospheric research. The meteorological satellites and the ground states are used to do observation. However, both ways do not satisfy the requirement of scientists, especially the profiles of atmosphere on the ocean and the data for global atmosphere. Radio occultation (RO) technique, which has been used in planet science, is a method to solve the problem. In RO technique, the low Earth orbit (LEO) satellite receives the two frequency signal of Global Positioning System (GPS) satellite. The excess phase of the signal is calculated to retrieve the profiles of atmosphere parameters. In moist troposphere, the fluctuations appear in the phase of the signal and open loop (OL) is used to resolve it. The quality of the GPS signal generally deteriorates as the altitude decreases. In the procedure, the SNR of the GPS signal is used as the criterion. However, the SNR decreases with fluctuation which makes it difficult to locate the data of poor quality. In this paper, the phase of the signal will be used as part of the criterion.

• Journal of the Korean Statistical Society
• /
• v.33 no.3
• /
• pp.313-321
• /
• 2004

We consider the problem of testing cell probabilities in sparse multinomial data. Aerts et al. (2000) presented T=${{\Sigma}_{i=1}}^{k}{[{p_i}^{*}-E{(p_{i}}^{*})]^2$ as a test statistic with the local least square polynomial estimator ${{p}_{i}}^{*}$, and derived its asymptotic distribution. The local least square estimator may produce negative estimates for cell probabilities. The local maximum likelihood polynomial estimator ${{\hat{p}}_{i}}$, however, guarantees positive estimates for cell probabilities and has the same asymptotic performance as the local least square estimator (Baek and Park, 2003). When there are cell probabilities with relatively much different sizes, the same contribution of the difference between the estimator and the hypothetical probability at each cell in their test statistic would not be proper to measure the total goodness-of-fit. We consider a Pearson type of goodness-of-fit test statistic, $T_1={{\Sigma}_{i=1}}^{k}{[{p_i}^{*}-E{(p_{i}}^{*})]^2/p_{i}$ instead, and show it follows an asymptotic normal distribution. Also we investigate the asymptotic normality of $T_2={{\Sigma}_{i=1}}^{k}{[{p_i}^{*}-E{(p_{i}}^{*})]^2/p_{i}$ where the minimum expected cell frequency is very small.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.20 no.11
• /
• pp.1025-1032
• /
• 2010

Gas turbine compressor blades used in a combined cycle power plant are possibly damaged and fractured during their operation. There are two possible causes of the failure of compressor blades; one is a defect of material quality which can be detected through some microscopic inspections for the fracture section, the other is high cycle fatigue problem caused by vibration and can be diagnosed by carrying out dynamic characteristics analysis for the blades. In this paper, in order to determine the cause of the failure of compressor blades in a combined cycle power plant, examination of the fracture section and the propagation mechanism of the crack via stress analysis are performed. Dynamic characteristics analysis via FRF estimation is also performed to identify the cause of failure.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.04a
• /
• pp.648-654
• /
• 2011

The feed-water piping system constitutes a complex flow impedance network incorporating dynamic transfer characteristics which will amplify some pulsation frequencies. Understanding pressure pulsation waves for the feed-water recirculation piping system with cavitation problem of flow control valve is very important to prevent acoustic resonance. Feed water recirculation piping system is excited by potential sources of the shock pulse waves by cavitation of flow control valve. The pulsation becomes the source of structural vibration at the piping system. If it coincides with the natural frequency of the pipe system, excessive vibration results. High-level vibration due to the pressure pulsation affects the reliability of the plant piping system. This paper discusses the piping vibration due to the effect of shock pulsation by the cavitation of the flow control valves for the recirculation piping of feed-water pump system in combined cycle power plants.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 1994.10a
• /
• pp.472-477
• /
• 1994

The lockup clutch is embeded on torque converter of automatic transmission to prevent the efficiency deterioration of torque converter in high speed. For improving fuel consumption rate, it is desirable to engage the lockup clutch earlier. But, it results in degrading shift quality, due to the transient torque. The transient clutch pressure which affects the shifting quality, should be controlled properly. In this study, to solve the problem, it is analysed the hydraulic circuit of lockup system including line pressure regulating circuit, established the nonlinear model, and designed the PID controller. The line pressure is supplied to the lockup clutch through the lockup control valve by switching the lockup solenoid valve on. In order to control the transient pressure actively, it is needed to control the lockup solenoid valve by closed loop control. The lockup solenoid valve is 2-way on-off valve, and is adequate for PWM control. To reduce the pressure chattering, the carrier frequency is increased. Target pressure profile is computed from optimized velocity difference profile throuth dynamic equation of vehicle system.