• Proceedings of the IEEK Conference
• /
• 2000.07a
• /
• pp.129-131
• /
• 2000

A new analog synchronous mirror delay to be used in the wide-bandwidth clocking circuits is proposed to overcome the frequency dependency of the negative-delay values in the conventional analog synchronous mirror delay. The scheme adopts a new dummy-delay compensation technique by adopting the comparator with inherent systematic offset to achieve the enhanced negative-delay range especially prominent at high frequency applications.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.5
• /
• pp.879-886
• /
• 2003

Agile frequency synthesizers are the common device used for commandable, wide-band frequency hopping in frequency-hopped (FH) communications. In this paper, synthesizer phase transient effect and its compensation methods in an FH/FSK(Frequency Hopped Frequency Shift Keying) system are studied. Models for these analysis are developed and resulting performance degradations are computed. The basic PLL is difficult to implement for fast frequency hopping in narrowband radio communication systems. To solve this problem, digital frequency synthesizer/CPM (Continuous Phase Modulation)modulator is proposed. And it's performance is analyzed theoretically. The analysis show that fast frequency hopping is possible in frequency hopping system that use digital frequency synthesizer/CPM modulator.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5A
• /
• pp.432-440
• /
• 2011

For the 4th generation mobile communication, LTE-advanced system needs the broad frequency band up to 100MHz for providing the data rate of maximum 1Gpbs. However, it is very difficult to secure the broad frequency band in the current frequency allocation situation. So, carrier aggregation was proposed as the solution, in which several fragmented frequency bands are used at the same time. Basically, multiple parallel receivers are required to get the information data from the different frequency bands but this conventional multi-chain receiver system is very inefficient. Therefore, in this paper, we like to study the single chain system that is able to receive the multi-band signals in a single receiver based on the time division multiplexing (TDM) reception method. This proposed TDM receiver efficiently manage to receive the multi-band signals in time domain and handle the baseband signals with one DSP board. However, the serious distortion could be generated by the sampling timing offset (STO) in the TDM-based system. Therefore, we like to analyze STO effects in the TDM-based system and propose a compensation method using estimated STO. Finally, it is shown by simulation that the proposed method is appropriate for the single chain receiver and show good compensation performance.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.3
• /
• pp.313-321
• /
• 2014

A low-power low-cost polar transmitter for EDGE is designed in $0.18{\mu}m$ CMOS. A differential delta-sigma modulator (DSM) tunes a three-terminal voltage-controlled oscillator (VCO) to perform RF phase modulation, where the VCO tuning curve is digitally pre-compensated for high linearity and the carrier frequency is calibrated by a dual-mode low-power frequency-locked loop (FLL). A digital intermediate-frequency (IF) pulse-width5 modulator (PWM) drives a complementary power-switch followed by an LC filter to achieve envelope modulation with high efficiency. The proposed transmitter with 9mW power dissipation relaxes the time alignment between the phase and envelope modulations, and achieves an error vector magnitude (EVM) of 4% and phase noise of -123dBc/Hz at 400kHz offset frequency.

• Proceedings of the IEEK Conference
• /
• 2001.06a
• /
• pp.13-16
• /
• 2001

In this paper, We have investigated the SER performance of a OFDM/QPSK system with carrier-frequency offset in a frequency non-selective fading channel. Adaptive linear equalizer is adopted to OFDH/QPSK systems for compensation of performance degradation according to the non-selective fading and carrier frequency offset. As a result of performance analysis, the more frequency offset is, the worse performance of OFDH/QPSK system is. However, when OFDH/QPSK system adopts the adaptive linear equalizer, the SER performance is enhanced to the limit range

• Journal of Power Electronics
• /
• v.14 no.3
• /
• pp.598-607
• /
• 2014

This paper proposes a frequency-locked loop (FLL) scheme for a single-phase grid-connected converter. A second-order generalized integrator (SOGI) based on fuzzy logic (FL) is applied to this converter to achieve precise phase angle detection. The use of this method enables the compensation of the nonlinear characteristic of the frequency error, which is defined in the SOGI scheme as the variation of the central frequency through the self-tuning gain. With the proposed scheme, the performance of the SOGI-FLL is further improved at the grid disturbances, which results in the stable operation of the grid converter under grid voltage sags or frequency variation. The PSIM simulation and experimental results are shown to verify the effectiveness of the proposed method.

• Journal of the Korea Society of Computer and Information
• /
• v.18 no.10
• /
• pp.63-70
• /
• 2013

In this paper, we investigated frequency synchronization through computer simulation of digital M/W transmission system in multipath fading channel. we suggested frequency offset correction algorithm against frequency offset between transmitter and receiver, then evaluated the degree of constellation performance enhancement. From the performance evaluation, in case of large frequency offset, although adopting frequency offset correction scheme, residual frequency offset degraded system performance. As a result, according to frequency offset value between transmitter and receiver residual frequency offset affects system performance significantly. The results of this paper should be utilized for frequency synchronization criterion when frequency band of broadcasting system is rearranged.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2004.11a
• /
• pp.366-366
• /
• 2004

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5B
• /
• pp.517-529
• /
• 2011

In this paper, the parameters of the RTT (Radio Transmission Techniques) for SANET (Ship Ad-hoc NETwork), which is considered for the next generation maritime communication systems, are set up. A channel model has been analyzed based on the practical measured maritime wireless channel in VHF (Very-High Frequency) for SANET system. Also, by considering the frame structure including preamble, guard time and pilots for both single and multi-carrier systems, the BER (Bit Error Rate) performances are evaluated and analyzed in the aspects of channel compensation and channel coding techniques. Based on the simulation results, optimal modulation & coding schemes are suggested for SANET. That is, in single-carrier system by using differential modulation schemes, channel compensation is not necessary. However, channel coding is helpful to achieve additional gain. On the other hand, when 16-QAM modulation is employed in multi-carrier system, the implementation of both channel compensation and channel coding techniques show huge performance gain for various of K values, which are related to different maritime environments, and the rolling effects of wave.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.48 no.2
• /
• pp.75-82
• /
• 1999

A compensation method of the motor parameters using zero sequence third harmonic voltage is presented for the speed sensorless vector control of the induction motor considering saturation of the flux. Generally, the air-gap flux of the saturated induction motor contains the space harmonic components rotating with the synchronous frequency of the motor. Because the EMF of the saturated induction motor contains the zero sequence harmonic voltages at the neutral point of the motor, those harmonic voltages can be used as a saturation index. In this work, the rotor flux observer is firstly designed for the speed sensorless vector control of induction motor. And a novel measurement method of the space harmonic voltage and a compensation method of th LPF(Low Pass Filter) are proposed. For compensating the non-linear variations of the magnetizing inductance depending on the saturation level of the motor, the dominant third harmonic voltage of the motor is used as a saturation function of the air-gap flux. And the variation of the stator resistance owing to the motor temperature can also be measured with the phase angle between the impressed voltage vector and the zero sequence voltage. The validity of the proposed parameter compensation scheme in the speed sensorless vector control using rotor flux observer is verified by the result of the simulations and the experiments.