• The Journal of Engineering Geology
• /
• v.14 no.4 s.41
• /
• pp.401-416
• /
• 2004

We have collected shale specimens from the Pungam Basin in Kangwon province and investigated change of physical properties by freezing and thawing in water as well as in acidic fluid. The temperature range was $-20{\pm}2^{\circ}C\~15{\pm}2^{\circ}C$. Specimens were frozen for 12 hours and thawed in water for 8 hours. Then, they were saturated in the vacuum chamber for 4 hours to make specimens fully saturated. This procedure was 1 cycle. We have measured absorption, ultrasonic velocity, shore hardness, slake durability and uniaxial compressive strength at every 5th cycles. The physical properties increased or decreased as freezing and thawing cycles increased. Uniaxial compressive strength decreased by 0.40MPa per cycle in water and by 0.48MPa in acidic fluid. Elastic constant also decreased by 0.21GPa per cycle in water and by 0.30GPa in acidic fluid. Absorption increased by $0.29\%$ and $0.37\%$ per cycle in water and acidic fluid, respectively. These results indicate that decrease in uniaxial compressive strength, elastic constant and absorption by freezing and thawing in acidic fluid is more rapid than in water. Ultrasonic velocities, shore hardness and slake durability show no differences in water and acidic fluid. When we compared our results with the temperatures in the Hongchon during the winter season, $6\~12$ cycles may be equivalent to 1 year.

• The Journal of Engineering Geology
• /
• v.17 no.3
• /
• pp.359-365
• /
• 2007

Freezing and thawing cycle is one of the major weathering-induced factors in the mechanical weathering of the rock mass. This natural process accelerates rock weathering process by breaking down the parent rock materials and makes soil or weathered rock formation in a rock slope surface zone. It can also cause reduction of the shear strength in slopes. It is important to calculate the deterioration depth caused by freezing-thawing for a slope stability analysis. In this study, deterioration depths of rock slope due to freezing-thawing were calculated using the 1-D heat conductivity equation. The temperature distribution analysis was also carried out using collected temperature distribution data for last five years of several major cities in Korea. The analysis was performed based on the distributed rock types in study areas. Thermal conductivities, specific heats and densities of the calculation rocks are tested in the laboratory. They are thermal properties of rocks as input parameters for calculating deterioration depths. Finally, the paper is showing the calculated deterioration depths of each rock type slopes in several major cities of Korea.

• Magazine of the Korea Concrete Institute
• /
• v.10 no.4
• /
• pp.153-161
• /
• 1998

Concrete structures has been deteriorated by and freezing the thawing due to temperature gap. This study was conducted to evaluate durability of concrete which are increasingly demanded recently. Therefore the research of durability must be executed for application of waste foundry sand concrete real structures. Concrete durability properties incorporating waste foundry sand was performed with the variable of W/C ratio. Sand/Waste foundry sand ratio and Air entrainment-Non air entrainment. Cylinder specimens were made and subjected to freezing and thawing cycle at -18$^{\circ}C$ and 4$^{\circ}C$. Dynamic modulus of elasticity were evaluated as F/T cycle increase. The results show that strength of concrete is increased the W/C ratio decrease, the Sand/Waste foundry sand ratio increases when the concrete contains AE agent and decreasing W/C ratio and AE concrete makes improved resistance of freezing and thawing improved. Especially, resistance of freezing and thawing is improved by Fine aggregate/Waste foundry sand ratio which is 50%, 25%, 0% in a row. Therefore it is turn out the waste foundry sand could be applied to concrete from the experiment.

• Korean Journal of Animal Reproduction
• /
• v.16 no.2
• /
• pp.117-123
• /
• 1992

This Study was carried out ot investigate the effects of concentration and equilibration time of cryoprotective aagents on survival rate of slowly and ultrarapidly frozen porcine embryos. The porcine embryos following dehydration by cryoprotective agents and 0.25M sucrose were slowly freezed(from 2$0^{\circ}C$ to -7$^{\circ}C$/-1$^{\circ}C$/min., from -7$^{\circ}C$ to -35$^{\circ}C$/-0.2$^{\circ}C$/min., from -35$^{\circ}C$ to -38$^{\circ}C$/-0.3$^{\circ}C$/min.) by Cell Freezer and directly plunged into liquid nitrogen and thawed in 38$^{\circ}C$ water bath. Survival rate was defined as development rate to the morula and blastocyst stage after in vitro culture or by FDA test. The results are summarized as follows : 1. The survival rates of porcine embryos after slow frozen-thawing in the freezing medium of 0.25M sucrose added 2.0M glycerol, 3.0M DMSO, 2.0M propanediol or 2.0M glycerol＋2.0M propanediol was 80.6, 84.7, 75.0 or 78.8%, respectively. 2. The survival rates of porcine embryos after slow frozen-thawing in the freezing medium of 0.50M sucrose added 2.0M glycerol, 3.0M DMSO, 2.0M propanediol or 2.0M glycerol＋2.0M propanediol was 80.9, 82.4, 73.1 or 77.1%, respectively. 3. The survival rates of porcine embryos after ultrarapid frozen-thawing in the freezing medium of 0.25M sucroese added 2.0M glycerol, 3.0M DMSO, 2.0M propanediol or 2.0M glycerol＋2.0M propanediol was 65.3, 68.6, 63.2 or 59.9%, respectively. 4. The survival rates of porcine embryos after ultrapid frozen-thawing in the freezing medium of 0.50M sucrose added 2.0M glycerol, 3.0M DMSO, 2.0 propanediol or 2.0M glycerol＋2.0M propanediol was 67.5, 62.9, 56.9, or 62.8%, respectively. 5. The higher survival rate of porcine embryos was attained at the short period ofequilibration time(5min.) in the freezing medium added 0.25M sucrose and 3.0 DMSO compared to those of 10 or 20min. equilibration time in the same condition.

• Journal of the Korean GEO-environmental Society
• /
• v.17 no.5
• /
• pp.37-46
• /
• 2016

In order to determine the variability of environmental characteristics of lightweight air-foamed soil using marine clay according to freezing-thawing and soaking conditions, unconfined compressive strength of the lightweight air-foamed soil samples made by changing the amount of cement under curing conditions of outdoor low temperature, underground or indoor wetting were observed. Compressive strength was not increased under freezing-thawing (temperature range of $-9.1^{\circ}C{\sim}17.2^{\circ}C$) regardless of the amount of cement but the more cement using, it was increased rapidly by underground curing conditions within 30 cm beneath ground level. Therefore, it is necessary to install insulation layer cutting off exterior cold air after construction of lightweight air-foamed soil in condition of freezing-thawing. Bulk density was increased too small under the long-time soaking condition, it tended to decrease rapidly when samples were dried up and had below 6% of water contents. But variability of compressive strength and bulk density was very small for preventing drying and keeping its wet state. The lightweight air-foamed soil that installed beneath ground water level or covered by soil can be evaluated as a long-term reliable construction material.

• Journal of the Korean GEO-environmental Society
• /
• v.15 no.5
• /
• pp.47-56
• /
• 2014

In winter season, the pore water inside the ground freezes and thaws repetitively due to the cold air temperature. When the freezing-thawing processes are repeated on the ground, the change in soil particle structure occurs and thus the damage of the infrastructure may be following. This study was performed in order to investigate the stiffness change of soils due to the freeze-thaw by using elastic waves. Sand-silt mixtures are prepared with in the silt fraction of 40 %, 60 % and 80 % in weight and in the degree of saturation of 40 %. The specimens are placed into the square freezing-thawing cell by the temping method. For the measurement of the elastic waves, a pair of the bender elements and a pair of piezo disk elements are installed on the cell, and a thermocouple is inserted into soils for the measurement of the temperature. The temperature of the mixtures is decreased from $20^{\circ}C$ to $-10^{\circ}C$ during freezing, is maintained at $-20^{\circ}C$ for 18 hours, is gradually increased up to the room temperature of $20^{\circ}C$ to thaw the specimens. The shear waves, the compressional waves and the temperature are measured during the freeze-thaw process. The experimental result indicates that the shear and the compressional wave velocities after thawing are smaller than those of before freezing. The velocity ratio of after thawing to before freezing of shear wave is smaller than that of the compressional wave. As silt fraction increases from 40 % to 80 %, the shear and compressional wave velocities are gradually increased. This study suggests that the freezing-thawing process in unsaturated soil loosens the soil particle structure, and the shear wave velocity reflects the effect of freezing-thawing more sensitively than the compressional wave velocity.

• Clinical and Experimental Reproductive Medicine
• /
• v.34 no.2
• /
• pp.117-124
• /
• 2007

Objective: The aim of this study was to compare the efficacy of slow freezing with vitrification method for cryopreservation of mouse pronuclear stage embryos. Methods: Mouse pronuclear embryos obtained from superovulated mice and classified into 2 groups of slow freezing and vitrification. Slow freezing solution consisted of 1.5 M PROH, 0.1 M sucrose, while vitrification solution consisted of 40% ethylene glycol, 18% Ficoll and 0.5 M sucrose diluted in Dulbecco's phosphate-buffered saline supplemented with 10% SSS. Recovery and survival rates after thawing and development rates to hatching balstocyst stage were compared between two groups. Results: After freezing and thawing, recovery rate of slow freezing group was 93.8%, whereas vitrification group was 66.5% (p<0.01). Survival rate of recovered embryos were similar between two groups as 83.2% in slow freezing and 87.6% in vitrification. Embryo development rates to 2-cell stage after 24 hrs (77.0% vs 59.1%), 4-cell after 48 hrs (72.6% vs 53.3%), blastocyst after 96 hrs (53.1% vs 40.1%) of thawing were significantly higher in vitrification group than those of slow freezing group, respectively. Conclusion: The vitrification method may provide better developmental competence of frozen-thawed embryos than that of slow freezing method for cryopreservation of mouse pronuclear stage embryos.

• Korean Journal of Agricultural Science
• /
• v.48 no.4
• /
• pp.739-751
• /
• 2021

The thawing process is usually essential for imported pork because this product is typically distributed frozen. Consumers prefer fresh pork because discoloration, nutrient spills, and microbial contamination are high during the thawing process. The illegal act of selling frozen pork by disguising it as fresh pork through various methods can occur for the benefit of the difference in the sales price. However, there is some difficulty in securing systematic and objective data, as sensory tests are generally performed on imported pork. In the experiment conducted here, the electrical conductivity and dielectric properties of pork neck and pork belly products were measured. The amounts of change before and after freezing were compared through a statistical analysis, and a new method for determining frozen meat was proposed based on the analysis results. The weight was reduced compared to that before freezing due to the outflow of drips from the thawing process, but there was no difference in the drip loss level due to the thawing method. Vacuum packaging was found to lead to more drip loss than regular packaging, but the difference was not statistically significant. Frozen pork neck meat can be determined by measuring the electrical conductivity in the lean parts and the dielectric characteristic in the fatty parts. Frozen pork belly is determined by measuring the dielectric constant of the part closest to the outer fat layer.

• Food Science of Animal Resources
• /
• v.44 no.4
• /
• pp.758-778
• /
• 2024

This study assessed previous research aimed at mitigating the adverse effects of freeze-thawing on meat quality. Specifically, it focuses on assessing the physicochemical alterations in meat resulting from freezing, freeze-thawing, or technologies to minimize these alterations. Recent studies have focused on conventional freeze-thaw technology applicable across various livestock species and muscle types. However, recent research has indicated the necessity for developing freeze-thaw technology considering the unique characteristics of individual muscles. In this review, we summarize previous studies that have compared alterations in the physicochemical properties of primary muscles owing to freezing or freeze-thawing. Despite the introduction of various technologies to significantly reduce the adverse effects on meat quality resulting from freeze-thawing, it is essential to consider the unique characteristics (proximate composition, pH, and muscle fiber characteristics) of individual muscles or cuts to develop enhanced the freeze-thaw processing technology.

• Journal of Food Hygiene and Safety
• /
• v.31 no.1
• /
• pp.42-50
• /
• 2016

The effects of freezing and thawing conditions on microbiological quality and microstructure change of inoculated (Listeria monocytogenes and Campylobacter jejuni) and non-inoculated chicken breasts were investigated. Chicken breasts were frozen with air blast freezing (-20, -70, and $-150^{\circ}C$), ethanol ($-70^{\circ}C$) and liquid nitrogen ($-196^{\circ}C$) immersion freezing. There were no significant differences on the populations of L. monocytogenes inoculated with chicken breasts under different freezing conditions. However, air blast freezing ($-20^{\circ}C$) resulted in significant reductions for total aerobic bacteria and C. jejuni compared to the control and other freezing treatments. The frozen samples were thawed with (hot or cold) air blast, water immersion, and high pressure thawing at $4^{\circ}C$ and $25^{\circ}C$. the populations of total aerobic bacteria, and yeast and mold in the frozen chicken breast increased by 5.78 and 4.05 log CFU/g after water immersion thawing ($25^{\circ}C$) treatment. After five freeze-thaw cycles, the populations of total aerobic bacteria, yeast and mold, and C. jejuni were reduced by 0.29~1.40 log cycles, while there were no significant differences (P > 0.05) in the populations of L. monocytogenes depending on the freeze-thaw cycles. In addition, the histological examination of chicken breasts showed an increase in spacing between the muscle fiber and torn muscle fiber bundles as the number of freeze-thaw cycles increased. These results indicate that freezing and thawing processes could affect in the levels of microbial contamination and the histological change of chicken breasts.