• Journal of The Geomorphological Association of Korea
• /
• v.25 no.1
• /
• pp.47-65
• /
• 2018

Frost shattering has traditionally been considered as one of the most effective process in rock weathering. Each slab specimens of five or six rhyolite, basalt and tuff was prepared and put in freeze-thaw cycles and repeated 300 times in the temperature of $-25^{\circ}C$ to $+30^{\circ}C$ and their weathering patterns and products were analyzed by surface observation, particle size, XRD and thin section. As the result, some changes were observed in weathering patterns and weathering products. Rock shattering was more active in waterlogging rather than atmospheric conditions, but there are many differences depending on the type of rock. Rhyolite is hardly weathered by 300 times freeze-thaw cycles and generates the least amount of weathering products. Weathering of Basalt is limited to the surface layer where water can be absorbed, and produces a few amount of platy-shape debris. Tuff are separated by blocky structure which the particles are aggregated along their edges rather than enlarged existing cracks/joins or generated new joints.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.33 no.4
• /
• pp.1499-1508
• /
• 2013

Freeze-thaw tests were performed on gneiss samples collected from Terra Nova Bay, Antarctica in order to examine the engineering properties of rocks with slightly weathered (SW) and moderately weathered (MW). The tests were conducted under temperature ranging from $20{\pm}2^{\circ}C$ to $-20{\pm}2^{\circ}C$. A cycle of test consisted of 5 hours of freezing followed by another 5 hours of thawing under full saturation. In this paper, total 200 cycles of freeze-thaw test were performed with measurements of porosity, absorption, ultrasonic velocity, and shore hardness per each 20 cycle and that of uniaxial compressive strength (UCS) per each 50 cycle. The UCS of the SW rocks approximately decreased 0.07 MPa per a single cycle, while that of MW rocks decreased around 0.2 MPa per a single cycle. During the 200 cycles of SW rocks, the absorption increased from 0.23% to 0.39%, the P-wave velocity decreased from 4,054 m/s to 3,227 m/s and S-wave velocity decreased from 2,519 m/s to 2,079 m/s. Similarly, those of MW rocks changed from 0.65% to 1.6%, 3,207 m/s to 2,133 m/s and 2,028 m/s to 1,357 m/s. In conclusion, it was inferred that the properties of SW rocks experienced approximately 200-300 cycles of freeze-thaw process become close to those of MW rocks.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.44 no.1
• /
• pp.116-124
• /
• 2002

Natural resources fur the construction materials such as good soil, sand, and coarse aggregates have been encountered to be short due to excessive use by human. Even though some soil has been found to be unsuitable for construction materials, soil with reinforcement can naturally be an answer to these alternatives. According to recently published papers on fiber mixed soil, fiber mixed with soil can improve shear strength, compressive strength and post-peak load strength retention. In this study, a series of tests were performed to clarify the characteristics of fiber mixed soil and to give basic data for design and construction and their engineering properties, that is, unconfined compressive strength, splitting tensile strength, shear strength, crack by drying, freeze-thaw, creep and Poisson\`s ratio, were investigated and analyzed. It has been shown that fiber mixed soil is one of good alternatives fur the civil and building construction materials.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.40 no.5
• /
• pp.59-67
• /
• 1998

The object of this study is to investigate the strength characteristics and the freeze-thaw resistance of high strength concrete incorporating fine blast furnace slag. Major experimental variables were the water/cement ratio, maximum size of coarse aggregate, and cement types such as ordinary portland and slag cement. The results were as follows ; The workability of fresh concrete incorporating fine blast furnace slag was better than that of OPC(ordinary Portland cement) in terms of slump. The freeze-thaw resistance showed better than that of OPC, keeping more than 90% of relative modules of elasticity after 506 cycles and showing only a hair crack at surface without serious damage. Thus, the fine blast furnace slag might be recycled at concrete to make high strength concrete at fields.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2018.05a
• /
• pp.259-260
• /
• 2018

This study evaluated the compressive strength, freeze-thaw and sulfate resistance characteristics of concrete using CFBC-Ash. The CFBC-Ash was adjusted to a particle size of 75 ㎛ or less and using by increasing the fineness of powder through milling. As a result, it was confirmed that the concrete using CFBC-Ash shows a high compressive strength, durability. Also, it is confirmed that CFBC-ash can be used as a concrete binder.

• The Journal of Engineering Geology
• /
• v.34 no.3
• /
• pp.367-379
• /
• 2024

We analyzed the changes in the properties of the Mudeungsan tuff by conducting an artificial weathering experiment based on the climatic conditions of Mudeungsan National Park, to evaluate the long-term stability of the columnar jointing in the tuff. The climate of Mudeungsan National Park over 20 years suggests the temperature conditions for freeze-thaw are -20 to 30℃. The change in tuff properties due to weathering were estimated by measuring the elastic wave velocity, which was measured after every 40 freeze-thaw cycles. Based on the origin of the Mudeungsan tuff and fracture distribution in the tuff, the elastic wave velocity in samples from 24 locations was measured at regular intervals in the axial and radial directions. The axial elastic wave velocity of the Mudeungsan tuff is 5,187~5,367 m/s, and the radial elastic wave velocity is 4,001~5,290 m/s. As a result of 200 freeze-thaw cycles, the axial elastic wave velocity decreased by 5.53% for sample MT-1, 4.89% for MT-2, and 5.36% for MT-3. The radial elastic wave velocity decreased by 20.00% for MT-1, 17.02% for MT-2, and 19.84% for MT-3. The decrease in elastic wave velocity due to the freeze-thaw cycles is greater for low values of elastic wave velocity. For the axial elastic wave velocity, the weathering is accelerated after 120 cycles and, for the radial elastic wave velocity, weathering actively progresses from the start of the freeze-thaw cycles. In summary, for a low elastic wave velocity, experimental weathering results in a large decrease in elastic wave velocity. In addition, the Mudeungsan tuff and its columnar joints have a distinct anisotropy.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2020.11a
• /
• pp.149-150
• /
• 2020

Granting self-sensing performance in a building is an important performance to ensure the degree of damage and safety of the building. Since the current research is being conducted in the state before deterioration loss occurs, it is necessary to confirm whether the self-sensing performance is maintained even in the damaged conductive cement composite. As part of the study, electrical resistance characteristics were analyzed in conductive cement composites in which freeze-thawing and chemical corrosion occurred. As a result, it was found that the change in electrical resistance value due to freeze-thawing was not as large as 1%, and chemical corrosion occurred. It was found that the change in electrical resistance value of the tested specimen increased by about 10%.

• Korean journal of food and cookery science
• /
• v.21 no.6 s.90
• /
• pp.942-949
• /
• 2005

To improve the textural properties and stabilize the structure and gel matrix of non-waxy rice starch gels, non-waxy rice starch/gum mixture gels were prepared from various food gums, gum arabic, guar, algin, deacyl gellan, xanthan and gellan gums. The morphological and textural properties and freeze-thaw stability of their gels were compared. Rice starch/gum mixture gels with various gums formed a more homogeneous gel matrix with smaller particle size than rice starch gel without Em, but the trends differed depending on the gum types. The textural properties of rice starch/gum mixture gels were changed with the gum types. The shape of the rice starch/gum mixture gel matrix was desirable when mixed with gellan and algin. The textural properties of gels hardened in the rice starch/algin mixture gel and softened in the rice starch/algin mixture gel. The rice starch gels showed V-type crystallinity by x-ray diffractometer, but the peak at $2\theta$ = $20^{o}$ was decreased with increasing gum addition. The freeze-thaw stability increased with increasing gum addition. Gellan and algin were especially effective.

• Structural Engineering and Mechanics
• /
• v.90 no.5
• /
• pp.467-480
• /
• 2024

The mechanical properties and durability of concrete pavements may be degraded in extreme situations, resulting in the need for partial repair or total replacement. During the past few decades, there has been a growing body of research on substituting a portion of Portland cement with alternative cementitious materials for improving concrete properties. In this study, two different configurations of powdered and granulated blast furnace slag were implemented, replacing fine aggregates (by 12 wt.%) and Portland cement (by 0, 20, 40, and 60 wt.%) in the making of roller-compacted concrete (RCC) mixes. The specimens were fabricated to investigate the mechanical properties and durability specifications, involving freeze-thaw, salt-scaling, and water absorption resistance. The experimental results indicated that the optimum mechanical properties of RCC mixes could be achieved when 20-40 wt.% of powdered slag was added to concrete mixes containing slag aggregates. Accordingly, the increases in compressive, tensile, and flexural strengths were 45, 50, and 28%, in comparison to the control specimen at the age of 90 days. Also, incorporating 60 wt.% of powdered slag gave rise to the optimum mix plan in terms of freeze-thaw resistance such that a negligible strength degradation was experienced after 300 cycles. In addition, the optimal moisture content of the proposed RCC mixtures was measured to be in the range of 5 to 6.56%. Furthermore, the partial addition of granulated slag was found to be more advantageous than using entirely natural sand in the improvement of the mechanical and durability characteristics of all mixture plans.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.05a
• /
• pp.991-996
• /
• 2001

The long-term durability characteristics of high-early-strength concrete were assessed. The effect of long-term durability characteristics of high-early-strength concrete were investigated. In experiment, two different types of fiber were adopted for improvement of durability. High-early-strength fiber reinforced concretes using regulated-set cements are compared with high-early-strength concrete without fiber. The durability performance of the laboratory-cured high-early-strength concrete specimens was determined by conducting an accelerated chloride permeability, abrasion resistance, freeze-thaw, surface deicer salt scaling and wet-dry repetition test. The results indicated that incorporation of fibers enhance durability performance.