• Journal of Broadcast Engineering
• /
• v.14 no.2
• /
• pp.134-143
• /
• 2009

In this paper, we propose a new relay selection algorithm for a two-way multiple relay channel. In the two-way multiple relay channel, two users exchange information with each other via multiple relays. The relays use a decode-and-forward or amplify-and-forward protocol, and exploit the combining process of the received packets to reduce the required channel resources. In the multiple relay network, diversity gain is achieved as the number of relays increases, and various schemes are proposed. In this paper, we propose a single best relay selection scheme based on instantaneous channel conditions. First of all, relays obtain the instantaneous channel state information in the handshaking process, and a single best relay is selected in a distributed methods prior to data transmissions. The relay selection metric is proposed so that the end-to-end channel condition is evaluated based on the intantaneous channel state informations. Simulation results show that the proposed relay selection algorithm achieve the increased throughput and diversity order when the number of potential relays is increased.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.8
• /
• pp.733-738
• /
• 2013

In this paper, we consider a physical layer security of an amplify-and-forward (AF) transmission in a presence of an eavesdropper in a wiretap channel. The proposed wiretap channel consists of a source, a destination, a relay, and an eavesdropper. Specifically, we consider that the relay has multiple antennas to exploit a diversity gain and a receive/transmit antenna selection schemes are applied to maximize a signal-to-noise ratio. In a practical point of view, we focus on the practical scenario where the relay does not have any channel state information of the eavesdropper while performing an AF protocol at the relay. For a secrecy performance analysis, we analyze a secrecy outage probability of the proposed system in one-integral form and verify our analysis with the computer-based simulation.

• Physical Therapy Rehabilitation Science
• /
• v.10 no.2
• /
• pp.147-155
• /
• 2021

Objective: This study is to investigate the effect of real-time feedback from the therapist on posture, muscle strength, pain of subjects with forward head posture based on a non-face-to-face complex exercise program. Design: Two-group pretest-posttest design. Methods: Thirty healthy men and women in their twenties with forward head posture with a Craniovertebral angle of 52° or less were targeted, the final selection was made as 15 experimental groups who performed the non-face-to-face intervention program while receiving real-time feedback and 15 control subjects who performed the non-face-to-face intervention program without providing feedback. Six of them were eliminated, and a total of 24 were conducted as subjects. All exercise groups performed an exercise program three times a week, 30 minutes each, for a total of two weeks. Before and after exercise, Craniovertebral angle (CVA), CranioRotation angle (CRA), muscle strength, and tenderness threshold were evaluated. Results: Significant differences were shown in both groups in CVA, and tenderness threshold before and after exercise (p<0.05), and CRA, the left middle trapezius muscle strength, only in the experimental group (p<0.05). In the comparison of theamount of change between exercise groups, the group that received feedback on CVA, CRA and tenderness threshold showed a significant change than the group without feedback (p<0.05). Conclusions: As a result of this study, it can be seen that the therapist's real-time feedback is more effective in improving the forward head posture. This requires feedback from the therapist on posture correction during non-face-to-face exercise intervention.

• Journal of IKEEE
• /
• v.15 no.1
• /
• pp.64-69
• /
• 2011

In this paper, a semi-analytical approach is proposed for decode-and-forward(DF) relay systems over rayleigh fading channels. At first, we derive the general form of the averaged bit error rate(BER) based on error-events at relay nodes in which a selection scheme is not used. It is confirmed that an erroneous detection and transmission at relay nodes can cause the degradation of the received signal-to-noise ratio (SNR) and the averaged BER performance. Furthermore, the proposed method can be extended to selective-DF(SDF) relay schemes so that it is verified to be another general solution for DF relay systems. Also, proposed semi-analytical expressions have been verified by comparing with simulations.

• Journal of the Korean Society for Precision Engineering
• /
• v.2 no.2
• /
• pp.31-42
• /
• 1985

The metal flow and the strain distribution is investigated for the steady state and non-steady state bulk deformation processes by using an improved visioplasticity method which includes the effective smoothing scheme. The comparison of various smoothing schemes leads to the selection of the five- point least square smoothing method which is employed to reduce the measurement errors. As a steady state forming process experiments are carried out for axisy- mmetric forward extrusion through conical and curved dies of various area reduc- tions using Aluminum and steel billets. Axisymmetric backward extrusion is chosen for a nonsteady state forming process. In axisymmetric forward extrusion the results from visioplasticity show that the curved die of a fourth-order polynomial renders more uniform distribution of strain rates and strains. Higher reduction leads to greater strain rates at the outer side of the billet. The visioplastic observation for axisymmetric backward extrusion as a non-steady state deformation process shows the concentration of higher strain at the inner wall of the extruded product. The visioplastic results in forward extrusion are in agreement with the computed results by the finite element method. It is thus shown that the visio- plasticity combined with a smoothing technique is an effective method to determine the pattern and the distribution of strain rates and strains.

• The Journal of the Acoustical Society of Korea
• /
• v.18 no.2
• /
• pp.66-76
• /
• 1999

This paper proposes that can take at high speed the information of binocular disparity with moving translational and forward stereo camera to the extent that does not occur the problem of a correspondence point. It shows that in case of stereo vision with translational motion, can take the information of binocular disparity being devoid of error and putting high confidence in, and that in case of stereo vision with forward motion, can take the horizontal component which can not be detected in common stereo vision. Besides, the stereo vision can be done at high speed due to being bright and small a correspondence point comparing not to do, because a correspondence between right and left images is previously limited. But there are problem that a resonable information of binocular disparity can not be taken, if the vicinity of center of image is in accord with the region of occlusion in stereo vision with forward motion.

• Journal of Biosystems Engineering
• /
• v.28 no.1
• /
• pp.19-26
• /
• 2003

An oscillating digger mechanism was designed, constructed. and tested. The mechanism is consisted of a six-bar linkage, one four-bar linkage was fer the digger blade and the other one fur variable soil-crop separation. Experimental variables were amplitude(3, 6, 9 mm). frequency(11.2, 14.9. 17.0 Hz), and forward speed of tractor(0.91, 1.13, 1.56 km/h). Each combination of these variables was replicated three times to measure the draft and torque for power requirement evaluation. and the broken-up soil height on the soil separation sieve mechanism. Four parameters λ(the ratio of vibration speed to forward velocity), p(the ratio of vibration acceleration to forward velocity), K(the ratio of vibration acceleration to gravitational acceleration), and T(the product of λ and K) were induced from three experimental variables: amplitude, frequency, and tractor speed. And the power requirement and soil separation ability were analyzed by regression. Though λ and K were known to be the representative parameters. T was the most moderate one to explain draft. torque. and soil separation in this study. It was estimated that the T equal to or greater than 2.4 was the minimum recommended value. Figure 18 would be useful fir the selection of amplitude. frequency, or operating tractor speed once any two variables are known.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.5
• /
• pp.2015-2028
• /
• 2016

In this paper, we propose a sum transmission rate maximization based cooperative spectrum sharing protocol with quality-of-service (QoS) support for both of the primary and secondary systems, which exploits the situation when the primary system experiences a weak channel. The secondary transmitter ST_b which provides the best performance for the primary and secondary systems is selected to forward the primary signal. Specifically, ST_b helps the primary system achieve the target rate by using a fraction of its power to forward the primary signal. As a reward, it can gain spectrum access by using the remaining power to transmit its own signal. We study the secondary user selection and optimal power allocation such that the sum transmission rate of primary and secondary systems is maximized, while the QoS of both primary and secondary systems can be guaranteed. Simulation results demonstrate the efficiency of the proposed spectrum sharing protocol and its benefit to both primary and secondary systems.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.11
• /
• pp.4087-4102
• /
• 2014

Two-way relaying is an effective way of improving system spectral efficiency by making use of physical layer network coding. However, energy efficiency in OFDM-based bidirectional relaying with asymmetric traffic requirement has not been investigated. In this study, we focused on subcarrier transmission mode selection, bit loading, and power allocation in a multicarrier single amplified-and-forward relay system. In this scheme, each subcarrier can operate in two transmission modes: one-way relaying and two-way relaying. The problem is formulated as a mixed integer programming problem. We adopt a structural approximation optimization method that first decouples the original problem into two suboptimal problems with fixed subcarrier subsets and then finds the optimal subcarrier assignment subsets. Although the suboptimal problems are nonconvex, the results obtained for a single-tone system are used to transform them to convex problems. To find the optimal subcarrier assignment subsets, an iterative algorithm based on subcarrier ranking and matching is developed. Simulation results show that the proposed method can improve system performance compared with conventional methods. Some interesting insights are also obtained via simulation.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.9
• /
• pp.2081-2100
• /
• 2013

In this paper, we propose a cooperative hybrid spectrum sharing protocol by jointly considering interweave (opportunistic) and underlay schemes. In the proposed protocol, secondary users can access the licensed spectrum along with the primary system. Our network scenario comprises a single primary transmitter-receiver (PTx-PRx) pair and a group of M secondary transmitter-receiver (STx-SRx) pairs within the transmission range of the primary system. Secondary transmitters are divided into two groups: active and inactive. A secondary transmitter that gets an opportunity to access the secondary spectrum is called "active". One of the idle or inactive secondary transmitters that achieves the primary request target rate $R_{PT}$ will be selected as a best decode-and-forward (DF) relay (Re) to forward the primary information when the data rate of the direct link between PTx and PRx falls below $R_{PT}$. We investigate the ergodic capacity and outage probability of the primary system with cooperative relaying and outage probability of the secondary system. Our theoretical and simulation results show that both the primary and secondary systems are able to achieve performance improvement in terms of outage probability. It is also shown that ergodic capacity and outage probability improve when the active secondary transmitter is located farther away from the PRx.