• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 B
• /
• pp.980-982
• /
• 2002

In this paper, we report the experimental results of the Forward-flyback DC-DC converter with current doubler and synchronous rectifier. The experimental converter, that has a output voltage 1.8V, output current 25A, maximum power of 45W, switching frequency of 290kHz and input voltage range of 36-75V, has been successfully implemented. As a result, in the entire voltage range the measured full load efficiency was above 82%, and the output voltage was regulated at 1.8V within ${\pm}$3% tolerance.

• Journal of Power Electronics
• /
• 제17권2호
• /
• pp.315-322
• /
• 2017

LED is a promising new generation of green lighting with the advantages of high efficiency, good optical performance, long lifetime and environmental friendliness. A pulsating current can be used to drive LEDs. However, current with a high peak-to-average ratio is unfavorable for LEDs. A novel control scheme for the ac-dc critical conduction mode (CRM) flyback LED driver is proposed in this paper. By using the input voltage, output voltage and average output current to control the turn-on time of the switch, the peak-to-average ratio of the output current can be reduced. The operation principle is analyzed and an implementation circuit is put forward. Experimental results show the effectiveness of the proposed scheme.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 F
• /
• pp.2252-2254
• /
• 1997

There are increasing demands on high accruacy DC power supplies for varous basic science reseach, such as accelerators and plasma applications, in Korea. In this paper, we present a study on 1kW class DC power supply using the parell operation method of the flyback converters. This DC power supply is equipped with a remote controller for computer interface. A Serial Communication Controller(SCC) is also developed for large scale scientific facilities which is capable of handling upto 32 power supplies simultaneously with one serial port in the host computer.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 추계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.213-215
• /
• 2003

The continuing need for more compact and reliable switching power supplies have aroused a renewed interest in a well founded control technique the Magnetic Amplifier(Magamp). Magamp have some advantages of higher power density simple control circuit, good regulation, high frequency and high performance. The control method with magamp become attractive solutions for high current post regulated output applications. In this study, it is proposed that the magamp technique in flyback converters with multiple output windings. Operation principle of the proposed approach is described and a description of magamp control loop behavior is given first from a circuit level point of view. Then the focus is shifted to look at the same issue from the block diagram point of view. Experimental verifications on 50W multiple output flyback converter are conducted. Simulations and experimental results show that the proposed approach is high efficiency and voltage regulation of the auxiliary output is excellent.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.266-270
• /
• 2001

This paper presents a novel topological prototype of voltage source series quasi-resonant zero current soft-switching pulse frequency modulated dc-dc power converter circuit using IGBTs which incorporates a high-frequency flyback transformer link. Its steady-state operating principle is described on the basis of simulation analysis, along with the open loop controlled power regulation characteristics of the multi-functional coupled inductors linked dc-dc power converter operating under a principle of zero current soft switching commutation.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2005년도 춘계학술대회논문집
• /
• pp.467-472
• /
• 2005

In this paper, design and control of the novel SEPIC-Flyback converter(SF converter) is developed as a possible converter for fuel cell system. This output characteristic of SF converter is similar to Buck-Boost converter in that it can step-up or step-down the voltage. With the small signal equivalent circuit modeling of SF converter, control-to-output transfer function is obtained. SF converter couples up the inductive type converter to capacitive type converter with one transformer, which has less ripple current than its respective one does. To verify the validity of the proposed converter, 500W, 100kHz converter is designed and tested. ZVS switching and active clamping are also tested in practice.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2007년도 추계학술대회 논문집
• /
• pp.130-132
• /
• 2007

Recently, regulation for THD(Total Harmonic Distortion) such as IEC 61000-3-2, IEEE 519 is being reinforced about a product which directly connects to AC line in order to prevent distortion of common power source in electronic equipment and electrical machinery. In order to satisfy these regulations, conventional circuits were used two-stage structure attached power factor correction circuit at ahead of converter but this method complicate the circuit and then a number of element increases thereupon the cost of production rises. In this paper, we propose a high efficiency single-stage 300W PFC flyback converter, that improved power factor and efficiency than conventional two-stage power module.

• Journal of Power Electronics
• /
• 제7권4호
• /
• pp.301-309
• /
• 2007

The flyback converter is one of the most attractive isolated converters in small power applications because of its simple structure. However, it suffers from high device stress, large transformer size, and high voltage stress across its switch and diode. To solve these problems a new cost-effective PWM single-switch isolated converter is proposed. The proposed converter has no output filter inductor, reduced voltage stress on the secondary devices, and reduced transformer size. Moreover, the switch turn-off loss is reduced and no dissipative snubber across the secondary diode is required. Therefore, it features a simple structure, a low cost, and high efficiency. The operational principle and characteristics of the proposed converter are presented and compared with the flyback converter and then verified experimentally.

• Journal of Power Electronics
• /
• 제18권4호
• /
• pp.1007-1014
• /
• 2018

A novel dual DC-DC flyback converter with leakage-energy recycling is presented in this paper. Only an active switch is used for this converter. A pulse-width-modulation strategy is adopeted to control this switch. Two transformers are employed for the proposed converter. During the switch ON-period, the primary windings of the two transformers store energies. At the switch OFF-period, the energies stored in the primary windings of the two transformers are released to the output via the secondary windings of the two transformers. Meanwhile, the leakage energies of the two transformers can be recycled. The operating principles and steady-state analyses of the proposed converter are described in detail. A prototype circuit of the proposed converter is implemented for verifying the performances.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2017년도 추계학술대회
• /
• pp.43-44
• /
• 2017

This paper presents design of auxiliary circuit to reduce loss of ZVT interleaved flyback converter. The ZVT interleaved converter using the conventional auxiliary circuit has a large conduction loss due to the constant circulating current in the auxiliary circuit. The auxiliary circuit proposed in this paper, which consists of the coupled inductor and DC-link capacitor, has linearly increasing or decreasing auxiliary current. Then, the conduction loss occurring in the auxiliary circuit is reduced. The validity of the proposed auxiliary circuit is verified with the prototype of 500W.