• 한국측량학회지
• /
• 제31권6_1호
• /
• pp.471-481
• /
• 2013

최근 우리나라에서는 극한 강우 조건에서 발생하게 되는 토석류의 발생 빈도가 증가하고 있다. 본 논문에서는 유하부의 지형 특성에 따른 토석류 퇴적의 발생 특성을 분석하는 방법을 기술하였다. 먼저 토석류 발생 전후 비교적 근시기의 고해상도 LiDAR DEM을 차분하여 지형변화를 관측하고, 유하부 외부로의 퇴적이 관측되는 지점을 토석류의 관성으로 인해 토석류 이동이 진행된 지점으로 가정한 후, 이러한 퇴적이 발생하는 유하부의 지형 특성을 유로방향경사, 유하부의 이동 전환각도, 발생부로부터 해당 지점까지의 이동거리에 대한 표고차의 비율계수(L/H)로 표현되는 토석류의 순효율 계수 특성 항목을 이용하여 분석을 수행하였다. 이러한 방법을 2011년 7월 발생한 우면산 토석류 재해를 대상으로 하여 실험을 수행하였다. 실험결과 관성에 의한 토석류의 퇴적은 유하부의 전환각도와 큰 상관관계를 갖는 것으로 나타났으며, '전환각도/(L/H)'의 비율이 8 이상인 지점에서 관성에 의한 진행이 주로 발생함을 알 수 있었다.

• International Journal of Aeronautical and Space Sciences
• /
• 제17권1호
• /
• pp.8-19
• /
• 2016

This paper investigates the effects of inlet turbulence conditions and near-wall treatment methods on the heat transfer prediction of gas turbine vanes within the range of engine relevant turbulence conditions. The two near-wall treatment methods, the wall-function and low-Reynolds number method, were combined with the SST and ${\omega}RSM$ turbulence model. Additionally, the RNG $k-{\varepsilon}$, SSG RSM, and $SST_+{\gamma}-Re_{\theta}$ transition model were adopted for the purpose of comparison. All computations were conducted using a commercial CFD code, CFX, considering a three-dimensional, steady, compressible flow. The conjugate heat transfer method was applied to all simulation cases with internally cooled NASA turbine vanes. The CFD results at mid-span were compared with the measured data under different inlet turbulence conditions. In the SST solutions, on the pressure side, both the wall-function and low-Reynolds number method exhibited a reasonable agreement with the measured data. On the suction side, however, both wall-function and low-Reynolds number method failed to predict the variations of heat transfer coefficient and temperature caused by boundary layer flow transition. In the ${\omega}RSM$ results, the wall-function showed reasonable predictions for both the heat transfer coefficient and temperature variations including flow transition onset on suction side, but, low-Reynolds methods did not properly capture the variation of the heat transfer coefficient. The $SST_+{\gamma}-Re_{\theta}$ transition model showed variation of the heat transfer coefficient on the transition regions, but did not capture the proper transition onset location, and was found to be much more sensitive to the inlet turbulence length scale. Overall, the Reynolds stress model and wall function configuration showed the reasonable predictions in presented cases.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집E
• /
• pp.45-50
• /
• 2001

This experimental study concerns the characteristics of a transitional flow in a concentric annulus with a diameter ratio of 0.52, whose outer cylinder is stationary and inner one rotating. The pressure losses and skin-friction coefficients have been measured for the fully developed flow of a 0.2 % aqueous solution of sodium carbomethyl cellulose (CMC) at a inner cylinder rotational speed of $0{\sim}600$ rpm. The transitional flow has been examined by the measurement of pressure losses, to reveal the relation of the Reynolds numbers with the skin-friction coefficients, in the laminar and transitional flow regimes. The occurrence of transition has been checked by the gradient change of pressure losses and skin-friction coefficient with respect to the Reynolds numbers. The increasing rate of skin-friction coefficient due to the rotation is uniform for laminar flow regime, whereas it is suddenly reduced for transitional flow regime and, then, it is gradually declined for turbulent flow regime. Consequently, the critical(axial-flow) Reynolds number decrease as the rotational speed increases. Thus, the rotation of inner cylinder promotes the early occurrence of transition due to the onset of taylor vortices.

• Wind and Structures
• /
• 제11권3호
• /
• pp.221-240
• /
• 2008

The spanwise flow structure around a rigid smooth circular cylinder model in cross-flow has been investigated based on the experimental data obtained from a series of wind tunnel tests. Surface pressures were collected at five spanwise locations along the cylinder over a Reynolds number range of $1.14{\times}15^5$ to $5.85{\times}10^5$, which covered sub-critical, single-bubble and two-bubble regimes in the critical range. Separation angles were deduced from curve fitted to the surface pressure data. In addition, spanwise correlations and power spectra analyses were employed to study the spatial structure of flow. Results at different spanwise locations show that the transition into single-bubble and two-bubble regimes could occur at marginally different Reynolds numbers which expresses the presence of overlap regions in between the single-bubble regime and its former and later regimes. This indicates the existence of three-dimensional flow around the circular cylinder in cross-flow, which is also supported by the observed cell-like surface pressure patterns. Relatively strong spanwise correlation of the flow characteristics is observed before each transition within the critical regime, or formation of first and second separation-bubbles. It is also noted that these organized flow structures might lead to greater overall aerodynamic forces on a circular cylinder in cross-flow within the critical Reynolds number regime.

• Journal of Mechanical Science and Technology
• /
• 제14권3호
• /
• pp.358-368
• /
• 2000

The hydrodynamic stability of the Karman boundary-layer flow due to a rotating disk has been numerically investigated for moving disturbance waves. The disturbed flow over a rotating disk can lead to transition at much lower Re than that of the well-known Type I instability mode. This early transition is due to the excitation of the Type II instability mode of moving disturbances. Presented are the neutral stability results concerning the two instability modes by solving new linear stability equations reformulated not only by considering whole convective terms but by correcting some errors in the previous stability equations. The reformulated stability equations are slightly different with the previous ones. However, the present neutral stability results are considerably different with the previously known ones. It is found that the flow is always stable for a disturbance whose dimensionless wave number k is greater than 0.75.

• 한국전산유체공학회지
• /
• 제16권3호
• /
• pp.52-58
• /
• 2011

This study investigates the bifurcation sequence to chaos in a horizontal annulus with a constant heat flux wall. After the first Hopf bifurcation from a steady to a simple time-periodic flow with a fundamental frequency, quasi-periodic flows with two or three incommensurable frequencies appear. A reverse transition from a quasi-periodic flow to a simple periodic flow is observed with increase of Rayleigh number. And finally, chaotic convection is established after appearance of three incommensurable frequencies at a high Rayleigh number. Simple periodic flows exist between quasi periodic flows. The transition route to chaos of the present simulations follows the Ruelle-Takens route.

• 대한기계학회논문집B
• /
• 제21권2호
• /
• pp.252-263
• /
• 1997

Steady-state two-dimensional natural convective heat transfer in horizontal cylindrical annuli was studied by solving the governing equations based on the primitive variables. Emphasis was put on the occurrence of the multiple solutions at a given set of parameter values, and on the determination of the bifurcation points at which those multiple solutions begin to branch out. The multicellular flow pattern from the results of melting process in an isothermally heated horizontal cylinder for high Rayleigh numbers, was used as initial guesses for the field variables. This was succeeded in new bifurcation point to tetracellular solutions for an identical set of parameter variables of previous works. The close examination of flow pattern transition around bifurcation point was also conducted. It was found that the mechanisms of flow transition are different depending on the critical Rayleigh number of bifurcation point.

• EDISON SW 활용 경진대회 논문집
• /
• 제2회(2013년)
• /
• pp.360-364
• /
• 2013

본 연구에서는 아음속 저 레이놀즈 수에서 NACA0012에 나타난 층류 박리 거품과 천이유동에 대해 연구하였다. 천이유동조건과 완전난류유동 조건에 따른 EDISON 계산 결과 값과 실험값의 공력계수를 비교하였다. 또한, EDISON 계산 결과 값과 Xfoil을 이용하여 나온 결과 값의 천이점 비교를 통해 Xfoil의 천이 모델과 EDISON 천이 모델간의 차이를 비교하였다.

• Wind and Structures
• /
• 제30권5호
• /
• pp.475-483
• /
• 2020

This work investigates Reynolds number Re (= 50 - 200) effects on the flows around a single cylinder and the two tandem (center-to-center spacing L^⁎= L/D = 4) cylinders, each of a diameter D. Vorticity structures, Strouhal numbers, and time-mean and fluctuating forces are presented and discussed. For the single cylinder, with increasing Re in the range examined, the vorticity magnitude, Strouhal number and fluctuating lift all monotonically rise but time-mean drag, vortex formation length, and lateral distance between the two rows of vortices all shrink. For the two tandem cylinders, the increase in Re leads to the formation of three distinct flows, namely reattachment flow (50 ≤ Re ≤ 75), transition flow (75 < Re < 100), and coshedding flow (100 ≤ Re ≤ 200). The reattachment flow at Re = 50 is steady. When Re is increased from 75 to 200, the Strouhal number of the two cylinders, jumping from 0.113 to 0.15 in the transition flow regime, swells to 0.188. The two-cylinder flow is more sensitive to Re than the single cylinder flow. Fluctuating lift is greater for the downstream cylinder than the upstream cylinder while time-mean drag is higher for the upstream cylinder than for the other. The time-mean drags of the upstream cylinder and single cylinder behaves similar to each other, both declining with increasing Re.

• 한국실내디자인학회논문집
• /
• 제15권5호
• /
• pp.265-272
• /
• 2006

Traditionally exhibition design as been restricted to architectural, interior, and lighting design, but recently it has begun to overlap into environmental, performance, and installation art. Exhibition design also increasingly involves the application of film, fashion, and the new media. In the past, exhibits were arranged and displayed for the visitor to view directly, but with the development of more effective exhibit media a connection has been created between the exhibit and the visitor. However exhibition design has reached the limits of continuous growth without background theory, when now it must take Into consideration the museum's activation and the importance of the exhibition's design. Exhibition design has developed and grown rapidly since the Taejeon Expo in 1993, but it is a difficult development without a theoretical structure. The flow of exhibition design must be systemized, as the systemization of the transition process of exhibition design has not yet been achieved. This study aims to present an arrangement of exhibition design flow, and to investigate the variation factors in the transition process of exhibition design and exhibit medium development, based on the 18 year history of the Independence Hall that introduced the first systematic planning of an exhibition in 1987.