• Journal of Korean Society for Geospatial Information Science
• /
• v.25 no.2
• /
• pp.49-56
• /
• 2017

In this study, flood analysis was conducted to prepare for damage caused by typhoons and heavy rain due to abnormal climate and climate change. Two - dimensional flooding analysis using the FLUMEN model, which is widely used for national and international flood risk mapping, was conducted for the Nam River Basin, which is the tributary of the Nakdong River. This study divides the topography into $5m{\times}5m$ DEM by ArcView, so that the accuracy of river repair and hydrological characterization and flood area identification can be maximized. As a result of simulation of water flooding, 163.3ha in section 1, 227.7ha in section 2 and 59.9ha in section 3 were simulated.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.38 no.3
• /
• pp.395-406
• /
• 2018

The XP-SWMM model, widely used for inundation analysis of urban watersheds, underestimated the inundation area (range) because the manhole was regarded as a node and the influence of the local loss occurring in the surcharged manhole can not be considered. Therefore, it is necessary to analyze the applicability of the head loss coefficients considering the local loss in the surcharged manholes in inundation analysis using XP-SWMM. The Dorim 1 drainage section of the Dorim-river watershed, where frequent domestic flood damage occurred, was selected as the study watershed. The head loss coefficients of the surcharged manholes estimated from the previous experimental studies were applied to the inundation analysis, and the changes of the inundation area with and without the application of the head loss coefficients with manhole types were compared and analyzed. As a result of inundation simulation with the application of head loss coefficients, the matching rates were increased by 17% in comparison with the without application of them. In addition, the simulated inundation area applied only the head loss coefficients of straight path manholes and applied up to the head loss coefficients of combining manholes ($90^{\circ}$ bend, 3-way, and 4-way) were similar. Therefore, in order to accurately simulate the storm drain system in urban areas, it could be to carry out two-dimensional inundation analysis considering the head loss coefficients at the surcharged manholes. It was expected that the study results will be utilized as basic data for establishing the identification of the inundation risk area.

• Journal of Korean Society of Disaster and Security
• /
• v.15 no.2
• /
• pp.13-25
• /
• 2022

Public consent is essential to proceed with large-scale projects such as dam and hydroelectric power plant in the Carbon Neutral Era. In general, when designing facilities such as dams and river facilities, the impact due to constructing them is analyzed through numerical simulation in advance. Those facilities are built to cope with floods and usually HEC-RAS is used for numerical simulation in this process. The numerical simulation provides accurate data, but it is very difficult to persuade the public only with the data. Therefore, this study intends to consider the utilization of metaverse in the field of urban flooding and flood response. The applicability of metaverse was confirmed by emphasizing visual effects and providing easy-to-see data, using a kind of metaverse platform called Cities: Skylines. The functions and limitations of this platform were reviewed. A virtual flood scenario was applied after implementing real cities on a metaverse. The hazard map established in Korea and the results of applying the scenario of metaverse platform were compared. On the metaverse, not only the disaster situation caused by realizing the city and society as it is, but also the spread of social disasters after the disaster can be confirmed. Through this, countermeasures can be virtually implemented. If these social and humanistic data are also verified in the future, it is expected that the overall process for responding to urban flooding can be modeled.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.24 no.3
• /
• pp.299-309
• /
• 2006

In recent years, a large natural disasters have occurred due to worldwide abnormal weather and the amount of damage has been increased more resulting from high density population and a large-sized buildings of the urbanized area. In this study. we estimate the flooded area according to rainfall probability intensify and sea level in Woreong dong, Masan occurred flood damages by typhoon Maemi using SWMM, a dynamic rainfall-runoff simulation model in urban area, and then analyze the damage of flood expected area through connecting with GIS database. In result, we can predict accurately expected area of inundation according to the rainfall intensity and sea level rise through dividing the study area into sub-area and estimating a flooded area and height using SWMM. We provide also the shelter information available for urban planning and flood risk estimation by landuse in expected flood area. Further research for hazard management system construction linked with web or wireless communication technology expects to increase its application.

• Journal of Korea Water Resources Association
• /
• v.31 no.5
• /
• pp.515-528
• /
• 1998

A quasi-two-dimensional model for simulating the flood plain flow is developed. The model consists, in general, of a multiply-connected network which combines the main channel and two-dimensional flood plain cells. The main channel flow is described by the Saint Venant equations for one-dimensional unsteady flow, and the flood plain flow by the cell continuity and river-or weir-type stage-discharge relations between flood plain cells. The implicit algorithm for unsteady flow in looped channel network is extended to incorporate the flood plain flow. To verify the performance of the model, it is applied to three test problems, and sensitivities to various model parameters are analyzed. It turns out that the present model gives more accurate result than that by Cunge (1975) as the shape of cross section becomes more complex and irregular. Not only the inundation of water from the main channel but the return flow from the flood plain is successfully simulated.

• Journal of Korea Water Resources Association
• /
• v.49 no.6
• /
• pp.459-467
• /
• 2016

LISFLOOD-FP model in which channel flows are resolved separately from the floodplain flows using either a kinematic or diffusive wave approximation has been used to analyze flooding behavior on the lower Mankyung River influenced by backwater. A calibration and validation process was applied using the previous flood events to assess the model performance. Sensitivity analysis was conducted for main calibrated parameters, such as Manning roughness coefficient and downstream boundary condition. Also, we examined the effect of warm-up for the initial conditions. The results show that the computed hydrograph is in good agreement with measured data on the study reach, even though it was a hydrologic kinematic wave model. The sensitive analysis show that the difference between the computed results may be greater depending on the used calibrated parameters and that the sufficient calibration/validation process against various flood events is necessary. If the flood inundation simulation is performed using the validated model, it is expected to be able to contribute about river planning and policy decision-making for flood damage reduction.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.38 no.2
• /
• pp.261-268
• /
• 2018

The study used the simplified flooding analysis model, SIMOD, to distribute the total flood discharge by time, so research on flooding in urban areas can be conducted. The conventional flooding analysis models have limitations in constructing input data and take a long time for analysis. However, SIMOD is useful because it supports rapid decision-making process using quick modeling based on simple hydrological data, such as topography and inflow flood of the study area, to analyze submerged routes formed by flooding. Therefore, the study used the SIMOD model to analyze flooding in urban areas before conducting a comparative study with the outputs from FLO-2D, which is one of the conventional flooding analysis models, to identify the model's applicability. Seongseoje was selected as the study area, as it is located downstream the Geumho river where streams flow in the adjacent areas, and dikes are high enough to apply the "Overflow and Break" scenario for urban areas. With regard to topography, the study applied DEM data for the conventional flooding analysis and DSM data to represent urban building communities, distribution of roads, etc. Input flood discharge was calculated by applying the rectangular weir equation under the bank and break scenario through a 200-year return period of a design flood level. Comparative analysis was conducted in a flooded area with a simulation time of 1-24 hours. The time for the 24-hour simulation in SIMOD was less than 7 minutes. Compared with FLO-2D, the difference in flooded areas was less than 20%. Furthermore, the study identified the need for topography data using DSM for urban areas, as the analysis result that applies DSM showed the influence of roads and buildings.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.2
• /
• pp.1149-1156
• /
• 2014

In order to reduce flood damages, there should demand an appropriate design such as enlarging a bank, dredging a river bottom, building a hydraulic structure and so on. The installation locations about the Watergate are listed of the seven provisions in the river design standard, but it is not detailed. In order to compute proper place considering landuse and basin characteristics of inlands, internal inundation modeling that should be performed is regarded with quantitative evaluation. Anyway, that is very complex and taking a long time because that has to consider hydraulic and hydrologic characteristics. In the current study, therefore, the simple and convenient method for internal inundation modeling was proposed to overview the Watergate location.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.27 no.6
• /
• pp.723-731
• /
• 2009

Recently, it has been strangely increasing rainfall and rainfall meter by global warming. so flood damage is being increase. It has happened there are so many damaged by influence by backwater of dam. However, the alleviative solutions of flood damages are focused on the lower river basin where the density of population is higher than upper river basin. This research proceeds based on design and build 3D topography model and reflects the topographical factors of upper river basin. It also simulated the circumstances of flooding by investigation of factors of outflow, hence, as a result, we would find out the vulnerable area for flooding and scale of damages effectively. This research suggests the solution and method of flooding for vulnerable area of the flooding to reduce the damages by predicting flooding. Thus, the suggestion may support to make a decision efficiently to prevent the damage of flooding.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.18 no.2
• /
• pp.1-15
• /
• 2015

Urban flooding threatens human beings and facilities with chemical and physical hazards since the beginning of human civilization. Recent studies have emphasized the integration of data and models for effective urban flood inundation modeling. However, the model set-up process is tend to be time consuming and to require a high level of data processing skill. Furthermore, in spite of the use of high resolution grid data, inundation depth and velocity are varied with building treatment methods in 2-D inundation model, because undesirable grids are generated and resulted in the reliability decline of the simulation results. Thus, it requires building generalization process or enhancing building orthogonality to minimize the distortion of building before converting building footprint into grid data. This study aims to develop building generalization method for 2-dimensional inundation analysis to enhance the model reliability, and to investigate the effect of building generalization method on urban inundation in terms of geographical engineering and hydraulic engineering. As a result to improve the reliability of 2-dimensional inundation analysis, the building generalization method developed in this study should be adapted using Digital Building Model(DBM) before model implementation in urban area. The proposed building generalization sequence was aggregation-simplification, and the threshold of the each method should be determined by considering spatial characteristics, which should not exceed the summation of building gap average and standard deviation.