• Electrical & Electronic Materials
• /
• v.8 no.5
• /
• pp.626-632
• /
• 1995

In this paper, The effect of the impedances in SNOSFET's memory devices has been developed. The effect of source and drain impedances measured by means of two bias resistances - field effect bias resistance by inner region, external bias resistance. The effect of the impedances by source and drain resistance shows the dependence of the function of voltages applied to the gate. It shows the differences of change in source drain voltage by means of low conductance state and high conductance state. It shows the delay of threshold voltages. The delay time of low conductance state and high conductance state by the impedances effect shows 3[.mu.sec] and 1[.mu.sec] respectively.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.56 no.1
• /
• pp.6-12
• /
• 2007

In this paper, an robust adaptive backstepping controller is proposed for the speed control of separately excited DC motor in pure electric vehicles. A general electric drive train of PEV is conceptually rearrange to major subsystems as electric propulsion, energy source, and auxiliary subsystem and the load torque is modeled by considering the aerodynamic, rolling resistance and grading resistance. Armature and field resistance, damping coefficient and load torque are considered as uncertainties and noise generated at applying load torque to motor is also considered. It shows that the backstepping algorithm can be used to solve the problems of nonlinear system very well and robust controller can be designed without the variation of adaptive law. Simulation results are provided to demonstrate the effectiveness of the proposed controller.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.24 no.10
• /
• pp.85-89
• /
• 2010

During a ground fault the maximum fault current and neutral to ground voltage will appear at the pole nearest to the fault. Distribution lines are consisted of three phase conductors, an overhead ground wire and a multi-grounded neutral line. In this paper phase to neutral faults were staged at the specified concrete pole along the distribution line and measured the ground fault current distribution in the ground fault current, three poles nearest to the fault point, overhead ground wire and neutral line. A effect by grounding resistance of poles of ground fault current in the 22.9[kV] multi-ground distribution system. by field tests.

• Proceedings of the KIEE Conference
• /
• 2003.07c
• /
• pp.1858-1860
• /
• 2003

Ground rods as the discharge path are commonly installed to ensure the safety of human beings and facilities from the surge. Accordingly, proper grounding resistance are specified by the grounding types, and the specified resistance are also required to install the lightning protective facilities. it is needed to analyze the difference between these two resistance through the field test. Therefore, in this paper, the impulse response behavior of the ground rods is analyzed by constructing the test facilities and by testing the ground rods in multi-ground power distribution systems. The impulse responses were analyzed, in transient state, by testing the concrete poles as well since the grounding wires are installed in the concrete poles.

• Journal of Microbiology and Biotechnology
• /
• v.18 no.5
• /
• pp.942-945
• /
• 2008

There have been concerns about possible pathogenicity and antimicrobial resistance in Enterococcus, which constitute more than 50% of probiotics in the worldwide market. In this study, Enterococcus in sixteen products manufactured by ten different companies was tested for the presence of six virulence genes and two vancomycin resistance genes. Results in this study showed the safety of Enterococcus on the Korean market and the importance of screening vanA, vanE, agg, cylA, esp, and gelE. Pulse-field gel electrophoresis showed that the sixteen isolates tested in this study are originated from three strains.

• Transactions on Electrical and Electronic Materials
• /
• v.18 no.4
• /
• pp.195-198
• /
• 2017

This research analyzed the electrical characteristics of an 80 V optimal trench power MOSFET (metal oxide field effect transistor) for mobile applications. The power MOSFET is a fast switching device in fields with low voltage(<100 V) such as mobile application. Moreover, the power MOSFET is a major carrier device that is not minor carrier accumulation when the device is turned off. We performed process and device simulation using TCAD tools such as MEDICI and TSUPREM. The electrical characteristics of the proposed trench gate power MOSFET such as breakdown voltage and on resistance were compared with those of the conventional power MOSFET. Consequently, we obtained breakdown voltage of 100 V and low on resistance of $130m{\Omega}$. The proposed power MOSFET will be used as a switch in batteries of mobile phones and note books.

• Journal of the Korean Society of Tobacco Science
• /
• v.16 no.1
• /
• pp.57-64
• /
• 1994

Burley tobacco (Nicotiana tabacum L.) KB 108 was developed from a single cross between KB 104 and TC 591 which was developed from a cross between Burley 49 and Tobacco Introduction 1406. It was tested for its resistance to black shank, potato virus Y(PVY), TMV and agronomic characteristics under field conditions. KB 108 has resistance to tobacco mosaic virus(TMV) and necrotic strain of potato virus Y(PVY-VN) with secreting glandular trichomes. It has also moderate resistance to black shank caused by phytophthora parasitica val. Nicotianae. KB 108 has an up-right plant growth habit similar to Burley 21. It flowers about 1-2 days later than Burley 21. The leaf width and length of KB 108 are approximately 3 cm wider and longer than those of Burley 21. The yield of KB 108 was higher 4%, nearly equal in value per kg compared to Burley 21.

• Journal of the Korean institute of surface engineering
• /
• v.36 no.4
• /
• pp.339-346
• /
• 2003

Stainless steel wire has been used in industry, dental and medical parts. Especially, it has been used widely for the dental orthodontic materials. The orthodontic wire requires good mechanical properties, such as elastic strength, combined with a high resistance to corrosion. To increase elastic strength and good corrosion resistance, drawing methods(one-step and two-step drawing) have been used and the electrochemical characteristics of drawed wire have been researched using potentiodynamic method in 0.9％NaCl and field emission scanning electron microscope. The one-step drawed wire showed the formation of rough surface. The hardness and tensile strength of two-step drawed wire increased. For the case of two-step drawed wire, the corrosion resistance and pitting potential increased compared with one-step drawed wire due to the drawing induced small surface roughness, such as scratch. The passivation and active current density decreased as the reduction in area for drawing increased.

• Journal of the Microelectronics and Packaging Society
• /
• v.26 no.1
• /
• pp.1-7
• /
• 2019

Recently, memristor (anion-based memristor) is referred to as the fourth circuit element which resistance state can be gradually changed by the electric pulse signals that have been applied to it. And the stored information in a memristor is non-volatile and also the resistance of a memristor can vary, through intermediate states, between high and low resistance states, by tuning the voltage and current. Therefore the memristor can be applied for analogue memory and/or learning device. Usually, memristive behavior is easily observed in the most transition metal oxide system, and it is explained by electrochemical migration motion of anion with electric field, electron scattering and joule heating. This paper reports the latest trends and issues of anion-based memristor.

• Geomechanics and Engineering
• /
• v.30 no.4
• /
• pp.337-343
• /
• 2022

The electrical resistivity method is a well-known geophysical method for observing underground conditions, (such as anomalies) and the properties of soil and rock (such as porosity, saturation, and pore fluid characteristics). The shape of electrodes used in an electrical resistivity survey depends on the purpose of the survey and installation conditions. Most electrodes for field applications are cylindrical for sufficient contact with the ground, while some are conically sharpened at their tips for convenient penetration. Previous study only derived theoretical equations for rod-shaped electrodes with spherical tips. In this study, the theoretical resistance for two cylindrical electrodes with conical tips is derived and verified experimentally. The influence of the penetration depth and tip on the measurement is also discussed.