• 품질경영학회지
• /
• 제27권4호
• /
• pp.241-255
• /
• 1999

This paper concerns Reliability Analysis System(RAS) developed by LG Electronics, Inc. for collecting, classifying, and analyzing field failure data. To develop this system, a database for the management of field failure data was built and several functions were included to analyze and assess the product reliability. Nonparametric estimation and cumulative hazard plotting techniques were applied to estimate the reliability for a specific period. This system serves not only engineers in charge of quality but also designers who wish to monitor the reliability of their own products.

• Neonatal Medicine
• /
• 제17권2호
• /
• pp.168-180
• /
• 2010

Acute renal failure (ARF) is common in the neonatal period, however, there are no uniform treatment strategies of ARF. The main treatment strategies are conservative management including medical treatment and the renal replacement therapy. Because ARF in the newborn is commonly acquired by hypoxic ischemic injury and toxic insults, removal of all the offending causes is important. Aminoglycoside, indomethacin, and amphotericin-B are the most common nephrotoxic drugs of ARF. To relieve the possible prerenal ARF, initial fluid challenge can be followed by diuretics. If there is no response, fluid restriction and correction of electrolyte imbalance should begin. Adequate nutritional support and drug dosing according to the pharmacokinetics of such drugs will be difficult problems. Renal replacement therapies may be provided by peritoneal dialysis, intermittent hemodialysis, or hemofiltration. New promising agents, bioartificial kidney, and stem cell will enable us to extend our therapeutic repertoire.

• 산업경영시스템학회지
• /
• 제17권32호
• /
• pp.227-232
• /
• 1994

In the performance domain, physical performance is a measure that represents some degree of system, subsystem, component or device success in a continuous sense, as opposed to a classical binomial sense (success or failure). If applicable sensing and monitoring means exist, physical performance can be observed over time, along with explanatory variables or covariables. Performance-based reliability represents the probability that performance will remain satisfactory over a finite period of time or usage cycles in the future when a performance critical limit (which represents an appropriate definition of failure in terms of performance) is set at a fixed level, based on application requirements. In the case of inadequate knowledge of the failure mechanics, this physical based empirical modeling concept along with performance degradation knowledge can serve as an important analysis tool in reliability work in product and process improvement.

• 산업경영시스템학회지
• /
• 제24권69호
• /
• pp.1-12
• /
• 2001

In this paper, the consumable concurred spare parts requirement determination problem of newly procured equipment systems is considered. The problem is formulated as the operational availability maximization problem with any given fund limitation. the that the failure of a part follows a Poisson process and part failure rate is constant in spite of the decrease of number of equipments during operational period, an analytical method is developed to obtain spare part requirements using the generalized Lagrange multipliers method, The numerical examples show that analytic solution is mostly equal to the realistic solution obtained from simulation regardless of assumptions about part failure rate. It is expected that the analytical method developed in the paper can be effectively used to make a budget for provisioning the concurrent spare parts of newly procured equipment system.

• International Journal of Reliability and Applications
• /
• 제4권2호
• /
• pp.79-95
• /
• 2003

Manufacturers collect and analyze field reliability data to enhance the quality and reliability of their products and to improve customer satisfaction. To reduce the data collecting and maintenance costs, the amount of data maintained for evaluating product quality and reliability should be minimized. With this in mind, some industrial companies assemble warranty databases by gathering data from different sources for a particular time period. This “marginal count failure data” does not provide (i) the number of failures by when the product entered service, (ii) the number of failures by product age, or (iii) information about the effects of the operating season or environment. This article describes a method for estimating age-based claim rates from marginal count failure data. It uses covariates to identify variations in claims relative to variables such as manufacturing characteristics, time of manufacture, operating season or environment. A Poisson model is presented, and the method is illustrated using warranty claims data for two electrical products.

• 한국국방경영분석학회지
• /
• 제18권1호
• /
• pp.110-127
• /
• 1992

In the preventive replacement policies of system that the failure can be detected through only periodic inspection, there is a penalty cost associated with the lapsed time between system failure and its detection. The system under study is replaced if the system fails before $n^{th}$ inspection, otherwise, preventive replacement is performed at the $n^{th}$ inspection. The decision variables are the inspection interval and the period of preventive replacement. This study presents the optimal preventive replacement policy that minimizes the long-run expected cost per unit time.

• 한국산업융합학회 논문집
• /
• 제12권4호
• /
• pp.209-214
• /
• 2009

Usually, it says that reliability is failure rate achieved by required functions for some period under limited use environment conditions. The reliability can be researched by automotive part or system module and it can be affected by using environment condition, such as using atmosphere temperature and using user's behavior. Also, the time can be influence on the reliability. Recently, the oil leakage from eng oil pan was raised by customer in the field. So, there is the purpose of this paper that research predicting the reliability of eng oil pan efficiently by using reliability method described below.

• 산업경영시스템학회지
• /
• 제19권39호
• /
• pp.89-98
• /
• 1996

This paper is concerned with cost analysis model in free -replacement policy under the periodic maintenance policy The free-replacement policy with minimal repairable item is considered as follows; in a manufacturer's view point operating unit is periodically replaced, if a failure occurs between minimal repair and periodic maintenance time, unit is remained in a failure condition. Also unit undergoes minimal repair at failures in minimal-repair interval. Then total expected cost per unit time is calculated according to maintenance period Tin a viewpoint of consumer's. The expected costs are included repair cost and usage cost: operating, fixed, minimal repair and loss cost. Numerical example is shown in which failure time of item has beta distribution.

• 대한약학회:학술대회논문집
• /
• 대한약학회 2003년도 Proceedings of the Convention of the Pharmaceutical Society of Korea Vol.1
• /
• pp.274.1-274.1
• /
• 2003

To elucidate the effect of bioconversioned ginseng(Sun ginseng) and its butanol fraction on adenine-induced renal failure. rats were fed ad libitum on diet containing 0.75％ adenine for 20 days to induce renal failure, and bioconversioned ginseng was orally administrated during the feeding period. On days 10 and 20, BUN, Creatinine, Ca and P contents were analyzed in serum and urine, and on days 20, BUN, Creatining, Ca and P contents were analyzed in serum and urine, and on days 20, blood pressure, hear pulse and relative kidney weight were measured. (omitted)

• 한국농공학회논문집
• /
• 제56권6호
• /
• pp.63-73
• /
• 2014

In this study, the large scale test was performed to investigate the behavior of failure on the embankment and spillway transitional zone by overtopping. The pore water pressure, earth pressure, settlement and failure behaviors according to several reinforcing method were compared and analyzed. The pore water pressure showed a small change in the spillway transition zone and core, indicating that the riprap and geotextile efficiently reinforced the embankment, but non-reinforcement showed a largely change in pore water pressure. The earth pressure by riprap and geotextile at upstream slope and bottom core increased rapidly with the infiltration of the pore water by overtopping. And the earth pressure at crest showed a smally change due to effect of the inclined core. A settlement by riprap showed a small change and the geotextile decreased a rapidly due to failure of crest. The width of failure by riprap at intermediate stage (50 min) showed a largely due to sliding of crest. But, the width and depth of the seepage erosion after the intermediate overtopping period (100 min) were very small due to the effect of riprap than geotextile and non-reinforcement which delayed failure. It has the effect that protect reservoir embankment from erosion in the central part. The pore water pressure at the spillway transition zone due to overtopping increased a rapidly in the case of non-reinforcement, but the reinforced methods by geotextile and riprap showed a smally change. Therefore, the reinforced method by riprap and geotextile was a very effective method to protect permanently and the emergency an embankment due to overtopping, respectively.