• KSBB Journal
• /
• 제25권4호
• /
• pp.371-378
• /
• 2010

For the biodiesel fuel production from microalgae, the lipid from wet and dry samples of green algae Scenedesmus sp. was extracted by using various solvents and pre-treatment methods. Extraction yield of the lyophilized sample was better than that of dry sample. Chloroform/methanol (2:1, v/v) and ultrasonication or homogenization method were also selected as the most effective solvent and pre-treatment methods for lipid extraction, respectively. Under these constraint conditions, optimization experiment of lipid extraction was investigated by Taguchi approach using orthogonal matrix $L_9$ ($3^4$) method. The optimum extraction conditions of lipid extraction was obtained at pre-treatment of homogenization, extraction time of 5 hour, temperature of $35^{\circ}C$, and solvent ratio of 1:20 (w/v). Yield of extraction at optimized condition was 20.55% and it was 96% of total lipid content (21.38%) of Scenedesmus sp.

• Bulletin of the Korean Chemical Society
• /
• 제23권10호
• /
• pp.1381-1391
• /
• 2002

The solvent sublation using ion pairs of metal-2-naphthoate(2-HNph) and tetrabutyl ammonium ($TBA^+$) ion has been studied for the concentration and determination of ultra trace Bi(III), In(III) and Tl(Ⅲ) ions in water samples. The partition coefficients ($K_p$) and the extraction percentages of 2-HNph and the ion pairs to methyl isobutyl ketone (MIBK) were obtained as basic data. After the ion pair $TBA^+$·M$(Nph)_4^-$ was formed in water samples, the analytes were concentrated by the solvent sublation and the elements were determined by GF-AAS. The pH of the sample solution, the amount of the ligand and counter ion added and stirring time were optimized for the efficient formation of the ion pair. The type and amount of optimum surfactant, bubbling time with nitrogen and the type of solvent were investigated for the solvent sublation as well. 10.0 mL of 0.1 M 2-HNph and 2.0 mL of 0.1 M $TBA^+$ were added to a 1.0 L sample solution at pH 5.0. After 2.0 mL of 0.2%(w/v) Triton X-100 was added, the ion pairs were extracted into 20.0 mL MIBK in a flotation cell by bubbling. The analytes were determined by a calibration curve method with measured absorbances in MIBK, and the recovery was 80-120%.

• Bulletin of the Korean Chemical Society
• /
• 제29권1호
• /
• pp.99-103
• /
• 2008

Solvent extraction using salphen as a ligand has been investigated for the selective separation and determination of trace Fe(II) and Fe(III). A salphen ligand was synthesized, and solvent extraction variables, such as solution pH, the concentration of salphen, the type of organic solvent, auxiliary agents, oxidants and the effect of interference were optimized. Salphen is stable at pH 3-4, and Fe(III)-salphen complexes can be selectively extracted into an MIBK(4-methyl-2-pentanone) phase from an aqueous solution within this pH range. For the determination of the total amount of iron in 100 mL of aqueous solution, Fe(II) ions were completely oxidized using 0.05 mL of 3.5% H2O2 without side reactions. To evaluate its applicability, the proposed method was applied to determine trace Fe(II) and Fe(III) in several kinds of water samples. Reproducible results were obtained with RSD of less than 3.0%, and the recoveries for this reliability were obtained with 91-112%.

• Plant Resources
• /
• 제6권3호
• /
• pp.221-226
• /
• 2003

To improve industrial scale extraction method for extraction of icariin from Epimedium koreanum Nakai, the yields under different extracting conditions such as solvent, temperature, duration and solvent to plant material weight ratio were compared. Regarding extracting solution, highest extracts and icariin yield could be achieved when 10% EtOH was used. In case of plant material to extracting solvent ratio, no significant differences could be observed from 1/10 to 1/50, indicating 1/10 was the most efficient. Extracting temperature significantly affected extracts and icariin yields in that 9$0^{\circ}C$ increased the collected extracts and icariin contents up to 29.6% and 0.76%, respectively, compared to 27.2%, 0.33% at 7$0^{\circ}C$. The yield of extracts was less dependent upon extracting temperature compared to icariin yield. Regarding extraction time, 4 hr and 6 hr resulted in high extracts and icariin yield, respectively. We found extracting Epimedium koreanum Nakai in 10 times volume of 10% EtOH for 4 and 6 hr at 9$0^{\circ}C$ seem to be relatively efficient methods for extracts and icariin, respectively.

• 대한화학회지
• /
• 제53권4호
• /
• pp.427-431
• /
• 2009

대두 잔기로부터 유기용매를 사용하여 이소플라본을 추출하는 열역학적 메카니즘을 조사하였다. 대두 잔기로부터 유기용매를 사용한 이소플라본 추출과정에서의 분배 계수를 결정하기 위한 간단한 모델을 설정하고 $K,\;{\Delta}H^0,\;{\Delta}S^0\;and\;{\Delta}G^0$ 간에 열역학적 함수를 계산하였다. 그 결과 대두 이소플라본 추출은 흡열과정이며 엔트로피 증가과정임을 발견하였다. 온도가 증가할수록 ${\Delta}G^0$가 감소하였다.

• 한국환경과학회지
• /
• 제12권1호
• /
• pp.81-86
• /
• 2003

The study was carried out to evaluate the new analytical method of phthalate esters(diethylphthalate, di-n-butylphthalate, butylbenzylphthalate, bis(2-ethylhexyl)phthalate), one of the endocrine disruptors, which were performed by GC/MS-SIM(selected ion monitoring). The phthalate esters were extracted from water samples using solid-phase extraction on $C_{18}$ columns. It investigated that the extraction recovery rate of phthalate esters with different solvents and solvent volume. The optimal solvent was dichloromethane and proper volume of dichloromethane for recovery of phthalate esters was 4 mL. There were good linearities(above $R^2$=0.9975) in the range 0.01~0.50mg/L, and the detection limits were below 0.01~0.03$\mu\textrm{g}$/L. The recovery rates, RSD and MDLs for phthalate esters were 80~114%, 5.0~8.1% and 0.03~0.11$\mu\textrm{g}$/L, respectively. This method shows a good precision of phthalate esters.

• 대한약침학회지
• /
• 제21권2호
• /
• pp.48-60
• /
• 2018

Objective: The aim of this study is to optimize the extraction of beneficial substance from Cudrania tricuspidata leaves grown at Jirisan Mountain in South Korea by three different solvents depending on extraction time and at different temperature. Methods: The total phenolic contents were determined by the method reported by $S{\acute{a}}nchez$-Moreno et al. The total flavonoid contents were analyzed by Slinkard and Singleton. The DPPH radical scavenging activity was determined according to the method reported by Blois Results: The extraction yield for each solvent is 9.05-14.1%, 2.17-5.67%, and 2.3-3.9% for D.W., ethanol, and hexane, respectively. The overall results were maximized for the extract obtained with D.W. for 5 min at $100^{\circ}C$. The average phenol contents were 77.11, 45.64, and 0.343 mg/g at $100^{\circ}C$ in water, $78^{\circ}C$ in ethanol, and $68^{\circ}C$ in hexane, respectively. The flavonoid contents were the highest in the materials extracted with D.W., and were increased with increasing temperature, regardless of the extraction solvents, whether water (green), polar organic ethanol, or nonpolar organic hexane. In the ethanol extract, the flavonoid contents are increased gradually from 5.66 mg/g to 7.73 mg/g. The total flavonoid contents were proportional to the concentrations of the water extracts, ranging from 4.14 mg/g to 48.89 mg/g. The antioxidative activities of the water-extracted compounds are generally increased with increasing temperature from 42.5% to 85.5%. Those of the hexane extracts are increased slowly from 3.79% to 8.8%, while those of ethanol extracts are increased from 29.8% to 47.4%. Conclusion: The extraction yields were dependent upon solvents for extraction as well as extraction time and the temperature. The optimal extraction time was 5 min and the extraction yields were increased with increasing temperature excepted hexane. Of the three tested extraction solvents, the greenest solvent of water shows excellent results, suggesting that water is among the most effective solvents for natural sample extractions for general medicinal, pharmaceutical, and food applications.

• Korean Chemical Engineering Research
• /
• 제46권5호
• /
• pp.965-970
• /
• 2008

접촉분해경유의 산화반응후 포함된 산화황화합물을 분리하기위해 다양한 용매를 사용하여 용매추출에 관한 연구를 수행하였다. 용매로는 극성을 가진 물, N-메틸피놀리논, 에틸아세테이트, 디메틸포름아마이드, 이소프로필알코올, 아세토니트릴, 메탄올등을 사용하였다. 실험결과, 접촉분해경유와 용매와의 층분리는 적절한 양의 물을 첨가한 경우에 이루어졌으며, 물과 N-메틸피놀리논을 혼합한 혼합용매가 접촉분해경유로부터 산화황화합물의 선택적인 분리에 가장 적절하였다. 또한 접촉분해경유로부터 황화합물을 99.5% 이상으로 제거하기 위해선, 4단 정도의 평형추출이 필요하였다.

• 대한약학회:학술대회논문집
• /
• 대한약학회 2003년도 Proceedings of the Convention of the Pharmaceutical Society of Korea Vol.1
• /
• pp.299.2-300
• /
• 2003

Various bupivacaine-Ioaded microspheres were prepared with poly (d,l-Iactide) (PLA) by solvent extraction method. The internal solution of polymer(PLA R104) and drug in glacial acetic acid was introduced into the external phase of polyvinylpyrrolidone (PVP K-30) in polyethyleneglycol (PEG), and emulsified to be an oil-in-oil (o/o) emulsion. The o/o emulsion was poured to the buffer solution. (omitted)

• Archives of Pharmacal Research
• /
• 제23권4호
• /
• pp.385-390
• /
• 2000

To demonstrate the effect of formulation conditions on the controlled release of protein from poly(lactide-co-glycolide) (PLGA) microspheres for use as a parenteral drug carrier, ovalbumin (OVA) microspheres were prepared using the W/O/W multiple emulsion solvent evaporation and extraction method. Methylene chloride or ethyl acetate was applied as an organic phase and poly(vinyl alcohol) as a secondary emulsion stabilizer. Low loading efficiencies of less than 20％ were observed and the in vitro release of OVA showed a burst effect in all batches of different microspheres, followed by a gradual release over the next 6 weeks. Formulation processes affected the size and morphology, drug content, and the controlled release of OVA from PLGA microspheres.