• Journal of the Korean Solar Energy Society
• /
• v.25 no.4
• /
• pp.69-76
• /
• 2005

The performance of water-to-water heat pump system coupled with the ground source vertical heat exchanger is presented in this paper. The CAP program of Florida Heat Pump Co. is used to predict the heat pump performances while the EED program calculates the borehole fluid temperature. It is shown that COPH increases with decreasing the temperature of output water for the operation of heating mode and COPR increases with increasing temperature of output water for the operation of cooling mode. The value of specific heat extraction rate must be moderate to insure the reasonable installation cost of borehole system. With $1^{\circ}C$decrease of $T_{wo}$ the average COPH increase is estimated as about $0.06/^{\circ}C$(for $T_{wo}\;=\;45{\sim}60^{\circ}C$ range) while with $1^{\circ}C$ increase of $T_{wo}$ the estimation of COPR increase is about $0.13/^{\circ}C$(for $T_{wo}\;= \;5{\sim}11^{\circ}C$ range) at the specific heat extraction rate of 30W/m.

• International Journal of Control, Automation, and Systems
• /
• v.2 no.2
• /
• pp.201-206
• /
• 2004

Counters for the various kinds of banknotes require high-speed distinctive point extraction and recognition. In this paper we propose a new point extraction and recognition algorithm for Euro banknotes. For distinctive point extraction we use a coordinate data extraction method from specific parts of a banknote representing the same color. To recognize banknotes, we trained 5 neural networks. One is used for inserting direction and the others are used for face value. The algorithm is designed to minimize recognition time by using a minimal amount of recognition data. The simulated results show a high recognition rate and a low training period. The proposed method can be applied to high speed banknote counting machines.

• Applied Chemistry for Engineering
• /
• v.34 no.4
• /
• pp.426-433
• /
• 2023

Capacitor performance was considered using coffee grounds-based activated carbon produced through oil extraction and KOH activation to increase the utilization of boiwaste. Oil extraction from coffee grounds was performed by solvent extraction using n-Hexane and isopropyl alcohol solvents. The AC_CG-Hexane/IPA produced by KOH activation after oil extraction increased the specific surface area by up to 16% and the average pore size by up to 2.54 nm compared to AC_CG produced only by KOH activation without oil extraction. In addition, the pyrrolic/pyridinic N functional group of the prepared activated carbon increased with the extraction of oil from coffee grounds. In the cyclic voltage-current method measurement experiment, the specific capacitance of AC_CG-Hexane/IPA at a voltage scanning speed of 10 mV/s is 133 F/g, which is 33% improved compared to the amorphous capacity of AC_CG (100 F/g). The results show improved electrochemical properties by improving the size and specific surface area of the mesopores of activated carbon by removing components from coffee grounds oil and synergistic effects by increasing electrical conductivity with pyrrolic/pyridinic N functional groups. In this study, the recycling method and application of coffee grounds, a bio-waste, is presented, and it is considered to be one of the efficient methods that can be utilized as an electrode material for high-performance supercapacitors.

• Journal of the Korean GEO-environmental Society
• /
• v.14 no.11
• /
• pp.25-31
• /
• 2013

Civil and military firing ranges are usually contaminated with heavy metals such as lead and copper and remediation is required. Acid washing and extraction are common remediation methods. Lead contaminated firing range soil samples were collected and a preliminary study was conducted to evaluate the characteristics of the contamination and the contribution of high specific gravity particles. Ethylenediamine tetra acetic acid(EDTA) extraction was applied for the removal of heavy metal but the extraction was not feasible for the firing range soil. Even after the repeated EDTA extraction, the contamination were still over the Korean environmental standard indicating that soil particles highly contaminated with heavy metal which release the heavy metal ion even after the repeated extraction. Some colored and higher specific gravity particles were separated from the soil samples and analyzed. The colored particles have specific gravity of 2.5-6.6. The saturation ratio of Pb and EDTA was 4.9-32%. After removal of these colored particles, the sandy soil showed moderate contamination which can be treated with soil washing. This was proved with the five-level sequential extraction and TCLP tests.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.1
• /
• pp.85-93
• /
• 2011

The structural components of microorganism are quite related to the toxin and environmental conditions. The vegetative and dormant cells are quite affected by the physical and chemical environments to survive and they will be dormant when they are in the extreme environment. The mechanism to activate the microorganisms however, is not well defined yet in the area of activation state and sporulation state through the analysis of EPS. Other than that even the main mechanism of prior to acquisition of analysis values is not well understood. Therefore, what kind of specific environment to affect the activation and sporulation will be discussed through the analysis of the extracellular polymeric substances(EPS). EPS are a high molecular weight mixture of polymers presenting both outside of cells and interior of microbial aggregates. They are a major complex materials in microbial aggregation for sustaining them together in a three dimensional matrix. Three commonly used extraction methods were applied to this study their effectiveness and quantification in extracting EPS from several Bacillus microorganisms and activated sludge. Three extraction methods used for this study are regular centrifugation with formaldehyde (RCF), Steaming, and EDTA extraction. The results of EPS contents such as the quantitative proteins, carbohydrates and the ratio of protein versus carbohydrate from the several species with the several specific methods showed in this research. This study aims to get comparable results of the quantitative production of EPS and the effectiveness of sedimentation for Bacillus microorganisms and activated sludge from several wastewater treatment plans. The results revealed that the protein amount extracted was the highest by the Steaming method of three extraction methods before sporulation and the carbohydrate amount extracted was the highest by the RCA method of three extraction methods after sporulation. The higher amount of protein compared with carbohydrate from Bacillus microorganisms affected higher sedimentation efficiency, however it could not be found the relation between the EPS production and sedimentation efficiency for the activated sludge.

• Journal of Microbiology and Biotechnology
• /
• v.14 no.2
• /
• pp.284-289
• /
• 2004

A PCR assay for the rapid detection of Vibrio vulnificus strains was developed using a virulence gene for elastase found in various Vibrio species. The DNA sequences in the elastase gene facilitated the identification of a species-specific probe for pathogenic V. vulnificus strains from both clinical and environmental sources. Using an elastase gene-based PCR reaction, a species-specific 507-bp PCR product was visualized by agarose gel electrophoresis. Three different DNA extraction methods were then compared to improve the simplicity and rapidity of detection. A PCR assay using the conventional DNA extraction or boiling method was able to detect as few as 25 V. vulnificus cells, making the detection limits at least 1-log-scale lower than that for the EDT A-treated DNA extraction method. In particular, the boiling method, which does not require purification of the chromosomal DNA, was very effective in terms of simple and rapid detection. Meanwhile, the detection limit in a mixed bacterial culture that included other bacteria, such as Escherichia coli or Bacillus subtilis, was two V. vulnificus cells, which was 1-log-scale lower than that for the control. Accordingly, when coupled with a new DNA extraction method, the elastase gene-based PCR can provide a rapid, specific, and sensitive method for identifying V. vulnificus in clinical and environmental samples.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.6 no.6
• /
• pp.386-394
• /
• 2001

Carboxylic acids are examples of compounds with wide industrial applications and high potential, This article presents the principles of reactive extraction along with the character-istics of tertiary amine extractants, while is given on considering the effect of the amine class and chain length, As such a brief overview the current research on reactive extraction, including the recovery of citric acid, selective amine-based extraction , and extractive fermentation is given. When discussing extractive fermentation strategies for reducing solvent toxicity are also suggested based on specific examples. Finally, solvent regeneration and stripping of extracted acid explained.

• Journal of Industrial Technology
• /
• v.22 no.A
• /
• pp.101-105
• /
• 2002

Counters for various kinds of bank notes require high-speed distinctive point extraction and recognition for notes. In this paper we propose a new point extraction and data extraction method from specific parts of a bank note representing the same color. The recognition algorithm uses a back-propagation neural network that has coordinate data input. The proposed algorithm is designed to minimize recognition time.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.24 no.67
• /
• pp.49-60
• /
• 2001

Data warehouse(DW) manages all information in a Enterprise and also offers the specific information to users. However, it might be difficult to develope an effective DW system due to varieties in computing facilities, data base, and operating systems. The heterogeneous system environments make it harder to extract data and to provide proper information to usesr in real time. Also commonly occurred is data inconsistency of non-integrated legacy system, which requires an effective and efficient data extraction flow control as well as data cleansing. We design the integrated automatic ETT(Extraction Transformation Transportation) system to control data extraction flow and suggest implementation methodology. Detail analysis and design are given to specify the proposed ETT approach with a real implementation.

• Mass Spectrometry Letters
• /
• v.7 no.1
• /
• pp.26-29
• /
• 2016

Simultaneous determination of three corticosteroids (clobetasol propionate, betamethasone dipropionate, fluticasone propionate) in moisturizers was performed by using liquid chromatography (LC) coupled with tandem mass spectrometry (MS/MS). Sample preparation was conducted by the liquid-liquid extraction (LLE). Moisturizers include emulsifying agent and it forms micelles. In order to improve the extraction efficiency of corticosteroids trapped in micelle, newly developed-optimized extraction conditions which can remove the matrix effect from moisturizers was applied with various pH conditions in LLE extraction stage of sample preparation. Thus, the addition of 10 μL of 1 M HCl into moisturizers sample before extraction could improve the extraction efficiency. For the quantitative analysis, SRM table that contained specific transition of all of target corticosteroids was created. The developed method was validated for linearity, accuracy, precision, limit of detection (LOD), limit of quantization (LOQ) and recovery. Over the 0.99 r² value was obtained in calibration standard range. Effective accuracy and precision were also obtained. LODs were below 31 ng/mL and LOQs were estimated below 94 ng/mL for all corticosteroids tested.