• 한국태양에너지학회:학술대회논문집
• /
• 2012.03a
• /
• pp.96-101
• /
• 2012

An experimental study was conducted to investigate the performance of a concentrating photovoltaic cell (CPV) against temperature. It is know that a high efficiency of a CPV can be achieved only with proper cell temperature as well as high concentration ratio (CR). This study is concerned with appropriate cooling condition for a liquid-convection cooler for the best performance of a specific CPV. A series of experiments was conducted in a range of cell temperatures as a result of varying cooling conditions, while the concentration ratio was 390 and the solar irradiation flux was higher than 900 $W/m^2$ in outdoor environment. The CPV had a planar dimension of 10 by 10 mm. A Fresnel lens was used as a concentrator, of which the dimension was 221 mm(W) ${\times}$ 221 mm(L) ${\times}$ 3 mm(t) and the transmissivity was known to be 0.8. The cooler was attached to the bottom side of the CPV and had a contact area of 21 mm(W) ${\times}$ 26 mm(L), which was identical to the size of the base plate of the CPV. The coolant temperature was controlled by an isothermal bath and the flow rate was controlled and measured by a flowmeter. The experimental results showed that the average of power efficiency of the CPV decreased from 28.6 % to 24.7 % as the cell temperature increased from $36^{\circ}C$ to $97^{\circ}C$. An appropriate cooling method of a CPV might increase the power conversion efficiency by about 4% for the same concentration ratio. Discussion is included from the viewpoint of the combined efficiency in addition to the power efficiency.

• Journal of the Korean Solar Energy Society
• /
• v.34 no.2
• /
• pp.60-65
• /
• 2014

A meteorological(met) tower is the first structure installed during the planning stages of offshore wind farm. The purpose of this paper is to design the met tower with tripod bucket type support structure and to install the sensors. The support structure consist of a central steel shaft connected to three cylindrical steel suction buckets which is more cheaper than monopile or jacket type. And the remote wind condition sensors and marine monitoring equipment, including adcp, pressure type tide gauge, wave height sensors, and scour sensors, remote power supply are installed. The manufactured met tower constructed on sea area which is in front of Gasa island. All of functions of met tower showed normal operation conditions and the wind data got by remote data collection system successfully.

• Journal of Digital Convergence
• /
• v.12 no.2
• /
• pp.111-117
• /
• 2014

Generally, TPM activity promotion program steps have been determined. However, in order to maximize the efficiency of the production system of TPM, industry types or production methods, equipment type and condition, the problems facing the environment are so different that tips and procedures should be chosen in the right way for each company to promote. This study is aimed at a manufacturing company promoting TPM KSA presented. The TPM activities are broken into two phases. And we employ the AHP method to analyze which phase of activities are more important to recognize than the other phase of activities. In Step 1 of the analysis of TPM activities, promotion improvement is the most important activities of the individual, and the overall activity of the most important activities are the field improvement and loss improvement, then followed by the basic conditions for the preparation and 5S activities to build a system activity, such as the order of the initial cleaning was analyzed.

• Journal of the Ergonomics Society of Korea
• /
• v.29 no.2
• /
• pp.225-239
• /
• 2010

A high prevalence of farmer's work-related musculo-skeletal disorders (MSDs) have been reported in precedent studies. Risk factors - physical, chemical, biological, ergonomic risk factor etc. - in farm-work were identified by previous studies. To prevent farmers from exposing to them and reduce, Agricultural Safety Technology were introduced and used on farm. The purpose of this study is to review and summarize the agricultural safety technology on farm in Korea. According to strategy principles, this technology is classified as four criteria - workload reduction by reducing awkward posture, workload reduction by using manual material handling aids, Comfort improvement by protecting worker from hot, cold environment and work efficiency improvement by workplace redesign and cultivation modification. This technology includes transporting tools, working cloth, personal protective equipment, and pesticide-proof Clothing. Anthropometric study of Korean farmers was also carried out to support the development of equipment and clothes. In long terms, it needs to precaution activity from risk factors by using cultivation modification and working improvement. Although working condition gets better and workload reduce by this technology, it required customized safety technology in each crops - rice cultivation, horticulture and livestock farming. And farmers should use the assistive technology and participate voluntarily in ergonomic intervention program.

• Journal of the Korean Society for Railway
• /
• v.9 no.4 s.35
• /
• pp.349-356
• /
• 2006

At present, the selecting system and analytic estimation criterion on repair materials and methods of the deteriorated RC structures have not yet been set up in domestic. Under these circumstances, deterioration such as shrinkage crack, corrosion of rebar has been often occurred after repair, and this finally results in too frequent repairs. In this study, three types of repair methods were experimentally investigated by the accelerating test in a combined deterioration chamber and long-term field exposure test. Three types of repair methods applied in this study belong to a group of polymer cement mortar, which is commonly used in repair works. According to the results of this study, durability of repair mortar layers and corrosion properties of recovered rebar could be investigated in short period by the accelerating test in a combined deterioration chamber, which can simulate the condition of repeated high-and-low temperature and repeated dry-and-wet environment, spraying chloride solution and emitting $CO_2$ gas. After 36 month long-term filed exposure test in the coastal area, harmful macro-cracks are observed in the polymer cement mortar layer of some repair methods. These crack are considered to result from drying shrinkage of polymer cement mortar. Also, after 36 month exposure, amount of corrosion area and weight loss of rebar are found to be different according to the types of repair methods.

• Journal of the Korean Society for Railway
• /
• v.13 no.5
• /
• pp.500-503
• /
• 2010

Until now, the track circuit with railroad which is a part of an electrical circuit wad used only for the detection of the train location, but as train speed is up to be higher, in order to overcome the limits of ground signal system the railway signal system has changed from the ground signal system to a cab signal system. The power source of the track circuit has also changed from a direct current or a high voltage impulse to an alternating current with high frequency which is a part of the audio frequency. To improve the maintenanability and according to the environment condition, the railway roadbed is rapidly changed to the ferroconcrete roadbed. In case of a track circuit to use an alternating current with high frequency as power source at a ferroconcrete roadbed, the characteristic of the track circuit is brought on a change from a loss of the magnetic combination instead of a leakage current from electric insulation which was caused by the reinforcing iron pod with lattice shape for durability. This paper is shown the influence and the loss of the signal current at AF track circuit on a ferroconcrete in the simulation sheets and presented a proposal for the preventive method from reduction of signal current.

• Journal of Fisheries and Marine Sciences Education
• /
• v.18 no.2
• /
• pp.77-84
• /
• 2006

This research evaluates thermal comfort by comparing the case of maintain cooing temperature of room with the case of raising it at the point of time that human body begins to adapt. An experiment uses constant temperature & humidity chamber 2 places. Pretesting room make up summer season environment, the testing room control by air-conditioner. In condition that maintain temperature of $33^{\circ}C$. The subjects stay in the pretesting room during the 30 minute for the heat storage amount of the normal summertime. The subjects stay in the testing room under each case (case 1: maintaining $24^{\circ}C$, case 2: maintaining $26^{\circ}C$, case 3: up $1^{\circ}C$ after maintaining $24^{\circ}C$ during 30 minute, case 4: up $1^{\circ}C$ after maintaining $26^{\circ}C$ during 40 minute). 1. Result of comparison of case 1 and case 2 appears that thermal sensitive vote examine from slight cool to cool and thermal comfort examine slight comfort by temperature rise at human body adaptation point of time.2. Test of case 3 and case 4 appear similar value at thermal sensitive vote and thermal comfort.3. Through the case 2 and case 4, continuous thermal comfort maintain at $24^{\circ}C$, if raise $26^{\circ}C$, same thermal comfort maintain after a human body adaptation temperature rising effect bring energy saving.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.47 no.1
• /
• pp.68-73
• /
• 2002

High temperature during sprout emergence period of potato (Solanum tuberosum L.) is a major limitation to the yield of fall-grown potato in Korea. To explore the possibility of improving the yield of fall-grown potato through recycled paper mulching, the changes of soil environment and the growth and yield of potato cv. Daeji as affected by three mulching treatments of non-mulched control, recycled paper mulching (RPM), and black polyethylene film-mulching (BPFM) were examined over two fall seasons at Suwon, Korea. The mulching materials were a recycled mulch paper with 110 g/$m^2$ and a thickness of 0.1 mm, which was manufactured from old corrugated containers for this experiment and a commercial black polyethylene film with a thickness of 0.01mm. On an average throughout the growing period, the soil temperature with RPM at the 5-cm depth was lower by 0.4-1.1$^{\circ}C$ than that of the control. The maximum temperature during daytime in RPM was lowered by approximately 1 to 5$^{\circ}C$ according to the weather condition during emergence period, the difference being great on a fine day. The soil temperature with BPFM was much higher than the control. The effect of the mulching treatments diminished as the canopy became developed. The mulching treatments were more advantageous than the control in the conservation of soil water. Moreover, RPM and BPFM efficiently suppressed the occurrence of weeds until the potato harvest. RPM improved the emergence significantly due to lower soil temperature, whereas BPFM showed much poorer emergence than the control. Growth after emergence and yield were significantly higher in RPM than in the control and BPFM. It was concluded that the significantly improved yield in RPM compared to that in the control was mainly due to the improvement of the sprout emergence and tuber growth accompanied by lower soil temperature and better conservation of soil water.

• Journal of Korean society of Dental Hygiene
• /
• v.15 no.4
• /
• pp.649-659
• /
• 2015

Objectives: The purpose of the study is to investigate the musculo-skeletal pain prevalence and severity in the dental hygienists based on PRECEDE model. Methods: A self-reported questionnaire was completed by 483 dental hygienists in Gwangju from September 13 to October 12, 2013. Data were analyzed by frequency analysis, chi-square test, t-test, and multiple logistic regression analysis using SPSS 18.0 program. Musculo-skeletal pain severity was classified from 1 to 5 by PRECEDE model. The questionnaire consisted of six questions of the general characteristics of the subjects, one question of musculo-skeletal pain prevalence, one question of body part musculo-skeletal pain prevalence, one question of subjective health status, three questions of activities of daily living, six questions of working environment, one question of musculoskeletal system diseases knowledge, two questions of social support, two questions of education experience and data use method, and five questions of necessity of health education. Results: The prevalence rate of musculo-skeletal pain within a year was 83.9% and 22.8% of the dental hygienists complained of severe pain. The odds ratio of moderate pain severity was 1.99(95% CI, 1.10-3.60) and the odds ratio of unhealthiness was 3.27 (95% CI, 1.35-7.94). The odds ratio of pain severity in those working for 4-6 years was 0.21(95% CI, 0.08-0.57). The odds ratio of pain severity in those practicing 6-10 scaling cases per day was 0.33(95% CI, 0.17-0.65). The odds ratio of pain severity in wrist turning and bending was 3.56(95% CI, 1.19-10.62). Conclusions: The muscolu-skeletal pain severity in the dental hygienists was closely associated with subjective health condition, work duration, the number of scaling practice activity, and a treatment posture. Regular physical checkup for the dental hygienists will improve the musculo-skeletal pain due to scaling practice.

• Korean Journal of Ecology and Environment
• /
• v.34 no.4 s.96
• /
• pp.319-326
• /
• 2001

The biological and physicochemical factors and geosmin concentration were monitored in the Daechung Reservoir for 25 weeks from April to October in 1999. Geosmin was detected 5 times within a range of $1.16{\sim}5.28\;ng\;L^{-1}$, mostly in the late summer. The highest geosmin concentration was recorded on August 31, which also overlapped with the peaks of phycocyanin concentration, cyanobacterial density, and Anabaena spiroides density. A correlation analysis indicated that geosmin production was closely related with a high water temperature, pH, total dissolved phosphorus (TDP), and A. spiroides density. A water temperature of $27^{\circ}^C$, pH of 8.5, and TDP of $0.06\;mg\;L^{-1}$ were identified as the prerequisite environmental condition sand threshold values for geosmin production. Accordingly, under such conditions, an A. spiroides density above $10,000\;cells\;mL^{-1}$ indicates imminent geosmin occurrence.