• Hwankyungkyoyuk
• /
• v.24 no.1
• /
• pp.88-101
• /
• 2011

This study aims to address the current status of ESD(Education for Sustainable Development) in Korean universities since UN DESD was launched in 2005, and to explore the possibilities and challenges in them. For this purpose we conducted questionnaire surveys and case studies on members of university communities which were engaged in green campus activities or interested in SD and ESD. Results of questionnaire surveys showed that most of those who answered the questionnaire were well aware of SD, but had comparatively low understanding of ESD. The highest number of respondents answered that since 2005 they had newly opened courses on SD or ESD, or added contents on SD or ESD to existing ones. Ratio of network participation among ESD-related universities was over 30%, and they appeared to have the highest partnership ratio with NGOs. Not many universities had policies for sustainable school management, and 'green space conservation and ecosystem protection' and 'energy and resource saving campaign and monitoring' were most common sustainable environment protection activities. Through case studies on eight universities, it was discovered that ESD programs in universities took various forms such as whole-university approaches, participatory courses and club activities. We suggest that it is needed to make efforts to find out good examples of ESD in Korean universities and share the results with university leaders, professors and staffs for further development of ESD.

• Journal of the Society of Naval Architects of Korea
• /
• v.48 no.6
• /
• pp.569-574
• /
• 2011

In research vessels or naval ships, airborne noise from machineries such as diesel engine is the major source of underwater noise at low speed. In this paper, effect of engine noise on underwater noise is studied by considering two paths; sound radiation from hull plate and direct airborne noise transmission through hull plate. SEA (Statistical energy analysis) is used to predict hull plate vibration induced by engine noise, where SEA model consists of only two subsystems; engine room air space and hull plate. The pressure level in water is calculated from sound radiation by plate. Engine noise transmission through hull plate is obtained by assuming plane wave propagation in air-limp plate-water system. Two effects are combined and compared to the measurement, where speaker is used as a source in engine room and sound pressure levels in engine room and water are measured. The hydrophone is located 1 m away from the hull plate. It is found below 1000 Hz, prediction overestimates underwater sound pressure level by 5 to 12 dB.

• Journal of Korean Elementary Science Education
• /
• v.39 no.1
• /
• pp.117-132
• /
• 2020

The purpose of this study is to investigate elementary school teachers' awareness of Artificial Intelligence (AI) and find out how to apply it in elementary science education. The survey was conducted online and involved 95 teachers working in the metropolitan area. The results of this study are as follows. First, teachers need to learn about the general characteristics of AI and how to apply it to education. Second, science classes had the highest preference for AI among elementary school subjects. Third, the preference for AI application by elementary science field was 68.4% for earth and space, 54.7% for exercise and energy, 32.6% for matter, 27.4% for life. Fourth, AI-based Science Education (AISE) teaching- learning strategies were developed based on AI characteristics and the changing perspective of elementary science education, AISE's teaching-learning strategies are five: 'automation', 'individualization', 'diversification', 'cooperation' and 'creativity' and teachers can use them in teaching design, class practice and evaluation stages. Finally, the creative problem-solving Doing Thinking Making Sharing (DTMS) model was devised to implement the creativity strategy in AISE. This model consists of four-steps teaching courses: Doing, Thinking, Making and Sharing based on the empirical learning theory. In the future, follow-up research is needed to verify the effectiveness of this model by applying it to elementary science education.

• KIEAE Journal
• /
• v.11 no.2
• /
• pp.105-111
• /
• 2011

Aims of this study is to investigate the daylighting control strategy of venetian blind system was performed as a function of ratio of shading height to window and slat angles in the preliminary stage of the parametric study. Floor-to-ceiling window walls of living spaces are used widely in apartment buildings since the Korean government has legally allowed elimination of the balcony area. Enlarging living area by balcony elimination, the larger glass area of window is exposed to the direct sunlight. As a common sunlight controlling device, blind system can be used in all orientations and all latitudes and it may obstruct, absorb, reflect and transmit solar radiation to building by proper adjusting. However, blind system can produce discomfort in occupant and less energy efficiency, if it has not been controlled optimally. The simulation model was based on the unit module of typical living space with balcony elimination. The room dimension was $6.0m(w){\times}6.9m(d){\times}2.7m(h)$ with floor to ceiling height of 2.5m. The blind system was simulated at five slat angles (horizontal, $30^{\circ}$, $45^{\circ}$ upward and downward tilted) and the four ratio of shading height to window (fully closed, partly opened, no-blind) using the Desktop RADIANCE 2.0 program. The series of simulation results indicates that the advantages of available daylight and outside of view can be improved by proper adjusting blind system.

• Journal of Power Electronics
• /
• v.16 no.1
• /
• pp.9-17
• /
• 2016

Maximum power point tracking (MPPT) is necessary for photovoltaic (PV) power system application to extract the maximum possible power under changing irradiation and temperature conditions. The β-parameter-based method has many advantages over conventional MPPT methods; such advantages include fast tracking speed in the transient stage, small oscillations in the steady state, and moderate implementation complexity. However, a problem in the implementation of the conventional beta method is the choice of an appropriate scaling factor N, which greatly affects both the steady-state and transient performance. Therefore, this paper proposes a modified β-parameter-based method, and the determination of the N is discussed in detail. The study shows that the choice of the scaling factor N is determined by the changes of the value of β during changes in irradiation or temperature. The proposed method can respond accurately and quickly during changes in irradiation or temperature. To verify the proposed method, a photovoltaic power system with MPPT function was built in Matlab/Simulink, and an experimental prototype was constructed with a solar array emulator and dSPACE. Simulation and experimental results are illustrated to show the advantages of the improved β-parameter-based method with the optimized scaling factor.

• Electrical & Electronic Materials
• /
• v.10 no.7
• /
• pp.692-699
• /
• 1997

The silicon doped $Al_{0.33}$G $a_{0.67}$As were grown by molecular beam epitaxy. The electroreflectance(ER) spectra of Schottky barrier Au/n-Al/suu x/G $a_{1-x}$ As have been measured at various modulation voltage( $V_{ac}$ ) and dc bias voltage( $V_{bias}$). From the observed Franz-Keldysh oscillations(FKO) peak, the band gap energy of the $Al_{x}$G $a_{1-x}$ As is 1.91 eV which corresponds to an Al composition of 33%. The internal electric field( $E_{i}$)of this sample is 2.96$\times$10$^{5}$ V/cm. As the modulation voltage( $V_{ac}$ ) is changed, the line shape of ER signal does not change but its amplitude varies linearly. The amplitude as a function of modulation voltage has saturated at 0.8 V. The internal electric field has decreased from 6.47$\times$10$^{5}$ V/cm to 2.00$\times$10$^{5}$ V/cm as the dc bias voltage( $V_{bias}$) increases from -3.5 V to +0.8 V. The values of built-in voltage( $V_{bi}$ ) and carrier concentration(N) determined from the plot of $V_{bias}$ from the plot of $V_{bias}$ versus $E_{i}$$^{2}$ are 0.855 V and 3.83$\times$10$^{17}$ c $m^{-3}$ , respectively.ively.y.y.y.

• Journal of Sensor Science and Technology
• /
• v.5 no.5
• /
• pp.1-10
• /
• 1996

Solar cells made of the edge-defined film-fed growth Si are characterized using current-voltage, surface photovoltage, electron beam induced current, electron microprobe, scanning electron microscopy, and electron backscattering. The weak temperature dependence of the I-V curves in the EFG solar cells is due to a voltage variable shunt resistance giving higher diode ideality factors than the ideal one. The voltage variable shunt resistance is modeled by a modified recombination mechanism which includes carrier tunneling to distributed impurity energy states in the band gap within the space-charge region. The junction integrity and the substrate quality are characterized simultaneously by combining I-V and surface photovoltage (SPV) measurements. The diode ideality factors and the surface photovoltages characterize the junction integrity while the SPV diffusion lengths characterizes the substrate quality. Most of the measured samples show the voltage variable shunt resistance although how serious it is depends on the solar cell efficiency. The voltage variable shunt resistance is understood as one of the most important factors of the degradation of EFG solar cells.

• Tunnel and Underground Space
• /
• v.26 no.6
• /
• pp.508-515
• /
• 2016

In this study, we compared the stability of the pillars by using room and pillar mining method with the four models with different stiffness and pillar overlap ratio. The experimental models consist of two plaster models (overlap ratio 0%, 100%) and two cement models(overlap ratio 0%, 100%). The soft and hard rocks are modeled by plaster and cement models respectively. In these experiments, the model materials with strength values reflecting the calculated scaled factors not been used, so it is not a true scaled model test that reproduces in situ state in the laboratory. Experimental results show that the different overlap ratio pillars are one of the factors that can affect the stability of the mine.

• Tunnel and Underground Space
• /
• v.27 no.3
• /
• pp.172-184
• /
• 2017

The hardness and mechanical properties of the minerals in the Daejeon granite according to depths were investigated by indentation test, load-unload test, and cycle test of dynamic ultra-micro hardness. As a result of the tests, it was possible to classify into three mineral groups (Group-1, -2, -3). The Martens hardness was not significantly different between 41 m and 223 m depths in three mode tests. Nevertheless, they showed in the order of a cycle test < load-unload test < indentation test. Considering the average Martens hardness, elastic modulus, and indentation work for each mineral group, their boundaries were relatively clear. In conclusion, A relatively accurate hardness of minerals can be obtained by three mode tests of dynamic ultra-micro hardness. In addtion, it was possible to characterize the elastic modulus and the elastic-plastic properties of the minerals from the load-unload and cycle tests.

• Tunnel and Underground Space
• /
• v.30 no.2
• /
• pp.149-163
• /
• 2020

This paper presents a logistic regression and GIS based urban ground sink susceptibility assessment using underground facility information considering soil particle loss. In the underground environment, the particle loss due to water flow or groundwater level change leads to the occurrence and expansion of cavities, which directly affect the ground sink. Four different contributory factors were selected according to the two underground facility domains (water pipeline area, sewer pipeline area) and subway line area. The logistic regression method was used to analyze the correlation and to derive the regression equation between the ground sink inventory and the contributory factors. Based on these results, three ground sink susceptibility maps were generated. The results obtained from this study are expected to provide basic data on the area susceptible to ground sink and needed to safety monitoring.