• Nuclear Engineering and Technology
• /
• v.35 no.6
• /
• pp.523-528
• /
• 2003

The efficiencies of single escape and double escape peaks were calculated by using Monte Carlo method and compared with measured efficiencies. The efficiency was obtained from the area ratio of escape peak to full energy absorption peak and the full energy absorption peak efficiency. For the escape peak interfered with other $\gamma-ray$ peaks, the net area was obtained by area correction. The GEANT code developed in CERN was used for the Monte Carlo calculation. The calculated efficiencies of the escape peaks agreed with the measurement within $12\%$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.2A
• /
• pp.107-112
• /
• 2009

Spectral efficiency of current two-phase cooperative communications protocols is low since in the second time the relay forwards the same signal received from the source to the destination, the source keeps silent in this time. In this paper, we propose a novel cooperative communications protocol where the signal needed to transmit to the destination is sent in both phases, the source and the relay also transmit different signal to the destination thus no loss of spectral efficiency. This protocol performs signal selection based on log-likelihood ratio (LLR) at relay and maximum likelihood (ML) detection at destination. While existing protocols pay for a worse performance than direct transmission in the low SNR regime which is of special interest in ad hoc networks, ours is better over the whole range of SNR. In addition, the proposal takes advantages of bandwidth efficiency, long delay and interference among many terminals in ad hoc network. Simulation results show that the proposed protocol can significantly save total energy for wireless ad hoc networks.

• Environmental Engineering Research
• /
• v.24 no.2
• /
• pp.347-353
• /
• 2019

Although membrane distillation (MD) has great promise for desalination of saline water sources, it is crucial to improve its thermal efficiency to reduce the operating cost. Accordingly, this study intended to examine the thermal energy efficiency of MD modules in a pilot scale system. Two different modules of hollow fiber membranes were compared in direct contact MD mode. One of them was made of polypropylene with the effective membrane area of $2.6m^2$ and the other was made of polyvinylidene fluoride with the effective membrane area of $7.6m^2$. The influence of operation parameters, including the temperatures of feed and distillate, feed flow rate, and distillate flow rate on the flux, recovery, and performance ratio (PR), was investigated. Results showed that the two MD membranes showed different flux and PR values even under similar conditions. Moreover, both flow rate and temperature difference between feed and distillate significantly affect the PR values. These results suggest that the operating conditions for MD should be determined by considering the module properties.

• Asian-Australasian Journal of Animal Sciences
• /
• v.14 no.9
• /
• pp.1238-1244
• /
• 2001

Two calorimetric experiments were performed to investigate the effects of two diets with same concentrate: roughage ratio (70:30) but varying in composition on energy metabolism and methane production in faunated (F) and defaunated (DF) Muzaffarnagari sheep. For experiment I, ten animals were divided equally into two groups of which one was kept normally F as such while other was DF using 10% sodium lauryl sulphate. All the animals were offered diet I which comprised of oat hay and concentrate mixture I (CM I) containing maize grain (93%) as a major ingredient in 70:30 ratio. Similarly, the experiment II was conducted for which four F and four DF sheep (same as used for experiment I) were switched to diet II that consisted of maize hay and CM II (maize grain 59% + molasses 36%). Through diet II, DM intake in DF sheep was significantly (p<0.05) lower. Intake of GE through both the diets was similar in F and DF sheep. Digestibility of DM, OM, CP and GE and also metabolisability (ME/GE) was similar in F and DF sheep on both the diets. Total urinary energy loss did not differ in F and DF on both the diets, but methane energy loss as a percent of GE in DF was significantly (p<0.05) lower on diet I (3.75 vs 2.48), while it did not differ on diet II (3.20 vs 3.60). Heat production was significantly (p<0.01) reduced in DF on both the diets. Although, efficiency of utilisation of ME for maintenance calculated as per ARC (1984) did not differ in F and DF on both the diets, efficiency for maintenance and growth was higher (0.60 vs 0.672) on diet I in DF. It was inferred that methane production in DF sheep reduces on good quality hay-based diet supplemented with slowly fermentable carbohydrate (maize grain) but supplementation of molasses (rapidly fermentable CHO) nullify this effect when sheep were fed diets with concentrate: roughage ratio of 70:30.

• Journal of the Korea Society for Simulation
• /
• v.6 no.2
• /
• pp.1-14
• /
• 1997

The characteristics of the flow and energy conversion in OMACON liquid-metal MHD system are investigated. Numerical simulation of two-phase flow in the OMACON system without magnetic field was carried out by the Phoenics code and the energy conversion characteristics are studied in association with the fact that the mechanical energy loss at the nozzle of the OMACON system are to be converted into electrical energy. In this system, working fluid (gas) is injected through the mixer located at the bottom of the riser, and is mixed with hot liquid metal. Therefore in the riser two-phase flow is developed under the influence of the gravity. In this study, the interaction between the gas and liquid is considered by the use of IPSA(InterPhase Slip Algorithm) where standard drag coefficient has been used. It has been assumed that in the flow regime the liquid is continuous and the gas is dispersed. For the liquid and gas, the continuity equations, momentum equations and energy equations are solved respectively in association with void fraction in the flow field. In order to calculate the energy conversion efficiency, firstly the ratio of the mechanical energy loss of liquid metal flow at the nozzle to the input thermal energy is considered. Secondly flow pattern of liquid metal in the generator has been analyzed, and the characteristics of the conversion of the mechanical energy into the electrical energy has been investigated. For an representative case where Hartmann number is 540 and magnetic field is 0.35 T, the present analysis shows that the energy conversion efficiency is 0.653. This result is considered to be reasonable in comparison with published experimental results.

• Journal of Korean Society on Water Environment
• /
• v.37 no.2
• /
• pp.128-136
• /
• 2021

It is generally known that a wastewater treatment plant (WWTP) consumes immense energy even if it can produce energy. With an aim to increase the energy independence rate of WWTP from 3.5% in 2010 to 50% in 2030, the Korean government has invested enormous research funds. In this study, cost-effective operating alternatives were investigated by analyzing the energy efficiency and economic feasibility for biogas and power generation using new and renewable energy. Based on the US EPA Energy Conservation Measures and Korea ESCO projects, energy production and independence rate were also analyzed. The main energy consumption equipment in WWTP is the blower for aeration, discharge pump for effluent, and pump for influent. Considering the processes of WWTP, the specific energy consumption rate of the process using media and MBR was the lowest (0.549 kWh/㎥) and the highest (1.427 kWh/㎥), respectively. Energy-saving by enhancing anaerobic digester efficiency was turned out to be efficient when in conjunction with stable wastewater treatment. The result of economic analysis (B/C ratio) was 2.5 for digestive gas power generation, 0.86 for small hydropower, 0.49 for solar energy, and 0.15 for wind energy, respectively. Furthermore, it was observed that the energy independence rate could be enhanced by installing energy production facilities such as solar and small hydropower and reducing energy consumption via the replacement of high-efficiency operating.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.14 no.1
• /
• pp.1-19
• /
• 2020

In an underlay cognitive simultaneous wireless information and power transfer (SWIPT) network, communication from secondary user (SU) to secondary destination (SD) is accomplished with decode-and-forward (DF) relays. Multiple energy-constrained relays are assumed to harvest energy from SU via power splitting (PS) protocol and complete SU secure information transmission with beamforming. Hence, physical layer security (PLS) is investigated in cognitive SWIPT network. In order to interfere with eavesdropper and improve relay's energy efficiency, a destination-assisted jamming scheme is proposed. Namely, SD transmits artificial noise (AN) to interfere with eavesdropping, while jamming signal can also provide harvested energy to relays. Beamforming vector and power splitting ratio are jointly optimized with the objective of SU secrecy capacity maximization. We solve this non-convex optimization problem via a general two-stage procedure. Firstly, we obtain the optimal beamforming vector through semi-definite relaxation (SDR) method with a fixed power splitting ratio. Secondly, the best power splitting ratio can be obtained by one-dimensional search. We provide simulation results to verify the proposed solution. Simulation results show that the scheme achieves the maximum SD secrecy rate with appropriate selection of power splitting ratio, and the proposed scheme guarantees security in cognitive SWIPT networks.

• Asian-Australasian Journal of Animal Sciences
• /
• v.9 no.1
• /
• pp.31-35
• /
• 1996

An experiment was conducted on rainbow trout(Oncorhynclus mykiss) for eight weeks to investigate the growth performance of the fish fed with different dietary protein with constant diet energy of $20kJg^{-1}$. Four diets containing 25, 30, 35 and 40% crude protein were used. The highest mean final weight was obtained for the fish fed with diet having 35% protein. Growth performance in terms of Specific Growth Rate (SGR), Food Conversion Ratio (FCR) and Protein Efficiency Ratio (PER) were calculated for each diet. There were no significant differences in SGR but the highest value was exhibited by fish fed with 35% protein diet. Significant differences were found among FCR of different diets. Diets with 35 and 40% crude protein gave better FCR value than that of 25 and 30% crude protein. Although significant differences were not found between PER of different diets but PER of diet with 35% protein was found to be better than PER of both high and low protein diets (diets of 40 and 30% crude protein). It is concluded that diet having 35% protein with protein energy ratio of $17.53mgkJ^{-1}$ was suitable for rainbow trout (O. mykiss) among the protein spectrum used.

• Journal of the Korean Society of Combustion
• /
• v.15 no.4
• /
• pp.65-73
• /
• 2010

In order to provide fundamental information for developing reaction model in the practical blended coal power plants, effects of particle size and blending ratio on combustion characteristics and thermal reaction in co-firing with bituminous and sub-bituminous coals were experimentally investigated using a TGA and a laboratory-scale burner. Characteristic parameters including ignition, burnout temperature and activation energy were determined from TG and DTG combustion profiles. Distributions of flame length and mean particle temperature were investigated from the visualization of flames in slit-burner system. As coal particle size decreased and volatile matter content increased, characteristic temperatures and activation energy decreased. The ignition/burnout characteristics and activation energy are linearly influenced by a variation in particle size and blending ratio. These results indicated that the control of the coal blending ratio can improve the combustion efficiency for sub-bituminous coals and the ignition characteristics for bituminous coals.

• New & Renewable Energy
• /
• v.17 no.3
• /
• pp.1-7
• /
• 2021

The Korean government announced various energy policies, such as the to reduce 37% of the business-as-usual (BAU) greenhouse gas emissions by 2030. The policies aim to increase the renewable electricity generation ratio to 20% by 2030. PVT is a hybrid technology, which combines photovoltaic (PV) and solar collectors. It is capable of generating electricity and thermal energy simultaneously. It has a great potential to be used as a renewable and clean solar energy. However, there exists a shortage of space for the installation of PVT systems in Korea. To overcome this, in this paper proposes four types of soundproof wall PVT air channels, which were designed and optimized, based on the CFD (Computation Fluid Dynamic) analysis results. The thermal energy generation for multiple PVT units connected in series and pressure drop sensitivity were analyzed, depending on inlet velocity.