• Transactions of the Korean Society of Automotive Engineers
• /
• v.16 no.1
• /
• pp.181-187
• /
• 2008

Recently, alternative fuels are drawing more attentions due to the increasing need for lower emission characteristics and fuel consumption rate in automotive engines. The GTL(gas to luquid) is the one of most favored candidates. It has higher cetane number(more than 75) and almost negligible sulphur and aromatic contents. Therefore, enhanced emission characteristics are expected even in the application in diesel engines without any modification. In this study, the cylinder pressure and heat release, emission characteristics with fuel injection timings are compared between diesel and GTL fuel in the single cylinder diesel engine. Noticeable reduction in PM, THC and CO emission are observed due to lower sulphur and aromatic contents in GTL. Also, the ignition delay decreased due to higher cetane number of GTL, which slightly decreased the amount of NOx emissions. With the retards of main injection timing, NOx decreases more for the case of GTL, while the level of THC and CO emissions still remains lower than the case of diesel. Therefore, there is much room for the control of injection timing for NOx reduction without sacrificing THC and CO emissions. With the retards of main injection timing, Small size distribution of PM became lager and there amount increased. But from all conditions, size distribution of PM for the case GTL was lower than Diesel.

• Applied Chemistry for Engineering
• /
• v.20 no.6
• /
• pp.675-680
• /
• 2009

This article describes NO emission characteristics in SM coal combustion. Combustion experiments was performed in the method of increasing temperature after feeding coal and feeding coal after increasing temperature. NOx emission is in inverse proportion to combustion temperature at the fuel rich condition and it was caused by conversion fuel N to $N_{2}$ at the strong reduction condition. In addition, feeding gas flow rate increased as total fuel NOx increase by conversion of fuel N to NO at the oxidation condition. It could be separated in total fuel-N, volatile-N, char-N to NO according to analysis of total fuel NO emission from char combustion at each temperature. In the result, almost total NOx emission was caused by volatile-N in SM-coal.

• Journal of Korean Society of Environmental Engineers
• /
• v.39 no.12
• /
• pp.672-678
• /
• 2017

In this study, municipal solid waste (MSW) has collected 3 times and physico-chemical analysis has done. Nitrous oxide emissions from MSW incineration plant were measured continuously by EPA Method 18 and it was compared with the emission by calculation using the emission factor. The $N_2O$ emission of MSW incineration plant was more than twice as large as the emission by calculation. It was found that the installation of abatement facilities in MSW incineration plant is effective in achieving the greenhouse reduction targets and it can be ensure economical efficiency through emission trading system.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.18 no.1
• /
• pp.86-92
• /
• 2010

The fuel is not injected when the driver doesn't push acceleration pedal of a vehicle with engine speed higher than about 1,500rpm above mid vehicle speed range. This is called "fuel-cut function" and almost every modern vehicle is equipped with this function. This is activated on downhill part of a highway most often. Therefore the vehicle-exhausted $CO_2$ can be zero in this downhill part if the driver could recognize this part of highway. We compared the vehicle-exhausted $CO_2$ emission when using fuel-cut function with the $CO_2$ mass when without using this function in this study. We found that the $CO_2$ emission reduced with fuel-cut function and measured the reduction rate of vehicle-exhausted $CO_2$ mass with this test results. The exhausted $CO_2$ mass of a passenger car(2,000cc engine volume) is reduced by 4% with this function used. This $CO_2$ reduction effect can be achieved if the downhill part of a highway is painted with a specific color. And this road painting can be included in the highway road rehabilitation policy.

• Journal of Korean Society for Atmospheric Environment
• /
• v.21 no.6
• /
• pp.561-571
• /
• 2005

To introduce an emissions trading system for GHG that currently have no reduction requirements, the following should be considered as priorities: eliciting the participation of the industrial sector and linking GHG emission trading systems to the emissions trading system (implemented from July 2007) that has become part of national policy with the enactment of the Special Act. Two directions can serve as viable alternatives in that regard. One is a baseline-and-credit method based on incentive auctioning. This has the advantage of inducing participation through economic incentives without a reductions commitment. The downside of this method is that it requires vast investments, as well as the fact that reaching an agreement between participants and the government to decide an objective baseline is difficult. On the other hand, the cap-and-trade method set forth in the Special Act is attractive in that it can be integrated with the air pollutant emissions trading system, but it would be difficult to elicit the participation of the industrial sector in the absence of GHG emission reduction requirements. In the current situation, it would be preferable for the government to induce the participation of the industrial sector by devising a wide variety of incentives because taking part in the emissions trading system before reducing GHG emissions offers large incentives through learning by doing. The timing of GHG reduction commitments and emissions trading system implementation may be uncertain but their Implementation will be unavoidable. Thus the government needs to facilitate preparations for emissions trading of GHG in the future and continuously review its operation in integration with the air pollutant emissions trading system to maximize adaptation and teaming by doing effect in the industrial sector.

• Asian Journal of Atmospheric Environment
• /
• v.7 no.1
• /
• pp.48-55
• /
• 2013

The purpose of this study was to develop a $CO_2$ emission factor for refuse plastic fuel (RPF) combustion facilities, and calculate the $CO_2$ emissions from these facilities. The $CO_2$ reduction from using these facilities was analyzed by comparing $CO_2$ emission to facilities using fossil fuels. The average $CO_2$ emission factor from RPF combustion facilities was 59.7 Mg $CO_2$/TJ. In addition, fossil fuel and RPF use were compared using net calorific value (NCV). Domestic RPF consumption in 2011 was 240,000 Mg/yr, which was compared to fossil fuels using NCV. B-C oil use, which has the same NCV, was equal to RPF use. In contrast, bituminous and anthracite were estimated at 369,231 Mg/yr and 355,556 Mg/yr, respectively. In addition, the reduction in $CO_2$ emissions due to the alternative fuel was analyzed. $CO_2$ emissions were reduced by more than 350 Mg $CO_2$/yr compared to bituminous and anthracite. We confirmed that using RPF, an alternative fuel, can reduce $CO_2$ emissions.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.3
• /
• pp.1495-1501
• /
• 2013

This study aims to figure out the effectiveness of low-carbon oriented residential regeneration by on-site improvement method. For this, we examined some technical planning elements for carbon reduction and selected standard criteria of computation on energy use-based amount of carbon emission through previous literature review and case studies. Next, based on this, we compared and analyzed three types of carbon emission in the designated renewal area in Cheongju City. The three types of carbon emission were the existing development, the redevelopment of apartment by overall removal, and the development of low-carbon oriented residential regeneration by on-site improvement method. Finally, we examined proper way to reduce carbon emission in low-carbon oriented residential regeneration.

• Journal of Climate Change Research
• /
• v.8 no.3
• /
• pp.221-230
• /
• 2017

There are two main policies to meet the national goal of reducing Greenhouse Gases (GHGs) emissions in Korea towards Paris Agreement. From 2012 to 2014, Target Management System (TMS) was operated and the Emissions Trading Scheme (ETS) has been established since 2015. To compare the impact of TMS and ETS on reducing GHGs, we collected annual GHGs emission reports submitted by individual business entities, and normalized them using a z-variant normalized function. In order to evaluate the impact of those policies, we calculated the amount of GHGs emissions of 73 business entities from 15 business sectors. Those entities emitted $508million\;CO_2eq$, which is 74% of total national GHGs emissions in 2014. The main results of analysis indicate that accumulated GHGs emissions during the period 2012 to 2014 affected by TMS was higher than the national goal of GHGs emission reduction, and only the GHGs emissions in 2014 were in the range of allowed GHGs emissions, set by the Government. In 2015, when ETS initiated, total GHGs emission trading was $4.84million\;tCO_2eq$, which is only 0.9% of total allowance in 2015. However, more than 50% of business entities, who got the allowance of GHGs emission given by the Government, met the goal of GHGs emissions. Particularly, 27 of 73 business entities reduced GHGs more under the ETS rather than the TMS. Even though we analyzed only 4 years' data to demonstrate the impact of TMS and ETS, it is expected to commit the national goal of GHGs reduction target by TMS and ETS.

• International Journal of Automotive Technology
• /
• v.2 no.4
• /
• pp.123-133
• /
• 2001

An important goal in diesel engine research is the development of a means to reduce the emission of oxides of nitrogen ($NO_x$) and soot particulate. A phenomenological model based on the multizone concept is used in the current paper to analyze and compare the effects of exhaust gas recirculation (EGR) and split fuel injection on emission from a compression-ignited, direct-injection engine. The present results show that $NO_x$ can be reduced with a minimum penalty of soot particle emission with cooled EGR. Compared with EGR, split fuel injection has a higher soot penalty at a given level of $NO_x$ reduction.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.10 no.3
• /
• pp.8-17
• /
• 2002

In this study, it was tried to analyze not only total hydrocarbon but individual hydrocarbon components from C$_1$to C$\sub$6/ in exhaust gas using gas chromatography to seek the reason fur remarkable differences of smoke emission of diesel fuel, esterfied rice bran oil and blended fuel(esterfied rice bran oil 20vo1-% + diesel fuel 80vo1-%). Individual hydrocarbons(C$_1$ ∼C$\sub$6/) as well as total hydrocarbon of esterfied rice bran oil is reduced remarkably compared with diesel fuel. Although smoke emission of esterfied rice bran oil reduced remarkably compared with commercial diesel fuel, NOx emission of esterfied rice bran oil and blended fuel was increased slightly at high loads and speeds. And, it was tried to reduced NOx emission of them by exhaust gas recirculation(EGR) method. Simultaneous reduction of smoke and NOx emission was achieved with the combination of esterfied rice bran oil and EGR method in consequence.