• Journal of Ocean Engineering and Technology
• /
• v.30 no.4
• /
• pp.287-293
• /
• 2016

This paper presents an effective damage detection method for offshore jackets using natural frequency change ratios. Two parameters, cosine similarity and magnitude index, are considered to estimate the location and severity of the damage in the structure. A numerical jacket structure model is considered to verify the performance of the proposed method. As observed through analysis, the damages in the structure are detected accurately.

• Korean Journal of Environmental Biology
• /
• v.26 no.1
• /
• pp.1-7
• /
• 2008

A mathematical model for the synergistic interaction of physical and chemical environmental agents was suggested for quantitative prediction of irreversibly damaged cells after combined exposures. The model took into account the synergistic interaction of agents and was based on the supposition that additional effective damages responsible for the synergy are irreversible and originated from an interaction of ineffective sublesions. The experimental results regarding the irreversible component of radiation damage of diploid yeast cells simultaneous exposed to heat with ionizing radiation ($^{60}Co$) or UV light (254 nm) are presented. It was shown that the cell ability of the liquid holding recovery decreased with an increase in the temperature, at which the exposure was occurred. A good correspondence between experimental results and model prediction was demonstrated. The importance of the results obtained for the interpretation of the mechanism of synergistic interaction of various environmental factors is discussed.

• Geomechanics and Engineering
• /
• v.7 no.5
• /
• pp.569-587
• /
• 2014

Triaxial compression creep tests were performed on salt rock samples using cyclic confining pressure with a static axial pressure. The test results show that, up to a certain time, changes in the confining pressure have little influence on creep properties of salt rock, and the axial creep curve is smooth. After this point, the axial creep curve clearly fluctuates with the confining pressure, and is approximately a straight line both when the confining pressure decreases and when it increases within one cycle period. The slope of these lines differs: it is greater when the confining pressure decreases than when it increases. In accordance with rheology model theory, axial creep equations were deduced for Maxwell and Kelvin models under cyclic loading. These were combined to establish an axial creep equation for the Burgers model. We supposed that damage evolution follows an exponential law during creep process and replaced the apparent stress in creep equation for the Burgers model with the effective stress, the axial creep damage equation for the Burgers model was obtained. The model suitability was verified using creep test results for salt rock. The fitting curves are in excellent agreement with the test curves, so the proposed model can well reflect the creep behavior of salt rock under low-frequency cyclic loading. In particular, it reflects the fluctuations in creep deformation and creep rate as the confining pressure increasing and decreasing under different cycle periods.

• Computational Structural Engineering : An International Journal
• /
• v.3 no.1
• /
• pp.1-7
• /
• 2003

For system identification of large structures, it is not practical to identify the entire structure due to the prohibitive computational time and difficulty in numerical convergence. This paper explores the possibility of performing system identification at substructure level, taking advantage of reduction in both the number of unknowns and the number of degrees of freedom involved. Another advantage is that different portions (substructures) of a structural system can be identified independently and even concurrently with parallel computing. Two substructural identification methods are formulated on the basis whether substructural approach is used to obtain first-order or second-order model. For substructural first-order model, identification at the substructure level will be performed by means of the Observer/Kalman filter Identification (OKID) and the Eigensystem Realization Algorithm (ERA) whereas identification at the global level will be performed to obtain second-order model in order to evaluate the system's stiffness and mass parameters. In the case of substructural second-order model, identification will be performed at the substructure level throughout the identification process. The efficiency of the proposed technique is shown by numerical examples for multi-storey shear buildings subjected to random forces, taking into consideration the effects of noisy measurement data. The results indicate that both the proposed methods are effective and efficient for damage identification of large structures.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.29 no.12 s.243
• /
• pp.1586-1596
• /
• 2005

In this paper, a structural damage identification method (SDIM) is developed to identify the line crack-like directional damages generated within a cylindrical shell. First, the equations of motion for a damaged cylindrical shell are derived. Based on a theory of continuum damage mechanics, a small material volume containing a directional damage is represented by the effective orthotropic elastic stiffness, which is dependent of the size and the orientation of the damage with respect to the global coordinates. The present SDIM is then derived from the frequency response function (FRF) directly solved from the equations of motion of a damaged shell. In contrast with most existing SDIMs which require the modal parameters measured in both intact and damaged states, the present SDIM may require only the FRF-data measured at damaged state. By virtue of utilizing FRF-data, one may choose as many sets of excitation frequency and FRF measurement point as needed to acquire a sufficient number of equations for damage identification analysis. The numerically simulated damage identification tests are conducted to study the feasibility of the present SDIM.

• Smart Structures and Systems
• /
• v.13 no.5
• /
• pp.849-868
• /
• 2014

An indirect approach is explored for structural health bridge monitoring allowing for wide, yet cost-effective, bridge stock coverage. The detection capability of the approach is tested in a laboratory setting for three different reversible proxy types of damage scenarios: changes in the support conditions (rotational restraint), additional damping, and an added mass at the midspan. A set of frequency features is used in conjunction with a support vector machine classifier on data measured from a passing vehicle at the wheel and suspension levels, and directly from the bridge structure for comparison. For each type of damage, four levels of severity were explored. The results show that for each damage type, the classification accuracy based on data measured from the passing vehicle is, on average, as good as or better than the classification accuracy based on data measured from the bridge. Classification accuracy showed a steady trend for low (1-1.75 m/s) and high vehicle speeds (2-2.75 m/s), with a decrease of about 7% for the latter. These results show promise towards a highly mobile structural health bridge monitoring system for wide and cost-effective bridge stock coverage.

• The Korea Journal of Herbology
• /
• v.32 no.3
• /
• pp.79-87
• /
• 2017

Objectives : This study aimed to investigate the protective effects of an herbal mixture of Atractylodes macrocephala and Taraxacum spp. (ATC) on ulcerative colitis. We have previously screened traditional medicinal herbs to discover the effective candidate by the animal model. A. macrocephala and T. spp were identified as one of the effective herbs in the screening process. Methods : Experimental colitis was induced in male Balb/c mice by administering drinking water containing dextran sulfate sodium, which mimics the clinical and histological features of ulcerative colitis in human. ATC at doses of 30, 100 or 300 mg/kg were orally administered to mice twice per day for 10 consecutive days. To evaluate the damage from experimentla ulcerative colitis, body weight, colon length, disease activity index, myeloperoxidase and histological changes were measured and analyzed. Results : The administration of dextran sulfate sodium with drinking water resulted in markedly reduced colon length, severe body weight loss, increased levels of myeloperoxidase activity and histological damages in mice. ATC treatment significantly ameliorated the colon shortening, histological damage, body weight loss and disease activity index score in a dose-dependent manner. ATC also attenuated the colonic myeloperoxidase activity which reflects the severity and extent of inflammatory damage of colon. Conclusions : ATC exerts protective effects against inflammatory colonic structural damage induced by epithelial barrier integrity impairment. ATC also inhibits weight loss and related symptoms of UC which can be considered as the functional recovery of colon.

• Journal of the Korean Geotechnical Society
• /
• v.38 no.11
• /
• pp.149-161
• /
• 2022

This study selected the indexes for evaluating the damage of the railway embankments due to liquefaction from the earthquake damage cases of railway embankments. The study correlated the selected indexes and the settlement of the embankment crest from the dynamic numerical analysis. Further, the correlation was used to develop a method for evaluating the liquefaction damage to the railway embankment. The damage cases and damage types were analyzed, and referring to the liquefaction damage assessment method for other structures, the embankment height (H), the non-liquefiable layer thickness (H₁), and the liquefaction potential index were selected as indexes for evaluating the damage. The study performed dynamic effective stress analyses on the railway embankment, and the PM4-Sand model was applied as the constitutive liquefaction model for the embankment foundation ground. The model's validity was first verified by comparing it with the existing dynamic centrifugal model test results performed on the railway embankment. Nine sites where the foundation ground can be liquefied were selected from the data of 549 embankments of the Honam High-speed Railway in Korea. Further, dynamic numerical analyses using four seismic waves as input earthquake load were performed for the selected site sections. The numerical analysis results confirmed the correlation between the evaluation indexes and the embankment crest settlement. A method for efficiently evaluating the damage to the embankment due to liquefaction was proposed using the chart obtained from this correlation.

• Structural Engineering and Mechanics
• /
• v.81 no.6
• /
• pp.665-675
• /
• 2022

The safety problems of giant hydraulic structures such as dams caused by terrorist attacks, earthquakes, and wars often have an important impact on a country's economy and people's livelihood. For the national defense department, timely and effective assessment of damage to or impending damage to dams and other structures is an important issue related to the safety of people's lives and property. In the field of damage assessment and vulnerability analysis, it is usually necessary to give the damage assessment results within a few minutes to determine the physical damage (crack length, crater size, etc.) and functional damage (decreased power generation capacity, dam stability descent, etc.), so that other defense and security departments can take corresponding measures to control potential other hazards. Although traditional numerical calculation methods can accurately calculate the crack length and crater size under certain combat conditions, it usually takes a long time and is not suitable for rapid damage assessment. In order to solve similar problems, this article combines simulation calculation methods with machine learning technology interdisciplinary. First, the common concrete gravity dam shape was selected as the simulation calculation object, and XFEM (Extended Finite Element Method) was used to simulate and calculate 19 cracks with different initial positions. Then, an LSTM (Long-Short Term Memory) machine learning model was established. 15 crack paths were selected as the training set and others were set for test. At last, the LSTM model was trained by the training set, and the prediction results on the crack path were compared with the test set. The results show that this method can be used to predict the crack propagation path rapidly and accurately. In general, this article explores the application of machine learning related technologies in the field of mechanics. It has broad application prospects in the fields of damage assessment and vulnerability analysis.

• Journal of Korean Society of Rural Planning
• /
• v.28 no.4
• /
• pp.93-104
• /
• 2022

Agriculture is one of the most vulnerable sector to droughts, and drought damage on the agriculture sector could have effects on other sector. Droughts have different characteristics compared to other extreme events, which means more sophisticated methods considering the characteristics of droughts are required when measuring their damage. The purpose of this study is to analyze the damage of droughts based on limited computational general equilibrium model. To be specific, we constructed a CGE model focusing on the agriculture sector in Korea. Also, to limit changes in land use and labor, we limited them, and assume droughts only have effects on productivity of value-added. Lastly, we simulate drought effects on rice production in Korea based on several climate scenarios and GCM to identify the economic effects of droughts. The results show that 1) the cumulated damage of droughts during 2021~2040 is higher than other periods (2040~2061, 2081~2100), 2) the correlation between the damage of droughts and SSP scenarios is insignificant. This result implies the necessity of the effective drought risk management to prevent future droughts effects, irrespective of mitigation policies. 3) Due to increases in rice price, GDP of rice sector is increased. However, GDP of the other sector and consumer welfare are decreased. This result show that indirect effects of droughts would be more important when measuring drought effects on agriculture sector.