• Membrane and Water Treatment
• /
• 제9권1호
• /
• pp.9-15
• /
• 2018

Coagulation process using aluminum sulfate ($Al_2(SO_4)_3$) and ferric chloride ($FeCl_3$) was employed as a treatment method for decolorization of a synthetic textile wastewater containing red dye in this paper. Factors such as initial pH, coagulant dosage, initial concentration, conductivity and mixing conditions that influence color removal efficiency were experimentally tested. It was found that $Al_2(SO_4)_3$ is more efficient than $FeCl_3$ as coagulant. When $40mgL^{-1}$ aluminum sulfate was used, results showed that color induced by the red dye was efficiently removed (> 90 %) and was obtained in a large range of initial pH from 4 to 8 with, and for a dye concentration lower than $235mg\;L^{-1}$. After addition of the coagulant, the medium had to be mixed for 30 min at 60 rpm, then allowed to settle for 40 min. The effects of water conductivity in the range $0.035-2.42mS\;cm^{-1}$ and dye concentration up to $380mg\;L^{-1}$ were also followed and discussed.

• Membrane and Water Treatment
• /
• 제11권2호
• /
• pp.131-139
• /
• 2020

The current study focused on the preparation of low-cost PVC-based adsorbing membrane. Metakaolin, as available adsorbent, was embedded into the PVC matrix via solution blending method. The as-prepared PVC/metakaolin mixed matrix membranes were characterized using scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), attenuated total reflectance-Fourier transform infrared (ATR-FTIR) spectroscopy, atomic force microscopy (AFM), pure water permeability and contact angle measurements. The results confirmed the improvement of PWP and hydrophilicity due to the presence of metakaolin in the PVC matrix. Additionally the structure of PVC membrane was changed due to the incorporation of metakaolin in the polymer matrix. The static adsorption capacity of all samples was determined through dye removal. The effect of metakaolin dosage (0-7%) and pH (4, 8, 12) on dye adsorption capacity was investigated. The results depicted that the highest adsorption capacity was achieved at pH of 4 for all samples. Additionally, adsorption data were fitted on Langmuir, Freundlich, and Temkin models to determine the appropriate governing isotherm model. Finally, the dynamic adsorption capacity of the optimum PVC/metakaolin membrane was studied using dead-end filtration cell. The dye removal efficiency was determined for pure PVC and PVC/metakaolin membrane. The results demonstrated that PVC/metakaolin mixed matrix membrane had a high adsorption capacity for dye removal from aqueous solution.

• Membrane and Water Treatment
• /
• 제7권6호
• /
• pp.477-493
• /
• 2016

Immediate use of activated carbon incorporated polysulfone membrane application for dye separation was reported in this work. Dimethylformamide (DMF) was used as the solvent for the membrane preparation. The membrane thus prepared were characterized in terms of surface morphology, ATR-FTIR, AFM, experimental results as membrane performance. The resultant nanofiltration (NF) membranes were tested with Congo red dye concentration 200 mg/L. The water permeability was found to be considerably higher than that reported in literature. Experimental results show that the real rejection of the Congo red is 99.57% over the transmembrane pressure 100 psi using 30% activated carbon incorporated membrane. Prepared NF membranes shows the corresponding permeates fluxes were $40Lm^{-2}h^{-1}$ to $82Lm^{-2}h^{-1}$ with different activated carbon percentage incorporated in polysulfone membrane. The present study demonstrated that dye rejection enhanced NF may be a feasible method for the dye wastewater treatment. The overall observations thus indicated that toxic residual dyes can be appreciably separated from the membrane technology, provided that the accompanying polymeric membrane, activated carbon as binding agents and the process parameter levels are astutely selected.

• 한국염색가공학회지
• /
• 제14권2호
• /
• pp.40-50
• /
• 2002

In order to remove the pollutants effectively in the dye wastewater by chemical precipitation process, coagulation arid flocculation test were carried out using several coagulants on various reaction conditions. It was found that the Ferrous sulfate was the most effective coagulant for the removal of disperse dye(B79), and we could get the best result lot the removal of disperse dye(B56) in the aspects of TOC removal efficiency and sludge field. When the Ferrous sulfate dosage was $800mg/\ell$, the sludge settling velocity was very fast>, and the color was effectively removed in the disperse dye(B79) solution. Although the color removal was ineffective when the Alum was used as a coagulant, the sludge field was decreased in comparison with the Ferrous sulfate or the Ferric sulfate was used in the disperse dye(B56) solution. The general color removal effect for the disperse dye(B56 and B79) solutions, the Ferric sulfate was more proper coagulant than the Alum. It was showed that TOC removal was improved 5% and over by the addition of Calcium hydroxide, and $30mg/\ell$ of sludge yield was decreased(B79). When Alum or Ferric sulfate was used as a coagulant, pH condition for most effective color removal was 5 in B56 solution. In case of Ferrous sulfate as a coagulant, most effective pH condition for color removal was 9. When Ferric sulfate or Ferrous sulfate was used as a coagulant, pH condition for most effective color removal was 9 in B79 solution.

• 한국염색가공학회지
• /
• 제13권1호
• /
• pp.38-44
• /
• 2001

The adsorption ability of dyes on chitin, a natural polymer was investigated for decolorization of dye wastewater. Chitin was manufactured in lab by decalcification in dilute aqueous hydrochloric acid solution and deproteination in dilute aqueous sodium hydroxide solution with shrimp shells. Absorbance of residue solution of dyebaths after dye adsorptions of chtin were measured in varieties of dye concentration and dipping periods. Three kinds of Direct dyes -C.I. Direct Red 81 (red 81), C.I. Direct Brown l(brown 1) and C.I. Direct Green 26(green 26) - were used. Red 81 and brown 1 have smaller molecular weight than green 26. The results from experimentals were of]tamed as follows: 1) Adsorption of green 26 was improved in dyebath by addition of salt, but red 81 and brown 1 were not found any improvements. 2) Smaller size of chitin particles could be absorbed much more speedy. In this experiments, the smallest range of chitin particle size was $250\mu{m}$ and less. 3) The most efficient amount of chitin for 20m1 of dyebath was 0.2g, 4) Both of red 81 and brown 1 showed good and speedy adsorption abilities as dyestuffs of over 90 percent in just one minute in dyebath of 0.01% dye concentration. But green 26 was absorbed slowly because of its large molecular weight. It took 40minutes to absorb dyestuffs of over 90 percent in dyebath of 0.01% dye concentration.

• Composites Research
• /
• 제35권6호
• /
• pp.402-411
• /
• 2022

In this study, the channels-contained hybrid membranes have been fabricated through the incorporation of glass fibers and GO sheets (GO/glass fibers, GG), or a mixture of chitosan/GO (CS/GO/glass fibers, CGG), as hybrid membranes using in organic dye removal. The material properties are well investigated the terms in the morphological, chemical, crystal, and thermal characterizations for verifying interactions in their formed structure. These hybrid membranes have been fitted well in pseudo-second order and Langmuir models that are associated with chemical adsorption and a monolayer approach, respectively. The highest adsorption ability of methylene blue and methyl orange reached 59.40 mg/g and 229.07 mg/g (GG); and 287.47 mg/g and 252.91 mg/g (CGG), which is more enhanced than that of previous GO-based other adsorbents. Moreover, the dye separation on these membranes could be favorable to superb sealing and trapping dye molecules from water instead of only the dye connection occurring on their surface, regarding the physically sieving effect. The membranes can also be reused within two and three adsorbing-desorbing cycles on the GG and CGG ones, respectively. These membranes can become future adsorbents to be applied for wastewater treatment due to their structural features.

• 생명과학회지
• /
• 제24권4호
• /
• pp.393-402
• /
• 2014

천연염색폐수시설 폐수의 세균 군집분석을 위해 배양 가능한 세균을 분리하는 방법과 비배양 방법인 denaturing gradient gel electrophoresis 방법을 이용하였다. 3개의 폐수 공정단계로부터 분리된 104개(폐수유입수, 48균주; 접촉포기조, 25균주; 침전조, 31균주) 균주들의 16S rRNA 유전자의 염기서열을 분석하였다. 104개의 분리균들은 Proteobacteria 문이 가장 많은 비율을 차지 하였으며, Actinobacteria, Firmicutes 와 Bacteriodetes 등 4개 문에 속했다. DGGE profile중 각 시료의 우점 군집을 대표하는17개의 band를 선택하여 부분 염기서열 분석 결과 분리균과 동일한 4개의 문에 속했다. 배양기법을 이용한 결과와 배양하지 않고 분석하는 방법인 DGGE결과 모두 Proteobacteria 문이 우점하였으며 Alphaproteabacteria강이 높은 비율을 차지하였다. 천연염색 폐수처리시설의 세균 군집들은 인간을 비롯한 동식물의 기생균, 다당류와 난분해성 화합물을 분해하는 세균 그리고 세포외 다당을 형성하는 세균들이 우점하고 있음을 알 수 있었다.

• Biotechnology and Bioprocess Engineering:BBE
• /
• 제9권5호
• /
• pp.419-422
• /
• 2004

Textile wastewater from the Pusan Dyeing Industrial Complex (PDIC) was treated utilizing a two-stage continuous system, composed of an upflow anaerobic sludge blanket reactor and an activated Sludge reactor. The effects of color and organic leading rates were studied by varying the hydraulic retention time and influent glucose concentration. The maximum color load to Satisfy the legal discharge limit of color intensity in Korea (400 ADMI, unit of the American Dye Manufacturers Institute) was estimated to be 2,700 $ADMI{\cdot}L^{-1}\;day^{-1}$. This study Indicates that the two-stage anaerobic/aerobic reaction system is potentially useful in the treatment of textile wastewater.

• Membrane and Water Treatment
• /
• 제13권3호
• /
• pp.121-128
• /
• 2022

A tremendous amount of energy resources is being wasted in cleaning wastewater to save the environment across the globe. Several different procedures are commercially available to process wastewater. In this work, membrane filtration technique is used to treat the textile wastewater because of its cost effectiveness and low environmental impacts. Mixed Matrix Membrane (MMM) consist of Polyvinyl Alcohol (PVA) in which Graphene Oxide (GO) was added as a filler material. Five different membranes by varying the quantity of GO were prepared. The prepared membrane has been characterized by Scanning Electron Microscopy (SEM), X-Ray Diffractometry (XRD), Fourier Transformed Infrared Spectroscopy (FTIR) and Water Contact Angle (WCA). The prepared membranes have been utilized to treat textile wastewater. The synthesized membranes are used for the elimination of total dissolve solids (TDS), total suspended solids (TSS), Methylene blue (MB) dye and copper metallic ions from textile wastewater. It is concluded that amount of GO has direct correlation with the quality of wastewater treatment. The maximum removal of TDS, TSS, MB and copper ions are found to be 7.42, 23.73, 50.53 and 64.5% respectively and are achieved by 0.02 wt% PVA-GO membrane.

• 멤브레인
• /
• 제32권4호
• /
• pp.227-234
• /
• 2022

폐수는 석유 정제 산업에서만 방출되는 것이 아니고 아니라 가죽, 섬유, 페인트, 목재, 염료 가공 산업에서 또한 방출된다. 이런 산업 폐수는 중금속과 질소화합물 등 수질오염물질을 포함하고 있으며 화학적 산소요구량(COD)이 높다. 안전한 처리를 위해 폐수에서 각종 오염물질을 걸러내는 방식이 있지만 막 기반 기술은 고효율, 저비용으로 가장 효율적인 방법 중 하나이다. 다양한 막 중에서, 제올라이트 막은 가성비로 주목을 받고 있으며 많은 연구를 거쳤다. 본 리뷰논문은 i) 폐수처리, ii) 미세여과막, iii) 중공사막, iv) 초여과막의 순서로 폐수처리를 위한 제올라이트 막의 최근 진척을 중점으로 다루고 있다.