• Journal of the Korean Society for Nondestructive Testing
• /
• v.18 no.3
• /
• pp.163-171
• /
• 1998

Near/far field length and directivity of transducers were investigated for the improvement and evaluation of the detectability of flaws in a disc. The reference block is fabricated for the disc of stage 6 in Yonggwang unit 1. The near/far field and directivity of an ultrasonic transducer with the center frequency of 5MHz were calculated for the inspection of the disc. These values showed good agreements with the experimental results. In the system composed of a wedge and a disc, those are evaluated theoretically and experimentally for the specimen with the artificial flaws of the size 2mm and 4mm and an ultrasonic transducer with the center frequency 5MHz and diameter 0.5inch. The detectability of keyway-flaw and detectable region for inspection were evaluated by using both tangential $45^{\circ}$ and $90^{\circ}$ transducers located at the distance of 53mm and 75mm from the disc hub, respectively.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.44 no.4
• /
• pp.423-430
• /
• 2011

The most satisfactory split-beam transducer for fish sizing maintains a wide bearing angle region for correct fish tracking without interference from side lobes and lower sensitivity to fish echoes outside of the main lobe region to correctly measure the angular location of free-swimming fishes in the sound beam. To evaluate the performance of an experimentally developed 50 kHz split-beam transducer, the angular location of a target was derived from the electrical phase difference between the resultant signals for the pair of transducer quadrants in the horizontal and vertical planes consisting of 32 transducer elements. The electrical phase difference was calculated by cross-spectral density analysis for the signals from the pair of receiving transducer quadrants, and the directivity correction factor for a developed split-beam transducer was estimated as the fourth-order polynomial of the off-axis beam angle for the angular location of the target. The experimental results demonstrate that the distance between the acoustic centers for the pair of receiving transducer quadrants can be controlled to less than one wavelength by optimization with amplitude-weighting transformers, and a smaller center spacing provides a range of greater angular location for tracking of a fish target. In particular, a side lobe level of -25.2 dB and an intercenter spacing of $0.96\lambda$($\lambda$= wavelength) obtained in this study suggest that the angular location of fish targets distributing within a range of approximately ${\pm}28^{\circ}$ without interference from side lobes can be measured.

• Korean Journal of Human Ecology
• /
• v.20 no.1
• /
• pp.243-255
• /
• 2011

The purpose of this study was to learn the lifestyles of college students based on the green building certification system. The importance for environmentally friendly housing patterns will be changed and predicted to provide the basis for future residential development. The subjects of this research were 706 college students living in Jeonbuk province. The results of this research were as follows. College students' lifestyles were measured by self-confidence, family orientation, leisure orientation, economic orientation, and a digital directivity by factor analysis. In eco-friendly residential ratings, as the results of analysis according to the land use, the transportation, the energy resources, the environment load, the ecosystems, the interior environment, and the soundproofing of the interior environment came out to be higher than other factors. While coming out to be higher in the lower group in a digital directivity, the life style of the college students mostly came to be higher in the average of importance for environment-friendly housing. This result means that the college students want environment-friendly housing while attaching importance to the convenience of daily life, especially a digital directivity of housing. Thus, when we plan residences in the future, we will have to reflect the environment-friendly housing on the basis of the results of this research, and improve the environment which is contributing to help form college students' characters well.

• The Journal of Korean society of community based occupational therapy
• /
• v.3 no.2
• /
• pp.67-74
• /
• 2013

Objective : The purpose of this study is to investigate the relation between sociodemographic characteristics and attitude of job for occupational therapist. Method : Among 125 occupational therapists who voluntarily responded on structured survey final subject of study is total 123 persons except two occupational therapists who did not respond completely. Result : Attitude of Job was significantly different according to employment status and hospital types, and job stress was significantly different according to employment status and job directivity was significantly different according to hosipital types. Also, for correlation of job attitude, job satisfaction was high as higher job stability, lower job stress, and higher job directivity. Conclusion : To improve attitude of job, employment status should be regularized and the education and improvement of labor conditions are necessary to improve attitude of job and job directivity.

• Journal of the Institute of Convergence Signal Processing
• /
• v.11 no.2
• /
• pp.151-156
• /
• 2010

This paper is a study on image noise reduction of modified sigma filter by image decomposition using directivity. Conventional sigma filter has been shown to be a good solution both in terms of filtering accuracy and computational complexity. However, the sigma filter does not preserve well small edges especially for high level of additive noise. In this paper, we propose here a new method using a modified sigma filter. In our proposed method the input image is first decomposed in two components that have features of horizontal, vertical and diagonal direction. Then, two components are applied HPF and LPF. By applying a conventional sigma filter separately on each of them, the output image is reconstructed from the filtered components. Added noise is removed and our proposed method preserves the edges from the image. Comparative results from experiments show that the proposed algorithm achieves higher gains, on average, 2.6 dB PSNR than the sigma filter and 0.5 dB PSNR than the modified sigma filter. When relatively high levels of noise added, the proposed algorithm shows better performance than two conventional filters.

• Journal of Korean Association for Spatial Structures
• /
• v.10 no.3
• /
• pp.75-80
• /
• 2010

The present study tried to provide useful data for the acoustic design of sound amplification system with measuring and analyzing subjective preference and intelligibility by varying the number of speakers and their directivity. The results suggest that the room absorption plays a key role in subjective responses of listeners and the large sound absorption of ceiling contributes to the increase of intelligibility. Also, larger number of speakers with narrow directivity improves perceived intelligibility when speakers were installed at the lower height. However, the highest degree of intelligibility and preference were obtained when speakers were installed close enough to the sound absorptive ceiling. The highest intelligibility and preference were observed when 8 to 10 speakers with the directivity of 60 degree were used.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.7 no.3
• /
• pp.15-21
• /
• 2003

This experimental study describes the propagation characteristics of the impulse noise emitted from the exit of a perforated pipe attached to the open end of a simple shock tube facility. The pressure amplitudes and directivities of the impulse wave propagating outside from the exit of pipe with several different configurations are measured and analyzed for the range of the incident weak shock wave Mach number between 1.02 and 1.2. In the experiments. the impulse waves are visualized by a Schlieren optical system for the purpose of understanding their propagation characteristics. The results obtained show that for the near sound field the impulse noise strongly propagates toward the pipe axis, but for the far sound field the impulse noise uniformly propagates toward the omnidirections, indicating that the directivity pattern is almost same regardless of the pipe type. For this non-directivity in the far sound field, it is shown that the perforated pipe has little performance to suppress the impulse noise.

• Earthquakes and Structures
• /
• v.8 no.6
• /
• pp.1363-1386
• /
• 2015

The October 23 2011 Van Earthquake is studied from an earthquake engineering point of view. Strong ground motion processing was performed to investigate features of the earthquake source, forward directivity effects during the rupture process as well as local site effects. Strong motion characteristics were investigated in terms of peak ground motion and spectral acceleration values. Directiviy effects were discussed in detail via elastic response spectra and wide band spectograms to see the high frequency energy distributions. Source parameters and slip distribution results of the earthquake which had been proposed by different researchers were summarized. Influence of the source parameters on structural response were shown by comparing elastic response spectra of Muradiye synthetic records which were performed by broadband strong motion simulations of the earthquake. It has been emphasized that characteristics of the earthquake rupture dynamics and their effects on structural design might be investigated from a multidisciplinary point of view. Seismotectonic calculations (e.g., slip pattern, rupture velocity) may be extended relating different engineering parameters (e.g., interstorey drifts, spectral accelerations) across different disciplines while using code based seismic design approaches. Current state of the art building codes still far from fully reflecting earthquake source related parameters into design rules. Some of those deficiencies and recent efforts to overcome these problems were also mentioned. Next generation ground motion prediction equations (GMPEs) may be incorporated with certain site categories for site effects. Likewise in the 2011 Van Earthquake, Reverse/Oblique earthquakes indicate that GMPEs need to be feasible to a wider range of magnitudes and distances in engineering practice. Due to the reverse faulting with large slip and dip angles, vertical displacements along with directivity and fault normal effects might significantly affect the engineering structures. Main reason of excessive damage in the town of Erciş can be attributed to these factors. Such effects should be considered in advance through the establishment of vertical design spectra and effects might be incorporated in the available GMPEs.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.31 no.4
• /
• pp.267-271
• /
• 2018

A high directivity TIR (total internal reflection) lens in the UV-A region was designed using a silicone resin, and a UV light source module with a maximum irradiation density of $150mW/cm^2$ was fabricated. The beam angle of the TIR lens was designed to be $8.04^{\circ}$ and the maximum diameter of the TIR lens was Ø13.5. A silicone resin having a UV transmittance of 93% and a refractive index of 1.4 at a wavelength of 365 nm was used, and the lens was manufactured using an aluminum mold, from which silicone could be easily released. The module was fabricated in a metal printed circuit board of COB (chip on board) type using a $0.75{\times}0.75mm^2$ UV chip. A jig was used to adjust the focal length between lens and chip and to fix the position of the lens. The optical characteristics such as illumination distributions of the lens and module were designed using 'LightTools' optical simulation software. The heat dissipation system was designed to use a forced-air cooling method using a heat-sink and fan.

• Journal of the Korean Institute of Navigation
• /
• v.5 no.2
• /
• pp.1-39
• /
• 1981

A doppler log is the typical device which can measure the ship's speed over the ground directly, by means of doppler effect of the underwater ultrasonic wave, which involves the error due to the sea bottom inclination, the trim and the incorrect transducer installation etc. The present doppler log adopts a single transducer, faced in the direction of themain beam, and therefore it is unable to correct the beam direction to eliminate the above mentioned error. Moreover, the frequencyis also limitted in a comparatively high range for getting a sharp beam with single transducer, and the speed over the ground can not be detectable at the deep sea, for an instance, over 200 meters. This paper describes a theoretical consideration for the doppler log error and an analysis by a computer on the observed speed data by a full size model ship. The result is verified that the most of doppler log error is caused by the ultrasonic beam angle of transducer. To eliminate the doppler log error due to the incorrect transducer installation and also to sharpen the beam for lower frequency range to expand measurable sea depth, this paper proposes a method of controlling the directivity adopting a linear transducer array and of controlling the directivity by the control of exciting current, and investigates by the computer simulation and make experiment with magnetostrictive ferrite transducer of 28, 50 and 75KHz. The experimental results are shown well coincide with the measured ones, and they are revealed that in case where the transducer interval is greater than 1 wavelength, the effective control of the beam direction is hardly performed with keeping adequate beam width and side lobe level. It is concluded that 6-elements array with inter element space of a half wavelength can make comparatively sharp beam and low side lobe level. The results obtained here will contribute very much to the improvement of the performance of doppler log.