• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.8
• /
• pp.1392-1398
• /
• 2000

In this paper, Sub Harmonic Ring Mixer using Anti-Parallel Diode Pair is studied. Conventional mixers mix LO signal with RF signal and, obtain IF signal from the difference between LO and RF. Sub harmonic ring mixers using APDP mix RF signal with the second harmonic of LO signal, LO frequency needed for conventional receiver is reduced by 1/2.The produced mixer showed 12 dB conversion loss, and 1 dB compression point of IF signal, in respect to RF signal, was found at the 0 dBm RF signal. Isolation LO/IF and LO/RF is 24.6 dB and 22.5 dB respectively. Isolation RF/LO and LO/RF is 32.6 dB and 22.5 dB respectively.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.2
• /
• pp.484-493
• /
• 2004

A new lightwave locking technique which can be used in tuning the wavelength of a local laser diode to the reference wavelength is presented in this paper. The optical frequency from the reference laser source and the optical frequency from the local slave VCO laser are heterodyned on a optical receiver, resulting in the 1.5GHz RF signal corresponding to the difference frequency between two input optical signals. The difference frequency is locked to the reference 1.5GHz oscillator source in off-set frequency locking loop. Using the commercialized microwave components, frequency difference detector can be easily established to lock the lightwave. The optical frequency of 1.55um laser diode which keeps the frequency off-set of 1.5GHz is locked to the input reference optical signal with the locking range of 320MHz.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.2
• /
• pp.46-54
• /
• 2007

In this paper, we introduce the performance of improved symbol timing detection by the superposed difference type symbol timing detection method in the OFDM system. Also, we represent the maximum detection probability of symbol synchronization timing at each received delay signal in multipath channel delay profile in the correlation and difference type symbol timing detection methods. The computer simulation results show that the correlation symbol timing detection method have maximum detection probability at the lead of the nth received delay signal of highest amplitude, but the difference type symbol timing detection method always have maximum detection probability at the lead of the first received delay signal in the channel delay spread of $70nsec{\sim}217nsec$. The simulation results indicate the possibility of the perfect detection of OFDM symbol synchronization timing and it fit well with the results of improved S/N to the eb/n0 and the performance of symbol timing detection of the proposed method.

• Journal of Satellite, Information and Communications
• /
• v.10 no.4
• /
• pp.146-150
• /
• 2015

The COSPAS-SARSAT committee decides MEOSAR (Medium-Earth Orbit for search and rescue) service development for installing 406MHz SAR instruments on their respective MEO navigation satellite system of the United States, EU, and Russia, since 2000. The transmitted beacon signal is separately arrived by satellites with different FOA (Frequency of Arrival) and TOA (Time of Arrival). It is directly transferred to MEOLUT. In MEOLUT, a LUT track at least 3 or 4 satellites simultaneously and estimate location of beacon using time difference of arrival (TDOA) and frequency difference arrival (FDOA). But the transmitted distress signals may be overlapped each other because the distress beacons transmit signal on mean interval of 50 seconds in arbitrary time. It's difficult that simultaneously estimate location of beacon by current scheme for several overlapped distress signal. So we use cross ambiguity function (CAF) Map algorithm and present Multi-CAF MAP scheme in order to satisfy performance requirement of system. The performance is analyzed for COSAPS-SARSAT MEOSAR.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.2
• /
• pp.154-159
• /
• 2019

When measuring the radiating noise of an underwater moving source, the range information between the acoustic source and the receiver is an important evaluation factor, and the measurement standards such as a receiver position, a moving source depth and a speed are set. Although there is a method of using the cross correlation as a method of finding the range of the underwater moving source, this method requires a time synchronization process. In this paper, we proposed the method to estimate the range by comparing the Doppler frequency difference of the theoretically calculated multipath signal with the Doppler frequency difference of the multipath signal estimated from the received signal. The proposed method does not require a separate time synchronization process. Simulations were performed to verify the performance, and the ranging error of the proposed method reduced by about 95 % than that of the conventional method.

• Science of Emotion and Sensibility
• /
• v.23 no.3
• /
• pp.3-10
• /
• 2020

This study is aimed at investigating drivers' reactions to yellow signal dilemma situations as a result of the existing signal system, and developing a new signal system. A driver-centered coping model was developed through bio-signal analysis. The driver's physiological response in the existing signal system was observed, and the signal system was developed by applying intersection road driving conditions using a car graphic simulator. Participants were classified into a control group (existing signal system) and an experimental group for a new yellow signal system (new signal system). Based on the results, the emergence of parasympathetic nerves was higher in the experimental group than in the control group, where a statistically significant difference was observed (p < 0.05). The newly developed signal system appeared to cause tension among drivers; however, the sympathetic to parasympathetic nerve ratio was 6: 4, which could be interpreted as an ideal balance. We conclude that drivers can drive more stably if the coping signal system developed in this study is applied to the traffic system.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.5
• /
• pp.11-16
• /
• 1998

DS/CDMA systems for the high speed communication require high code rats. In discrete time CDMA receivers, the performance degradation, caused by the phase difference between transmission code and reference code, increase the sampling frquency of the receiver. This increment of the sampling frequency makes hard to implement high speed CDMA systems. This paper analyzes the SIR(signal to interference Ratio) performance of the discrete time DS/CDMA system, based on the code phase difference. The results of this paper may be useful to study a low-sampling CDMA receiver.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.10 no.1
• /
• pp.77-84
• /
• 2017

Generally, a time-varying vibration signal is generated in a rotating machine system, and when there is a failure in the rotating machine, the signal contains noise. In this paper, we propose a system consisting of an adaptive predictor and a binary tree filter bank for analyzing time - varying vibration signals with noise. And the vibration signal analyzed results in this system is used for fault diagnosis of the rotating machine. The adaptive predictor of the proposed system predicts the periodic signal components, and the filter bank system decomposes the difference signal between the input signal and the predicted periodic signal into subband. Since each subband signal includes a noise signal component due to a failure, it is possible to diagnose the failure of the using rotary machine. The validity of the proposed vibration signal analysis method is shown in the simulations, where the periodic components cancelled vibrating signals are decomposed to 32 subband, and the signal characteristics related faults are analyzed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.11
• /
• pp.1044-1050
• /
• 2013

This paper analyzes what is mitigated as spoofing attack using the U-Blox Receiver and GPS RF signal generator developed at ETRI. Generally the spoofing attack made the target receiver to be wrong navigation solution by providing false measurement of code and carrier. So we analyzed the impact of spoofing attack through the signal strength and navigation solution. In oder to test of effect of anti-spoofing signal, we consider the signal with antiphase code to spoofing signal and generated GPS normal signal and spoofing signal and anti-spoofing signal using GPS RF signal generator. This paper analyzed that the GPS receiver was responded to the spoofing attack according to code phase difference between spoofing and anti-spoofing signal. We confirmed that the spoofing signal was disappeared by anti-spoofing signal if code phase is an exact match.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.8
• /
• pp.1076-1082
• /
• 2018

This paper describes interferometer direction finder which measures the angle of arrival based on calculation of the phase difference of received radio signal from different antennas. Modern Electronic Warfare direction finder uses digital phase difference measuring techniques which have less effect on temperature variation and better performance under low Signal to Noise Ratio environment. In this paper, we analyze acceptable phase difference error for requirement of system's direction finding accuracy and introduce digital phase difference calculation techniques. We have investigated quantitative analysis on phase difference calculation according to sample number, SNR, interference injection. Through the simulation, frequency domain measurement technique is better performance than the time domain one at the environment of low SNR and interference injection. Proposed method can be used to determine the performance of interferometer direction finder.