• Journal of Korean Society of Forest Science
• /
• v.80 no.2
• /
• pp.187-192
• /
• 1991

This study was carried out to estimate the stand volume for Japanese larch(Larix leptolepis) by Strand sampling method. The data collected for this study were based on the 380 sample plots from the field survey, which were distributed in the major part of Korea(Kyeongi, Kangweon, Chungbuk, Chungnam, Chunbuk and Kyeongbuki), and the plotless sampling instrument such as dendrometer, spiegel relascope and tele-relascope were used. The procedure for this study is summarized briefly as follows : 1. There were not only significant differences between volume estimation by Strand sampling method and that by plot survey method, and the relationship was y=bx, where b approached nearly 1. Therefore, the stand volume of Japanese larch could by estimated by Strand sampling method. 2. The value measured by three different plotless sampling instruments did not showed any significant differences between instruments and observers, density and instruments, and ground slope and instruments. 3. With the stand volume, basal area height showed the highest correlation and stand form height, average height, basal area per ha correlated with the volume in thier orders. 4. The best fitted equation of stand volume estimation with basal area height by relascope was as follow. log V=-0.0375+0.8910 log GH-1.5946 1/GH Stand volume table also was obtained using the above estimeated equation. 5. The relationship between estimated value and actual value was Y=bx, where b was nearly 1. The correlation coefficient was very high and the percentage of estimated error was 4.5%.

• Food Science of Animal Resources
• /
• v.33 no.3
• /
• pp.390-394
• /
• 2013

The aim of this study was to determine the optimal storage condition of pre-packed Hanwoo beef without freezing. Hanwoo loin was purchased from a local distributor at 48 h after slaughter, then sliced in $1.5{\pm}0.5$ cm thickness, and packed in a polyethylene (PE) tray covered with linear low-density polyethylene (LLDPE) film. The studied factors to set the optimal storage condition were chamber temperature (5, 2.5 and $-1^{\circ}C$ for 14 d), cooling method (direct and indirect cooling system), and ultraviolet (UV) light irradiation for beef surface sterilization (0, 30, 60, and 120 min). The changes of pH, thiobarbituric acid reactive substances (TBARS) and number of aerobic bacteria were measured during storage. Beef samples stored in $-1^{\circ}C$ showed the minimal increasing rate in TBARS and microbial growth. After 15 d of storage, there was no significant difference in pH and TBARS values. However, the microbial population of beef stored in direct type cooling chamber ($4.25{\pm}0.66$ Log CFU/g) was significantly lower than that of beef stored in indirect type chamber ($6.47{\pm}0.08$ Log CFU/g) (p<0.05). After 4 d of storage, 60 or 120 min UV light irradiated beef samples showed significantly lower microbial population, and at 14 d of storage, 60 min UV irradiated beef sample showed significantly lower microbial population ($3.14{\pm}0.43$ Log CFU/g) than control ($4.46{\pm}0.13$ Log CFU/g) (p<0.05). However, TBARS values of 60 or 120 min UV light irradiated beef samples were significantly higher than non-irradiated beef sample after 4 d of storage (p<0.05).

• The Journal of Engineering Geology
• /
• v.17 no.3
• /
• pp.483-494
• /
• 2007

The properties of fracture system on road-cut slopes along the Busan-Ulsan express way under construction are investigated and analyzed. Fracture spacing distributions show log-normal form with extension fractures and negative exponential form with shear fractures. Straight line segments in log-log plots of cumulative fracture length indicate a power-law scaling with exponents of -1.13 in site 1, -1.01 in site 2 and -1.52 in site 3. It is likely that the stability and strength of rock mass are the lowest in site 1 as judged from the analyses of spacing, density and inter-section of fractures in three sites. In contrast, the highest efficiency of the fracture network for conducting fluid flow is seen in site 3 where the largest cluster occupies 73% through the window map. Based on the field survey data, this study modified weighting values of the RMR system using a multiple regression analysis method. The analysis result suggests a modified weighting values of the RMR parameters as follows; 18 for the intact strength of rock; 61 for RQD; 2 for spacing of discontinuities; 2 for the condition of discontinuities; and 17 for ground water.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.35 no.6
• /
• pp.146-154
• /
• 2023

In this study, the peak wave period T_p and mean wave period T₀₂ and T_{m-1, 0}, which are major parameters for classifying ocean characteristics, were calculated using water surface elevation data observed from the second west coast oceanographic and meteorological observation tower. In addition, the ratio of abnormal data, correlation analysis, and optimal probability density function were estimated. In the case of T_p among the calculated representative periods, the proportion of abnormal data was 5.73% and 0.67% at each point, and T₀₂ was 4.35% and 0.01%. T_{m-1, 0} was found to be 2.82% and 0.03%. Meanwhile, as a result of analyzing the relationship between T₀₂ and T_p, the relationship was calculated to be 0.53 and 0.63 for each point. The relationship between T_{m-1, 0} and T_p was 1.15 and 1.32, respectively, and T₀₂, T_{m-1, 0} was 1.18 and 1.22. As a result of estimating the optimal probability density function of the calculated representative period, T_p followed the 'Log-normal' and 'Normal' distributions at each point, and T₀₂ was 'Gamma', 'Normal' distribution and T_{m-1, 0} showed that 'Log-normal' and 'Normal' distribution were dominant, respectively. It is decided that these results can be used as basic data for wave analysis conducted on the west coast.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.7C
• /
• pp.611-617
• /
• 2010

In this paper, we investigate the performances of the serial concatenated convolutional codes (SCCC) and low-density parity-check (LDPC) codes on perpendicular magnetic recording (PMR) channels. We discuss the performance of two systems when user bit-densities are 1.7, 2.0, 2.4 and 2.8, respectively. The SCCC system is less complex than LDPC system. The SCCC system consists of recursive systematic convolutional (RSC) codes encoder/decoder, precoder and random interleaver. The decoding algorithm of the SCCC system is the soft message-passing algorithm and the decoding algorithm of the LDPC system is the log domain sum-product algorithm (SPA). When we apply the iterative decoding between channel detector and the error control codes (ECC) decoder, the SCCC system is compatible with the LDPC system even at the high user bit density.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.47-47
• /
• 2009

The photoconductive $CdGa_2Se4$ layer has been investigated using photocurrent (PC) spectroscopy as a function of temperature. Three peaks corresponding to the band-to-band transitions were observed in the PC spectra for all temperature ranges. Also, contrary to our expectation, the PC intensities decreased with decreasing temperatures. From the relation of log $J_{ph}$ vs 1/T, where $J_{ph}$ is the PC density, two dominant levels by the exponential variation of the PC with varying temperature were observed, one at high temperatures and the other at low temperatures.

• Proceedings of the Korean Environmental Health Society Conference
• /
• 2005.11a
• /
• pp.154-159
• /
• 2005

The markers for Environmental Tobacco Smoke(ETS) a.e necessary to obtain, to interpretate and to provide the data of quantitative exposure assessment. The purpose of this research is to evaluate Indoor environment using the concentration of ETS and the correlations between markers(RSP, nicotine, 3-EP) and environmental conditions(smoking density, ventilation rate). The mean ACH(air change per hour) in smoking rooms showed non-compliance with ASHRAE standard value. The concentrations of RSP, 3-EP, nicotine showed log-normal distributions, and became different statistically depending on smoking condition(p<0.01). The geometric mean concentration of RSP in smoking room was 441.7 ${\mu}g/m^3$ that is far exceeded environmental standard(150 ${\mu}g/m^3$). The correlation coefficients between RSP and SI, 3-EP and SI, and Nicotine and SI were 0.67, 0.84, 0.74 respectively. The correlation coefficient between nicotine and 3-EP, Nicotine and RSP, and RSP and 3-EP were 0.76, 0.78, 0.57 respectively.

• Journal of the Korean Society of Combustion
• /
• v.6 no.2
• /
• pp.43-49
• /
• 2001

Instantaneous, three-dimensional scalar dissipation rates of the reaction progress variable are measured in turbulent premixed Bunsen flames of lean hydrocarbon/air mixtures with the two-sheet, two-dimensional Rayleigh scattering technique. The flames investigated are located in the turbulent flame-front regime on a newly proposed combustion diagram for premixed flames. The conditionally-averaged mean scalar dissipation rates, $N_{\zeta}$ are found to be lower than the calculated laminar values, indicating a locally broadened flame front. In agreement with previous measurements, the maximum of $N_{\zeta}$, decreases strongly with increasing Karlovitz numbers. The conditional probability density functions are close to a log-normal distribution for scalar dissipation rates conditioned at the progress variable value where the scalar dissipation is maximum in unstretched laminar flame calculations. The time scale for the Favre-averaged mean scalar dissipation rate decreases in general across the turbulent flame brush from the unburnt to burnt side.

• Communications for Statistical Applications and Methods
• /
• v.23 no.4
• /
• pp.321-334
• /
• 2016

In this paper, we propose power t distribution based on t distribution. We also study the properties of and inferences for power t model in order to solve the problem of real data showing both skewness and heavy tails. The comparison of skew t and power t distributions is based on density plots, skewness and kurtosis. Note that, at the given degree of freedom, the kurtosis's range of the power t model surpasses that of the skew t model at all times. We draw inferences for two parameters of the power t distribution and four parameters of the location-scale extension of power t distribution via maximum likelihood. The Fisher information matrix derived is nonsingular on the whole parametric space; in addition we obtain the profile log-likelihood functions on two parameters. The response plots for different sample sizes provide strong evidence for the estimators' existence and unicity. An application of the power t distribution suggests that the model can be very useful for real data.

• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.604-609
• /
• 2003

Flaw geometries, applied stress, and material properties are major input variables for the fracture mechanics analysis. Probabilistic approach can be applied for the consideration of uncertainties within these input variables. But probabilistic analysis requires many assumptions due to the lack of initial flaw distributions data. In this study correlations are examined between initial flaw distributions and in-service flaw distributions on structures under cyclic load. For the analysis, LEFM theories and Monte Carlo simulation are applied. Result shows that in-service flaw distributions are determined by initial flaw distributions rather than fatigue crack growth rate. So initial flaw distribution can be derived from in-service flaw distributions.