• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.3C
• /
• pp.329-340
• /
• 2009

This paper proposes a novel code tracking scheme to track the fine code synchronization for BOC(pn,n) modulated spreading signals. The correlation function of BOC(pn,n) modulated spreading signals has been several peaks. In this paper, we observe that the correlation function in the advanced offset region remains almost unchanged, due to the multipath signals being received later than a line-of-sight signal. Based on this observation, we propose a novel code tracking scheme which is called the advanced region correlation (ARC) method for BOC(n,n) modulated spreading signals. And, we compare with the code tracking accuracy between the conventional and proposed methods in the static multipath and land mobile satellite system channels through the Monte-Carlo simulation. Then, base on the proposed scheme, we propose the generalized-ARC (ARC) scheme for BOC(pn, n) modulated spreading signals.

• Explosives and Blasting
• /
• v.17 no.1
• /
• pp.27-55
• /
• 1999

The excavation works for deep foundation in urban areas have recently increased complaints of blasting vibration and settlement of ground level. Foundation must be excavated approximately up to 24-28m depths from the surface. The roads and subway line pass through the excavation area. The Dae-chung station is also located at the nearest distance 5-35m from the working site. To protect subway station and adjacient some structures from blasting and settlement, the level of ground vibration, displacements and stress were monitored and analyzed. The results can be summarized as follows ; 1. An empirical particle velocity equation were obtained by test blasts at Nassan Missi 860 Office tel construction site. $V{\;}={\;}K(D/\sqrt{W})^{-n}$, where the values for n and k are estimated tobe 0.371 and 1.551. From this ground vibration equation, the max. charge weight per delay time against distance from blasting point is calculated. Detailed blasting method is also presented. 2. To measure the horizontal displacement in directions perpendicular to the borehole axis, 6 inclinometers installed around working sites. The displacement at the begining was comparatively high because the installation of struts was delayed, but after its installation the values showed a stable trend. Among them, the displacement by 3 inclinometers installed on a temporary parking area showed comparatively high values, for example, the displacement measured at hole No. IC-l recoded the max. 47.04mm for 6 months and at hole No. IC-2 recorded the max. 57.33mm for 7 months. So, all of these data was estimated below a safe standard value 103mm. 3. Seven strain gauge meter was installed of measure the magnitude and change of stress acted on structs. The measured value of maximum stress was $-465{\;}kgf/\textrm{cm}^2,{\;}-338.4{\;}kgf/\textrm{cm}^2,{\;}302.3{\;}kgf/\textrm{cm}^2$ respectively. In compareto the allowable stress level of steel, they are estimated to be safe.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.1B
• /
• pp.89-98
• /
• 2000

This paper presents an active noise cancelling model using wavelet transform and subband filter banks based on adaptive filter. The analysis filter banks decompose input and error signals into QMF filter banks of lowpass and highpass bands. Each filter bank uses wavelet filter with dyadic tree structure. The decomposed input and error signals are iterated by adaptive filter coefficients of each subband using filtered-X LMS algorithm. The synthesis filter banks make output signal of wideband with perfect reconstruction to prepare adaptive filter output signals of each subband. The analysis and synthesis niter hants use conjugate quadrature filters for Pefect reconstruction. Also, The delayed LMS algorithm model for on-line identification of error path transfer characteristics is used gain and acoustic time delay factors. The proposed adaptive active noise cancelling modelis suggested by system retaining the computational and convergence speed advantage using wavelet subband filter banks.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.71-71
• /
• 2012

As the critical dimensions of integrated circuits are scaled down, the line width and spacing between the metal interconnects are made smaller. The dielectric film used as insulation between the metal lines contributes to the resistance-capacitance (RC) time constant that governs the device speed. If the RC time delay, cross talk and lowering the power dissipation are to be reduced, the intermetal dielectric (IMD) films should have a low dielectric constant. The introduction of Cu and low-k dielectrics has incrementally improved the situation as compared to the conventional $Al/SiO_2$ technology by reducing both the resistivity and the capacitance between interconnects. Some of the potential candidate materials to be used as an ILD are organic and inorganic precursors such as hydrogensilsequioxane (HSQ), silsesquioxane (SSQ), methylsilsisequioxane (MSQ) and carbon doped silicon oxide (SiOCH), It has been shown that organic functional groups can dramatically decrease dielectric constant by increasing the free volume of films. Recently, various inorganic precursors have been used to prepare the SiOCH films. The k value of the material depends on the number of $CH_3$ groups built into the structure since they lower both polarity and density of the material by steric hindrance, which the replacement of Si-O bonds with Si-$CH_3$ (methyl group) bonds causes bulk porosity due to the formation of nano-sized voids within the silicon oxide matrix. In this talk, we will be introduce some properties of SiOC(-H) thin films deposited with the dimethyldimethoxysilane (DMDMS: $C_4H_{12}O_2Si$) and oxygen as precursors by using plasma-enhanced chemical vapor deposition with and without ultraviolet (UV) irradiation.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.4
• /
• pp.1344-1367
• /
• 2014

Mobile traffic is increasing a masse because of the propagation of the Internet and the development of wireless mobile technology. Accordingly, the Network Local Mobility Management (NETLMM) working group [1] of the Internet Engineering Task Force (IETF) has standardized Proxy Mobile IPv6 (PMIPv6) [2] as a protocol for accomplishing the transmissibility of mobile terminals. PMIPv6 is a network-led IP-based mobility management protocol, which can control terminal mobility without depending on the type of access system or the capability of the terminal. By combining PMIPv6 and the mobility of Session Initiation Protocol (SIP), we can establish terminal mobility and session mobility through a more effective route. The mobility function can be improved and the overlap of function reduced as compared to that in the case of independent operation. PMIPv6 is appropriate for a non-real-time service using TCP, and SIP is appropriate for a real-time service using RTP/UDP. Thus, in the case of a terminal using both services, an effective mobility management is possible only by using PMIPv6 together with SIP. In order to manage mobility in this manner, researches on PMIPv6-SIP are in progress. In line with this trend, this paper suggests a new PMIPv6-SIP architecture where when a mobile terminal conducts a handover, a network-led handover while maintaining the session without the addition of a special function or middleware is possible along with effective performance evaluation through mathematical modeling by comparing the delay and the packet loss that occur during the handover to the Pure-SIP.

• Journal of Internet Computing and Services
• /
• v.7 no.6
• /
• pp.175-183
• /
• 2006

An ad-hoc network is a group of mobile nodes acting as routers. The of hoc node has a precondition of mobility, allowing path to be easily disconnected when transmitting data, thereby increasing network overhead. However, most of hoc routing protocols set up the path based only on the number of hops without considering other practical factors. Here we consider a path with the least substantial number of transmission (SNT) from source to destination based on reliabilities of links. This includes retransmissions due to unreliable links. In this paper, an efficient ad-hoc link reliability based routing (PU) protocol suitable for mobile ah-hoc network in terms of SNT, is proposed. The network overhead and data transmission delay ore reduced, by considering both ad-hoc link reliability and the number of hops. Our empirical performance evaluation comparing to AODV (8) shows that the enhancement is up to about 31% for SNT depending upon the mobility of nodes.

• Journal of the Institute of Convergence Signal Processing
• /
• v.3 no.2
• /
• pp.30-36
• /
• 2002

This paper describes a nonlinear adaptive noise canceler(ANC) using neural networks(NN) based on filter to make up for the drawback of the conventional ANC with the linear adaptive filter. The proposed ANC was tested its noise rejection performance using broadband time-varying noise signal and compared with the ANC of TDL linear filter. Experimental results show that in cases of nonlinear correlations between the noise of primary input and reference input, the neural network based ANC outperforms the linear ANC with respect to mean square error It is also verified that the recurrent NN adaptive filter is superior to the feedforward NN filter. Thus, we identify that the NN adaptive filter is more effective than the linear adaptive filter for rejection of broadband time-varying noise in the ANC.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.7
• /
• pp.1777-1784
• /
• 1998

The packet error rates of an optical packet switching node with an optical address processor using an EDFA in order to detect M-ary correlation pulses at a fiber-optical delay line matched filter output have been evaluated. Effects of A PIN diode NEP, the gain and noise figure of the EDFA, and the bandwidth of an optical filter on the packet error rate of the switching node have been compared. There is negligible error rate change depending upon the variation of the PIN diode NEP and the EDFA gain. If the bandwidth of the optical filter is below 10 times of the data rate, there is no appreciable effect on the error rate. If the noise figure of the EDFA increases, however, the power penalty increases as much as the noise figure increment at all the bit rates and for address code sets considered in this work.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.3A
• /
• pp.223-232
• /
• 2004

In this paper we propose the hierarchical-based dynamic bandwidth allocation algorithm for multi-class services in Ethernet-PON. The proposed algorithm consists of the high level scheduler in OLT and the low level scheduler in ONU. The hierarchical architecture is able to provide scalability and resource efficiency in Ethernet-PON which has the distributed nature of the scheduling domain, with queues and the scheduler located at a large distance from each other. We also propose three dynamic bandwidth allocation algorithms for the low level scheduler: Proportional Allocation algorithm, Maximum Request First Allocation (MRFA) algorithm and High Priority First Allocation (HPFA) algorithm. We implement the Ethernet-PON standardized in the IEEE 802,3ah using OPNET. We also evaluate and analyze the performance for the proposed algorithms in terms of channel utilization, queuing delay and the amount of remainder.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.2A
• /
• pp.128-133
• /
• 2010

We investigate the optimal chip rate of power or rate adapted direct-sequence code division multiple access (DS/CDMA) communication systems in Nakagami fading channels. We find that the optimal chip rate that maximizes the spectral efficiency depends upon both the channel parameters, such as multipath intensity profile (MIP) and line-of-sight (LOS) component, and the adaptation scheme itself. With the rate adaptation, the optimal chip rate is less than $1/T_m$, irrespective of the channel parameters, where $1/T_m$ is multipath delay spread. This indicates that with the rate adaptation, correlation receiver achieves higher spectral efficiency than RAKE receiver. With the power adaptation, however, the optimal chip rate and the corresponding number of tabs in RAKE receiver are sensitive to MIP and LOS component.