• Current Optics and Photonics
• /
• 제2권1호
• /
• pp.53-58
• /
• 2018

A novel X-band high speed frequency sweep signal generator based on a tunable optoelectronic oscillator (OEO) incorporating a frequency-swept laser is presented and the theoretical fundamentals of the design are explained. A prototype of the generator with tuning range from 8.8552 GHz to 10.3992 GHz and a fine step about 8 MHz is achieved. The generated radiofrequency signal with a single sideband (SSB) phase noise lower than -100 dBc/Hz@10KHz is experimentally demonstrated within the whole tunable range, without any narrow RF band-pass filters in the loop. And the tuning speed of the frequency sweep signal generator can reach to over 1 GHz/s benefiting from applying a novel dispersion compensation modular instead of several tens of kilometers of optical fiber delay line in the system.

• 대한전기학회논문지:전력기술부문A
• /
• 제55권6호
• /
• pp.221-226
• /
• 2006

The current flowing though a power line is measured by a current transformer (CT). Since a CT is a kind of transformer, saturation of magnetic flux in the core may occur when a large primary current flows. This saturation makes the secondary current of a CT distorted and causes problems in the protection point of view. Because of the current distortion, a protection relay cannot collect the correct information showing how the primary power system changed. Consequently, the current distortion may cause the mal-operation or operation time delay of protective relay. In this paper, an algorithm based on AR model and LSQ is proposed to compensate the saturated CT secondary currents. Various test results indicate that the proposed algorithm can accurately compensate a severely distorted secondary current and is not affected by remanence.

• 한국멀티미디어학회논문지
• /
• 제21권9호
• /
• pp.1068-1075
• /
• 2018

We propose a method for driving loudspeakers from class D audio power amplifiers in current mode, instead of in conventional voltage mode, which was impossible with the feedback circuitry. Unlike analog audio amplifiers, Class D audio power amplifiers have signal delay between the input and output signals, which makes it difficult to apply the feedback circuitry for current-mode driving. The idea of the pre-distortion scheme used for the compensation of the non-linearity of RF power amplifiers is adapted to remedy the impedance variation effect of the loudspeakers for current driving. The method uses the speaker model for the pre-distorter to compensate for the speaker impedance variation with frequency. The simulation and test results confirms the validity of the proposed method.

• Journal of Power Electronics
• /
• 제13권4호
• /
• pp.600-608
• /
• 2013

This paper analyzes the effect of the admittance component for the digitally controlled single-phase bridgeless power factor correction (PFC) converter. To do this, it is shown how the digital delay effects such as the digital pulse-width modulation (DPWM) and the computation delays restrict the bandwidth of the converter. After that, the admittance effect of the entire digital control system is analyzed when the bridgeless PFC converter which has the limited bandwidth is connected to the grid. From this, the waveform distortion of the input current is explained and the compensation method for the admittance component is suggested to improve the quality of the input current. Both the simulations and the experiments are performed to verify the analyses taken in this paper for the 1 kW bridgeless PFC converter prototype.

• ETRI Journal
• /
• 제28권5호
• /
• pp.680-683
• /
• 2006

One objective in developing the next generation of wireless communication systems is to increase data rates and reliability. A promising way to achieve this is to combine multiple-input and multiple-output signal processing with a space-time coding scheme, which offers higher coding and diversity gains and improves the spectrum efficiency and reliability of a wireless communication system. It is noted, however, that time delay differences and phase differences among different channels increase symbol interference and degrade system performance. In this letter, we investigate phase differences and their effects on multiple-input and multiple-output systems, and propose a compensation algorithm for the Rayleigh fading model to minimize their effects.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제53권8호
• /
• pp.500-508
• /
• 2004

This paper presents a new sensorless vector control system for high performance induction motor drives fed by a matrix converter with non-linearity compensation and disturbance observer. The nonlinear voltage distortion that is caused by commutation delay and on-state voltage drop in switching device is corrected by a new matrix converter modeling. The lumped disturbances such as parameter variation and load disturbance of the system are estimated by the radial basis function network (RBFN). An adaptive observer is also employed to bring better responses at the low speed operation. Experimental results are shown to illustrate the performance of the proposed system.

• 전자공학회논문지SC
• /
• 제42권1호
• /
• pp.13-21
• /
• 2005

본 논문에서는 시간지연과 입력포화를 갖는 카오스 시스템에 대한 퍼지 모텔 기반의 동기화 기법을 제안한다. 시간지연을 갖는 카오스 마스터 시스템과 슬레이브 시스템을 모델링하기 위해 Takagi-Sugeno(T-S) 퍼지 모델을 이용한다. 특히 슬레이브 시스템은 제어 입력이 제한되는 입력포화 특성을 갖는다고 가정한다. 선형 오차 피드백과 병렬 분상 보상(PDC) 방법에 따라 퍼지 카오스 동기화 시스템을 설계하고 동기화 오차 시스템의 국소 안정도 조건을 해석한다. 신호 전송 채널에는 시간지연이 항상 존재하므로 채널 시간지연 또한 고려한다. 입력포화와 시간지연을 갖는 퍼지 동기화 시스템의 국소 안정도에 대한 충분 조건은 Lyapunov-Krasovskii 이론을 적용하여 선형 행렬 부등식 (LMI) 문제의 해를 통해 얻어진다. 제안된 동기화 기법의 효과를 확인하기 위해서 모의 실험을 수행한다.

• 한국정보통신학회논문지
• /
• 제22권4호
• /
• pp.683-690
• /
• 2018

본 논문에서는 배열 안테나 기반의 MVDR (minimum variance distortionless response) 항 재밍 GPS (global positioning system) 수신기에서 안테나 경로 사이에 존재하는 이득, 위상, 지연 편차를 교정하기 위한 안테나 교정 기법을 제안한다. 제안하는 기법은 다중 안테나 시스템에서 안테나 경로들 사이의 이득, 위상, 지연 편차를 추정하고 이를 보상한다. 경로 간 이득, 위상, 지연 편차를 정확히 추정하기 위해 좋은 상관 특성을 갖는 파일럿 신호가 사용된다. 교차 상관에 기반하여 지연 편차가 먼저 추정되며 이후에 이득과 위상 편차가 추정된다. 정밀한 지연 편차 추정 및 보상을 위해 보간기법을 사용하는데 이산 푸리에 변환 (DFT) 기반의 보간기법으로 계산 복잡도를 감소시킨다. 제안된 기법은 MATLAB을 이용한 컴퓨터 모의실험을 통해 검증한다. 모의실험 결과에 따르면 제안하는 기법을 적용하면 이득, 위상 시간 지연 편차를 각각 0.01 dB, 0.05 도, 0.5 ns 이내로 줄일 수 있다.

• 대한임베디드공학회논문지
• /
• 제15권1호
• /
• pp.17-23
• /
• 2020

We propose a system time synchronization method between embedded Linux-based distributed control devices by using Transmission Control Protocol (TCP) communication and General Purpose Input Output (GPIO) device. The GPIO signal is used as the trigger signal for synchronization and the TCP communication is used to transfer the system time of master Linux, which serves as the reference clock, to slave Linux. Precise synchronization performance is achieved by measuring and compensating for the propagation delay of GPIO signal and the acquisition and setting latency of Linux system time. We build an experimental setup consisting of two embedded Linux systems, and perform extensive experiments to verify the performance of the proposed synchronization method.

• Journal of Electrical Engineering and Technology
• /
• 제8권6호
• /
• pp.1283-1295
• /
• 2013

This study proposed an improvement in synchronously rotating reference frame-based voltage sag detection under distorted grid voltages. In the past, the conventional synchronously rotating reference frame (CSRRF)-based voltage sag detection was generally used in the voltage sag compensation applications. Its disadvantage is a long delay of detection time. The modified synchronously rotating reference frame (MSRRF)-based voltage sag detection is able to detect the voltage sag with only a short delay in detection time. However, its operation under distorted grid voltage conditions is unavailable. This paper proposed the improvement of modified synchronously rotating reference frame (IMSRRF)-based voltage sag detection for use in distorted grid voltages with very fast operation of voltage sag detection. The operation of the proposed voltage sag detections is investigated via simulations and experimentations to verify the performance of the IMSRRF-based voltage sag detection.