• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.7
• /
• pp.3482-3486
• /
• 2013

In the case of the Pilot Symbol Assisted Modulation (PSAM) method predicting and compensating amplitude and phases caused on fading channels, there can be severe performance deterioration by Doppler spread on fast fading channels. In this paper, the fading compensation method suggested so as to improve occurring problems as well as analyze them. Doppler spread is the major cause of the bit error rate(BER) performance deterioration. Compared to the existing PSAM method, the more performance deterioration occurs, the larger Doppler spread appears but performance shows well its less $10^{-2}BER$ performance than the existing PSAM method in the suggested method whereas the existing PSAM method has about $10^{-1}BER$ its considerable performance deterioration that caused by Doppler spread within a symbol cycle with the level of delay wave interference.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.9
• /
• pp.1847-1853
• /
• 2011

Analysis of an indoor propagation channel has conventionally used the ray-tracing method. But, in this paper, we had modelling the channel for three dimensional indoor structure by the finite difference time domain method for three dimensional full wave analysis. An excitation signal of the FDTD method used plane wave. The plane wave was excited using the total field/scattered field method. And absorbing boundary condition used the perfectly matched layer method with 7 layers. An living room for the simulation of indoor channel modeling is surrounded the wall that be composed of the wood, the conductor, the glass and concrete. When there are furniture in the living room or not, it were simulated, respectively. As simulation results, we could identify the fading effect of multipath at indoor propagation environment, calculated mean excess delay and rms delay spread for the receiver design.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.4
• /
• pp.310-317
• /
• 2013

In this paper an ESPRIT-based super-resolution time delay estimation algorithm is developed for real-time locating system (RTLS) and its performance is analyzed in various multipath environments. The performance of the existing correlation method for time delay estimation seriously degrades in multipath environments where the relative time delays of multipath signals are less than a PN chip. To solve the problem we shall develop a frequency domain super-resolution time delay estimation algorithm using the ESPRIT, the most representative super-resolution direction-of-arrival (DOA) estimation algorithm, and analyze its performance in various multipath environments.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.11 no.1
• /
• pp.9-14
• /
• 2016

Since Devices such labtop, tablet, smartphone have been developed, a lots of huge data that can be classified as content is flooded in the network. According to changing Internet usage, Content-Centric Network(CCN) what is new concept of Internet Architecture is appeared. Initially, CCN is studied on wired network. but recently, CCN is also studied on wireless network. Since a characteristic of wireless environment is different from a characteristic of wired environment, There are issues in wireless CCN. In this paper, we discuss improvement method of Data spread issue on wireless CCN. The proposed scheme of this paper use MAC Address of nodes when Interest and Data Packet are forwarded. As using the proposed scheme, we reduce the spread of Data and offer priority of forwarding to nodes of shortest path, reduce delay by modifying retransmission waiting time.

• ETRI Journal
• /
• v.45 no.4
• /
• pp.557-569
• /
• 2023

Traditional deterministic channel modeling is accurate in prediction, but due to its complexity, improving computational efficiency remains a challenge. In an alternative approach, we investigated a multilayer artificial neural network (ANN) to predict large-scale and small-scale channel characteristics in metro tunnels. Simulated high-precision training datasets were obtained by combining measurement campaign with a ray tracing (RT) method in a metro tunnel. Performance on the training data was used to determine the number of hidden layers and neurons of the multilayer ANN. The proposed multilayer ANN performed efficiently (10 s for training; 0.19 ms for prediction), and accurately, with better approximation of the RT data than the single-layer ANN. The root mean square errors (RMSE) of path loss (2.82 dB), root mean square delay spread (0.61 ns), azimuth angle spread (3.06°), and elevation angle spread (1.22°) were impressive. These results demonstrate the superior computing efficiency and model complexity of ANNs.

• Journal of the korean Society of Automotive Engineers
• /
• v.11 no.6
• /
• pp.48-56
• /
• 1989

A shock tube technique was developed in which a freely falling droplets column produced by an ultrasonic atomizer was ignited behind reflected shock. In the present study, the effects of turbulent mixing on the ignition delay of a cetane was decided, also, ignition process was investigated. For the purpose of disturbance of droplets column and mixing, authors installed turbulent lattice in shock tube. Usually, the ignition delay is so called Arrhenius plot which found break point in the Arrhenius plot on the high temperature side. The rate of misfiring increased rapidly below 1080K, but ignition took place from 838k and luminous flame was seen to spread over the whole section by turbulent lattice. Length, from end plate to turbulent lattice, was varied with 60,40,20mm. Also, ignition process was detected by Photo transistor. As a result, it was found that physical factors changed ignition delay greatly and turbulent mixing had a considerable effects in the ignition process.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.1 no.1
• /
• pp.55-64
• /
• 1997

Spread Spectrum Communication is a core technique in CDMA system, but the problem for SS Communication schemes is synchronous method. There are DLL, Tau-dither, SO etc, in the synchronous method. But since there are analog operations, the settling is difficult and size is large. In this paper we realized Digital Delay Lock Loop (DDLL) and estimated it's performance through the Power line experiment.

• ETRI Journal
• /
• v.38 no.6
• /
• pp.1031-1041
• /
• 2016

This paper presents millimeter-wave (mmWave) propagation characteristics and channel model parameters including path loss, delay, and angular properties based on 28 GHz and 38 GHz field measurement data. We conducted measurement campaigns in both outdoor and indoor at the best potential hotspots. In particular, the model parameters are compared to sub-6 GHz parameters, and system design issues are considered for mmWave 5G Giga communications. For path loss modeling, we derived parameters for both the close-in free space model and the alpha-beta-gamma model. For multipath models, we extracted delay and angular dispersion characteristics including clustering results.

• Proceedings of the KSR Conference
• /
• 2008.11b
• /
• pp.673-678
• /
• 2008

In crushed service areas of Metro railway lines, there are problems such as the buildup discontent, the irregular operation time and rotation of rolling stocks, caused by frequently occurred train delay. Train delay is affected by operation conditions or infrastructure capacities such as train schedule, line capacity, car rotation plan, shunting movements at origin and destination, and also by transport demand characteristics. Furthermore, a delay produce another delays and spread over the following trains. So it is not easy to build up a protection and recovery plan. In this research, we conduct experimental analysis study based on the real metro data, and as a result, present the relation between the traffic demand and the dwell time. And finally, propose future research themes for improving the operation efficiency of metro railways.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.12 no.2
• /
• pp.168-174
• /
• 2012

This paper describes a novel global on-chip interconnect scheme, in which a one UI-delayed symbol as well as the current symbol is sent for easing the sensing operation at receiver end. With this approach, the voltage swing on the channel for reliable sensing can be reduced, resulting in performance improvement in terms of power consumption, peak current, and delay spread due to PVT variations, as compared to the conventional repeater insertion schemes. Evaluation for on-chip interconnects having various lengths in a 130 nm CMOS process indicated that the proposed on-chip interconnect scheme achieved a power reduction of up to 71.3%. The peak current during data transmission and the delay spread due to PVT variations were also reduced by as much as 52.1% and 65.3%, respectively.