• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2005년도 춘계 학술발표회 논문집
• /
• pp.439-444
• /
• 2005

Shotcrete lining is likely to be deteriorated due to the ground water which the lining is exposed to. Some tunnel collapses seemed to be affected by shotcrete degradation were reported. But there isn't any assessment method of shotcret long-term degradation. So, Experimental technology for shotcrete long-term degradation modeling was developed in this study. The shotcrete long-term degradation modeling, developed in other study in Korea Institute of Construction Technology, require the time-history of volume change. Digital strain observation system was used to acquire the time-history of volume change. To verify the Strain Observation Digital System, the measurement using the system was compared to the one using a micrometer. Through this process, The experiment for shotcrete long-term degradation modeling was set up.

• 산업기술연구
• /
• 제29권A호
• /
• pp.89-94
• /
• 2009

The efficiency of heterogeneous catalysts has been investigated in ozonation process for organic removal. Heterogeneous catalytic ozonation was conducted for the degradation of humic acid in the presence of Granular Activated Carbon or Zeolite as a solid catalyst. And the results were compared to those of ozonation alone and adsorption alone without ozonation. The degradation characteristics of humic acid in each process were examined with the values of pH, TOC, $UV_{254}$ and $COD_{Cr}$.

• 한국신뢰성학회지:신뢰성응용연구
• /
• 제18권2호
• /
• pp.114-121
• /
• 2018

Purpose: This study proposes a process for evaluating the preventive maintenance policy for a system with degradation characteristics and for calculating the appropriate preventive maintenance cycle using time- and condition-based maintenance. Methods: First, the collected data is divided into the maintenance history lifetime and degradation lifetime, and analysis datasets are extracted through preprocessing. Particle filter algorithm is used to estimate the degradation lifetime from analysis datasets and prior information is obtained using LSE. The suitability and cost of the existing preventive maintenance policy are each evaluated based on the degradation lifetime and by using a minimum repair block replacement model of time-based maintenance. Results: The process is applied to the degradation of the reverse osmosis (RO) membrane in a seawater reverse osmosis (SWRO) plant to evaluate the existing preventive maintenance policy. Conclusion: This method can be used for facilities or systems that undergo degradation, which can be evaluated in terms of cost and time. The method is expected to be used in decision-making for devising the optimal preventive maintenance policy.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 하계학술대회 논문집 Vol.5 No.2
• /
• pp.784-789
• /
• 2004

Bulk ZnO varistor based on Matsuoka, which varied $SiO_2$ addition has fabricated by standard ceramic process. The micro-electrode, which fabricated for investigation on degradation property of the Single Grain Boundary of ZnO varistor, has sticked by lithography semiconductor process. The values of AC degradation has measured with 150% operating voltage in varistor threshold with 120 minute in 60Hz. In here we observed V-I and V-C property in every 30minute. The operating voltage of Single Grain Boundary has shown in variable patterns in the characteristic of V-I Property. By increasing the $SiO_2$ contents, operating value has also increased and dominated on degradation proper. In EPMA analysis, we know that added $SiO_2$ was nearly distributed at the Grain Boundary. $SiO_2$ has gradually distributed in Grain Boundary condition during the process of crystal growth. It contributes to degradation depression and decision of operating voltage. We also demonstrated for using practical application and performance on distribution random loop based on V-I Properties in Single-Grain-Boundary.

• 한국환경과학회지
• /
• 제20권2호
• /
• pp.231-239
• /
• 2011

Diethyl phthalate (DEP) and nonylphenol (NP) are widely spread in the natural environment as an endocrine disruption chemicals (EDs). Therefore, in this study, ultrasound (US) and ultraviolet (UVC), including $TiO_2$, as advanced oxidation processes (AOPs) were applied to a DEP and NP contaminated solution. When only the application of US, the optimum frequency for significant DEP degradation and a high rate of hydrogen peroxide ($H_2O_2$) formation was 283 kHz. We know that the main mechanism of DEP degradation is radical reaction and, NP can be affected by both of radical reaction and pyrolysis through only US (sonolysis) process and combined US+UVC (sonophotolysis) process. At combined AOPs (sonophotolysis/sonophotocatalysis) such as US+UVC and US+UVC+$TiO_2$, significant degradation of DEP and NP were observed. Enhancement effect of sonophotolysis and sonophotocatalysis system of DEP and NP were 1.68/1.38 and 0.99/1.17, respectively. From these results, combined sonophotocatalytic process could be more efficient system to obtain a significant DEP and NP degradation.

• Journal of Electrochemical Science and Technology
• /
• 제13권2호
• /
• pp.292-307
• /
• 2022

The study presents kinetics of degradation and mineralization of an anti-epileptic drug Lamotrigine (LAM) in the aqueous matrix by electrochemical advanced oxidation process (EAOP) on Ti/DSA (Ta₂O₅-Ir₂O₅) and Stainless Steel (SS) anodes using sodium sulphate as supporting electrolyte. On both the anodes, kinetic behaviour was pseudo-first-order for degradation as well as mineralization of LAM. On Ti/DSA anode, maximum LAM degradation of 75.42% was observed at an associated specific charge of 3.1 (Ah/litre) at a current density of 1.38 mA/cm² and 100 ppm Na₂SO₄ concentration. Maximum mineralization attained was 44.83% at an associated specific charge of 3.1 (Ah/litre) at a current density of 1.38 mA/cm² and 50 ppm concentration of Na₂SO₄ with energy consumption of 2942.71 kWh/kgTOC. Under identical conditions on SS anode, a maximum of 98.92% LAM degradation was marked after a specific charge (Q) of 3.1 (Ah/litre) at a current density of 1.38 mA/cm² and 100 ppm concentration of Na₂SO₄. Maximum LAM mineralization on SS anode was 98.53%, marked at a specific charge of 3.1 (Ah/litre) at a current density of 1.38 mA/cm² and 75 ppm concentration of Na₂SO₄, with energy consumption of 1312.17 kWh/kgTOC. Higher Mineralization Current Efficiency (MCE) values were attained for EAOP on SS anode for both degradation and mineralization due to occurrence of combined electro-oxidation and electro-coagulation process in comparison to EAOP on Ti/DSA anode due to occurrence of lone electro-oxidation process.

• 분석과학
• /
• 제37권1호
• /
• pp.25-38
• /
• 2024

The study aimed to investigate a novel approach by utilizing liquid chromatography (LC) and liquid chromatography-mass spectrometry (LC-MS) to separate, identify and characterize very nominal quantities of degradation products (DPs) of balsalazide along with its process related impurities without isolation from their reaction mixtures. The impurities along with balsalazide were resolved on spherisorb ODS2 (250×4.6 mm, 5.0 ㎛) column at room temperature using 0.2 M sodium acetate solution at pH 4.5 and methanol in the ratio of 55:45 (v/v) as mobile phase pumped isocratically at 1.0 mL/min as mobile phase and UV detection at 255 nm. The method shows sensitive detection limit of 0.003 ㎍/mL, 0.015 ㎍/mL and 0.009 ㎍/mL respectively for impurity 1, 2 and 3 with calibration curve liner in the range of 50-300 ㎍/mL for balsalazide and 0.05-0.30 for its impurities. The balsalazide pure compound was subjected to stress studies and a total of four degradation products (DPs) were formed during the stress study and all the DPs were characterized with the help of their fragmentation pattern and the masses obtained upon LC-MS/MS. The DPs were identified as 3-({4-[(E)-(4-hydroxyphenyl) diazenyl]benzoyl}amino)propanoic acid (DP 1), 4-[(E)-(4-hydroxyphenyl)diazenyl] benzamide (DP 2), 5-[(E)-(4-carbamoylphenyl)diazenyl]-2-hydroxybenzoic acid (DP 3) and 3-({4-[(E)-phenyldiazenyl]benzoyl}amino)propanoic acid (DP 4). Based on findings, it was concluded that, the proposed method was successfully applicable for routine analysis of balsalazide and its process related impurities in pure drug and formulations and also applicable for identification of known and unknown impurities of balsalazide.

• Nuclear Engineering and Technology
• /
• 제44권3호
• /
• pp.297-310
• /
• 2012

Aging-related degradation of nuclear power plant components is an important aspect to consider in securing the long term safety of the plant, especially the seismic safety, since the degradation of the components affects not only their seismic capacity but their response. This can cause a change in the seismic margin of a component and the overall seismic safety of a system. To better understand the status and characteristics of degradation of components in Nuclear Power Plants (NPPs), the degradation occurrences of components in the U.S. NPPs were identified by reviewing recent publicly available information sources and the characteristics of these occurrences were evaluated and compared to observations from the past. Ten categories of components that are of high risk significance in Korean NPPs were identified, comprising anchorage, concrete, containment, exchanger, filter, piping systems, reactor pressure vessels, structural steel, tanks, and vessels. Software tools were developed to expedite the review process. Results from this review effort were compared to previous data in the literature to characterize the overall degradation trends.

• 한국CDE학회논문집
• /
• 제18권1호
• /
• pp.36-48
• /
• 2013

In general, the product is used under several circumstances including environmental and usage conditions. According to the circumstances, the product has various performance degradation processes. In order to optimize the lifecycle of product usage, it is important to observe the degradation process and make suitable decisions on product operations. However, there are not much research works in evaluating the degree of product degradation based on product usage data. Recently, due to emerging ICT (Information and Communication Technology) technologies, it becomes possible to get the product usage data. Based on the gathered data, it is possible to analyze the degree of product degradation. The analysis of product usage data can improve product use and product design with advanced decisions. To this end, this study addresses one approach based on FMEA/FMECA method, called PDMCA (Performance, Degradation Modes and Criticality Analysis) for evaluating product degradation status and making suitable decisions.

• 한국미생물생명공학회:학술대회논문집
• /
• 한국미생물생명공학회 2000년도 추계 학술대회
• /
• pp.125-139
• /
• 2000

The differential enhanced degradation of cis- and trans-1,3-D was observed in the previous two studies performed by Ou et al. (1995) and especially Chung et al. (1999). This study was initiated to investigate the involvement of microorganisms in the differential enhanced degradation of the chemicals. As expected, microorganisms were responsible for the enhanced degradation of the chemicals. A mixed bacterial culture capable of degrading 1,3-D was isolated from an enhanced soil sample collected from a site treated with 1,3-D. Similar to the enhanced soil, the mixed culture degraded trans-1,3-D faster than cis-1,3-D. This mixed culture could not utilize cis- and trans-1,3-D as a sole source of carbon for growth. Rather, a variety of second substrates were evaluated to stimulate the differential enhanced degradation of the two isomers. As a result, the mixed culture degraded cis- and trans-1,3-D only in the presence of a suitable second substrate. Second substrates that had the capacity to stimulate the degradation included soil leachate, tryptone, tryptophan, and alanine. Other substrates tested, including soil extract, glucose, yeast extract, and indole (ailed to stimulate the degradation of the two isomers. Therefore, it appeared that the degradation of cis- and trans-1,3-D was a cometabolic process. The mixed culture was composed of four morphologically distinctive bacterial colonies.