• Convergence Security Journal
• /
• v.19 no.4
• /
• pp.87-96
• /
• 2019

Recently, with the rapid development of video equipment and technology, tremendous video information is produced and utilized in military domain to acquire battlefield information or for effective command control. Note that the video playback devices currently used in the military domain ranges from low-performance tactical multi-functional terminals (TMFT) to high-performance video servers and the networks where the video information is transmitted also range from the low speed tactical information and communication network (TICN) to ultra-high speed defense broadband converged networks such as M-BcN. Therefore, there is a need for an efficient streaming technique that can efficiently transmit defense video information in heterogeneous communication equipment and network environments. To solve the problem, this paper proposes a Scalable Video Coding (SVC) and balanced selection algorithm based Peer-to-Peer (P2P) streaming technique and the feasibility of the proposed technique is verified by simulations. The simulation results based on our BitTorrent simulator show that the proposed balanced selection scheme outperforms the sequential or rarest selection algorithm.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.10
• /
• pp.1161-1168
• /
• 2010

The FHSS(Frequency Hopping Spread Spectrum), in which a transmitter changes its carrier frequency according to a certain hopping pattern, is widely used in the military communication system, since it is highly resistant to deliberate Jamming. However, the difference of BER performance of satellite communication system which using the different modulation scheme and Jamming model was not studied. Thus, in this paper, we consider PBNJ(Partial-Band Noise Jamming) and WPBJ(Worst case Partial-Band noise Jamming) as Jamming models, and evaluate BER(Bit Error Rate) performances of NC-MFSK(Non-Coherent M-ary Frequency-Shift Keying), SDPSK(Symmetric Differential Phase-Shift Keying), and GMSK(Gaussian filtered Minimum-Shift Keying) modulation schemes. Based on the results, we suggest the best transmission method for each condition.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.20 no.1
• /
• pp.8-13
• /
• 2016

The purpose of the pyro-shock compliant joint is to isolated vibration using the compliant material in order to prevent the shock generated by pyro propulsion at the electronics equipment. The performance of the pyro-shock compliant joint can be determined by measuring bending natural frequency and transmissibility. In this study, we established the design requirements based on bending natural frequency and transmissibility results of the reference model. We developed a compliant material with sufficient shock compliant properties and a pyro-shock compliant joint for the new rocket. This results can be used to develop a pyro-shock compliant joint for any rocket using the compliant material and performance measurement.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.9
• /
• pp.135-140
• /
• 2015

Web-services employ XML that is the well-formed structure as a de-facto standard to represent data. SOAP or REST is one of the representative web-services using XML based massage passing systems. The XML parser can be divided into event driven and DOM tree. A streaming parser as an event driven is widely used for high-speed parsing. Since the streaming parser processes XML documents in sequence, they have any limitation to improve system performance. In order to improve speed of streaming XML parser, we present multibyte based streaming XML hardware parser using the element analyzer instead of the state machine. Compared to other parsers, the proposed MStreXHP can achieve about 2.72 times improvement in the number of clock cycles to be consumed in comparison of characters and sustain about 7.8Gbps throughput. Therefore, our MStreXHP is desirable for the streaming XML hardware parser on high-performance systems.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.6
• /
• pp.545-556
• /
• 2016

JPDAF is a method of updating target's state estimation by using posterior probability that measurements are originated from existing target in multi-target tracking. In this paper, we propose a multi-target tracking algorithm for falling cluster bombs separated from a mother bomb based on JPDAS method which is obtained by applying fixed-interval smoothing technique to JPDAF. The performance of JPDAF and JPDAS multi-target tracking algorithm is compared by observing the average of the difference between targets' state estimations obtained from 100 independent executions of two algorithms and targets' true states. Based on this, results of simulations for a radar tracking problem that show proposed JPDAS has better tracking performance than JPDAF is presented.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.1
• /
• pp.29-37
• /
• 2012

In this paper, a stabilizd system operation through a composition of a protective circuit and an improvement of active reflection coefficient(ARC) is studied. Unlike the passive-phased array antenna, the APPA is a combined form of radiating element and transmitter-reciever module. Therefore, a definition of new ARC that differentiates itself from typical passive-phased array antenna must apply. The ARC is a reflection coefficient considering a superposition of a coupling from nearby radiating elements and self reflection. It is an important parameter that predicts and analyzes charateristics of a APPR system. A high level ARC is a direct source inducing a performance degradation of a system. In this paper, as a method for a stabilized operation of APAR, one method for improving a performance and another for degradation prevention are analyzed. An effectiveness of two methods was validated using experiment results of real-fabricated active-phased array antenna.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.10
• /
• pp.810-818
• /
• 2017

This paper presents the approaching target above ground tracking based on Kalman filter applied to the proximity sensor for the active defense system. The proximity sensor located on the front of the countermeasure is not easy to detect when the anti-tank threat enters a fragment dispersion range due to limited antenna beamwidth. In addition, it is difficult for the proximity sensor to detect the anti-tank threat accurately at a terrestrial environment including various clutters. To solve these problems, this study presents the approaching target above ground tracking based on Kalman filter and applies the novel estimation method for a noise covariance matrix to improve a tracking performance. Then, a high tracking performance of Kalman filter applied the proposed noise covariance matrix is presented through field firing test results and the validity of the proposed study is examined.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.6
• /
• pp.689-695
• /
• 2018

This paper presents the means of controlling the regeneration of a diesel particulate filter (DPF) that is mounted on tactical vehicles to satisfy exhaust gas standards. The DPF captures particulate matter in the exhaust gas and combusts the captured particulate matter. This process is regeneration, which is essential to the normal performance of the DPF. Bad regeneration causes degradation of vehicle performance; worse, it can lead to a vehicle fire. DPF regeneration is performed by control logic. If the regeneration control logic does not properly reflect the operating characteristics of the vehicle, DPF regeneration may not occur. Consequently, it is very important to ensure the DPF operates properly by reflecting the operating characteristics of the tactical vehicle. This study analyzes the operational characteristics of a tactical vehicle and the DPF, and adds proper DPF regeneration control logic. Additionally, this study is intended to simultaneously improve the additional problems that may occur from operating under the added regeneration control logic.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.41 no.5
• /
• pp.373-382
• /
• 2013

In this paper, in order to analyze the performance of a decoy system for ship defense against an anti-ship missile(ASM) with an infrared image(IIR) seeker, the modeling and engagement simulation program is introduced. The IIR seeker on the ASM detects the infrared signal of ship from a distance and approaches the ship based on proportional navigation guidance(PNG) or impact angle control guidance(IACG). Hence the guidance performance of the ASM is basically depend on the target tracking algorithm of the seeker as well as the infrared signal of the ship. Using the developed program, we can investigate the effect of the ship decoy system such as flares and surface cooling system of the ship with respect to various kinds of tracking algorithms of the IIR seeker of the ASM.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.48 no.11
• /
• pp.903-910
• /
• 2020

This paper introduces a simulator to assess the impacts of the wind and the airframe vibration on the performance of the Active Electronically Scanned Array (AESA) radar mounted in an aircraft. The AESA radar is mounted on the nose cone of an aircraft, and vibration occurs due to the drag force. This vibration affects the behavior of the AESA radar and can cause phase errors in signal. The simulator adopts the geometric model for nose cone, the mathematical models on the rigid-body dynamics of the aircraft, the average/turbulent winds, and the mode/ambient vibrations to compute the position and the attitude of the radar accurately. Numerical studies reflecting a set of test scenarios were conducted to demonstrate the effectiveness of the developed simulator.