• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.12
• /
• pp.1618-1624
• /
• 1988

In this paper, a robust discrete model reference adaptive controller is proposed using a generalized model reference adaptive algorithm for single-input single-output discrete systems. A signal dependent time-varying dead-zone is employed in a generalized adaptive control structure. This adaptive controller is shown to assure the boundedness of the signals of the system even in the presence of bounded external disturbance.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2019.06a
• /
• pp.114-115
• /
• 2019

This paper introduces an adaptive scalar quantization scheme for video coding technology. The method utilizes the property of the coefficient groups (CG) inside each transform block so that the dead-zone interval of the scalar quantizer is adaptively set up for different CGs. Its experimental results show that our proposed quantization scheme can achieve BDBR reduction of 4.75%, 5.93, and 5.16% for Y, Cb, and Cr channel respectively when encoding with HEVC.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 1998.10a
• /
• pp.28-35
• /
• 1998

The seismic overstrength factor $\Omega$ is evaluated for 4-story reinforced concrete buildings in Korea(of which seismic intensity is low). The study model is designed according to aseismic guideline research - phase II in Korea. The effect of variation of span length and bay number, dead load is considered, especially including the variation of hardening ration after yielding. And push-over analysis is performed, in which the external and internal frame is connected by rigid-link and the $\Omega$ is calculated using the roof drift ratio at 2%. For Zone I, the mean value of $\Omega$ is ranged form 2.3 to 2.5, For Zone II, from 3.1 to 3.4. For low hardening ratio(3%) after yielding, $\Omega$ has little relations with the number of bay, like as the results of other research. But for 5% hardening ratio, $\Omega$ is increased as the number of bay is increased. Within general gravity-load bound, the variation of D.L. has variation of D. L. has no effect on $\Omega$. And, $\Omega$ is increased as the span length is increased.

• Structural Monitoring and Maintenance
• /
• v.4 no.1
• /
• pp.17-31
• /
• 2017

Since extensometers are used to determine the absolute deformation of foundation and abutments and all results are obtained in reference to the base rod, the accuracy of these results has been constantly a subject of debate. In this regard, locating and installing extensometers outside the range of effect zone is also another challenge. The main purpose of this paper is to investigate and modify extensometers results based on the mentioned issues. For this aim, the concrete RCC Zhaveh dam in Iran was selected as the case study. To study the results of extensometers installed in this dam, first, the 3DEC_DP 5.00 software was applied for numerical modeling. Parameters such as discontinuities, dead load and piezometric pressure in the interface of concrete and rock were considered. Next, using the results obtained from 6 extensometers in foundation and abutments and 4 clinometers in dam body, the numerical model was calibrated through back analysis method. The results indicate that the base rod is moved and is not recommended being used as the base point. In other words, because installation of base anchor outside the range of effect zone is not possible due to the operational and economic considerations, the obtained results are not accurate enough. The results indicate a considerable 2-3 mm displacement of the base rod (location of the base anchor) in reference to the real zero point location, which must be added to the base rod results.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.5
• /
• pp.77-86
• /
• 2016

This paper describes a dual-mode reference-less CDR(Clock Data Recovery) operating at full / half-rate and its operation algorithm. Proposed reference-less CDR consists of a frequency detector, a phase detector, a charge pump, a loop filter, a voltage controlled oscillator, and a digital block. The frequency and phase detectors operate at both full / half-rate for dual-mode operation and especially the frequency detector is capable of detecting the difference between data rate and clock frequency in the dead zone of general frequency detectors. Dual-mode reference-less CDR with the proposed algorithm can recover the data and clock within 1.2-1.3 us and operates reliably at both full-rate (2.7 Gb/s) and half-rate (5.4 Gb/s) with 0.5-UI input jitter.

• Korean Journal of Environment and Ecology
• /
• v.21 no.2
• /
• pp.161-167
• /
• 2007

To investigate the structure and the conservation strategy of Korean native species, the Abies koreana forest at sub-alpine zone centering on the Witsaeorum(1,714m) shelter in Hallasan National Park was selected for a survey subject with 20 plots $(10{\times}10m)$ set up with random sampling method. Mean importance percent(MIP) of Abies koreana showed the highest numerical value-57.7%, and that of faxus cuspidata was the next value-16.2%. High positive correlations were shown between Taxus cuspidata and Prunus maximowiczii, Euonymus alatus; Betula ermani and Berberis amurensis var. quelpaertensis, Prunus sargentii; Prunus maximowiczii and Euonymus alatus; Berberis amurensis var. quelpaertensis and Prunus sargentii. Vigor of Abies koreana was so low that as much as 6.44% of total number of Abies Koreana investigated were dead. DBH of dead individuals ranged mainly from 5cm to 15cm.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.18 no.1
• /
• pp.185-194
• /
• 2023

The 4-axis strain-gauge, which is widely applied to military weapon systems, is operated in poor temperature and vibration conditions, tolerance may increase and malfunctions may occur. To improve this, this paper proposes a signal-processing software technique for the tolerance of the 4-axis strain gauge applied to a military weapon system. First, the tolerance of the strain-gauge and the signal processing circuit according to the ambient temperature were evaluated and analyzed. Second, a software technique for processing the dead zone and offset area that can improve the tolerance of the strain-gauge is proposed. The experimental results applying the software technique confirmed that it operated normally in the temperature test and operation test. Therefore, the proposed software technique is valid and can be used as useful information to improve tolerance due to ambient temperature and vibration when designing a system using a strain-gauge.

• Korean Journal of Environment and Ecology
• /
• v.34 no.1
• /
• pp.42-54
• /
• 2020

This study aimed to analyze the rate of increase and spread patterns of dead trees of the conifer (Abies koreana and others) in subalpine zones by using the high-resolution aerial images in Jirisan National Park around 10 years ago. Furthermore, factors affecting the death of conifer were identified by analyzing the altitude, topographical information, solar radiation, and moisture environment of the site where the dead trees are located. The number of dead trees per unit area increased by two to five times in the Banyabong peak, Yeongsinbong peak, and Cheonwangbong peak in Jirisan National Park over the past decade. The increase was about 2 times in the Banyabong peak, about 3.9 times in the Yeongsinbong peak, and about 5.2 times in the Cheonwangbong peak, indicating the most notable increase in the Cheonwangbong peak. It is estimated that dead trees commonly occurred in the environments where the soil moisture content was low due to the high slope, amount of evaporation was high due to strong solar radiation as the location faced south, and the soil was dry due to strong solar radiation and short rain retention time. In other words, dead conifer trees in subalpine zones were concentrated in dry location environments, and the tendency was the same more than ten years ago.

• Journal of Korean Society of Forest Science
• /
• v.85 no.2
• /
• pp.260-270
• /
• 1996

Structure and dynamics of Pinus densiflora community in Mt. Kaya were studied to provide the information needed for management of Pinus densiflora forest in the southern inland of Korea. Stratification structure of Pinus densiflora community in the lower and middle slope consisted of tree layer(10~15m), subtree layer(4~10m), shrub layer(1~4m), and herb layer(below 1m), while in the rock zone of ridge and top area consisted of tree layer(7~10m), subtree layer(2~7m), shrub layer(1~2m), and herb layer(below 1m). According to the diameter distribution of tree species in Pinus densiflora community, secondary Pinus densiflora forest will gradually decline. Its forest may be replaced by Quercus mongolica, Quercus serrata, Carpinus laxiflora, C. cordata, and Fraxinus rhychophylla in the lower slope, and by Quercus mongolica in the middle slope. Pinus densiflora forest has its seedlings and saplings in ridge and top area, so it may be sustained. By taking cores from Pinus densiflora trees in research area, it could be obtained that in the lower and middle slope, age of Pinus densiflora forest was about 80~90 years old. When the age of its trees was about 72~80 years old, withering trees of standing dead occurred. Disturbance regime of Pinus densiflora community in Mt. Kaya consisted of standing dead, uprooting and limbfall, these were 70.6%, 17.6% and 11.8% respectively. It takes about 100~110 years for advance growth of Pinus densiflora in ridge and top area to reach tree layer. During the period, it has twice chances of disturbance in standing dead. Annual diameter growth of Pinus densiflora was 2.45~2.9mm in the lower and middle slope, while it was 1.75mm in ridge and top region, by measuring cores.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.14 no.5
• /
• pp.379-386
• /
• 2009

This paper investigates the operation of ITER(International Thermonuclear Experimental Reactor) Vertical Stabilization(VS) converter with circulating current. The VS converter has two subunits in parallel. The subunit is composed two back-to-back 12 pulse thyristor converter in series. The circulating current free technique can not always maintain the closed path for the load current because of a dead time zone of the converter operation at the region of the load current inversion. The complex circulation current technique for the load current inversion with VS converter can achieve the fast response and always maintain the closed path for the load curret. The paper proposes the new circulating current algorithm for the load current inversion of ITER VS converter and proves the performance of the circulating current technique with PSIM simulation study.