• Korean Journal of Environmental Agriculture
• /
• v.12 no.1
• /
• pp.69-80
• /
• 1993

Environmental hazards of a chemical could be assessed by two different approaches : toxicity test and assessment of exposure potentials to human and environmental organisms. For the prediction of environmental fate of chemicals three available computer programs were compared each other and were verified. The results obtained by using these computer programs, PCHEM, EXAMS, and E4CHEM were summarized as follows. The estimated octanol/water partition coefficients by PCHEM were similar to the experimental values in the literature. But the other factors, water solubility and vapor pressure were different from the data in the literature. The simulation results of selected compounds by EXAMS showed similar tendency to the literature results of model field environment. Therefore, this computer program could be utilized to predict the environmental fate of chemicals. E4CHEM program is very simple and this program could predict the ultimate environmental fate of stable chemicals by input of two or three parameters. However, the validity should further be verified in the future field study using more compounds. It is suggested that these approaches could be fully utilized by understanding their limitations to predict the environmental fate of new chemicals under development, to screen the potential environmental pollutants among chemicals already-in use, and to devise measures to minimize the hazards to the environment.

• Journal of Korean Society for Atmospheric Environment
• /
• v.18 no.4
• /
• pp.265-274
• /
• 2002

The concentrations of polychlorinated biphenyls (PCBs) in air and plant were measured every other week at Hankyong University located in Ansung, Kyoung-ki province from July to November of 1999. The predicted PCB concentrations in air derived from measured Morus allba were compared with ambient measurement data. This was necessary to test the possibility of using the two equations incorporating Riederer's and Bacci's bioconcentration factors (BCFs) based on the octanol-air partition coefficient (Ksub/oa/) to predict the air-plant equilibrium of PCBs. Ratios of calculated to measured PCB concentrations in air were 2.4 (1.24~4.36), 2.7 (0.17~7.96) using Riederer's and Bacci's equations, respectively Regression analysis between PCBs calculated by Riederer's equation and PCBs directly measured in air, showed correlation ($R^2$= 0.90). However, slope of regression between calculated and directly measured PCB concentrations was above 1. The results thus suggest that calculated PCBs were overestimated comparing with direct measurements. Bio-monitoring using Morus allba may have possibilities in predicting PCBs concentration in air with a further extension of air-plant equilibrium research.

• Journal of Microbiology and Biotechnology
• /
• v.13 no.5
• /
• pp.778-782
• /
• 2003

In the course of screening anti-influenza agents from natural products, four neuraminidase inhibitors were isolated from the methanol extract of mushroom Microphorus affinis by purification using solvent partition, silica gel column chromatography, Sephadex LH-20, and semi-preparative HPLC. The chemical structures of these compounds were identified as ${\alpha}-lupeol$, methyl linoleate, methyl palmitate, and methyl oleate by means of spectral data including GC-MS, $^1H-,\;and\;^{13}C-NMR\;with\;IC_{50}$ values of 5.65, 7.07, 7.12, and $7.52\;\mu\textrm{M}$, respectively. They did not inhibit other glycosidases such as glucosidase, mannosidase, and galactosidase, indicating that they were relatively specific inhibitors of neuraminidase. The relationship between the fatty acid structure and inhibitory activity was investigated. The result showed that, in the case of an aliphatic linear hydrocarbon skeleton, at least one carboxyl (presumably any carbonyl) moiety and sixteen carbons were the necessary requirements for potent inhibition, whereas saturated, unsaturated, free, and ester forms did not have any significant effect on the activity.

• Journal of the Korean Institute of Educational Facilities
• /
• v.11 no.1
• /
• pp.39-46
• /
• 2004

The objective of this study is to propose the architectural basic data for the planning of kindergarten attached to the elementary school. For this study, we selected and investigated 23kindergartens in Gwangju city. The results of this study are as follows. 1) The elementary school in separated style had the advantage of securing educational space and reducing interference with students of elementary school. But it had the problem in using the facilities of elementary school. So we have to consider the kindergarten to be located near by dinning room, multi-purpose hall. 2) Concentrating the entrance, it makes the inside and outside space use easily. For the actual use, we have to establish facilities for convenience in outer-space. 3) For each room, we suggest guides as follow. The classroom and the playroom have to be combined for flexibility and supervision. In the planning of toilet, it must have sliding door for confirm the inside situation and reasonable height partition to consider the student's body-size. The shape of teacher's room must be open-type for supervising children but protect the entry of children. There is consideration for the material room and the sleeping room for all-day-long class.

• Proceedings of the KSRS Conference
• /
• v.2
• /
• pp.610-614
• /
• 2006

In this paper the advanced method of geodesic active contours was developed for the task of building detection from aerial and satellite images. Automatic extraction of man-made structures including buildings, building blocks or roads from remote sensing data is useful for land use mapping, scene understanding, robotic navigation, image retrieval, surveillance, emergency management procedures, cadastral etc. A level set method based on a region-driven segmentation model was implemented with which building boundaries were detected, through this curve propagation technique. The essence of this approach is to optimize the position and the geometric form of the curve by measuring information along that curve, and within the regions that compose the image partition. To this end, one can consider uniform intensities inside objects and the background. Thus, given an initial position of the curve, one can determine global, region-driven functions and provide a statistical description of the inside and outside object area. The calculus of variations and a gradient descent method was used to optimize the variational functional by an iterative steady state process. Experimental results demonstrate the potential of the proposed processing scheme.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.792-793
• /
• 2005

Circuit testing process is very important in IC Manufacturing there are two ways in research for circuit testing improvement. These are ATPG Tool Design and Test simulation application. We are interested in how to use parallel technique such as one-side communication, parallel IO and dynamic Process with data partition for circuit testing improvement and we use one-side communication technique in this paper. The parallel ATPG Tool can reduce the test pattern sets of the circuit that is designed in laboratory for make sure that the fault is not occur. After that, we use result for parallel circuit test simulation to find fault between designed circuit and tested circuit. From the experiment, We use less execution time than non-parallel Process. And we can set more parameter for less test size. Previous experiment we can't do it because some parameter will affect much waste time. But in the research, if we use the best ATPG Tool can optimize to least test sets and parallel circuit testing application will not work. Because there are too little test set for circuit testing application. In this paper we use a standard sequential circuit of ISCAS89.

• ETRI Journal
• /
• v.39 no.3
• /
• pp.301-309
• /
• 2017

In this paper, we propose a parallelization method for a High Efficiency Video Coding (HEVC) deblocking filter with transform unit (TU) split information. HEVC employs a deblocking filter to boost perceptual quality and coding efficiency. The deblocking filter was designed for data-level parallelism. In this paper, we demonstrate a method of distributing equal workloads to all cores or threads by anticipating the deblocking filter complexity based on the coding unit depth and TU split information. We determined that the average time saving of our proposed deblocking filter parallelization method has a speed-up factor that is 2% better than that of the uniformly distributed parallel deblocking filter, and 6% better than that of coding tree unit row distribution parallelism. In addition, we determined that the speed-up factor of our proposed deblocking filter parallelization method, in terms of percentage run-time, is up to 3.1 compared to the run-time of the HEVC test model 12.0 deblocking filter with a sequential implementation.

• Journal of Food Hygiene and Safety
• /
• v.3 no.3
• /
• pp.105-109
• /
• 1988

To develop a method for detecting and e&timating the quantity of adulterant rapeseed oil in sesame oil, five kinds of sesame oils and three kinds of rapeseed oils collected from different sources were fractionated by TLC (thin layer chromatography) and separated on the basis of PN (partition number) by HPLC (high performance liquid chromatography). These obsenations indicate that the proportion of adulterant rapeseed oil when mixed minimum 4% with sesame oil can be detected.

• Journal of the Korean housing association
• /
• v.24 no.5
• /
• pp.1-8
• /
• 2013

Recently, as people have more interest in health, and some change takes place in their lifestyles, a demand for environment-friendly residential space is also increasing. Research on the introduction of natural elements is mostly conducted for humans to pursue a more pleasant and comfortable life in residential space since it has one of the closest relation with humans. Therefore, it is such an important assignment at present when environmental problems are considered significant. Based on such a necessity, this study analyzed the introduction types and characteristics of natural elements in residential space by considering essential and psychological aspects more than previous researches on residential space with practical and functional aspects. As natural elements, this study put limits on plants and water that are used a lot in the interior space, and by dividing introduction types into recomposition of courtyard space, spatial partition and decorative elements, this study carried out a case analysis of residential space structures recently completed in Japan. As a basic research on space planning that is desperately required by change in the residential life paradigm and on the basis of understanding about nature, it is expected that the results of this study will be used as design basic data useful when establishing plans of introducing natural elements for residential space in the future.

• Architectural research
• /
• v.1 no.1
• /
• pp.31-40
• /
• 1999

In this age of "Information", many people consider it a deterrent to information flow to provide a hierarchy with private rooms in a modern office layout. There are others, however, who insist that visual and acoustical privacy are more important than any other design factor in achieving higher productivity. The debate may never end, but the partitioned open plan, which is a new form of the vast open plan, has merits of each concept - open and closed layout. Consequently, office design has dramatically shifted to partitioned open planning, with shorter, temporary walls or partitions, originally intended for increasing privacy and diminishing hierarchy, yet still keeping flexibility in spatial organization. The introduction of low-level partitioned spaces in an office layout, however, produces a complicated lighting design problem. Obviously, accurately predicted daylighting performance data are needed not only for daylighting design but for artificial lighting system design. Scale models of 12 sets of unit partitioned spaces are constructed and extensive scale model measurements of both daylight and reflected sunlight have been performed within an artificial sky simulator. The prototype-building interior is modeled with different partition configurations, each of which is modeled using the different envelope geometry and exterior configurations, and then the variations in interior light levels are estimated. The result indicates that partitioned spaces employed in an open plan of modern offices still offer a large potential for daylighting and energy saving as well. Much of the savings may derive from the cumulative effect of reflected sunlight. Optimal design for building envelope geometry and exterior configuration promises additional savings.