• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.55 no.4
• /
• pp.144-150
• /
• 2006

IEC 61850 is the worldwide protocol for the substation automation system. IEC 61850 transports the information which consists of different formats such as GOOSE(Generic Object Oriented Substation Event), MMS(Manufacturing Message Specification), SV(Sampled Values) and so on. For real time data transmission, GOOSE can be used. The remote-bus current data which were collected in a local-bus current differential IED can be transmitted to a distance IED at the same location by using GOOSE messages. The distance IED can eliminate the reactance effect by using the transmitted remote-bus current data. This method can improve the performance of the fault location.

• Proceedings of the KIEE Conference
• /
• summer
• /
• pp.192-194
• /
• 2004

At present, application of PSS/E input data for power flow , stability and fault analysis consist of only 154kV and over data(except 22.9kV data). 22.9kV(5.C) Static Condenser is in operation and installation at 22.9kV Bus of 154kV Substation. however, we assume that 22.9kV 5.C install at 154kV Bus. so, we need to study and search about critical limit for 154kV Bus standard operating Voltage according to 22.9kV 5.C Modeling Site by PSS/E Ver28

• Journal of Korean Society of Transportation
• /
• v.23 no.7 s.85
• /
• pp.53-61
• /
• 2005

The Seoul City Government recently reformed the entire public transport system in an effort to prevent further deterioration in urban bus system's performance and service level. To analyze into impact on the productivity of Seoul's urban bus firms, this paper measures firm-level technical efficiency and productivity change with data envelopment analysis and Malmquist index approach. The paper then conceptualizes that these forms produce three kinds of output (bus-kilometers, passengers, or bus-kilometers and passengers) using five inputs (driver, maintenance, management, vehicle and fuel). The findings show that most (over one half) firms experienced a decline (an improvement) in productivity in the case of specifying only bus-kilometers (passengers) as output. As a result, it is discovered that an average firm had no change in productivity in the case of combining bus-kilometers and passengers as output. This is because the efficiency of an average firm declined due to increase in employees per bus and to an decrease in kilometers per bus. while its effectiveness improved due to an increase in passengers per bus which was caused by an increase in routes and a change in fare structure.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.1
• /
• pp.94-101
• /
• 2010

Optimization of interconnects among processors and memories becomes important as multiple processors and memories can be integrated on a Multi-Processor System-on-Chip (MPSoC). Since the optimal interconnection architecture is usually dependent on the applications, systematic design methodology for various data transfer requirements is necessary. In this paper, we focus on bus interconnection for MPSoC applications which use 4 ~ 16 processors. We propose a new systematic bus design methodology under performance constraints using Single Arbitration Multiple Bus Accesses (SAMBA) style bus architectures. Optimized bus architecture is found to satisfy performance constraints for a single or multiple applications. When compared to the unoptimized architecture, our method can reduce the bus switch logic circuits significantly (by more than 50% sometimes). Furthermore, low cost bus architectures can be found to satisfy the performance constraints for multiple applications.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.2
• /
• pp.343-350
• /
• 2016

A secure and effective on-chip bus for detecting and preventing malicious attacks by infected IPs is presented in this paper. Most system inter-connects (on-chip bus) are vulnerable to hardware Trojan (Malware) attack because all data and control signals are routed. A proposed secure bus with modifications in arbitration, address decoding, and wrapping for bus master and slaves is designed using the Advanced High-Performance and Advance Peripheral Bus (AHB and APB Bus). It is implemented with the concept that arbiter checks share of masters and manage infected masters and slaves in every transaction. The proposed hardware is designed with the Xilinx 14.7 ISE and verified using the HBE-SoC-IPD test board equipped with Virtex4 XC4VLX80 FPGA device. The design has a total gate count of 39K at an operating frequency of 313MHz using the $0.13{\mu}m$ TSMC process.

• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.515-518
• /
• 1998

This paper describes a direct transfer method of multimedia data stream between multimedia processor and network device without using system memory. The hardware architecture and functions for direct transfer, the method to transfer multimedia data to and from the multimedia processor and etc are described. Comparing the proposed method with general methods, I show that the direct transfer method can decrease number of bus accesses and bus cycles.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10b
• /
• pp.1348-1351
• /
• 1996

In field bus network, field device are connected with a medium. Because a medium must be shared for transmitting data, there are random delay time when data arrive destination station. It is difficult that all data packets are guaranteed synchronization and real-time restriction. In this paper, we show an algorithm that makes network utilization to maximum, guarantees real-time restriction, calculates sampling time at all control loop.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.155-155
• /
• 2000

A high performance control and monitoring system for a high speed railway train requires a reliable the real-time communication network. TCN/WTB is designed for the data transmission over the train bus, and UIC556 defines that all the data be transmitted over TCN/WTB. This paper evaluates the performance of the link layer of WTB(Wired Train Bus). The evaluated results can be used for the selection of parameters for the sporadic message data.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.21 no.1
• /
• pp.35-50
• /
• 2022

After the introduction of the central bus lane system, bus traffic was prioritized. This resulted in improved trust from bus users. However, the low capacity at the central bus stop reduces traffic speed and punctuality. In addition, physical constraints are inevitable because the construction of central bus lanes and bus stops considers the city's road geometry. Therefore, this study attempted to optimize the effective green time of the traffic signal system at the entrance and exit of the central bus stop to remedy its insufficient operational capacity. The Transit Capacity and Quality of Service Manual and Korea Highway Capacity Manual were used as the analysis methodologies. The number of stop areas for central bus stops to be built was determined by excluding variable physical factors, and field survey data collected from nine randomly selected central bus stops currently installed in Seoul were used. A scenario analysis was conducted on the central bus stops with insufficient capacity by adjusting the effective green time, and the capacity of the central bus stop was set as the dependent variable. According to the results, 26.7 percent of the central bus stops with insufficient capacity can solve the problem of insufficient capacity. Therefore, the results of this study can be verified by improving the operation level, and it can be effective even if the number of central bus stops calculated by engineering is not guaranteed during the planning stage of the central bus stop. As the number of central bus stops is expected to increase further as the number of central bus stops increases, it is necessary to improve the number of central bus stops. Therefore, it is hoped that the results presented in this study will be used as basic data for the improvement plan at the operational level before introducing the physical improvement plan.

• 제어로봇시스템학회:학술대회논문집
• /
• 1994.10a
• /
• pp.251-256
• /
• 1994

Integration of intelligent robot workcell is now a hot issue in CIM and robotics area. This piper dealt with relatively low-level essential topics, i.e., multi-robot coordination and real-time communication for the integration of intelligent robot workcell. For the coordination of multi-robot system, the tightly-coupled coordination is proposed using the various sensors. In order to handle the numerous communication data, time-critical communication network (Field-bus) is introduced and investigated. Finally, intelligent robot workcell is suggested using the Mini-MAP and Field-bus.