• Geomechanics and Engineering
• /
• v.37 no.2
• /
• pp.167-178
• /
• 2024

The natural frequency shift under cyclic environmental loads is a key issue in the design of monopile-based offshore wind power turbines because of their dynamic sensitivity. Existing evidence reveals that the natural frequency shift of the turbine system in sand is related to the varying foundation stiffness, which is caused by soil deformation around the monopile under cyclic loads. Therefore, it is an urgent need to investigate the effect of soil deformation on the system frequency. In the present paper, three generalized geometric models that can describe soil deformation under two-way cyclic loads are proposed. On this basis, the cycling-induced changes in soil parameters around the monopile are quantified. A theoretical approach considering three-spring foundation stiffness is employed to calculate the natural frequency during cycling. Further, a parametric study is conducted to describe and evaluate the frequency shift characteristics of the system under different conditions of sand relative density, pile slenderness ratio and pile-soil relative stiffness. The results indicate that the frequency shift trends are mainly affected by the pile-soil relative stiffness. Following the relevant conclusions, a design optimization is proposed to avoid resonance of the monopile-based wind turbines during their service life.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.12
• /
• pp.1700-1706
• /
• 2016

To improve the number of simultaneous transmissions of machine-to-machine traffic in a spread spectrum ALOHA channel, we propose a new spreading technique called doubly truncated cyclic code shift keying (DTCCSK). By truncating the codeset of cyclic code shift keying, DTCCSK freely adjusts the spreading factor and the symbol length. As a result, DTCCSK exhibits both a high spectral efficiency of M-ary signaling and low implementation complexity of a direct sequence.

• Honam Mathematical Journal
• /
• v.26 no.2
• /
• pp.147-153
• /
• 2004

We provide some sufficient conditions for the adjoint of a unilateral weighted shift operator on a Hilbert space to be cyclic.

• Journal of IKEEE
• /
• v.16 no.1
• /
• pp.51-55
• /
• 2012

In this paper, we propose to employ a ternary sequence as a cyclic code shift keying (CCSK) modulation sequence. And we simulate the performance in a frequency hopping spread spectrum/time division multiple access (FHSS/TDMA) system with CCSK. Wireless channel is modeled as Rayleigh fading channel. From the simulation results, it is demonstrated that the system adopting the ternary sequence as a CCSK sequence has higher performance than that with a random sequence.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.6
• /
• pp.42-48
• /
• 2010

Joint Tactical Information Distribution System (JTIDS) uses cyclic code shift keying (CCSK) for baseband symbol modulation, in which 5-bit information is mapped to one of thirty two 32-chip sequences. It is a kind of direct sequence based spread spectrum communication. In this paper, the performance of non-coherent detection of CCSK using non-orthogonal 32-chip sequence is evaluated. And a 32-chip sequence with better performance is also proposed and compared with the conventional one.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.1
• /
• pp.83-91
• /
• 1993

In the digital transmission system, cyclic redundancy check(CRC) code is widely used because it is easy to be implemented and has good performance in error detection. CRC code generator consists of several shift registers and modulo 2 adders. After manipulation of input data stream in the encoder, the remaining value of shift registers becomes CRC code. At the receiving side, error can be detected and corrected by CRC codes immediately transmitted after data stream. But, in the high speed system such as an A TM switch, it is difficult to implement the serial CRC encoder because of speed limitation of available semiconductor devices. In this paper, we propose the efficient parallel CRC encoder and syndrome calculator to solve the speed problem in implementing these functions using the existing semiconductor technology.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.8
• /
• pp.2879-2899
• /
• 2021

The tone reservation (TR) scheme is an attractive method to reduce peak-to-average power ratio (PAPR) in the filter bank multicarrier with offset quadrature amplitude modulation (FBMC-OQAM) systems. However, the high PAPR of FBMC signal will severely degrades system performance. To address this issue, a cyclic shift based TR (CS-TR) scheme with embedding side information (SI) is proposed to reduce the PAPR of FBMC signals. At the transmitter, four candidate signals are first generated based on cyclic shift of the output of inverse discrete Fourier transform (IDFT), and the SI of the selected signal with minimum peak power among the four candidate signals is embedded in sparse symbols with quadrature phase-shift keying constellation. Then, the TR weighted by optimal scaling factor is employed to further reduce PAPR of the selected signal. At the receiver, a reliable SI detector is presented by determining the phase rotation of SI embedding symbols, and the transmitted data blocks can be correctly demodulated according to the detected SI. Simulation results show that the proposed scheme significantly outperforms the existing TR schemes in both PAPR reduction and bit error rate (BER) performances. In addition, the proposed scheme with detected SI can achieve the same BER performance compared to the one with perfect SI.

• ETRI Journal
• /
• v.42 no.3
• /
• pp.324-332
• /
• 2020

In this paper, a blind symbol timing offset (STO) estimation method is proposed for offset quadrature phase-shift keying (OQPSK) modulated signals, which also works for other linearly modulated signals (LMS) such as binary-PSK, QPSK, 𝜋/4-QPSK, and minimum-shift keying. There are various methods available for blind STO estimation of LMS; however, none work in the case of OQPSK modulated signals. The popular cyclic correlation method fails to estimate STO for OQPSK signals, as the offset present between the in-phase (I) and quadrature (Q) components causes the cyclic peak to disappear at the symbol rate frequency. In the proposed method, a set of close and approximate offsets is used to compensate the offset between the I and Q components of the received OQPSK signal. The STO in the time domain is represented as a phase in the cyclic frequency domain. The STO is therefore calculated by obtaining the phase of the cyclic peak at the symbol rate frequency. The method is validated through extensive theoretical study, simulation, and testbed implementation. The proposed estimation method exhibits robust performance in the presence of unknown carrier phase offset and frequency offset.

• Bulletin of the Korean Mathematical Society
• /
• v.60 no.2
• /
• pp.443-460
• /
• 2023

A binary linear code is said to be a ℤ₂-double cyclic code if its coordinates can be partitioned into two subsets such that any simultaneous cyclic shift of the coordinates of the subsets leaves the code invariant. These codes were introduced in [6]. A ℤ₂-double cyclic code is called reversible if reversing the order of the coordinates of the two subsets leaves the code invariant. In this note, we give necessary and sufficient conditions for a ℤ₂-double cyclic code to be reversible. We also give a relation between reversible ℤ₂-double cyclic code and LCD ℤ₂-double cyclic code for the separable case and we present a few examples to show that such a relation doesn't hold in the non-separable case. Furthermore, we list examples of reversible ℤ₂-double cyclic codes of length ≤ 10.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.55 no.3
• /
• pp.107-110
• /
• 2006

We fabricated the monolayers onto QCM by self-assembly using viologen, which has been widely used as electron acceptor. A gold electrode of the QCM was cleaned by piranha solution and prepared the ethanol-acetonitrile(1:1) solution with 2 m mol/l viololgen compounding of pure hi gas. We determined the time dependence to resonant frequency shift during self-assembly process and the electrochemical behavior of the self-assembled viologen monolayers by cyclic voltammetry. With increasing scan rate, the redox peak current of the viologen increased linearly. This was signified that the redox reaction was reversible. The EQCM measurements revealed the anions transfer during redox reactions, respectively. From the EQCM data, the well-defined shape peaks were nearly equal charges by cyclic voltammetry.