• 한국철도학회논문집
• /
• 제10권2호
• /
• pp.117-123
• /
• 2007

In this study, a ubiquitous sensor for condition monitoring of insulators and lightning arresters installed in power distribution lines and electric traction vehicles is presented. The sensor consists of two parts; a leakage current measurement and a lightning surge detection. Measured data are transmitted to a supervisory computer through ZigBee protocol based on IEEE 802.15.4. To detect leakage current, a window type Mn-ZCT is used and a low-noise amplifier with a gain of 60dB is designed, and this can measure leakage current in ranges of $100{\mu}A{\sim}5mA$. A sample-hold (S/H) and a Rogowski coil are injected to analyze the magnitude of surge current in ranges from 100A to 10kA with $8/20{\mu}s$-waveform.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 C
• /
• pp.1693-1695
• /
• 2000

In this paper with deposition 8A5H induce monolayers which has photoisomerization response displacement current was detected by photoisomerization and the amplifier was designed in order to amplify detected displacement current and then secondary current characteristic was measured. The experimental results are as following: In case of ultraviolet(${\lambda}_1$) and visible(${\lambda}_2$) irradiation on 8A5H induce monolayers depositioned on board the peak of current was detected about 9[fA]. Displacement current amplified as secondary transition form was measured but there was any particular reaction for detailed and accurate measurement restruction of the circuit is required.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2019년도 전력전자학술대회
• /
• pp.71-73
• /
• 2019

The output current of the Grid Connected Inverter (GCI) can be polluted with harmonics mainly due to i) dead time in switches, ii) non-linearity of switches, iii) grid harmonics, and iv) DC link fluctuation. Therefore, it is essential to design the robust Harmonic Compensation (HC) technique for the improvement of output current quality and fulfill the IEEE 1547 Total harmonics Distortion (THD) limit i.e. <5%. The conventional harmonic techniques often are complex in implementation due to their i) additional hardware needs, ii) complex structure, iii) difficulty in tuning of parameters, iv) current controller compatibility issues, and v) higher computational burden. In this paper, to eliminate the harmonics from the GCI output current, a novel Digital Lock-In Amplifier (DLA) based harmonic detection is proposed. The advantage of DLA is that it extracts the harmonic information accurately, which is further compensated by means of PI controller in feed forward manner. Moreover, the proposed HC method does not require additional hardware and it works with any current controller reference frame. To show the effectiveness of the proposed HC method a 5kW GCI prototype built in laboratory. The output current THD is achieved less than 5% even with 10% load, which is verified by simulation and experiment.

• 대한전자공학회논문지SD
• /
• 제49권8호
• /
• pp.22-26
• /
• 2012

본 논문에서는 0.18um CMOS(1P4M) 공정을 이용하여 HDMI용 액티브 광케이블에 적합한 채널당 2.5-Gb/s의 동작 속도를 갖는 광 수신기를 구현하였다. 광 수신기는 차동 증폭구조를 가지는 트랜스임피던스 증폭기, 5개의 증폭단을 갖는 리미팅 증폭기, 출력 버퍼단으로 구성된다. 트랜스임피던스 증폭기는 피드백 저항을 가진 인버터 입력구조로 구현함으로써 낮은 잡음지수와 작은 전력소모를 갖도록 설계하였다. 연이은 차동구조 증폭기 및 출력 버퍼단을 통해 전체 전압이득을 증가하였고, 리미팅 증폭단과의 연동을 용이하게 했다. 리미팅 증폭기는 다섯 단의 증폭단과 출력 버퍼단, 옵셋 제거 회로단으로 이루어져 있다. 시뮬레이션 결과, 제안한 광 수신기는 $91dB{\Omega}$ 트랜스임피던스 이득, 1.55 GHz 대역폭(입력단 0.32 pF의 포토다이오드 커패시턴스 포함), 16 pA/sqrt(Hz) 평균 잡음 전류 스펙트럼 밀도, 및 -21.6 dBm 민감도 ($10^{-12}$ BER)를 갖는다. 또한, DC 시뮬레이션 결과, 1.8-V의 전원전압에서 총 40 mW의 전력을 소모한다. 제작한 칩은 패드를 포함하여 $1.35{\times}2.46mm^2$의 면적을 갖는다. optical eye-diagram 측정 결과, 2.5-Gb/s 동작속도에서 크고 깨끗한 eye-diagram을 보인다.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 추계종합학술대회 논문집(1)
• /
• pp.337-340
• /
• 2000

In this paper, I compared some characteristics between HPA and LPA using Feedforward method. Feedforward method is known for best IMD correction. HPA generated 46.5㏈c at 45.5㏈m output power. But, using feedforward linearing method, I could improve IMD to 67.17㏈c at the same output power. IMD could be improved 20.67㏈ at 45.5㏈m output power. I measured average power, IMD, total current, and efficiency of two amplifier at many different power levels. I could get about 70d3c IMD using feedforward method.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.103-106
• /
• 2000

In this paper a communication system that is not using the communication line but power line is presented. It will be very useful for an information-oriented society with tele-metering and home automation. Conventional system has a difficulty in transmitting information due to decreasing communication voltage and increasing carrier, current. Proposed idea is a special type switching amplifier system which has a low inner resistance. It can provide reactive power and dose not have low impedance between the transceivers. This new system is proposed to overcome the loss of conductor load in a PLC system.

• 전자공학회논문지A
• /
• 제32A권1호
• /
• pp.138-145
• /
• 1995

The offset voltage in silicon Hall plates is mainly caused by stress and strain in package, and by alignment in process. The offset voltage is appeared random for condition change with time in the factory, is non-linearly changed with temperature. In this paper proposed new method of design of Hall IC, and methematicaly proved relation layout of chip of 90$^{\circ}$-shift-current Hall plate pair is matched with "Differentail to single ended Conversion amplifier." In the experiment, the offset voltage is reduced about 1/100 time than the original offset voltage.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1999년도 제14차 학술회의논문집
• /
• pp.259-261
• /
• 1999

An operational transconductance amplifier (OTA) based precision full-wave rectifier circuit is presented in this article. The proposed circuit has a very sharp corner in the DC transfer characteristic and simple configuration comprised three OTAs and one current mirror. The temperature dependence of the OTA transconductance is reduced. Experimental results demonstrating the characteristic of the circuit are included.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 하계종합학술대회 논문집
• /
• pp.305-308
• /
• 1999

In this paper, a transimpedance optical receiver based on PIN/P-HEMT with cascoded input stage and inductor peaking technique was designed for several giga bits optical communication. Analysis of the receiver shows that cascoded input stage with inductor peaking increase bandwidth without sacrificing low frequence gain. The receiver achieved a low noise characteristic and maximally flat frequence response. It is shown that the 3-dB bandwidth of the designed receiver is 8.3 ㎓ and input equivalent noise current is as low as 16pA/√Hz to 10㎓.

• International Journal of Precision Engineering and Manufacturing
• /
• 제4권3호
• /
• pp.5-11
• /
• 2003

A simulation model for radial magnetic bearings is presented. The model incorporates hysteresis, saturation and eddy current effects. A simple magnetization model that describes hysteresis and saturation is proposed. Eddy currents are taken into consideration by assuming that they are generated by single-turn fictitious coils wrapped around each magnetic flux path. The dynamic equations describing the simulation model can easily incorporate the operation of switching power amplifier. A simulation of a typical 8-pole radial magnetic bearing produces switching waveforms very similar to the experimental observation.