• Proceedings of the Korean Geotechical Society Conference
• /
• 2001.03a
• /
• pp.33-40
• /
• 2001

In this research, the cracking of tunnel concrete lining was investigated and analyzed through long-term measurement and nonlinear numerical analysis. For one year after the casting of lining, the stresses and strains were measured by the sensors installed in hard rock tunnel lining. The measurements showed that only small stresses which were less than cracking stress occurred in every survey sections regardless of sensor directions. It could be induced that the external load applied to the lining was small or ignorable. Also, it was carried out short-term numerical analysis based on such site condition as ambient temperature, the- degree of overbreak and mold staying period. Long-term numerical analysis based on creep & shrinkage and nonlinear cracking was carried out. The output showed that construction condition and ambient environments could make the lining concrete crack without external loads. The cracks formed in this process does not indicate the structural instability of the tunnel.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.05a
• /
• pp.346-349
• /
• 2006

Superstructure of reinforced concrete bridges are shortened or elongated due to creep, drying shrinkage, temperature and so on. Most of bridge superstructures are free to shortening and elongation without constraint and stresses will not be induced by creep, drying shrinkage and temperature. But if bridge superstructure are constraint due to wrong setting and functional defects of bridge bearing, very large constraint forces can be induced. In this study, PSCI-Beam by tilt-constructed with constraint and deviation of bearings are presented and the effects of time-dependent constraint stress and temperature loads are investigated.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2009.05a
• /
• pp.103-104
• /
• 2009

This paper focuses on the characteristics on long-term deflection and creep recovery of reinforced concrete beams under a sustained load of 25kN. In order to investigate the residual strengthen of the RC beam, a static flexural experiment was conducted. The result of the RC beam preloaded was compared with that of a RC beam, which was not preloaded.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.6 no.2
• /
• pp.17-22
• /
• 1986

The primary objective of this study is to compare the effects that are caused by shrinkage and creep of a concrete bridge deck during its construction. In this study four different bridge structures were compared. Two straight box girders and two curved box girders were compared for stress changes in positive moment region and negative moment region due to the effects of concrete. The effects on displacement behavior by the assumed section length by concrete placement were also studied. The analyses were performed by using Vlasov equation and finite difference numerical method to solve the governing differential equation.

• Magazine of the Korea Concrete Institute
• /
• v.8 no.3
• /
• pp.135-146
• /
• 1996

In this study, the properties of super flowing concrete containing fly ash were experimentally investigated and compared with those of ordinary concrete. Tests were carried out on five types of super flowing concrete mixes containing fly ash and three types of ordinary concrete mixes without fly ash. Flow test, 0-funnel test, box test, L type test and slump test were carried out to obtain the properties for flowability and workability of fresh concrete. The mechanical properties of hardened concrete were also investigated in terms of compressive strength, splitting tensile strength, modulus of elasticity, creep and drying shrinkage. In fresh concrete, it was found that super flowing concrete had excellent workability and flowability compared with ordinary concrete, and had self-compactable performance. Super flowing concrete *also had good mechanical properties at both early and late ages with compressive strength reaching as high as 40 MPa at 28 days. The creep deformation of super flowing concrete investigated was relatively lower than that of ordinary concrete, but drying shrinkage was much higher.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1994.04a
• /
• pp.187-190
• /
• 1994

During the initial design phases for prestressed concrete structures, the mecessary information concerning the physical properties of the hardened concrete such as creep, drying shrinkage, modulus of elasticity, and Poisson's ratio are obtained from design assumptions or accepted standards. But these assumptions may not totally reflect the actual long-term behavior of the concrete. So they may be of limited use in predicting the actual behavior. The purpose of this paper is to describe the test procedures and methods of evaluation which were used during the long-term study.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1991.10a
• /
• pp.41-44
• /
• 1991

Time dependent analysis of prestressed concrete beams subjected to pure torsion is studied. The present theory covers the behavior from the service load range to the ultimate stage. The tensile resistance of concrete is appropriately considered. The biaxial stress effects due to diagonal cracking are also taken into account. The time dependent aging, creep and shringkage effects are modelled by employing the equivalent nonmechanical torque concept. The present theory allows more accurate prediction of the service load behavior of pretressed concrete members.

• Journal of the Korea Concrete Institute
• /
• v.18 no.1 s.91
• /
• pp.29-36
• /
• 2006

Steel reinforced concrete(SRC) columns, which have been widely employed in high-rise buildings, exhibit a time-dependent behavior because of creep and shrinkage of concrete. This long-term behavior may cause a serious serviceability problem in structural systems, so it is very important to predict the deformation due to creep and shrinkage of concrete. However, it was found from the previous experimental studies that the long-term deformation of SRC columns was quite dissimilar from that of RC columns. A new method is required to quantitatively predict the long-term deformation of SRC columns. In this study, the causes of the discrepancy between the behaviors of RC and SRC columns are investigated and discussed. SRC columns exhibit a time-dependent relative humidity distribution in a cross section differently from that of reinforced concrete(RC) columns owing to the presence of a inner steel plate, which interferes with the moisture diffusion of concrete. This relative humidity distribution may reduce the drying shrinkage and the drying creep in comparison with RC columns. Therefore it is suggested that the differential moisture distribution should be taken into account in order to reasonably predict column shortening of SRC columns.

• Advances in concrete construction
• /
• v.15 no.2
• /
• pp.115-126
• /
• 2023

This paper investigates creep analysis of a plate made of Al-SiC functionally graded material using Mendelson's method of successive elastic solution. All mechanical and thermal material properties, except Poisson's ratio, are assumed to be variable along the thickness direction based on the volume fraction of reinforcement and thickness. First, the basic relations of the plate are derived using the Love-Kirchhoff plate theory. The solution of governing equations yields an elastic solution to start creep analysis. The creep behavior is demonstrated through Norton's equation based on Pandey's experimental results extracted for Al-SiC functionally graded material. A linear variation is assumed for temperature distribution along the thickness direction. The creep strain, as well as the thermal strain, are included in the governing equations derived from classical plate theory for mechanical strain. A successive elastic solution based on Mendelson's method is employed to derive the history of stresses, strains, and displacements over a long time. History of stresses and deformations are obtained over a long time to predict damage to the plate because of various loadings, and material composition along the thickness and planar directions.

• International Journal of Concrete Structures and Materials
• /
• v.7 no.1
• /
• pp.79-93
• /
• 2013

One of the biggest problems affecting bridges is the transverse cracking and deterioration of concrete bridge decks. The causes of early age cracking are primarily attributed to plastic shrinkage, temperature effects, autogenous shrinkage, and drying shrinkage. The cracks can be influenced by material characteristics, casting sequence, formwork, climate conditions, geometry, and time dependent factors. The cracking of bridge decks not only creates unsightly aesthetic condition but also greatly reduces durability. It leads to a loss of functionality, loss of stiffness, and ultimately loss of structural safety. This investigation consists of field, laboratory, and analytical phases. The experimental and field testing investigate the early age transverse cracking of bridge decks and evaluate the use of sealant materials. The research identifies suitable materials, for crack sealing, with an ability to span cracks of various widths and to achieve performance criteria such as penetration depth, bond strength, and elongation. This paper also analytically examines the effect of a wide range of parameters on the development of cracking such as the number of spans, the span length, girder spacing, deck thickness, concrete compressive strength, dead load, hydration, temperature, shrinkage, and creep. The importance of each parameter is identified and then evaluated. Also, the AASHTO Standard Specification limits liveload deflections to L/800 for ordinary bridges and L/1000 for bridges in urban areas that are subject to pedestrian use. The deflection is found to be an important parameter to affect cracking. A set of recommendations to limit the transverse deck cracks in bridge decks is also presented.