• 문화기술의 융합
• /
• 제9권6호
• /
• pp.855-859
• /
• 2023

질산구리삼수화물염(copper(II) nitrate trihydrate) 수용액을 공업용 전분(starch)에 함침 시킨 전구체를 이용하여 산화구리(CuO) 나노 입자를 합성하였다. 주사전자현미경(SEM)을 통하여 질산구리삼수화물염 수용액이 함침된 전구체에 대한 구조를 분석하였고, 전구체에 대한 열처리 온도를 증가 시킴에 따라 생성되는 산화구리 입자의 입자 크기와 결정 구조를 X선회절분석법(XRD)과 주사전자현미경(SEM)으로 분석하였다. 분석 결과에 따르면, 전구체에서 유기물질이 완전히 열분해 되어지는 온도는 450-490℃이며, 열처리하는 온도가 증가함에 따라 생성되는 산화구리 입자의 크기와 결정성이 증가하는 것을 확인할 수 있었고, 또한 500-800℃에서 1시간씩 열처리하여 얻은 산화구리 입자의 크기는 100nm-2㎛인 것으로 나타났다. 하소 온도 400℃에서 산화구리 결정상이 형성되고, 800℃까지는 산화구리 단일상만 존재하며, 하소 온도의 증가에 따라 생성되는 입자의 크기가 커지는 것을 확인하였다.

• 한국분말야금학회:학술대회논문집
• /
• 한국분말야금학회 2006년도 Extended Abstracts of 2006 POWDER METALLURGY World Congress Part 1
• /
• pp.167-168
• /
• 2006

A hyrdrothermal synthesis has been developd to prepare rod-like crystals of copper oxide using copper nitrate trihydrate as a function of synthesis temperature, stirring speed and solution pH value. The properties of the fabricated crystals were studied using scanning electron microscopy, X-ray diffraction and particle size analysis. The morphology of the synthesized CuO was dependent on both the pH value of the solution and the morphology of the seed materials. Synthesized particles have regular morphologies and a uniform size distribution.

• Bulletin of the Korean Chemical Society
• /
• 제7권5호
• /
• pp.385-388
• /
• 1986

The reaction of cupric nitrate trihydrate with S-2-pyridyl thioates in acetonitrile was studied. The major products were the corresponding carboxylic acids and $[Cu(NO_3)(C_5H_4NS)(C_5H_5NS$)] (Complex A). Sometimes $[Cu(NO_3)(C_5H_4NS)(H_2O$)] was also obtained in addition to Complex A. When Complex A was recrystallized in dimethylsulfoxide, $[Cu(NO_3)(C_5H_4NS)(C_5H_5NS)$ {$(CH_3)_2SO$}$_2]{\cdot}2H_2O$ was crystallized. The structures of these copper complexes and the role of cupric nitrate in the hydrolysis of S-2-pyridyl thioates are discussed.

• 한국재료학회지
• /
• 제24권1호
• /
• pp.19-24
• /
• 2014

We report the nitrogen monoxide (NO) gas sensing properties of p-type CuO-nanorod-based gas sensors. We synthesized the p-type CuO nanorods with breadth of about 30 nm and length of about 330 nm by a hydrothermal method using an as-deposited CuO seed layer prepared on a $Si/SiO_2$ substrate by the sputtering method. We fabricated polycrystalline CuO nanorod arrays at $80^{\circ}C$ under the hydrothermal condition of 1:1 morality ratio between copper nitrate trihydrate [$Cu(NO_2)_2{\cdot}3H_2O$] and hexamethylenetetramine ($C_6H_{12}N_4$). Structural characterizations revealed that we prepared the pure CuO nanorod array of a monoclinic crystalline structure without any obvious formation of secondary phase. It was found from the gas sensing measurements that the p-type CuO nanorod gas sensors exhibited a maximum sensitivity to NO gas in dry air at an operating temperature as low as $200^{\circ}C$. We also found that these CuO nanorod gas sensors showed reversible and reliable electrical response to NO gas at a range of operating temperatures. These results would indicate some potential applications of the p-type semiconductor CuO nanorods as promising sensing materials for gas sensors, including various types of p-n junction gas sensors.

• 한국산학기술학회:학술대회논문집
• /
• 한국산학기술학회 2011년도 추계학술논문집 1부
• /
• pp.196-199
• /
• 2011

In this study we synthesized mesoporous carbon supported CuO by using mesoporous silica i.e. SBA-15 as the template and cupric nitrate trihydrate ($Cu(NO_3)_23H_2O$)as copper source. The porous CuO was characterized with XRD, TGA, SEM and BET. The result reveals porous CuO has good crystal structure with uniform size of spherical crystal particles. The surface are a ($S_{BET}$) of porous CuO was found to be $153.46m^2g^{-1}$ with a total pore volume ($V_p$)of$0.1516cm^3g^{-1}$ and average pore size of 3.9 nm which was much higher than that of commercial CuO ($S_{BET}$, $7.6m^2g^{-1}$; $V_p$, $0.01cm^3g^{-1}$). The obtained porous CuO was studied for adsorption of $CO_2$and the maximum $CO_2$ adsorption capacity was found to be 67.5 mg/g of the sorbent at $25^{\circ}C$.