• 한국태양에너지학회:학술대회논문집
• /
• 2012.03a
• /
• pp.149-152
• /
• 2012

$Cu(In,Ga)Se_2$ (CIGS) is one of the most promising photovoltaic materials because of large conversion efficiency which has been achieved with an optimum Ga/(In+Ga) composition in $CuIn_{1-x}Ga_xSe_2$ (X~0.3). The Ga/(In+Ga) content is important to determine band gap, solar cell performances and carrier behaviors at grain boundary (GB). Effects of Ga/(In+Ga) content on physical properties of the CIGS layers have been extensively studied. In previous research, it is reported that GB is not recombination center of CIGS thin-film solar cells. However, GB recombination and electron-hole pair behavior studies are still lacking, especially influence of with different X on CIGS thin-films. We obtained the GB surface potential, local current and I-V characteristic of different X (00.7 while X~0.3 showed higher potential than 100 mV on GBs. Higher potential on GBs appears positive band bending. It can decrease recombination loss because of carrier separation. Therefore, we suggest recombination and electron-hole behaviors at GBs depending on composition of X.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.10
• /
• pp.758-765
• /
• 2018

This paper presents a 24-GHz frequency-modulated continuous wave(FMCW) radar transceiver with two Rx and one Tx channels in 65-nm complementary metal-oxide-semiconductor(CMOS) process and implemented it on a radar system using the developed transceiver chip. The transceiver chip includes a $14{\times}$ frequency multiplier, low-noise amplifier, down-conversion mixer, and power amplifier(PA). The transmitter achieves >10 dBm output power from 23.8 to 24.36 GHz and the phase noise is -97.3 GHz/Hz at a 1-MHz offset. The receiver achieves 25.2 dB conversion gain and output $P_{1dB}$ of -31.7 dBm. The transceiver consumes 295 mW of power and occupies an area of $1.63{\times}1.6mm^2$. The radar system is fabricated on a low-loss Duroid printed circuit board(PCB) stacked on the low-cost FR4 PCBs. The chip and antenna are placed on the Duroid PCB with interconnects and bias, gain blocks and FMCW signal-generating circuitry are mounted on the FR4 PCB. The transmit antenna is a $4{\times}4$ patch array with 14.76 dBi gain and receiving antennas are two $4{\times}2$ patch antennas with a gain of 11.77 dBi. The operation of the radar is evaluated and confirmed by detecting the range and azimuthal angle of the corner reflectors.

• Applied Chemistry for Engineering
• /
• v.8 no.6
• /
• pp.960-966
• /
• 1997

The effects of epoxy resins and content of catalyst on the cure characteristics were studied by FT-IR, DSC and dynamic viscometer for the thermal properties and rheological properties of the catalytic (N-Benzylpyrazinium hexafluoroantimonate, BPH) epoxy thermosetting system. Compared with DSC results of DEGBF containing 0.5wt% BPH, the DSC thermograms of DGEBA containing 0.5wt% BPH indicated that the reaction was faster than that of DGEBF/BPH and the conversion rate of DGEBA/BPH was high in the initial stage of the reaction. As the concentration of BPH increases, the reaction and conversion rates show similar value in both the cases. The influence of hydroxyl group of epoxy resin on gel point defined from the crossover point of storage modulus (G') and loss modulus (G") could be explained by the formation of 3-dimensional network in the initial stage owing to the curing reaction between epoxides and hydroxyl groups of epoxy resin. This was consistent with the gel point obtained from DSC, FT-IR and moduli crossover. The activation energy (Et) obtained from the crossover point (G'/G"=1) are $31-39kJ.mol^{-1}$ for various BPH compositions in case of two epoxy systems.

• Asian-Australasian Journal of Animal Sciences
• /
• v.33 no.8
• /
• pp.1310-1322
• /
• 2020

Objective: The current study was conducted to evaluate the quality and profile of fatty acid in the breast and thigh, and the performance of broilers fed diets containing seed or oil of chia (Salvia hispanica L.) as a replacement for soybean, in the rearing period from 29 to 42 days of age. Methods: On the 29th day of age, 120 broilers were distributed in four treatments evaluated in five replicates of six birds. The grain or oil of soybean was respectively replaced on a weight-to-weight basis in the formulation by the seed or oil of chia, constituting the experimental diets. The roasted whole soybean and chia seed were included in the feed at 16.4%, whereas the soybean and chia oils were included at 2.5%. Results: The dietary chia oil increased the lipid peroxidation in the thigh meat, and the dietary chia seed increased the cooking loss of the thigh. However, for the other physicochemical parameters evaluated and for the proximate composition of the breast and thigh, in general, the inclusion of chia seed or oil in the diet provided similar or better results than those observed when the diets contained soybean oil or roasted whole soybean. With regard to the fatty acid profile and associated parameters, dietary chia increased the concentrations of α-linolenic, eicosapentaenoic, and docosahexaenoic acids and reduced the Σω-6:Σω-3 ratio and the atherogenicity and thrombogenicity indices of the broiler meat. However, the dietary chia seed worsened the feed conversion ratio. Conclusion: Diet containing 2.5% chia oil supplied to broilers during the period from 29 to 42 days of age improves the feed conversion ratio, increases the deposition of the ω-3 fatty acids in the breast and thigh, in addition to reducing the Σω-6:Σω-3 ratio and the atherogenicity and thrombogenicity indices, thereby resulting in meat with higher nutritional quality.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.2
• /
• pp.170-175
• /
• 2016

In order to transmit baseband signals through frequency dividing devices, we studied the transfer function of the device in the term of the baseband signal distortion. From the analysis, it is shown that the magnitude of the envelope signal is related to the mixer gain and the insertion loss of the low pass filter whilst the phase is the additional function with the 1/2 of the phase delay. For the purpose of the verification of the study, we designed a dynamic frequency divider at 1,400 MHz. The operating frequency range of the device is closely related to the conversion gain of mixers and the amplitude of input signal, and becomes wide as the conversion gain of mixers increases. The designed frequency divider operates between 0.9 GHz and 3.2 GHz, for -14.5 dBm input power. The circuit shows 20 mW power dissipation at $V_{DD}=2.5V$, and the simulation result shows that an amplitude modulated signal at 1,400 MHz with the modulation index of 0.9 was successfully downconverted to 700 MHz.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.10 no.6
• /
• pp.578-586
• /
• 2005

Recently, due to the launch of digital broadcasting service, the demand of Flat Panel Display (FPD) is sharply rising. Among them, the PDP is expected to be one of the most promising digital displays of next generation because of its large screen size, high resolution, thinness and board field of view. Meanwhile, the PDP uses ADS (Address Display-period Separation) scheme which divide one subfield into address and sustaining period to express the grey scale of images. Since the output of sustaining power module Is mostly used for sustaining period, the load of the sustaining power module can be considered as a pulsating load. Due to this particular load condition, if the wide ZVS range of the power switches is not guaranteed, the hard switching causes large amount of switching loss and serious thermal problem in power module. In this paper, a high efficiency power conversion circuit for 60' PDP sustaining power module which achieves wide ZVS range with the help of additional ZVS tank is proposed. According to the various gating methods, the different operations of the proposed converter are presented. And, to confirm the properties of the proposed converter, an experimental prototype of 900W power converter is constructed md tested. As a result, more than $92\%$ of high efficiency is obtained at $10\%$ load condition, and the ZVS operation is achieved from full load to $10\%$ load condition.

• Journal of the Institute of Convergence Signal Processing
• /
• v.18 no.2
• /
• pp.76-83
• /
• 2017

In this study, the original medical image, DICOM file, was converted into TIFF, BITMAP, GIF, JPEG image file, and then the conversion loss ratio according to the image compression and conversion process was quantitatively evaluated using Origin pro and ICY image analysis program. As the evaluation method, 50% MTF, structural similarity index, MSE, RMSE, maximum signal - to - noise ratio and so on were evaluated. The TIFF image file showed the same result as DICOM image in all experimental groups, Image file format. In this study, we propose a new method for evaluating the quality of digital images by applying original evaluation program such as Origin pro or ICY medical image analysis program. Is expected to be used as research data in the field of medical image processing, and TIFF image file showing the same result as DICOM image in the basic research field using digital medical image and evaluation program that does not support DICOM file Therefore, it is believed that it will help to secure reliability in digital medical image processing research using image file.

• Journal of the Korea Institute of Building Construction
• /
• v.20 no.6
• /
• pp.505-514
• /
• 2020

This research introduces the method of developing Korea BIM standard (KBIMS) architectural and structural element library and the methodology of converting KBIMS IFC property names with special characters. Diverse BIM tools are utilizing in project, however BIM library researches lack diversity on BIM tool selection. This research described the method to generate twelve categories and seven hundred and ninety-three elements library containing geometrical and numerical data in CATIA V6. KBIMS has its special property data naming systems which was the challenge inputting to ENOVIA IFC database. Three mapping methods for special naming characters had been developed and the ASCII code method was applied. In addition, the convertor prototype had been developed for searching and replacing the ASCII codes into the original KBIMS IFC property names. The methodology was verified by exporting 2,443 entities without data loss in the sample model conversion test. This research would provide a wider choice of BIM tool selection for applying KBIMS. Furthermore, the research would help on the reduction of data interoperability issues in projects. The developed library would be open to the public, however the continuous update and maintenance would be necessary.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.11
• /
• pp.44-52
• /
• 1998

In this paper, we proposed a node architecture and cell routing strategies for ATM applications in WDM multihop networks. The proposed node architecture employs the optical delay loop for storing the cell which is failed in out-link contention. This optical delay loop allows the delay of one cell without the electro-optic conversion. Therefore, we can get the advantages of S&F(Store-and-Forward) routing in Deflection-based all-optical networks. To support the ATM applications efficiently. we considered the transmission priority of ATM cell so that high priority cell can be transmitted with lower loss and shorter delay than low priority one. Two kinds of routing strategies are designed for this architecture: Scheme-Ⅰand Scheme-Ⅱ. Scheme-Ⅰapplies S&F routing to high cell and Deflection routing to low cell, i.e., high cells are routed along the shortest path based on S&F routing, but low cells are deflected or lost. Schem-Ⅱ is similar to Scheme-Ⅰexcept that low cells can occupy the optical loop if it is available. This Scheme-Ⅱ increases the utilization of network resources without decreasing the throughput of high cell by reducing the low cell loss rate when traffic load is low. Simulation results show that our routing strategies have better performance than conventional ones under non-uniform traffic as well as uniform traffic.

• Asian-Australasian Journal of Animal Sciences
• /
• v.29 no.10
• /
• pp.1470-1476
• /
• 2016

Octacosanol, which has prominent physiological activities and functions, has been recognized as a potential growth promoter in animals. A total of 392 1-d-old male Arbor Acres broiler chicks with similar body weight were randomly distributed into four dietary groups of seven replicates with 14 birds each supplemented with 0, 12, 24, or 36 mg octacosanol (extracted from rice bran, purity >92%)/kg feed. The feeding trial lasted for six weeks and was divided into the starter (day 1 to 21) and the grower (day 22 to 42) phases. The results showed that the feed conversion ratio (FCR) was significantly improved in broilers fed a diet containing 24 mg/kg octacosanol compared with those fed the control diet in the overall phase (day 1 to 42, p = 0.042). The average daily gain and FCR both showed linear effects in response to dietary supplementation of octacosanol during the overall phase (p = 0.031 and 0.018, respectively). Broilers fed with 24 or 36 mg/kg octacosanol diet showed a higher eviscerated yield, which increased by 5.88% and 4.26% respectively, than those fed the control diet (p = 0.030). The breast muscle yield of broilers fed with 24 mg/kg octacosanol diet increased significantly by 12.15% compared with those fed the control diet (p = 0.047). Eviscerated and breast muscle yield increased linearly with the increase in dietary octacosanol supplementation (p = 0.013 and 0.021, respectively). Broilers fed with 24 or 36 mg/kg octacosanol diet had a greater (p = 0.021) $pH_{45min}$ value in the breast muscle, which was maintained linearly in response to dietary octacosanol supplementation (p = 0.003). There was a significant decrease (p = 0.007) in drip loss value between the octacosanol-added and the control groups. The drip loss showed linear (p = 0.004) and quadratic (p = 0.041) responses with dietary supplementation of octacosanol. These studies indicate that octacosanol is a potentially effective and safe feed additive which may improve feed efficiency and meat quality, and increase eviscerated and breast muscle yield, in broiler chicks. Dietary supplementation of octacosanol at 24 mg/kg diet is regarded as the recommended dosage in the broilers' diet.