• 조명전기설비학회논문지
• /
• 제27권2호
• /
• pp.102-109
• /
• 2013

In this paper, a new torque predictive control method of interior permanent magnet synchronous motor is developed based on an extended rotor flux. Also, a duty ratio prediction method is proposed and allows the duty ratio of the active stator voltage vector to be continuously calculated. The proposed method makes it possible to relatively reduce the torque ripple under the steady state as well as to remain the good dynamic response in the transient state. With the duty ratio prediction method, the magnitude and time interval of the active stator voltage vector applied can be continuously controlled against the varying operation conditions. This paper shows a comparative study among the switching table direct torque control(DTC), the SVM-DTC, conventional torque predictive control, and the proposed torque predictive control. Simulation results show validity and effectiveness of this work.

• 전력전자학회논문지
• /
• 제12권6호
• /
• pp.441-448
• /
• 2007

대화면 LCD TV (40인치 이상)에서 LCD 인버터의 가격 경쟁력을 위해 인버터 하나로 다수의 램프를 병렬 구동하면서 Two Stage System 구조인 IP(Integrated Power) Board 형태의 인버터 회로가 많이 사용되고 있다. 본 논문에서는 기존 IP Board의 인버터 구동 방식인 Pulse Width Modulation (PWM) 제어 방식을 분석하고, 문제점으로 제기되었던 Half-Bridge단 스위치의 하드 스위칭과 과도한 Circulating Energy 문제를 해결한 새로운 Pulse Count Modulation (PCM) 방식을 적용한 인버터를 제안하고 이론 및 실험적 검증을 통해 제안된 방식의 우수성을 확인하였다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1998년도 추계학술대회 논문집
• /
• pp.9-12
• /
• 1998

Film characteristics of thin reoxidized nitrided oxides were investigated by SIMS analysis and C-V method in order to use the gate dielectric for charge-trap type NVSMs instead of ONO stacked layers. Nitric oxide(NO) annealed film has the nitrogen content sharply peaked at the Si-SiO$_2$ interface, while it is broad for nitrous oxide($N_2$O) ambient. The nitrogen peak concentration increased with anneal temperature and time. The position of nitrogen content in the oxide layer was due to be precisely controlled. For the films annealed NO ambient at 80$0^{\circ}C$ for 30min. followed by reoxidized at 85$0^{\circ}C$, the maximum memory window of 3.5V was obtained and the program condition was +12V, 1msec for write and -l3V, 1msec for erase.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2012년도 추계학술대회 논문집
• /
• pp.88-90
• /
• 2012

A study on an integrated single stage AC/DC converter is presented in this paper. The input current can be controlled by the auxiliary winding($L_{aux}$), auxiliary primary winding($N_3$), and the boost inductor($L_B$) which are designed to operate in discontinuous conduction mode(DCM) to reduced the total harmonic distortion(THD) of input current. The auxiliary primary winding($N_3$) is critically selected in order to compress the input capacitor voltage($V_{in}$) as well as to reduce the current stress of the switch(Q). Low total harmonic distortion(THD), low input voltage($V_{in}$) in universal input voltage($V_{AC}$), low current stress at the switching device and high efficiency are the main consideration keys in this design to achieve high performance system with low cost of single stage AC/DC converter. A 30W single stage AC/DC prototype converter is under study.

• 한국광학회지
• /
• 제7권4호
• /
• pp.414-418
• /
• 1996

광표백 광도파로 자기정렬 전극을 이용하여 전기광학 폴리머 디지탈 광스위치를 제작하였다. 이 광스위치는 파장에 무관하게 동작하고 제작조건에 민감하지 않고 설계가 다양하다는 특성을 갖는다. 또한 광섬유와의 결합 손실이 작고 넓은 대역폭을 갖는 장점이 있다. 스위칭 성능을 향상시킬 목적으로 광표백 시간을 이용하여 광표백 광도파로의 도파모드 분포를 적절하게 조절함으로써 브랜치 영역에서의 모드 결합을 최적화 하였다. 또한 광과 인가 전계의 효과적인 겹침과 점진적으로 테이퍼된 전극을 형성하기 위해 자기정렬전극을 이용하였다. 측정된 누화는 1.32.mu.m와 1.55.mu.m에서 모두 -21dB 이하였고 각 출력포트의 소멸비도 모두 20dB 이상이었다.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2005년도 ICCAS
• /
• pp.145-150
• /
• 2005

This paper presents an Electrotactile Display System (ETCS). One of the most important human sensory systems for human computer interaction is the sense of touch, which can be displayed to human through tactile output devices. To realize the sense of touch, electrotactile display produces controlled, localized touch sensation on the skin by passing small electric current. In electrotactile stimulation, the mechanoreceptors in the skin may be stimulated individually in order to display the sense of vibration, touch, itch, tingle, pressure etc. on the finger, palm, arm or any suitable location of the body by using appropriate electrodes and waveforms. We developed an ETCS and investigated effectiveness of the proposed system in terms of the perception of roughness of a surface by stimulating the palmar side of hand with different waveforms and the perception of direction and location information through forearm. Positive and negative pulse trains were tested with different current intensities and electrode switching times on the forearm or finger of the user with an electrode-embedded armband in order to investigate how subjects recognize displayed patterns and directions of stimulation.

• 한국통신학회논문지
• /
• 제13권3호
• /
• pp.239-254
• /
• 1988

현대 통신에서 혼신방지및 보안유지를 위한 방법으로 ECCM기법이 개발되었다. 주파수 도약방식은 이러한 기법중의 하나이며 RF변조된 신호를 일정한 대역폭내에서 빠르게 움직여 신호의 추적을 어렵게 만드는 방법이다. 본 논문에서는 1.25MHz-800Hz의 FM변조된 기준 신호와 LO(Local Oscillator)에 의해 30-80MHz의 FM출력을 얻을 수 있는 PLL-Exciter를 구성하였다. Exciter의 LO로는 42.5-100.5 MHz에서 도약시킬 수 있는 주파수 합성기를 사용하였다.

• 한국통신학회논문지
• /
• 제26권12C호
• /
• pp.225-232
• /
• 2001

MPLS 방식 공중망에 구축된 가상사설망(VPN)에서 이동성 지원 방안을 기술한다. 이 논문에서 제시된 MPLS VPN은 CE(Customer Edge) 라우터 기반의 VPN이다. MPLS VPN에서 Customer 사이트에 속한 노드의 이동 서비스를 지원하기 위해 CE 라우터에 이동 엔티티(홈 에이전트, 외부 에이전트, 대응 에이전트) 기능이 추가된다. 노드가 같은 VPN 내의 사이트로 이동하는 경우, 다른 VPN 내의 사이트로 이동하는 경우, 그리고 일반 인터넷 지역으로 이동하는 경우를 고려하여 이동성 지원 프로토콜을 설계한다. 시뮬레이션 도구 COVERS를 사용하여 프로토콜을 구현하고 성능 분석을 수행하며, PE(Provider Edge) 라우터 기반의 MPLS VPN과의 성능을 비교한다.

• 한국군사과학기술학회지
• /
• 제15권1호
• /
• pp.66-74
• /
• 2012

The virtual target signal generator was developed to verify the shipborne tracking radar performance. It was used to DRFM(Digital RF Memory) method to generate the virtual moving targets. The target signal includes Doppler shift and RCS according to the target motion. And the signal generator can make jamming signal and clutter to test shipborne radar performance at real environmental condition. This paper described the functional diagram and the hardware configuration items to meet the test requirements for the tracking radar. And it showed the critical design points for the sub-systems. The signal generator which was developed in this paper shared the operational information of the radar with the radar command and control part. To test the frequency agility of the radar, it had the local oscillator which could do high speed frequency switching according to radar information. By communicating between the signal generator and the radar command and control part, the local oscillator of signal generator could be controlled every pulse. It reduced the instantaneous bandwidth of signal generator and minimized the spurious. So it lowered the probability of generating wrong targets.

• Journal of Power Electronics
• /
• 제10권1호
• /
• pp.85-90
• /
• 2010

In this paper the effects of a Static Synchronous Series Compensator, which is constructed with a 48-pulse inverter, on the power demand from the grid are studied. Extensive simulation studies were carried out in the MATLAB simulation environment to observe the compensation achieved by the SSSC and its effects on the line voltage, line current, phase angle and real/reactive power. The designed device is simulated in a power system which is comprised of a three phase power source, a transmission line, line inductance and load. The system parameters such as line voltage, line current, reactive power Q and real power P transmissions are observed both when the SSSC is connected to and disconnected from the power system. The motivation for modeling a SSSC from a multi-pulse inverter is to enhance the voltage waveform of the device and this is observed in the total harmonic distortion (THD) analysis performed at the end of the paper. According to the results, the power flow and phase angle can be controlled successfully by the new device through voltage injection. Finally a THD analysis is performed to see the harmonics content. The effect on the quality of the line voltage and current is acceptable according to international standards.