• Journal of the Korean Geotechnical Society
• /
• v.19 no.3
• /
• pp.39-44
• /
• 2003

Centrifuge test was conducted to simulate the effects of consolidation settlement of capped contaminated marine sediment. A fluorescent dye was used to monitor the movement of pore water through the cap layer. Dye tracer study clearly showed the consolidation induced advective transport of contaminants. Thus, the capping layer must be appropriately designed to reduce the effects of consolidation induced advective transport. The results from the centrifuge test were compared to predictions made by the Primary consolidation, Secondary compression, and Desiccation of Dredged Fill (PSDDF) computer program, which can qualitatively estimate the consolidation settlement of capped marine sediment. Although PSDDF approximated closely the secondary compression in the centrifuge test (i.e., compare data points from 18 to 25 prototype years), the maximum deviation between centrifuge test result and PSDDF prediction was 20 % about prototype time 6 years. Thus, designers should utilize PSDDF consolidation settlement results with caution.

• Journal of Environmental Science International
• /
• v.8 no.5
• /
• pp.593-600
• /
• 1999

In order to determine the changes of sediment facies and metal levels in surface sediments after the construction of Shiwha Lake, surface sediments were sampled at 8 sites located on the main channel monthly from June, 1995 to August, 1996 and analysed for 12 metals (Al, Fe, Mn, V, Cr, Co, Ni, Cu, Zn, Cd, As and Pb) by ICP/AES and ICP/MS. Two groups of sampling sites(the inner lake with 3 sites and the outer lake with 5 sites) are subdivided by the surface morphology ; the inner lake is a shallow channel area with a gentle slope, while the outer lake is relatively deep and wide channel with a steep slope which has many small distributaries. After the construction of dam, fine terrestrial materials were deposited near the outer lake, which resulted in the change of major sediment facies from sandy silt to mud. With the deposition of fine sediments in the outer lake, anoxic water column induced the formation of sulfide compounds with Cu, Cd, Zn and part of Pb. Metal (Cr, Ni, Cu, Zn and Cd) contents in sediments increased up to twice within 2 years after the construction of dam. This is due to the direct input of industrial and municipal wastes into the lake and the accumulation of metals within the lake. In addition, frequent resuspension of contaminated sediments in a shallow part of the lake may make metal-enriched materials transport near the outer lake with fine terrestrial materials. As the enrichment of Cu, Zn, Cd and part of Pb in the Shiwha Lake may be related to the formation of unstable sulfide compounds by sulfate reduction in anoxic water or sediment column, the effect of mixing with open coastal seawater is discussed.

• Journal of Korean Society of Water and Wastewater
• /
• v.31 no.3
• /
• pp.229-236
• /
• 2017

In this study, a direct contact membrane module was manufactured to be used in a pilot scale membrane distillation process to treat $3m^3/day$ of the digestate produced from anaerobic digestion of livestock manure. In order to investigate the performance of the membrane module, permeate flux was measured with and without spacer inside the module under various condition of temperature difference and cross flow velocity (CFV) through the membrane surfaces. Flux recovery rate after chemical cleaning was also investigated by applying three different cleaning methods. Additionally, thermal energy consumption was theoretically simulated based on actual pilot plant operation conditions. As results, we observed flux of the module with spacer was almost similar to the theoretically predicted value because the installation of spacer reduced the channeling effect inside the module. Under the same operating condition, the permeate flux also increased with increasing temperature difference and CFV. As a result of chemical in-line cleaning using NaOCl and citric acid for the fouled membranes, the recovery rate was 83.7% compared to the initial flux when NaOCl was used alone, and 87% recovery rate was observed when only citric acid was used. However, in the case of using only citric acid, the permeate flux was decreased at a rapid rate. It seemed that a cleaning by NaOCl was more effective to recover the flux of membrane contaminated by the organic matter as compared to a cleaning by citric acid. The total heat energy consumption increased with increasing CFV and temperature difference across the membrane. Thus, further studies should be intensively conducted to obtain a high permeate flux while keeping the energy consumption to a minimum for a practical application of membrane distillation process to treat wastewater.

• Journal of Korean Society on Water Environment
• /
• v.18 no.2
• /
• pp.151-157
• /
• 2002

Landfill leachate is one of highly contaminated and heterogeneous wastewater. The leachate from initial landfill can be treated by anaerobic process because it contains biodegradable matters, particularly, volatile fatty acids (VFAs). However, the anaerobic treatment of leachate is generally required longer hydraulic retention time (HRT) than aerobic process and another treatment process to satisfy effluent concentration. Therefore the modification of conventional anaerobic treatment is needed. Two phase anaerobic membrane process (TPAMP) is an integrated membrane process to be able to separate anaerobic metabolism into two phase which are acidogenesis and methanogenesis for improvement of anaerobic treatment efficiency. In this study, the efficiency of TPAMP and conventional anaerobic treatment were compared in terms of HRT, effluent SCOD, VFAs Membrane used in TPAMP was the UF of capillary type with the surface area of $0.048m^2$. The average effluent SCOD of conventional anaerobic treatment was 1352 mg/L and the removal was 96 % at HRT 60 days, while in TPAMP, 927 mg/L and 98% at HRT 30 days.

• Korean Journal of Ecology and Environment
• /
• v.47 no.spc
• /
• pp.19-30
• /
• 2014

Microcystins (MCs) produced by cyanobacteria are severe hepatotoxins for mammalian and protein phosphatase inhibitors. Irrigation water for grain and vegetables is often contaminated with cyanobacteria and microcystin during warm seasons. We assessed the effects of various concentrations (0, 0.01 to $10{\mu}gmL^{-1}$) of microcystin-LR (MC-LR) and microcystin-RR (MC-RR) exposure on Oryza sativa (rice) and Brassica oleraces var. italica (broccoli). The $EC_{50}$ of leaves and roots of rice was 0.9 and $1.1{\mu}gMC-LRmL^{-1}$, respectively. The no observed effect level (NOEL) of rice was less than $0.1{\mu}gmL^{-1}$ ($100{\mu}gL^{-1}$). The $EC_{50}$ of the stems and roots of broccoli was 8.7 and $7.2{\mu}gMC-RRmL^{-1}$, respectively. There was no difference in the germination rate of broccoli among microcystin-RR concentrations. After exposure to 0, 0.01 to $10{\mu}gmL^{-1}$ MC-RR for seven days, 14, 89 and 154 ng mg-1 (dry weight) MC-RR accumulated in B. oleracea. These $EC_{50}$ values showed that microcystin-LR and -RR affected the growth of rice and broccoli. These findings suggest that MC is carried into terrestrial ecosystems via irrigation, and that the biota of higher ecological niches can be influenced by MC through bioaccumulation. Therefore, a guideline for MC concentrations in irrigation water should be set using the NOEL.

• Journal of Soil and Groundwater Environment
• /
• v.17 no.4
• /
• pp.44-50
• /
• 2012

A new type of chemical oxidation technology utilizing micro bubble ozone oxidizer and a pneumatic fracturing equipment was developed to enhance field applicability of a traditional chemical oxidation technology using hydrogen peroxide as an oxidizer for in-situ soil remediation. To find an efficient way to dissolve gaseous ozone into hydrogen peroxide, ozone was injected into water as micro bubble form then dissolved ozone concentration and its duration time were measured compared to those of simple aeration of gaseous ozone. As a result, dissolved ozone concentration in water increased by 31% (1.6 ppm ${\rightarrow}$ 2.1 ppm) and elapsed time for which maximum ozone concentration decreased by half lengthened from 9 min to 33 min. When the developed pneumatic fracturing technology was applied in sandy loam, cracks were developed and grown in soil for 5~30 seconds so that the radius of influence got longer by 71% from 392 cm to 671 cm. The remediation system using the micro bubble ozone oxidizer and the pneumatic fracturing equipment for field application was made and demonstrated its remediation efficiency at petroleum contaminated site. The system showed enhanced remediation capacity than the traditional chemical oxidation technology using hydrogen peroxide with reduced remediation time by about 33%.

• Journal of Soil and Groundwater Environment
• /
• v.26 no.6
• /
• pp.65-73
• /
• 2021

Since the amount of red mud, generated from aluminum smelting process as a by-product, has increased worldwide, the recycle and metal resource recovery from the red mud is becoming more important. In this study, in order to recycle the red mud as a soil stabilizer to remediate arsenic contaminated soils, neutralization of red mud was investigated. Red mud was neutralized by washing with distilled water and NaCl, CaCl₂, FeCl₃, and HCl solutions and heating at 200-800℃, and arsenic stabilization characteristics in soils were evaluated with the neutralized red mud. Although washing with distilled water was not effective in neutralizing red mud, the application of the washed red mud to soils lowered the soil pH compared to the application of untreated red mud. Among NaCl, CaCl₂, FeCl₃, and HCl solutions, washing with FeCl₃ showed the most effective in lowering pH of the red mud from pH 10.73 to pH 4.26. Application of the neutralized red mud in soils resulted in quite different arsenic stabilization efficiency depending on soil samples. In M1 soil, which showed relatively high arsenic stabilization efficiency by untreated red mud, the neutralization of red mud resulted in little effect on arsenic stabilization in soil. On the other hand, in M2 soil, which showed low arsenic stabilization efficiency by untreated red mud, the neutralization of red mud increased arsenic stabilization significantly. Soil characteristics such as clay minerals and pH buffering capacity seemed to affect reactions between red mud and soils, which resulted in different effects of the red mud application on soil pH and arsenic stabilization efficiencies.

• Applied Chemistry for Engineering
• /
• v.30 no.3
• /
• pp.345-351
• /
• 2019

In this study, the hollow fibers from $TiO_2$ and various metal oxides additives were fabricated and characterized in order to remove the arsenic substance from a contaminated water. Experimental results showed the best arsenic adsorption performance from pristine $TiO_2$ hollow fibers. When metal oxides were added, the metal oxides reduced the acid sites on the surface of $TiO_2$ and the arsenic adsorption performance decreased. However, the long term arsenic adsorption performance was enhanced and showed better performance than that of using pristine $TiO_2$ hollow fibers when $Al_2O_3$ was added during the hollow fiber fabrication. In addition, the arsenic adsorption performance showed a high dependency on the specific surface area of hollow fibers. It was confirmed that the abundancy of Lewis and Bronsted acid sites provided was favorable for the arsenic adsorption. It was also demonstrated that commercially available $TiO_2$ powders can be an attractive candidate material for manufacturing hollow fibers for a small scale water treatment plant.

• Journal of Korean Society on Water Environment
• /
• v.38 no.2
• /
• pp.82-94
• /
• 2022

In this study, chemically modified biochar (NSBP500, KSBP500, OSBP500) derived from starfish was utilized to improve the adsorption ability of the SBP500 (Starfish Biochar Pyrolyzed at 500℃) in a solution contaminated with heavy metals. According to the biochar modification performance evaluation batch tests, the removal rate and adsorption amount of NSBP500 increased 1.4 times for Cu, 1.5 times for Cd, and 1.2 times for Zn as compared to the control sample SBP500. In addition, the removal rate and adsorption amount of KSBP500 increased 2 times for Cu, 1.8 times for Cd, and 1.2 times for Zn. The removal rate and adsorption amount of OSBP500 increased 5.8 times for Cu. The FT-IR analysis confirmed the changes in the generation and movement of new functional groups after adsorption. SEM analysis confirmed Cu in KSBP500 was in the form of Cu(OH)₂ and resembled the structure of nanowires. The Cd in KSBP500 was densely covered in cubic form of Cd(OH)₂. Lead(Pb) was in the form of Pb₃(OH)₂(CO₃)₂ in a hexagonal atomic layer structure in NSBP500. In addition, it was observed that Zn was randomly covered with Zn₅(CO₃)₂(OH)₆ pieces which resembled plates in KSBP500. Therefore, this study confirmed that biochar removal efficiency was improved through a chemical modification treatment. Accordingly, adsorption and precipitation were found to be the complex mechanisms behind the improved removal efficiency in the biochar. This was accomplished by electrostatic interactions between the biochar and heavy metals and ion exchange with Ca²⁺.

• Journal of Korean Society on Water Environment
• /
• v.38 no.2
• /
• pp.72-81
• /
• 2022

Numerous studies have investigated the occurrence and fate of microplastics in the environment; however, only limited effort has been devoted to exploring the characteristics of dissolved organic matter (DOM) leached from microplastics. In microplastic (MP)-contaminated environment, MPs are typically mixed with naturally-occurring particles, which interferes with their detection in the environment. Thus, it is necessary to distinguish between the DOM leached from MPs and those leached from natural particles and also to characterize their properties. This study investigated DOM leaching behavior from MPs (polystyrene: PS, polyvinylchloride: PVC) and natural particulates (forest soil: FS, litter leaves: LL) under light, which is considered one of the main weathering processes that affect MPs in the environment. The leached DOM concentrations and fluorescence characteristics were compared under dark versus light conditions. Regardless of the origins, UV light promoted DOM release from all the particulates. More DOM was released from natural particles than from MPs under both conditions. However, the effect of promoting DOM release by UV was more pronounced for MPs than for natural particles. It was observed from fluorescence spectra that the intensity of the humic-like region was substantially reduced when MP-derived DOM was exposed to UV light, whereas the change of intensity was very little for natural particles. Under light conditions, the ratio of protein-like to humic-like fluorescence of MP-derived DOM was higher than that of DOM from natural particles. This study implies that a substantial amount of DOM could be leached from MPs even in MP-polluted environment under UV irradiation. Protein/humic fluorescence ratio could be utilized as a fast probing indicator to separate the two sources of particles under light.