• Journal of Integrative Natural Science
• /
• v.6 no.4
• /
• pp.211-214
• /
• 2013

In this study, in order to investigate how consecutive treatments of glass surface with HF acid and water vapor/Ar plasma affect the quality of 3-aminopropyltriethoxysilane self-assembled monolayer (APS-SAM), poly(3,4-ethylenedioxythiophene) (PEDOT) thin films were vapor phase-polymerized immediately after spin coating of FeCl3 and poly-urethane diol-mixed oxidant solution on the monolayer surfaces prepared at various treatment conditions. For the film characterization, various poweful tools were used, e.g., FE-SEM, an optical microscope, four point probe, and a contact angle analyzer. The characterization revealed that HF treatment is not desirable for the synthesis of a high quality PEDOT thin film via vapor phase polymerization method. Rather, sole treatment with plasma noticeably improved the quality of APS-SAM on glass surface. As a result, a highly dense and smooth PEDOT thin film was grown on uniform oxidant film-coated APS monolayer surface.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.15 no.8
• /
• pp.690-696
• /
• 2003

This paper presents the heat recovery performance of water fluidized-bed heat exchanger. Temperature and humidity ratio of waste gas are considered as important parameters in this study. Therefore, the heat recovery rate through water fluidized-bed heat exchanger for exhaust gases with various temperatures and humidity ratios can be estimated from the results of this study. Mass flow ratio (the ratio of mass flow rate of water to that of gas) and temperature of inlet water are also considered as important operating variables. Increase of heat recovery rate can be obtained through either high mass flow ratio or low temperature of inlet water with resultant low recovered temperature. The heat recovery performance with the mass flow ratio of about up to 10 has been investigated. The effect of number of stages of water fluidized-bed on the heat recovery performance has been also examined in this study.

• Proceedings of the SAREK Conference
• /
• 2006.06a
• /
• pp.442-447
• /
• 2006

In semiconductor manufacturing clean rooms, it becomes important to remove airborne molecular contaminants as well as particulate contaminant in outdoor air introduced into clean rooms. One suitable control technique for these chemical contaminants is air washing by water in an outdoor air handling unit. In order to enhance the removal efficiency of chemical contaminants the effect of adding a heating and humidifying process before an air washer was examined.

• The Journal of Korean Medicine Ophthalmology and Otolaryngology and Dermatology
• /
• v.15 no.2
• /
• pp.145-155
• /
• 2002

Allergic Rhinitis is specified by three symptoms such as sternutation, rhinorrhea and rhinanchon. Besides these three major symptoms, it is characterized by sternutation, frontal headache, photophobia and epiphora. The allergic rhinitis occurs when inhaled allergen is in contact with nasal mucosa, which causes immune response. And Tonguetangmi is one of the most frequently used medical treatment for the allergic rhinitis. A study on the 20 patients with allergic rhinitis who took Tonguetangmi a year ago shows that the oral medication for 10 days of Tonguetangmi for an adult who has allergic rhinitis less than one year results in the best efficiency of the remedy.

• Nuclear Engineering and Technology
• /
• v.53 no.10
• /
• pp.3352-3358
• /
• 2021

Aiming at selective adsorption and separation of Y(III) from the Y(III)-Sr(II) group in acid solution, a silica-based TODGA impregnated adsorbent [(TODGA+1-dodecanol)/SiO₂-P-F600] has been prepared. Batch adsorption experiments were conducted under the effect of contact time, acid concentration, solution temperature, and adsorption capacity etc. Chromatography recovery of more than 90% Y(III) was successfully achieved under elution with 0.01 M DTPA solution in nitric acid adsorption system, and 0.1 M HCl solution in hydrochloride adsorption system, respectively.

• International Journal of Precision Engineering and Manufacturing-Green Technology
• /
• v.5 no.5
• /
• pp.631-636
• /
• 2018

Extraction of photosynthetic currents from thylakoids was studied using micro pillar structured electrode. Thylakoids were isolated from spinach leaves, and the size and shape of thylakoids were estimated from scanning electron microscopy images. Based on the geometry information of thylakoids, micro pillar shaped electrode was designed and fabricated using metal-assisted chemical etching of silicon wafers. Influence of photovoltaic effect on the silicon-based micro pillar electrode was confirmed to be negligible. Photosynthetic currents were measured in a three-electrode setup with an electron mediator, potassium ferricyanide. Photosynthetic currents from micro pillar electrodes were enhanced compared with the currents from flat electrodes. This indicates the significance of the enhanced contact between thylakoids and an electrode for harvesting photosynthetic electrons.

• Nuclear Engineering and Technology
• /
• v.51 no.6
• /
• pp.1650-1657
• /
• 2019

Fluidelastic instability and nonlinear dynamics of tube bundles is a key issue in a steam generator. Especially, once the post-instability motion of the tube becomes larger than the clearance gap to other tubes, effective contact or impact between the tubes under consideration and the other tube inevitable. There is seldom theoretical analysis to the nonlinear dynamic characteristics of a tube array in two-phase flow. In this paper, experimental and numerical studies were utilized to obtain the critical velocity of the flow-induced instability of a rotated triangular tube array. The calculation results agreed well with the experimental data. To explore the post-instability dynamics of the tube array system, a Runge-Kutta scheme was used to solve the nonlinear governing equations of tube motion. The numerical results indicated that, when the flow pitch velocity is larger than the critical velocity, the tube array system is undergoing a limit cycle motion, and the dynamic characteristics of the tube array are almost similar for different void fractions.

• Smart Structures and Systems
• /
• v.23 no.4
• /
• pp.347-357
• /
• 2019

A new methodology for mitigation of the wheel squealing is proposed and investigated based on the dithering control. The idea can be applied in railway lines particularly in urban areas. The idea is clearly presented, and applied to a validated model. A full-scale model including the vehicle, curved track and wheel/rail contact is developed in the time domain to analyze the possibility and level of wheel squeal noise. Comparing the numerical results with a field test, the model is validated in different levels namely i) occurrence, ii) squealing frequency and iii) noise level. Two different approaches are proposed a) dithering of the wheel with piezoelectric patches and b) dithering of the rail with piezoelectric stacks. The noise level as well as the wheel responses is compared after applying the control strategy. A parametric study is carried out and effect of the dithering voltage and frequency on the squealing noise is investigated. It is found that both the strategies perform quite effectively within the saturating threshold of piezoelectric actuators.

• Nuclear Engineering and Technology
• /
• v.53 no.3
• /
• pp.920-926
• /
• 2021

Capsules containing NaCl-MgCl₂ salt with 316L stainless steel or alloy N samples were irradiated in the Ohio State University Research Reactor for 21 nonconsecutive hours. A custom irradiation vessel was designed for this purpose, and details on its design and construction are given. Stainless steel samples that were irradiated during exposure had less corrosive attack than samples exposed to the same conditions without irradiation. Alloy N samples showed no significant effect of irradiation. This work shows a method for conducting in-reactor irradiation-corrosion experiments in static molten salts and presents preliminary data showing that neutron irradiation may decelerate corrosion of alloys in molten chloride salts.

• Proceedings of the Korean Society for Information Management Conference
• /
• 2016.08a
• /
• pp.35-38
• /
• 2016

본 연구는 공공도서관의 서비스 성과 향상을 위해 경영활동에서 고려되어야 할 요소와 개선 방법을 논의하는 것을 목적으로 공공도서관 5개관을 선정, 이용자 서비스를 담당하는 사서들을 대상으로 개별 심층면담을 진행하여 조직의 서비스 지향성(Service Orientation)에 대한 접점 직원의 인식을 조사, 그들의 서비스 태도와 행동에 영향을 미치는 요인을 분석하였다. 그 결과 공공도서관 접점 직원들은 도서관의 다양한 서비스 중 이용자서비스의 중요도가 저평가되어 있고, 이에 대한 조직의 목표관리와 지원은 취약하다고 인식하고 있었으며 특히 서비스 지향성의 4가치 차원 중 서비스리더십, 인적자원관리의 측면은 서비스 동기에 직접적 영향을 미치는 것으로 파악되었다. 이에 이용자서비스를 사서직 전문성이 발현되어야 할 핵심 영역으로 재인식, 이를 강화하기 위한 전략적 접근의 필요성을 제안하였다.