• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.48 no.9
• /
• pp.676-680
• /
• 1999

To do breath alcohol measurement, a sensor is necessary that it can detect low alcohol gas concentration of 0.01% at least. In this work, a capacitance-type alcohol gas sensor using porous silicon layer is developed to measure low alcohol gas concentration. The sensor using porous silicon layer has some sensitivity at room temperature by very large effective surface area, but there is still much room for improvement. In this experiment, we measured the capacitance of the sensor under 254 nm UV light on the porous silicon layer, in which alcohol solution was kept in a flask at 25, 35, and $45^{\circ}C$ by a heater. As the result, the improvement of sensitivity by illuminating UV light was observed. The increasing rate of the capacitance was shown to be double more than those measured under UV-off state. It is supposed that UV light activates response of the oriental and interfacial polarizations which have slow relaxation time for AC field.

• Membrane Journal
• /
• v.9 no.4
• /
• pp.240-244
• /
• 1999

Diagnostic membranes which were made of multi-layered gelatin films were prepared to measure the concentration of glucose in solution. It was found that the maximum diffusion rate of glucose had a linear relationship toward the glucose concentration. The effects of possible interferents in human blood on the reaction between glucose and reductive enzymes were examined. As a result, most of the interferents did not affect seriously on the maximum diffusion rate of glucose.

• 한국연소학회:학술대회논문집
• /
• 1998.10a
• /
• pp.103-110
• /
• 1998

This experiment is performed to investigate the effects of the emulsion on the flame temperature and soot formation in a diesel engine. The two-color method is used to measure the flame temperature for combustion of emulsified diesel in the Rapid Compression and Expansion Machine(RCEM). The concentration of soot is estimated via calculation of the KL factor. The solenoid valve, elecronic controller and needle lift sensor are used to control the exact injection timing and duration under various operating conditions. According to the results the soot concentration is reduced with the increasing W/O while the temperature reduced. The pressure data and the flame images captured by a high speed camera show that the ignition delay of emulsified diesel increase the duration of premixed combustion. The sizes of water drops are measured to be about 10${\mu}m$ by a microscope.

• Elastomers and Composites
• /
• v.33 no.5
• /
• pp.363-369
• /
• 1998

Photografting reaction onto styrene-butadiene rubber (SBR) as a function of monomer concentration, irradiation time and carbon black content has been studied using ultraviolet (UV). Acrylamide and benzophenone are used as monomer and photoinitiator, respectively. FT-IR ATR and static contact angle analysis using distilled water are used to measure the graft ratio of acrylamide onto SBR surface. Graft ratio of acrylamide increases with acrylamide concentration and irradiation time and contact angle tends to decrease with increasing graft ratio. It is observed that graft ratio increases with carbon black content.

• Journal of Environmental Health Sciences
• /
• v.18 no.1
• /
• pp.47-57
• /
• 1992

This study was performed to evaluate contamination degree of heavy metals in sediments of Han River, compared with other nation's evaluation method. The results were as follows 1. The contamination Ratio calculation method by heavy metal concentration in differnt fraction size has a limitation to apply to all of the areas of Han river because of its characteristics of sediment. As a result, this method applied to only 4 areas of Pal Dang, Wang Sook Chon, Uk Chon, and Bul Kwang Chon, and Contmination Ratio of heavy metals in those areas were relatively low of below 3. So it's considered that those areas have less contaminated from anthropogenic contaminants. 2. The Contamination Ratio calculation method by heavy metal concentration in different areasthat of upper area to be background level-has a limitation also to apply to Han river. But it is considered that this method was relatively suitable to apply, so it should be prepared evaluation standand method for them. Contamination ratio from background level as Pal Dang area were most high in An Yang Chon. So it must be prepared purification and control measure at An Yang Chon.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.10
• /
• pp.2861-2866
• /
• 2010

We studied effects of the 11-Mercaptoundecylphosphoric-acid layer formation on gold surfaces that have the interactions with the titanium dioxide surface for design of gold- titanium dioxide distribution. The atomic force microscope (AFM) was used to measure forces between the surfaces as a function of the salt concentration and pH value. The forces were analyzed with the DLVO (Derjaguin-Landau-Verwey-Overbeek) theory, to evaluate the potential and charge density of the surfaces quantitatively for each salt concentration and each pH value. The interpretation for the evaluation was performed with the law of mass action and the ionizable groups on the surface.

• Proceedings of the KSME Conference
• /
• 2004.04a
• /
• pp.1841-1844
• /
• 2004

'Mixing Index($D_I$)'s generally used to measure the degree of mixing. A new method to calculate $D_I$ was proposed, when insoluble solution flows in micromixer. 'Vortex Index (${\Omega}_I$)'which indicate the degree of chaotic advection, is defined and formulated. A lots of arbitrary shaped microchannels were tested to calculate the $D_I$ and ${\Omega}_I$. And then a simple algebraic equation, $D_I=A{\Omega}_I+B$, was obtained. This equation may be used instead of partial differential equation, concentration equation.

• Environmental Engineering Research
• /
• v.10 no.2
• /
• pp.71-78
• /
• 2005

A series of column experiments was conducted to develop a monitoring system for in-situ and realtime measurement of ozone transport in unsaturated porous media using a fiber optic sensor. The calibration of the fiber optic transflection dip probe (FOTDP) system was successfully carried out at various ozone concentrations using a column with length of 30 cm and diameter of 5 cm packed with glass beads, which don't react with gaseous ozone. The breakthrough curves (BTCs) of ozone were obtained by converting the normalized intensity into ozone concentration. The FOTDP system worked well for in-situ monitoring of gas phase ozone at various water saturations and in presence of soil organic matter (SOM). However, the FOTDP system did not measure the ozone concentration at more than 70% water saturation.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.7
• /
• pp.1049-1055
• /
• 2012

We measure the hemodynamic responses during the 4 kinds of tasks on the motor cortex in the right and left human brain by using near-infrared spectroscopy. The experimental results show that the change of concentration of oxy-hemoglobin is larger than that of deoxy-hemoglobin and the change of concentration of chromophores induced by finger and arm related task show more activations than that of leg.

• Journal of Advanced Marine Engineering and Technology
• /
• v.22 no.4
• /
• pp.505-514
• /
• 1998

Flow pattern of air-water two phase flow depends on the conditions of pressure void fraction and channel geometry. We classify the flow pattern by measuring the output signal of the conductivity probe. under the classified flow pattern we mount a visualization equipment on the test section and take pictures. We vary the concentration of pure solvent and polymer to measure local void fraction. We know that the maximum point position of local void fraction distribution move from the center of the pipe to the wall of the pipe as JSL increase when JSA is constant in two phase flow. But we find that the maximum point position of local void friction move from the wal of the pipe to the center of the pipe when polymer concentration increase.