• Journal of the Korean Solar Energy Society
• /
• v.32 no.4
• /
• pp.24-33
• /
• 2012

Recently, finishing materials at spandrel area, a part of curtain-wall system, are gradually forced to improve thermal insulation performance in order to enhance the building energy efficiency. Also, Building Integrated Photovoltaics(BIPV) systems have been installed in the exterior side of the spandrel area, which is generally composed of windows. Those BIPVs aim to achieve high building energy efficiency and supply the electricity to building. However, if transparent BIPV module is combined with high insulated spandrel, it would reduce the PV efficiency for two major reasons. First, temperature in the air space, located between window layer and finishing layer of the spandrel area, can significantly increase by solar heat gain, because the space has a few air density relative to other spaces in building. Secondly, PV has a characteristics of decreased Voltage(Voc and Vmp) with the increased temperature on the PV cell. For these reasons, this research analyzed a direct interrelation between PV Cell temperature and electricity generation performance under different insulation conditions in the spandrel area. The different insulation conditions under consideration are 1) high insulated spandrel(HIS) 2) low insulated spandrel(LIS) 3) PV stand alone on the ground(SAG). As a result, in case of 1) HIS, PV temperature was increased and thus electricity generation efficiency was decreased more than other cases. To be specific, each cases' maximum temperature indicated that 1) HIS is $83.8^{\circ}C$, 2) LIS is $74.2^{\circ}C$, and 3) SAG is $66.3^{\circ}C$. Also, each cases yield electricity generation like that 1) HIS is 913.3kWh/kWp, 2) LIS is 942.8kWh/kWp, and 3) SAG is 981.3kWh/kWp. These result showed that it is needed for us to seek to the way how the PV Cell temperature would be decreased.

• KIPS Transactions on Computer and Communication Systems
• /
• v.6 no.5
• /
• pp.219-230
• /
• 2017

General-Purpose Graphics Processing Units (GPGPUs) build massively parallel architecture and apply multithreading technology to explore parallelism. By using programming models like CUDA, and OpenCL, GPGPUs are becoming the best in exploiting plentiful thread-level parallelism caused by parallel applications. Unfortunately, modern GPGPU cannot efficiently utilize its available hardware resources for numerous general-purpose applications. One of the primary reasons is the inefficiency of existing warp/thread block schedulers in hiding long latency instructions, resulting in lost opportunity to improve the performance. This paper studies the effects of hardware thread scheduling policy on GPGPU performance. We propose a novel warp scheduling policy that can alleviate the drawbacks of the traditional round-robin policy. The proposed warp scheduler first classifies the warps of a thread block into two groups, warps with long latency and warps with short latency and then schedules the warps with long latency before the warps with short latency. Furthermore, to support the proposed warp scheduler, we also propose a supplemental technique that can dynamically reduce the number of streaming multiprocessors to which will be assigned thread blocks when encountering a high contention degree at the memory and interconnection network. Based on our experiments on a 15-streaming multiprocessor GPGPU platform, the proposed warp scheduling policy provides an average IPC improvement of 7.5% over the baseline round-robin warp scheduling policy. This paper also shows that the GPGPU performance can be improved by approximately 8.9% on average when the two proposed techniques are combined.

• Solar Energy
• /
• v.15 no.3
• /
• pp.3-14
• /
• 1995

The Direct Contact heat Exchanger(DCHX) has been widely studied in the chemical industry for many years due to its inherent simplicity as a counter-current divice for heat and mass transfer. In many solar systems, the DCHX unit can be combined with the thermal storage unit, or alternatively, it can be used separately from the storage unit, much like an external(to storage) closed heat exchanger system. In the present work, the spray column type of direct contact heat exchangers are studied extensively to harness the solar energy for hot water and spaced heating. Some of the major considerations that are involved in the design of heat exchangers in this study are that : working fluid is a hydrocaabon(such as Texaterm) or water which is either lighter or heavier than storage medium. The experimental data have revealed some interesting characteristics concerning the application of DCHXs for solar energy utilization. These experiments are carried out in the line of solar heating system, major results are as follows : 1) the flow and aspect of working fluid drop for maxium heat transfer 2) efficiency and volumetric heat transfer coefficient of D.C.H.X with a heavier working fluid are higher than those of D.C.H.X with a lighter working fluid.

• Animal cells and systems
• /
• v.12 no.4
• /
• pp.313-319
• /
• 2008

The ultrastructure of oocytes during oogenesis and oocyte degeneration associated with follicle cells in female Sinonovacula constricta(Lamarck, 1818) were investigated by electron microscope observations. Ovarian follicles are surrounded by a matrix of vesicular connective tissue cells(VCT cells). VCT cells contain large quantities of glycogen particles and several lipid droplets in their cytoplasm. It is suggested that VCT cells act as a source of nutrients for vitellogenesis during oogenesis. In early vitellogenic oocytes, several coated vesicles, which appear at the basal region of the oocyte, lead to the formation of membrane-bound vesicles via endocytosis. The uptake of nutritive materials in coated vesicles formed by endocytosis appears through the formation of coated pits on the oolemma during vitellogenesis. During the late stage of oogenesis, yolk precursors(yolk granules), mitochondria and lipid droplets are present in the cytoplasm of late vitellogenic oocytes. In particular, proteinaceous yolk granules containing several different components are intermingles and form immature yolk granules. In the mature oocyte, small immature yolk granules are intermingled and form large mature yolk granules. Vitellogenesis occurs through a process of autosynthesis, involving combined activity of the Golgi complex, mitochondria and rough endoplasmic reticulum in the cytoplasm of vitellogenic oocytes. The process of heterosynthesis is where extraovarian precursors are incorporated into oocytes by endocytosis at the basal region of early vitellogenic oocytes before the formation of the vitelline coat. Follicle cells appear to play an important role in vitellogenesis and oocyte degeneration. The functions of attached follicle cells to the oocyte during oocyte degeneration are phagocytosis and digestion of phagosomes originating from oocyte degeneration. After digestion of phagosomes, it is assumed that the function of follicle cells can permit a transfer of yolk precursors necessary for vitellogenesis and allows for the accumulation of glycogen and lipid during oocyte degeneration, which can be employed by vitellogenic oocytes. Follicle cells of S. constricta may possess a lysosomal system for induction of oocyte breakdown and might resorb phagosomes in the cytoplasm for nutrient accumulation during oocyte degeneration.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.17 no.2
• /
• pp.245-250
• /
• 2017

From the instant of installation and operation, power cables start deteriorating. Cable systems can be maintained not only by monitoring the insulation status of the insulation layer and oversheath, but also the insulation status of the terminal and junction in high-voltage power cables. When the cable system (the cable itself and cable junctions combined) deteriorates, fire accidents happen due to dielectric breakdowns. We have invented a device to monitor the deteriorating status of cables, and installed it at Korea Western Power Co. Ltd. located in Taean, Chungcheongnam-do Province. In this paper, we present the results obtained using our device, through analysing and calculating the standard deviation of leakage current from cable insulators attached to the cables. When the standard deviation of analysed leakage current falls below a critical value, a cable system is deemed to be operating safely. But when the standard deviation of analysed leakage current is larger than the critical value, the insulation status of the terminal and junction in the cable system is considered to have seriously deteriorated. The terminal and junction in the relevant system should then be replaced preemptively in order to prevent blackout accidents of cables caused by the suspension of power supply.

• Journal of the Korean Chemical Society
• /
• v.25 no.2
• /
• pp.75-84
• /
• 1981

Ultraviolet spectrophotometric investigations have been carried out on the systems of mesitylene with iodine, bromine, iodine monochloride and iodine monobromide in carbon tetrachloride. The results reveal the formation of the charge transfer complexes of the type, $C_6H_3(CH_3)_3{\cdot}X_2$ or $C_6H_3(CH_3)_3{\cdot}IX$ (X denotes halogen atoms). The equilibrium constants were obtained in consideration of that absorption maxima due to the formation of the charge transfer complexes shift to blue with the increasing temperatures. Thermodynamic parameters, ${\Delta}H$, ${\Delta}G$ and ${\Delta}S$ for the formation of the charge transfer complexes were calculated from these values. These results indicate that the relative stabilities of the mesitylene complexes at each temperature decrease in the order, ICl > IBr > $I_2$ > $Br_2$. This order may be a measure of their relative acidities toward mesitylene, which is explaned in terms of the relative polarizabilities of halogen molecules and the relative electronegativities of halogen atoms. These results combined with previous study of this series indicated that the relative stabilities of the polymethylbenzene complexes with iodine increase in the order Benzene < Toluene < Xylene < Mesitylene Thus, analysis of these findings is discussed.

• Journal of Radiation Protection and Research
• /
• v.40 no.1
• /
• pp.55-64
• /
• 2015

Dose calculations which are a crucial requirement for radiotherapy treatment planning systems require accuracy and rapid calculations. The conventional radiotherapy treatment planning dose algorithms are rapid but lack precision. Monte Carlo methods are time consuming but the most accurate. The new combined system that Monte Carlo methods calculate part of interesting domain and the rest is calculated by neural can calculate the dose distribution rapidly and accurately. The preliminary study showed that neural networks can map functions which contain discontinuous points and inflection points which the dose distributions in inhomogeneous media also have. Performance results between scaled conjugated gradient algorithm and Levenberg-Marquardt algorithm which are used for training the neural network with a different number of neurons were compared. Finally, the dose distributions of homogeneous phantom calculated by a commercialized treatment planning system were used as training data of the neural network. In the case of homogeneous phantom;the mean squared error of percent depth dose was 0.00214. Further works are programmed to develop the neural network model for 3-dimensinal dose calculations in homogeneous phantoms and inhomogeneous phantoms.

• Journal of the Korean Geographical Society
• /
• v.36 no.5
• /
• pp.561-577
• /
• 2001

Urban spatial structure is closely related to the spatial distribution of urban economic activities. The spatial distribution pattern is no more than an aggregated expression of the location and/or relocation behavior of individual firms and establishments. In this respect, it is important to identify and examine the factors that affect the spatial behavior of individual firms for a more comprehensive understanding of urban space. Agglomeration economies are one of the most prominent urban economic phenomena in the modern metropolitan area. Most firms in an urban space seek external economies through the spatial clustering of their activities. Agglomeration economies feature prominently in the analysis of urban economic structure across urban areas. While the agglomeration economies between cities focus at the macro-scale of analysis, such economies within any given city focus more on the micro geographical scale. There have been a number of researches on agglomeration economies, among which there are relatively few approaches based on an intra-urban context. This proper explores the agglomeration economies at the micro scale and tries to reseal the spatial realization of the agglomeration economies within and between sectors. Three sectors are considered in the analysis; manufacturing, retail and service. The model is based on simultaneous equation systems combined with spatially weighted variables and estimated by the KRP estimators.

• Journal of the Korean Geographical Society
• /
• v.46 no.6
• /
• pp.707-723
• /
• 2011

The purpose of this study was to quantitatively evaluate the effectiveness of learning management systems (LMS) in the physical geography class. The study adopted the experimental design and three classes participated in this study. The first class was controlled using only classroom lectures, the second class used PPT slides along with the classroom lectures, and the third class used online video clips along with the lectures. The experiments were conducted from the Spring Semester 2007 to the Spring Semester 2008 for the introductory physical geography course. The study results showed that online learning tools help students improve academic performance and their attitudes towards the class and the instructor. Compared to simple PowerPoint slides, voice recording attached to the visual lecture slide materials enhanced students' motivation. Class lectures with lecture slides did not improve students' scores. However, when the visual materials were combined with voice recording, the number of internet access to online class materials increased, and class attendance and students' final grades were improved. Based on the results, the instructional design model that combines classroom and online learning was suggested.

• Journal of Intelligence and Information Systems
• /
• v.18 no.3
• /
• pp.1-12
• /
• 2012

There are many trees in a roadside, parks or facilities for landscape. Although we are easily seeing a tree in around, it would be difficult to classify it and to get some information about it, such as its name, species and surroundings of the tree. To find them, you have to find the illustrated books for plants or search for them on internet. The important components of a tree are leaf, flower, bark, and so on. Generally we can classify the tree by its leaves. A leaf has the inherited features of the shape, vein, and so on. The shape is important role to decide what the tree is. And texture included in vein is also efficient feature to classify them. This paper evaluates the performance of a leaf classification system using both shape and texture features. We use Fourier descriptors for shape features, and both gray-level co-occurrence matrices and wavelets for texture features, and used combinations of such features for evaluation of images from the Flavia dataset. We compared the recognition rates and the precision-recall performances of these features. Various experiments showed that a combination of shape and texture gave better results for performance. The best came from the case of a combination of features of shape and texture with a flipped contour for a Fourier descriptor.